Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Physical Review

Operation of a Solid-State Quantum-Mechanical Amplifier

M. W. P. Strandberg, C. F. Davis, Brian W. Faughnan, Robert L. Kyhl, G. J. Wolga

Published Mar 15, 1958• 20 citations
Publisher

Abstract

The operation of an $S$-band solid-state quantum-mechanical amplifier operated at 4.2\ifmmode^\circ\else\textdegree\fi{}K with a computed noise temperature of less than 4.5\ifmmode^\circ\else\textdegree\fi{}K is compared with similar devices and is used as proof of the condition of discrete phonon saturation which has been previously postulated.

DOI
10.1103/physrev.109.1988

Related papers

Quantum description of noise in saturated semiconductor optical amplifiers; analysis of generation of squeezed states

B. Tromborg, Mark Shtaif, Gad Eisenstein

We describe the relative intensity noise (RIN) and phase noise properties of semiconductor optical amplifiers operating in the nonlinear regime. We demonstrate the possibility of noise supression below the shot noise limit under some operating conditions.

IEEE International Semiconductor Laser Conference (ISLC)•Nov 27, 2002•1 citation

Squeezed Quantum Fluctuations and Noise Limits in Amplifiers and Attenuators

Claire R Gilson, Stephen Mark Barnett, Stig Stenholm

Conventional amplifiers add quantum noise to a signal. Both amplifiers and attenuators lead to a reduction of the signal-to-noise ratio. We find, however, that devices exhibiting squeezed fluctuations in the gain or loss medium lead to an improved signal-to-noise ratio, in one quadrature of the output, compared to the limits associated with conventional devices. We investigate amplifier and attenuator noise properties using a simple model in which the gain or loss medium is a broad-band reservoir in a specially prepared, or ‘rigged’, state.

Journal of Modern Optics•Jun 1, 1987•25 citations

Computation of Noise Figure for Quantum-Mechanical Amplifiers

M. W. P. Strandberg

An expression is derived for the noise figure for a quantum-mechanical amplifier in terms of the physical quantities describing the electromagnetic structure and the paramagnetic salts---such as gain, circuit $Q'\mathrm{s}$, and salt molecular weight and volume.

Physical Review•Sep 15, 1957•10 citations

Photonic-Crystal Josephson Traveling-Wave Parametric Amplifier

Luca Planat, Arpit Ranadive, Rémy Dassonneville +7 more

A microwave amplifier combining noise performances as close as possible to the quantum limit with large bandwidth and high saturation power is highly desirable for many solid-state quantum technologies.Here, we introduce a new traveling-wave parametric amplifier based on superconducting quantum interference devices.It displays a 3-GHz bandwidth, a -100-dBm saturation (1-dB compression) point and added noise near the quantum limit.Compared to the previous state of the art, it is an order of magnitude more compact, its characteristic impedance is in situ tunable, and its fabrication process requires only two lithography steps.The key is the engineering of a gap in the dispersion relation of the transmission line.This is obtained using a periodic modulation of the SQUID size, similarly to what is done with photonic crystals.Moreover, we provide a new theoretical treatment to describe the nontrivial interplay between nonlinearity and such periodicity.Our approach provides a path to cointegration with other quantum devices such as qubits given the low footprint and easy fabrication of our amplifier.

arXiv:1907.10158•Physical Review X•Apr 28, 2020•145 citations

Three-Mode Optoacoustic Parametric Amplifier: A Tool for Macroscopic Quantum Experiments

Chunnong Zhao, L. Ju, Haixing Miao +3 more

We introduce the three-mode optoacoustic parametric amplifier (OAPA), a close analog of the optical parametric amplifier, for macroscopic quantum mechanics experiments. The radiation pressure reaction of light on the reflective surface of an acoustic resonator provides a nonlinearity similar to the Kerr effect in the optical parametric amplifier. The OAPA can be tuned to operate in a positive gain regime where acoustic signals are amplified or in a negative gain regime where acoustic modes are cooled. Compared with conventional optoacoustic devices, (i) the OAPA incorporates two transverse cavity modes such that the carrier and sideband fields simultaneously resonate, and (ii) it is less susceptible to the laser phase and amplitude noise. These two features significantly ease the experimental requirements for cooling of acoustic modes to their quantum-ground state and creating entangled pairs of phonons and photons.

