Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Applied Physics Letters

Continuous weak measurement of a trapped electron using a percolation field effect transistor

S. Fleming, William Ireland Milne, D. G. Hasko

Published Aug 26, 2013• 3 citations
Publisher

Abstract

We investigate the use of a percolation-field-effect-transistor for the continuous weak measurement of a spatially Rabi oscillating trapped electron through the change in percolation pathway of the transistor channel. In contrast to conventional devices, this detection mechanism in principle does not require a change in the stored energy of the gate capacitance to modify the drain current, so reducing the measurement back-action. The signal-to-noise ratio and measurement bandwidth are seen to be improved compared to conventional devices, allowing further aspects of the dynamic behaviour to be observed.

DOI
10.1063/1.4819382

Related papers

Electrical Detection of Trapped Charge Displacements Using an Ultra-Thin SOI Percolation Transistor

Stephen Fleming, William Ireland Milne, D. G. Hasko

Electrical detection of solid-state charge qubits requires ultra-sensitive charge measurement, typically using a quantum point contact or single-electron-transistor, which imposes strict limits on operating temperature, voltage and current. A conventional FET offers relaxed operating conditions, but the back-action of the channel charge is a problem for such small quantum systems. Here, we discuss the use of a percolation transistor as a measurement device, with regard to charge sensing and backaction. The transistor is based on a 10nm thick SOI channel layer and is designed to measure the displacement of trapped charges in a nearby dielectric. At cryogenic temperatures, the trapped charges result in strong disorder in the channel layer, so that current is constrained to a percolation pathway in sub-threshold conditions. A microwave driven spatial Rabi oscillation of the trapped charge causes a change in the percolation pathway, which results in a measurable change in channel current.

ECS Transactions•Jun 28, 2013•0 citations

Coherent control of trapped-charge induced resonances in a field-effect transistor

Jaime Oscar Tenorio-Pearl, Ernst David Herbschleb, Celestino Creatore +2 more

Trapped charges at oxide interfaces in field effect transistors are well known sources of noise and generally degrade the device performance. At low temperatures, operating in the sub-threshold regime, conduction electrons can be confined to percolation pathways [1]. The scattering potential produced by trapped charge can then have a dramatic effect on the conductance, normally observed as random telegraph noise [2]. Here we show that it is possible to coherently excite the trapped electrons with microwave fields, which induce polarization fields that interact with the percolating electrons, measured as high-quality resonances (Q ~ 104- 105) in the transistor current. Implementing single-shot measurements gives the possibility to study the dynamics of the trapped electrons, and using a standard Ramsey protocol, coherent control is achieved. Given the long coherence times observed (T2~ 10 μs) and since each resonance can be addressed independently in frequency space, the possibility to use such systems as quantum memories or quantum bits is discussed.

IEEE Silicon Nanoelectronics Workshop•Jun 1, 2016•0 citations

Continuous Weak Measurement of Qubit Oscillations with Strongly Responding Single Electron Transistors

HuJun Jiao, Shi-Kuan Wang, Feng Li +1 more

We investigate the continuous weak measurement of a solid-state qubit by single electron transistors in nonlinear response regime. It is found that the signal-to-noise ratio can violate the universal upper bound imposed quantum mechanically to any linear response detectors. We understand the violation by means of the cross-correlation of the detector currents.

•Jun 16, 2008•0 citations

Continuous monitoring and feedback control of a charge qubit

G. Kießlich, Gemot Schaller, Tobias Brandes

We investigate an individual charge qubit coupled to an electronic detector where its current flow enables the continuous monitoring of the qubit dynamics. As specific detector model we employ a capacitively coupled single-electron transistor. Even though the detector signal-to-noise ratio is very low we demonstrate a successful qubit manipulation by back-coupling of the time-dependent detector current into qubit parameters.

International Conference on Noise and Fluctuations•Jun 1, 2011•0 citations

Solid-state qubit measurement with single electron transistors

HuJun Jiao, Feng Li, Shi-Kuan Wang +3 more

In this paper we consider the continuous weak measurement of a solid‐state qubit by single electron transistors (SET). For single‐dot SET, we find that in nonlinear response regime the signal‐to‐noise ratio can violate the universal upper bound imposed quantum mechanically on any linear response detectors. We understand the violation by means of the cross‐correlation of the detector currents. For double‐dot SET, we discuss its robustness against wider range of temperatures, quantum efficiency, and the relevant open issues unresolved.

