Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE

Experimental demonstration of all-optical flip flop memory based on wave mixing in a semiconductor optical amplifier

Kimberly Kaltenecker, Yevhen Rutovytskyy, Fahad A. Althowibi, Eric Donkor

Published May 31, 2013• 0 citations
Publisher

Abstract

We present an experimental demonstration of an all optical memory consisting of a single semiconductor optical amplifier as the active medium based on wave mixing. The circuit is a fiber ring consisting of a semiconductor amplifier, a bi-directional 2x2 fiber coupler, an isolator, a polarization controller, and a Faraday mirror. The output is observed on the spectrum analyzer, which consists of the peak wavelength of the SOA plus an additional signal generated through wave mixing, which is tunable within the band gap of the SOA. We shall demonstrate two modes of operation of the device, which will consist of a flip flop switch between three states, as well as a single data storage memory. The stable states consist of two modes, where the mode amplitude represents the state. Mode 1 corresponds to 1500 nanometers and mode 2 corresponds to 1530 nanometers. A contrast ratio between an “on” and “off” state is measured for each mode and the mode of operation is based on the polarization. We shall present the states for the circuit, the effect of drive current on the system, the effect of the SOA structure, wave mixing effects, and how to operate the device for both logic operation and data storage.

DOI
10.1117/12.2018071

Related papers

SOA Fiber Ring Laser-Based Three-State Optical Memory

Jing Wang, Yuancheng Zhang, Antonio Malacarne +3 more

By exploiting three coupled semiconductor optical amplifier (SOA) fiber ring lasers, a compact, integratable, and polarization-independent three-state all-optical memory is demonstrated, with 40-dB extinction ratio for each state. Dynamic flip-flop operation between states is also demonstrated with switching pulse energy of 13.6 nJ. Due to the broad bandwidth of SOA gain spectrum, the wavelength range of set pulses is large. Finally, the transition behavior of state switching is investigated.

IEEE Photonics Technology Letters•Aug 28, 2008•10 citations

All-optical flip-flop memory for quantum computing

Eric Donkor

We present an experimental demonstration of an all-optical flip-flop based on mode competition in a polarization-coupled two-energy system. The two energy systems are comprised of a semiconductor optical amplifier and a supercontinuum generator. Adjusting the polarization state of the coupling between the two energy systems allows for a stable cycling between the four states of a flip-flop namely: (off, off); (off, on); (on, off); (on, on). So that, in this case, representing qubit by orthogonal polarization states enables qubit storage and logic operations.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•May 13, 2011•2 citations

All-optical flip-flop operation of VCSOA

Aaron M. Kaplan, Govind Prasad Agrawal, Drew N. Maywar

An all-optical flip-flop, the memory of which is based on dispersive bistability in a single vertical cavity semiconductor optical amplifier, is demonstrated experimentally. Flip-flop control is achieved using two mechanisms: cross-phase modulation to set the flip-flop and cross-gain modulation of the holding beam within a remote SOA to reset it. Optical control signals are sub-milliwatt in power and derived from a single 5 ns, 1539 nm initial pulse. Flip-flop operation at 1542 nm is polarisation insensitive to control signals and achieved with an on-off contrast greater than 3 dB.

Electronics Letters•Jan 13, 2009•25 citations

Single-SOA optical memory based on coupled fiber ring lasers

Jing Wang, Yuancheng Zhang, Minyu Yao +2 more

A compact optical memory with single SOA is demonstrated by exploiting two coupled fiber ring lasers. Without necessity of feedback, the memory shows bi-stability over a large wavelength range. Dynamic flip-flop operation is also investigated.

International Conference on Photonics in Switching•Aug 1, 2008•4 citations

Broad-Band All-Optical Flip–Flop Based on Optical Bistability in an Integrated SOA/DFB-SOA

Young‐Il Kim, J.H. Kim, S. Lee +3 more

We have demonstrated a broad-band all-optical flip-flop for wavelength-division-multiplexing system based on optical bistability in a semiconductor optical amplifier (SOA)/distributed feedback (DFB)-SOA with wide gain bandwidth for both SOA and DFB-SOA regions. Input signal with two different wavelength selections of 1530.45 and 1578.12 nm and the repetition ration of about 6 ns is injected into the SOA/DFB-SOA.

IEEE Photonics Technology Letters•Feb 1, 2004•38 citations

The Impact of Polarization on the Performance of All-Optical Flip-Flops

Claudio E. Ippolito

This thesis experimentally characterizes the polarization dependence of an all-optical flip-flop (AOFF) based on a resonant-type semiconductor optical amplifier. Previous demonstrations of such an optical-memory device have exhibited poor on-off contrasts of around 3 dB (2:1). Our work maps out the dependence of the bistable hysteresis on the injected polarization state for the first time and clearly shows how to optimize the on-off contrast to achieve 8 dB. Beyond this optimization technique, it also demonstrate a novel technique to achieve and on-off contrast exceeding 30 dB (1000:1).

•Jan 1, 2012•0 citations
We present an experimental demonstration of an all optical memory consisting of a single semiconductor optical amplifier as the active medium based on wave mixing. The circuit is a fiber ring consisting of a semiconductor amplifier, a bi-directional 2x2 fiber coupler, an isolator, a polarization controller, and a Faraday mirror. The output is observed on the spectrum analyzer, which consists of the peak wavelength of the SOA plus an additional signal generated through wave mixing, which is tunable within the band gap of the SOA. We shall demonstrate two modes of operation of the device, which will consist of a flip flop switch between three states, as well as a single data storage memory. The stable states consist of two modes, where the mode amplitude represents the state. Mode 1 corresponds to 1500 nanometers and mode 2 corresponds to 1530 nanometers. A contrast ratio between an “on” and “off” state is measured for each mode and the mode of operation is based on the polarization. We shall present the states for the circuit, the effect of drive current on the system, the effect of the SOA structure, wave mixing effects, and how to operate the device for both logic operation and data storage.
We present an experimental demonstration of an all-optical flip-flop based on mode competition in a polarization-coupled two-energy system. The two energy systems are comprised of a semiconductor optical amplifier and a supercontinuum generator. Adjusting the polarization state of the coupling between the two energy systems allows for a stable cycling between the four states of a flip-flop namely: (off, off); (off, on); (on, off); (on, on). So that, in this case, representing qubit by orthogonal polarization states enables qubit storage and logic operations.
An all-optical flip-flop, the memory of which is based on dispersive bistability in a single vertical cavity semiconductor optical amplifier, is demonstrated experimentally. Flip-flop control is achieved using two mechanisms: cross-phase modulation to set the flip-flop and cross-gain modulation of the holding beam within a remote SOA to reset it. Optical control signals are sub-milliwatt in power and derived from a single 5 ns, 1539 nm initial pulse. Flip-flop operation at 1542 nm is polarisation insensitive to control signals and achieved with an on-off contrast greater than 3 dB.
This thesis experimentally characterizes the polarization dependence of an all-optical flip-flop (AOFF) based on a resonant-type semiconductor optical amplifier. Previous demonstrations of such an optical-memory device have exhibited poor on-off contrasts of around 3 dB (2:1). Our work maps out the dependence of the bistable hysteresis on the injected polarization state for the first time and clearly shows how to optimize the on-off contrast to achieve 8 dB. Beyond this optimization technique, it also demonstrate a novel technique to achieve and on-off contrast exceeding 30 dB (1000:1).