In this thesis I discuss work that has been carried out on the dynamics of a Bose Einstein condensate of Rb 87 produced near an atom chip. A Bose Einstein Condensate (BEC) is a quantum state of matter where a single quantum state becomes occupied by a macroscopic number of identical Bosons. In our case this is achieved by cooling a system of trapped identical rubidium 87 atoms to its ground state. To reach temperatures of condensation we initially laser cool atoms from room temperature, before loading them into a magnetic trap. The magnetic trap is produced through a combination of uniform magnetic fields from coils outside our vacuum chamber and currents running through wires on an atom chip. The atom chip is a microfabricated device, produced by a coating a silicon chip with a thin layer of gold and etching wires into it. Together, these fields create a magnetic field minimum 120μm from the surface of the chip which can be used to confine low field seeking hyperfine states of the atom in an elongated harmonic trap. Once the atoms are confined in the magnetic trap we used force evaporative cooling out to reach the phase space densities required for Bose Einstein condensation. The BEC is used to investigate the relative dynamics between the fraction of the atoms in the condensate to those not in the condensate. Our atom chip provided a suitable environment to investigate this due to fragmentation of the magnetic potential close to the chip. Small imperfections in the wires on our atom chip mean that the trapping potential isn’t smooth. Small regions of higher trapping frequency - or fragments - are formed. Due to the small size of these fragments it is possible to find a position where a condensate can form in the fragment, and see a potential of high frequency, whereas a non-condensed atom will see a lower frequency potential. We exploit this to set the condensed fraction moving relative to the non condensed part and investigate the subsequent damping of their motion relative to each other.
A
87Rb Bose-Einstein condensate (BEC) is produced in a portable atom-chip system less than $30\ifmmode\times\else\texttimes\fi{}30\ifmmode\times\else\texttimes\fi{}15\phantom{\rule{0.3em}{0ex}}\mathrm{cm}$, where the ultrahigh vacuum is maintained by a small,
8L∕s, ion pump and nonevaporable getter. An aluminum nitride chip with lithographically patterned copper is used to seal the vacuum system, provide the electrical feedthroughs, and create the magnetic trap potentials. All cooling and trapping processes occur
0.6−−2.5mm from ambient laboratory air. A condensate of about 2000
87Rb atoms in
F=2,mF=2 is achieved after
4.21s of rf forced evaporation. A magneto-optical trap lifetime of
30s indicates the vacuum near the chip surface is about ${10}^{\ensuremath{-}10}\phantom{\rule{0.3em}{0ex}}\text{torr}$. This work suggests that a chip-based BEC-compatible vacuum system can occupy a volume of less than
0.5L.
Atom chips are an excellent tool for studying ultracold degenerate quantum gases, due to the high degree of controllability afforded by the precise potentials generated from the current-carrying microfabricated wires on the chip surface. The geometries of the trapping potentials are inherently capable of realising extreme aspect ratios, and therefore creating model systems with effectively reduced dimensionality, particularly the theoretically-tractable one-dimensional Bose gas. In addition, the temporal tunability makes it possible to impart non-adiabatic changes on the trapping potentials, allowing experimental investigation of samples which have been brought out of equilibrium - a situation which is not fully theoretically understood. This thesis describes the implementation, development and characterisation of an experimental system for producing the first Bose-Einstein condensates of atomic rubidium 87 gas trapped on the surface of an atom chip in Nottingham. Such an apparatus is very complex and requires careful characterisation in order to run in a stable and reliable way. Details of the experimental setup are thoroughly outlined, including the vacuum system, lasers, electronics, computer control and timing, and the optical imaging system. A newly installed compact two-dimensional magneto-optical trap provides an loading rate of 5e7 atoms per second for loading a three-dimensional mirror-magneto-optical trap with 1.5e8 atoms, at a temperature of 300uK within 10s. The cloud is then sub-Doppler cooled to 50uK, and spin-polarised with 96% purity into the |F=2,mF=+2> ground state within 5ms, in preparation for loading a purely magnetic trap. A millimeter sized copper Z-shaped conductor located beneath the atom chip surface creates a Ioffe-Pritchard magnetic trap, into which the laser cooled cloud is loaded with 70% efficiency, and can be held with a vacuum-limited lifetime of 40s. Evaporative cooling then pre-cools the sample to below 20uK within 10s, to allow the subsequent loading into potentials created by the atom chip with 100% efficiency. A final evaporation stage then cools the cloud below the phase transition temperature of 800nK, resulting finally in pure BECs with
105 atoms confined using the atom chip. Key measurements of various properties of the trapped condensates are presented, which are important in order to characterise the system fully, and to compare with theoretical expectations. In particular, included are the variation of condensate fraction with temperature, the BEC expansion dynamics, and the condensate lifetime in the trap, for example. Finally, it is demonstrated how BECs can be produced on the atom chip without the use of external macroscopic coils, achieved by using novel, integrated sheet structures located beneath the chip surface - unique to this experimental system - to create the necessary bias fields.
