Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of the Optical Society of America B

Optimization of selective erasure in photorefractive memories

María Aguilar, M. Carrascosa, Fernando Agulló-López, E. Serrano

Published Jan 1, 1997• 29 citations
Publisher

Abstract

A theoretical analysis for the optimization of the selective-erasure process in holographic photorefractive memories is presented. It is based on the solution of the standard material equations under a linear approximation (low modulation depths). Specific expressions for the optimum phase shifts and erasure rates are obtained. The approach includes all transport processes and so applies to photovoltaic materials such as LiNbO3. The different behavior with regard to nonphotovoltaic materials is discussed. Some additional strategies to improve the overall erasure process are proposed.

DOI
10.1364/josab.14.000110

Related papers

Fast update of dynamic photorefractive optical memory

Hironori Sasaki, Yoshinao Taketomi, Jian Ma +2 more

We have analyzed the dynamics of the selective erasure process in photorefractive crystal. The selective erasure process is much faster than the incoherent erasure process. Experimental results show good agreement with theoretical prediction. We have applied the incremental recording schedule and selective erasure process to a dynamic photorefractive optical memory and experimentally demonstrated the robust readout and fast update capabilities.

Optics Letters•Oct 15, 1992•35 citations

Photorefractive dynamic memories for optical processing: performances and limitations (Invited Paper)

Gilles Pauliat, Gérald Roosen

After a rapid introduction that presents the main reasons for the renewal of interest for photorefractive holographic memories, we first discuss their potentialities and limitations. We then continue by a presentation and analysis of novel techniques that permit considerable facilitation of the memory operation and improve its capabilities. In conclusion, we indicate envisioned applications for photorefractive holographic memories.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Oct 30, 1992•0 citations

Status of 3D memory storage materials

Gajendra D. Savant, Tomasz P. Jannson, Winston Ho

The speed of modern supercomputers is primarily limited by the relatively slow speed of memory. Research over the past years has focused on developing optical memory systems that, by nature of optics, promise to achieve high speed and high memory capacity. Three- dimensional optical memory systems are well known for their storage capacity and achievable short access time. But the early attempts to exploit 3-dimensional media were limited to photorefractive crystals such as lithium niobate, due to the unavailability of any other suitable medium (alternative media are precluded by their diffraction limited storage densities and non- erasable characteristics). Although volume phase holograms can be recorded in photorefractive crystals, these materials have many obvious flaws such as strong scattering, phase distortion, self diffraction, fast decay, and low refractive index modulation. There have also been continuous efforts to develop new 3-D media (such as photon echo, photorefractive polymers, bacteriorhodusphin, memory access cache, etc., but none can be applied in real world 3-D device because these materials are still in the early stage of development.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Apr 27, 1993•0 citations

Nonlinear vectorial two-beam coupling and forward four-wave mixing in photorefractive materials

Baruch Fischer, Jeffrey Owen White, Mark Cronin‐Golomb +1 more

We present an exact solution of a nonlinear vector analysis of two-beam coupling and forward four-wave mixing in photorefractive media.In this Letter we present an exact solution with linear absorption for a system of nonlinear differential equations that model two separate photorefractive processes.The first is the coupling of two beams with general

Optics Letters•Apr 1, 1986•25 citations

Noise reduction strategy in high-speed replication of holographic memories using photorefractive amplification

Nobuhiro Takahashi, Atsushi Okamoto, Takayuki Sano +1 more

We propose a high-speed replication system using photorefractive amplification for holographic memories. Also, we show a noise reduction strategy that enables to ensure a high signal-to-noise ratio of replicated holograms by using a transient gain of photorefractive amplification.

