Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Applied Physics Letters

Theory of the dispersive modulator

D. Grischkowsky, M. M. T. Loy

Published Feb 15, 1975• 17 citations
Publisher

Abstract

The recent observations by Loy of amplitude modulation and compression of infrared laser pulses caused by passage through the dispersive modulator (a cell containing dilute NH3 vapor with a Stark−modulated resonant frequency) are explained. It is shown that there is a formal equivalence between (i) the passage of a near−resonant light beam through a vapor with a time−dependent resonant frequency, and (ii) the passage of a frequency−modulated light beam through a vapor with a constant resonant frequency. For low−intensity light this equivalence reduces the problem to the optical analog of chirp radar.

DOI
10.1063/1.88124

Related papers

A dispersive modulator

M. M. T. Loy

Amplitude modulation and temporal compression of 10−μ light at a frequency up to 80 MHz were demonstrated using a dispersive molulator—a NH3 vapor cell with a near−resonant time−dependent transition frequency controlled externally via the Stark effect. The peak output intensity was observed to be higher than the input intensity, showing that compression effects due to the time−dependent dispersion are essential in determining the output waveform.

Applied Physics Letters•Feb 1, 1975•21 citations

Optical pulse compression

D. Grischkowsky

Dramatic and controllable reshaping of frequency-modulated dye laser pulses has been observed. The pulses, nearly resonant with the 2P1/2 line (7948 Å) of Rb, first passed through a LiNbO3 frequency modulator, and then through a cell containing dilute Rb vapor where the reshaping took place. Large pulse compressions were obtained with only 400 MHz of frequency modulation due to the extremely large frequency dispersion of the group velocity.

Applied Physics Letters•Nov 15, 1974•88 citations

Temporal compression of light

J. Keith Wigmore, D. Grischkowsky

The 5890 Å output from a CW dye laser was converted into a train of 0.5 ns pulses by frequency modulation and passage through a near-resonant atomic vapor delay line of Na. The theory of the process is discussed in both the time and frequency domains. Using a modulation index of 120 at a frequency of 17.8 MHz, we obtained values for the temporal compression ratio and intensity enhancement of 112 and 14, easily the largest that have been reported.

IEEE Journal of Quantum Electronics•Apr 1, 1978•51 citations

Atomic-vapor laser interaction

Priscila Mayana Torres Barboza

In this work we investigate the transmission in an optical cell containing an atomic vapor, when a laser is tuned to the wings of the Doppler line, presenting inhomogeneous broadening. The experiment is designed to detect the transmission of a laser beam through a an atomic cesium vapor within a quartz cell. Due to the high atomic density in the 1 mm cell, the laser beam is totally absorbed at resonance. On the other hand, when the detuning by few GHz from the center of the line an oscillatory signal is observed as a function of the laser frequency. The amplitude of the transmission signal varies linearly with the laser intensity. These oscillations exhibit diferent behavior as we change some parameters of the system, and the rate of the oscillations vary with laser detuning and on the atomic density. The phase of the transmited field is also sensitive to the angle of incidence of the laser beam in the cell, which allows to vary the lineshape of the signal without changing the parameters of the laser (intensity, frequency, ...) or atomic vapor. Out of resonance with the atomic vapor, the parallel windows of commercial optical cell cavity works as a low finesse Fabry-Pérot with a free spectral range of 150 GHz. However, in resonance, the optical path of the cavity changes varies with frequency due to the dispersive response of the atomic vapor. This study experimentally characterized the transmission signal through a cavity containing resonant vapor as a function of intensity and frequency of the laser, as well as its dependence on the angle of incidence of the beam. A numerical model that allows to determine the collisional broadening of the atomic vapor adjusting the spectral curves of the transmission signal was developed. As an application, exploring the oscillations in the wings of the resonance, we can lock the laser frequency at a few GHz off the center of the atomic resonance. The lock was performed in the frequency range between 0,8 GHz and 2,4 GHz from the center of the D2 line of cesium. To characterize the locking stability we measure the optical beat signal between two similar experiments, using the same locking technique.

•Jul 28, 2014•0 citations

Conversion of cw light into a train of subnanosecond pulses using frequency modulation and the dispersion of a near-resonant atomic vapor

John E. Bjorkholm, E. H. Turner, D. B. Pearson

Sinusoidally frequency-modulated cw laser light is converted into a train of repetitive short pulses by passing it through a nearly resonant atomic vapor. Using a 200-MHz modulation frequency and sodium vapor, pulses as short as 240 psec, having peak powers of 6.3 times the input power, have been obtained at 5890 Å. Calculation and experiment are in good agreement.