This thesis describes production of and experiments with a Bose-Einstein condensate of approximately 2 × 10[superscript 4] [superscript 87]Rb atoms, trapped at the surface of an atom chip. In the first half of this thesis I describe the process of trapping and cooling the atomic vapour close to the surface of an atom chip. This process, which cools the vapour by over 9 orders of magnitude, involves a highly complex sequence of events which I implemented and optimised over the first two years of my PhD. In the early stages of this process, the atomic vapour is laser cooled and magneto-optically trapped. The vapour is then transferred to a highly elongated magnetic trap produced by high field gradients a few hundred microns from the surface of the atom chip. Here the vapour is evaporatively cooled to below the transition temperature where a Bose-Einstein condensate emerges. A simple existing analytic model of evaporative cooling is extended in this work to account for the shape of our highly elongated trap. Predictions of this model are presented here along with experimental observations with which it has good agreement. The second part of my thesis investigates some of the characteristics of the condensate, and dynamics of its low energy collective oscillations in the trap, based on experimental measurements taken in the final 18 months of my PhD. In particular, measurements taken of the centre of mass oscillations of the condensate along the long axis of the trap are presented. In the zero temperature limit the condensate is expected to behave as a perfect superfluid, and these low energy oscillations should go undamped. However, at finite temperature where not all atoms in the gas are condensed, damping is observed. In our experiment significant damping is found with an 1/e decay rate which varies between 2s[superscript -1] and 8s[superscript -1], depending on the fraction of non-condensed atoms in the gas. A finite temperature formalism is then used to describe the likely damping mechanism - Landau damping. We use a simple model of this formalism which estimates the temperature dependence of the damping rate γ(T), but find this gives a significant overestimation of the rates we measure. However, we argue that a straightforward adaptation to this model reduces the predicted damping rate significantly, and suggests a functional form of γ(T) that is in much better agreement with our experimental measurements.
Since its first observation in 1995, Bose-Einstein condensation (BEC) experiments in dilute gases have been performed with only a few different kinds of magnetic traps. We have performed a BEC experiment with /sup 87/Rb atoms in a Ioffe-Pritchard magnetic potential, which opens up the possibility to study, e.g., Bose-Einstein condensates released in only one dimension. Our trap consists of a clip-like coil, which generates a pure two-dimensional (2D) quadrupole field for radial confinement. The axial confinement is provided by two plane pinch coils inside the clip-coil. These two coils create a bottle field. Two additional Helmholtz coils on the same symmetry axis are used to compensate the homogeneous part of the bottle field. By continuously varying the currents through the coils, the trapping potential can be changed from a 3D spherical harmonic to a 2D linear potential. The change can be done adiabatically or nonadiabatically by switching off the axial confinement slowly, or instantaneously respectively. This opens up the possibility to study 1D nonlinear atom optics. In combination with, e.g., far detuned light sheets, a Fabry-Perot type interferometer for a condensate might be realizable. Our experiments are performed in a vacuum system with two magneto-optical traps, which serves as the source of cold atoms for the magnetic trap. 10/sup 9/ atoms are captured in less than one minute. RF-induced evaporative cooling is used to increase the phase space density of the trapped atomic cloud. The BEC phase transition occurs at a temperature of 550 nK with 10/sup 6/ particles in the trap. Pure condensates with more than 10/sup 5/ atoms were produced.