AIP conference proceedings•Jan 1, 2008•0 citations

Realistic Monitoring of a Charge Qubit by a Quantum Tunnellling Device a Quantum Trajectory Approach

Neil P. Oxtoby, Howard M. Wiseman, Prahlad Warszawski +1 more

Full text: Recently, we presented a model for continuous DC-biased measurement of a coupled quantum dot (CQD) charge qubit by realistic measurement devices. Modelling realistic measurement devices as ideal detectors embedded in an equivalent measurement circuit (see figure), our aim was to describe the evolution of the qubit state conditioned on the macroscopic output of the external circuit, i.e. the measured current. We generalised a recently developed quantum trajectory theory for realistic photodetectors to treat solid-state detectors-primarily a single electron transistor (SET). This method yields stochastic equations whose (numerical) solutions are the 'realistic quantum trajectories' of the conditioned qubit state. Here we present numerical solutions and analysis for the SET equations. The solutions elucidate the regimes in which (Rabi) electron tunnelling between the CQDs can be detected in a realistic measurement. Further to this, the solutions reveal the conditions under which electron tunnelling events through the SET can be observed, which is related to the question of the nature of the back-action noise of the SET. Copyright (2005) Australian Institute of Physics.

•Jul 1, 2005•0 citations
We investigate the use of a percolation-field-effect-transistor for the continuous weak measurement of a spatially Rabi oscillating trapped electron through the change in percolation pathway of the transistor channel. In contrast to conventional devices, this detection mechanism in principle does not require a change in the stored energy of the gate capacitance to modify the drain current, so reducing the measurement back-action. The signal-to-noise ratio and measurement bandwidth are seen to be improved compared to conventional devices, allowing further aspects of the dynamic behaviour to be observed.
Electrical detection of solid-state charge qubits requires ultra-sensitive charge measurement, typically using a quantum point contact or single-electron-transistor, which imposes strict limits on operating temperature, voltage and current. A conventional FET offers relaxed operating conditions, but the back-action of the channel charge is a problem for such small quantum systems. Here, we discuss the use of a percolation transistor as a measurement device, with regard to charge sensing and backaction. The transistor is based on a 10nm thick SOI channel layer and is designed to measure the displacement of trapped charges in a nearby dielectric. At cryogenic temperatures, the trapped charges result in strong disorder in the channel layer, so that current is constrained to a percolation pathway in sub-threshold conditions. A microwave driven spatial Rabi oscillation of the trapped charge causes a change in the percolation pathway, which results in a measurable change in channel current.
Trapped charges at oxide interfaces in field effect transistors are well known sources of noise and generally degrade the device performance. At low temperatures, operating in the sub-threshold regime, conduction electrons can be confined to percolation pathways [1]. The scattering potential produced by trapped charge can then have a dramatic effect on the conductance, normally observed as random telegraph noise [2]. Here we show that it is possible to coherently excite the trapped electrons with microwave fields, which induce polarization fields that interact with the percolating electrons, measured as high-quality resonances (Q ~ 104- 105) in the transistor current. Implementing single-shot measurements gives the possibility to study the dynamics of the trapped electrons, and using a standard Ramsey protocol, coherent control is achieved. Given the long coherence times observed (T2~ 10 μs) and since each resonance can be addressed independently in frequency space, the possibility to use such systems as quantum memories or quantum bits is discussed.
In this paper we consider the continuous weak measurement of a solid‐state qubit by single electron transistors (SET). For single‐dot SET, we find that in nonlinear response regime the signal‐to‐noise ratio can violate the universal upper bound imposed quantum mechanically on any linear response detectors. We understand the violation by means of the cross‐correlation of the detector currents. For double‐dot SET, we discuss its robustness against wider range of temperatures, quantum efficiency, and the relevant open issues unresolved.
Full text: Recently, we presented a model for continuous DC-biased measurement of a coupled quantum dot (CQD) charge qubit by realistic measurement devices. Modelling realistic measurement devices as ideal detectors embedded in an equivalent measurement circuit (see figure), our aim was to describe the evolution of the qubit state conditioned on the macroscopic output of the external circuit, i.e. the measured current. We generalised a recently developed quantum trajectory theory for realistic photodetectors to treat solid-state detectors-primarily a single electron transistor (SET). This method yields stochastic equations whose (numerical) solutions are the 'realistic quantum trajectories' of the conditioned qubit state. Here we present numerical solutions and analysis for the SET equations. The solutions elucidate the regimes in which (Rabi) electron tunnelling between the CQDs can be detected in a realistic measurement. Further to this, the solutions reveal the conditions under which electron tunnelling events through the SET can be observed, which is related to the question of the nature of the back-action noise of the SET. Copyright (2005) Australian Institute of Physics.