Applied Physics Letters•May 15, 1975•57 citations

Passive pulse train generation from a frequency modulated diode laser

J. Menders, Kyunam Choi, Eric J. Korevaar

By sweeping the frequency of a diode laser beam near the cesium resonance frequency, followed by propagation through a short length of cesium vapor, we obtained periodic peaks with peak-to-average ratios near 5 at pulse repetition rates up to a gigahertz. Light in the wings of a strong atomic absorption line of an alkali metal vapor encounters large group velocity dispersion. A frequency modulation in an off-resonance cw beam passing through the vapor consequently develops an amplitude modulation. For certain combinations of laser and vapor parameters, a sinusoidally frequency modulated beam can be made to develop peaks. We generated pulse trains in a frequency modulated single mode diode laser tuned to the cesium absorption line near 852 nm, which we observed by using a fast p-i-n photodiode and a sampling oscilloscope. The frequency of a diode laser was sinusoidally modulated with a sweep of about a gigahertz and a period of a few nansoseconds by introducing a small modulation into the laser pump current. We observed the formation of sharp peaks with a width of about one-tenth of the modulation period and a peak-to-background ratio of approximately 5.

Annual Meeting Optical Society of America•Jan 1, 1992•0 citations
The recent observations by Loy of amplitude modulation and compression of infrared laser pulses caused by passage through the dispersive modulator (a cell containing dilute NH3 vapor with a Stark−modulated resonant frequency) are explained. It is shown that there is a formal equivalence between (i) the passage of a near−resonant light beam through a vapor with a time−dependent resonant frequency, and (ii) the passage of a frequency−modulated light beam through a vapor with a constant resonant frequency. For low−intensity light this equivalence reduces the problem to the optical analog of chirp radar.
In this work we investigate the transmission in an optical cell containing an atomic vapor, when a laser is tuned to the wings of the Doppler line, presenting inhomogeneous broadening. The experiment is designed to detect the transmission of a laser beam through a an atomic cesium vapor within a quartz cell. Due to the high atomic density in the 1 mm cell, the laser beam is totally absorbed at resonance. On the other hand, when the detuning by few GHz from the center of the line an oscillatory signal is observed as a function of the laser frequency. The amplitude of the transmission signal varies linearly with the laser intensity. These oscillations exhibit diferent behavior as we change some parameters of the system, and the rate of the oscillations vary with laser detuning and on the atomic density. The phase of the transmited field is also sensitive to the angle of incidence of the laser beam in the cell, which allows to vary the lineshape of the signal without changing the parameters of the laser (intensity, frequency, ...) or atomic vapor. Out of resonance with the atomic vapor, the parallel windows of commercial optical cell cavity works as a low finesse Fabry-Pérot with a free spectral range of 150 GHz. However, in resonance, the optical path of the cavity changes varies with frequency due to the dispersive response of the atomic vapor. This study experimentally characterized the transmission signal through a cavity containing resonant vapor as a function of intensity and frequency of the laser, as well as its dependence on the angle of incidence of the beam. A numerical model that allows to determine the collisional broadening of the atomic vapor adjusting the spectral curves of the transmission signal was developed. As an application, exploring the oscillations in the wings of the resonance, we can lock the laser frequency at a few GHz off the center of the atomic resonance. The lock was performed in the frequency range between 0,8 GHz and 2,4 GHz from the center of the D2 line of cesium. To characterize the locking stability we measure the optical beat signal between two similar experiments, using the same locking technique.
By sweeping the frequency of a diode laser beam near the cesium resonance frequency, followed by propagation through a short length of cesium vapor, we obtained periodic peaks with peak-to-average ratios near 5 at pulse repetition rates up to a gigahertz. Light in the wings of a strong atomic absorption line of an alkali metal vapor encounters large group velocity dispersion. A frequency modulation in an off-resonance cw beam passing through the vapor consequently develops an amplitude modulation. For certain combinations of laser and vapor parameters, a sinusoidally frequency modulated beam can be made to develop peaks. We generated pulse trains in a frequency modulated single mode diode laser tuned to the cesium absorption line near 852 nm, which we observed by using a fast p-i-n photodiode and a sampling oscilloscope. The frequency of a diode laser was sinusoidally modulated with a sweep of about a gigahertz and a period of a few nansoseconds by introducing a small modulation into the laser pump current. We observed the formation of sharp peaks with a width of about one-tenth of the modulation period and a peak-to-background ratio of approximately 5.