Conference on Lasers and Electro-Optics Pacific Rim (CLEO-PR)•Aug 1, 2007•0 citations

Optical Memories and Processing in Time- and Frequency Domain

Baozhu Luo

Spectral hole burning and photon echoes are the techniques for frequency-selective optical memories, which have the potential to increase areal data storage density by a factor 10**7. They also have the capability to perform in-memory data processing. In this thesis, several materials and techniques for optical memories in the frequency- and time domain have been investigated. In the frequency domain, ways to increase the storage density and the working temperature were studied using photon-gated spectral hole burning materials of the metal-tetrabenzoporphyrin derivatives. A selection rule for the electron acceptors in the donor-acceptor electron transfer systems was deduced. By doping the material with two different donors a maximum inhomogeneous line width of more than 30 THz was achieved. A polarization holographic technique was established for the formation and detection of spectral holes. Our results indicate that this technique can provide a better signal-to-noise ratio than that achieved by a conventional holographic technique, in particular for samples of poor optical quality. In the time domain, magnetic field-induced and the intensity-induced dephasing processes were studied in Pr3+ doped in a YAlO3 crystal and a Y2SiO5 crystal, respectively. As a step along the route to make photon echo based optical processing possible, the amplification of photon echo signals by the use of a fiber amplifier (Pr3+-doped ZBLAN) was demonstrated. A gain of 45 was achieved. The erasure of stored data using photon echoes has also been investigated. A technique to diagnose the phase and frequency stability of a light source by the photon echo erasure process was proposed and illustrated. An approach to bit-selective data erasure, that is free from laser phase and frequency fluctuations, is also suggested. A concept for an arbitrary shape pulse generator based on photon echoes and hole-burning was experimentally and theoretically studied. Finally, a comparison between the properties and capabilities of spectral hole burning and photon echoes was made.

Lund reports on atomic physics•Jan 1, 1998•0 citations
A theoretical analysis for the optimization of the selective-erasure process in holographic photorefractive memories is presented. It is based on the solution of the standard material equations under a linear approximation (low modulation depths). Specific expressions for the optimum phase shifts and erasure rates are obtained. The approach includes all transport processes and so applies to photovoltaic materials such as LiNbO3. The different behavior with regard to nonphotovoltaic materials is discussed. Some additional strategies to improve the overall erasure process are proposed.
The speed of modern supercomputers is primarily limited by the relatively slow speed of memory. Research over the past years has focused on developing optical memory systems that, by nature of optics, promise to achieve high speed and high memory capacity. Three- dimensional optical memory systems are well known for their storage capacity and achievable short access time. But the early attempts to exploit 3-dimensional media were limited to photorefractive crystals such as lithium niobate, due to the unavailability of any other suitable medium (alternative media are precluded by their diffraction limited storage densities and non- erasable characteristics). Although volume phase holograms can be recorded in photorefractive crystals, these materials have many obvious flaws such as strong scattering, phase distortion, self diffraction, fast decay, and low refractive index modulation. There have also been continuous efforts to develop new 3-D media (such as photon echo, photorefractive polymers, bacteriorhodusphin, memory access cache, etc., but none can be applied in real world 3-D device because these materials are still in the early stage of development.
Spectral hole burning and photon echoes are the techniques for frequency-selective optical memories, which have the potential to increase areal data storage density by a factor 10**7. They also have the capability to perform in-memory data processing. In this thesis, several materials and techniques for optical memories in the frequency- and time domain have been investigated. In the frequency domain, ways to increase the storage density and the working temperature were studied using photon-gated spectral hole burning materials of the metal-tetrabenzoporphyrin derivatives. A selection rule for the electron acceptors in the donor-acceptor electron transfer systems was deduced. By doping the material with two different donors a maximum inhomogeneous line width of more than 30 THz was achieved. A polarization holographic technique was established for the formation and detection of spectral holes. Our results indicate that this technique can provide a better signal-to-noise ratio than that achieved by a conventional holographic technique, in particular for samples of poor optical quality. In the time domain, magnetic field-induced and the intensity-induced dephasing processes were studied in Pr3+ doped in a YAlO3 crystal and a Y2SiO5 crystal, respectively. As a step along the route to make photon echo based optical processing possible, the amplification of photon echo signals by the use of a fiber amplifier (Pr3+-doped ZBLAN) was demonstrated. A gain of 45 was achieved. The erasure of stored data using photon echoes has also been investigated. A technique to diagnose the phase and frequency stability of a light source by the photon echo erasure process was proposed and illustrated. An approach to bit-selective data erasure, that is free from laser phase and frequency fluctuations, is also suggested. A concept for an arbitrary shape pulse generator based on photon echoes and hole-burning was experimentally and theoretically studied. Finally, a comparison between the properties and capabilities of spectral hole burning and photon echoes was made.