Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Physica C Superconductivity

The 2 GHz high temperature superconducting receiver equipment for mobile communications

K. Satoh, T. Mimura, Shoichi Narahashi, T. Nojima

Published Aug 1, 2001• 14 citations
Publisher
DOI
10.1016/s0921-4534(01)00595-0

Related papers

Achieving 500-GHz communication over 1.2 km using an astronomical telescope with a quantum-limited superconducting receiver

Wei Miao, Jing Li, Xianjin Deng +39 more

500 GHz video transmission over 1.2 km is achieved using an astronomical telescope equipped with a quantum-limited superconducting SIS receiver.

National Science Review•Jun 4, 2025•1 citation

A superconducting tunnel junction receiver for 345 GHz

Edmund C. Sutton, W. C. Danchi, P. A. Jaminet +1 more

International Journal of Infrared and Millimeter Waves•Feb 1, 1990•18 citations

Superconducting receivers for advanced satellite communication systems

FULVIO ANANASSO, Fortunato Santucci

AIAA International Communications Satellite Systems Conference (ICSSC)•Feb 28, 1994•0 citations

The stability of a terahertz receiver based on a superconducting integrated receiver

Roman V. Ozhegov, К. Н. Горшков, Gregory N Gol'tsman +2 more

We present the results of stability testing of a terahertz radiometer based on a superconducting receiver with a SIS tunnel junction as the mixer and a flux-flow oscillator as the local oscillator. In the continuum mode, the receiver with a noise temperature of 95 K at 510 GHz measured over the intermediate frequency (IF) passband of 4–8 GHz offered a noise equivalent temperature difference of 10 ± 1 mK at an integration time of 1 s. We offer a method to significantly increase the integration time without the use of complex measurement equipment. The receiver observed a strong signal over a final detection bandwidth of 4 GHz and offered an Allan time of 5 s.

Superconductor Science and Technology•Dec 23, 2010•6 citations

Noise figure of HTS JJ MMIC downconverter at 12 GHz

Kenji Suzuki, S. Yoshikawa, Kenzo Yamaguchi +8 more

A YBa/sub 2/Cu/sub 3/O/sub 7- delta / (YBCO) step-edge microbridge JJ (Josephson junction), two 12-GHz YBCO microstrip bandpass filters, a 1-GHz YBCO filter, and current bias and voltage monitor circuits were successfully combined on a 20-mm*20-mm MgO substrate and integrated into a frequency downconverter for receiving DBS (direct broadcast satellite) signals. The YBCO downconverter and the GaAs low-noise IF (intermediate frequency) amplifier were combined in a microwave cryostat. The dependence of mixing signals on temperature and LO (local oscillator) input power was measured. The conversion gain and the noise figure corresponding to the YBCO downconverter package were -14.5 dB and 12.2 dB, respectively, at 15 K and low LO power (-25 dBm). The first demonstration of the HTS (high-temperature superconductive) subsystem, i.e. the monolithic YBCO downconverter, shows potential for applications in mobile radio communications and satellite broadcasting.>

IEEE MTT-S International Microwave Symposium digest•Dec 31, 2002•10 citations

Superconducting receivers of millimeter waves

Alexander N. Vystavkin, V. P. Koshelets, G. A. Ovsiannikov

Radiotekhnika i Elektronika•Dec 1, 1989•0 citations
We present the results of stability testing of a terahertz radiometer based on a superconducting receiver with a SIS tunnel junction as the mixer and a flux-flow oscillator as the local oscillator. In the continuum mode, the receiver with a noise temperature of 95 K at 510 GHz measured over the intermediate frequency (IF) passband of 4–8 GHz offered a noise equivalent temperature difference of 10 ± 1 mK at an integration time of 1 s. We offer a method to significantly increase the integration time without the use of complex measurement equipment. The receiver observed a strong signal over a final detection bandwidth of 4 GHz and offered an Allan time of 5 s.
A YBa/sub 2/Cu/sub 3/O/sub 7- delta / (YBCO) step-edge microbridge JJ (Josephson junction), two 12-GHz YBCO microstrip bandpass filters, a 1-GHz YBCO filter, and current bias and voltage monitor circuits were successfully combined on a 20-mm*20-mm MgO substrate and integrated into a frequency downconverter for receiving DBS (direct broadcast satellite) signals. The YBCO downconverter and the GaAs low-noise IF (intermediate frequency) amplifier were combined in a microwave cryostat. The dependence of mixing signals on temperature and LO (local oscillator) input power was measured. The conversion gain and the noise figure corresponding to the YBCO downconverter package were -14.5 dB and 12.2 dB, respectively, at 15 K and low LO power (-25 dBm). The first demonstration of the HTS (high-temperature superconductive) subsystem, i.e. the monolithic YBCO downconverter, shows potential for applications in mobile radio communications and satellite broadcasting.>