Physical Review Letters•Jun 17, 2009•43 citations

Inherent Noise of Quantum-Mechanical Amplifiers

M. W. P. Strandberg

The noise figure or limiting sensitivity for both traveling-wave and resonant-cavity quantum-mechanical amplifiers, sensitive to one direction of propagation, is derived with spontaneous emission as the limiting noise. The concept of effective temperature is introduced as an analytical parameter; thus negative temperatures appear in a natural fashion. It is pointed out that the results of this calculation can be considered the solution to the problem of linear counting of coherent particles. In this case the least count is one and the signal-to-noise ratio (for constant photon flux) increases as the reciprocal of the band width. The limiting temperature sensitivity of properly designed quantum-mechanical amplifiers is given as $\frac{h\ensuremath{\nu}}{k}$ degrees because of the drastic difference between negative and positive temperatures.

Physical Review•May 15, 1957•75 citations
The operation of an SSS-band solid-state quantum-mechanical amplifier operated at 4.2\ifmmode^\circ\else\textdegree\fi{}K with a computed noise temperature of less than 4.5\ifmmode^\circ\else\textdegree\fi{}K is compared with similar devices and is used as proof of the condition of discrete phonon saturation which has been previously postulated.
Conventional amplifiers add quantum noise to a signal. Both amplifiers and attenuators lead to a reduction of the signal-to-noise ratio. We find, however, that devices exhibiting squeezed fluctuations in the gain or loss medium lead to an improved signal-to-noise ratio, in one quadrature of the output, compared to the limits associated with conventional devices. We investigate amplifier and attenuator noise properties using a simple model in which the gain or loss medium is a broad-band reservoir in a specially prepared, or ‘rigged’, state.
An expression is derived for the noise figure for a quantum-mechanical amplifier in terms of the physical quantities describing the electromagnetic structure and the paramagnetic salts---such as gain, circuit Q′sQ'\mathrm{s}Q′s, and salt molecular weight and volume.
A microwave amplifier combining noise performances as close as possible to the quantum limit with large bandwidth and high saturation power is highly desirable for many solid-state quantum technologies.Here, we introduce a new traveling-wave parametric amplifier based on superconducting quantum interference devices.It displays a 3-GHz bandwidth, a -100-dBm saturation (1-dB compression) point and added noise near the quantum limit.Compared to the previous state of the art, it is an order of magnitude more compact, its characteristic impedance is in situ tunable, and its fabrication process requires only two lithography steps.The key is the engineering of a gap in the dispersion relation of the transmission line.This is obtained using a periodic modulation of the SQUID size, similarly to what is done with photonic crystals.Moreover, we provide a new theoretical treatment to describe the nontrivial interplay between nonlinearity and such periodicity.Our approach provides a path to cointegration with other quantum devices such as qubits given the low footprint and easy fabrication of our amplifier.
We introduce the three-mode optoacoustic parametric amplifier (OAPA), a close analog of the optical parametric amplifier, for macroscopic quantum mechanics experiments. The radiation pressure reaction of light on the reflective surface of an acoustic resonator provides a nonlinearity similar to the Kerr effect in the optical parametric amplifier. The OAPA can be tuned to operate in a positive gain regime where acoustic signals are amplified or in a negative gain regime where acoustic modes are cooled. Compared with conventional optoacoustic devices, (i) the OAPA incorporates two transverse cavity modes such that the carrier and sideband fields simultaneously resonate, and (ii) it is less susceptible to the laser phase and amplitude noise. These two features significantly ease the experimental requirements for cooling of acoustic modes to their quantum-ground state and creating entangled pairs of phonons and photons.
The noise figure or limiting sensitivity for both traveling-wave and resonant-cavity quantum-mechanical amplifiers, sensitive to one direction of propagation, is derived with spontaneous emission as the limiting noise. The concept of effective temperature is introduced as an analytical parameter; thus negative temperatures appear in a natural fashion. It is pointed out that the results of this calculation can be considered the solution to the problem of linear counting of coherent particles. In this case the least count is one and the signal-to-noise ratio (for constant photon flux) increases as the reciprocal of the band width. The limiting temperature sensitivity of properly designed quantum-mechanical amplifiers is given as $\frac{h\ensuremath{\nu}}{k}$ degrees because of the drastic difference between negative and positive temperatures.