An optical Kerr gate is operated at high repetition rates using picosecond pulses from a mode−locked cw laser. A new mode of gate operation is demonstrated in which incremental transmission is linearly proportional to pump power. Direct temporal measurement of a 2.1−psec response time of the optical Kerr effect in CS2 is reported.
We have performed experimental studies designed to elucidate the parameters which limit the efficiency and fidelity of optical phase conjugate reflection of picosecond laser pulses in transparent Kerr media. The experimental data show that at low pulse energies, the reflectivity follows the expected square dependence on the pulse energies. However, it falls below the square at high energies even though, at these high energies, a phase conjugation efficiency of 300% was observed. We observed a rather strong dependence of the reflectivity on the ratio of pump to probe pulse energy. The quality of phase conjugation decreased at very high pump energies, but could under some conditions be improved by focusing the probe beam into the interaction region. Of the several mechanisms responsible for the decrease in efficiency and fidelity, we find that the predominant ones are pump depletion, small scale self-focusing, and dephasing owing to a difference in energy of the two pump pulses.
The ultrafast detection of single photons is currently restricted by the limited time resolution (a few picoseconds) of the available single-photon detectors. Optical gates offer a faster time resolution, but so far they have been applied mostly to ensembles of emitters. Here, we demonstrate through a semi-analytical model that the ultrafast time-resolved detection of single quantum emitters can be possible using an optical Kerr shutter at gigahertz rates under focused illumination. This technique provides sub-picosecond time resolution, while keeping a gate efficiency at around 85%. These findings lay the ground for future experimental investigations on the ultrafast dynamics of single quantum emitters, with implications for quantum nanophotonics and molecular physics.
We proposed an improved femtosecond optical Kerr gate with double gate pulses (DOKG) using a femtosecond laser, in which an ultrashort switching time can be realized even when a relatively slow response optical Kerr medium of carbon disulfide was used. The results showed that when the time delay and the light intensity ratio of the two pump pulses were adjusted to be about 140 fs and 1:0.9, the switching time and the maximum transmission efficiency of the DOKG could be optimized to be about 130 fs and 37%. The DOKG is convenient to be built and offers a good choice for applications based on ultrafast optical switch.
We show that both the power and repetition rate of a frequency comb generated in a nonlinear ring resonator, pumped with continuous-wave (cw) coherent light, are modulated. The modulation is brought about by the interaction of the cw background with optical pulses excited in the resonator, and occurs in resonators with nonzero high-order chromatic dispersion and wavelength-dependent quality factor. The modulation frequency corresponds to the detuning of the pump frequency from the eigenfrequency of the pumped mode in the resonator.
We offer a perspective on recent advances in picosecond-timescale all-optical switching with applications in quantum optics. The switch is based on polarization rotation in standard single-mode fiber via the optical Kerr effect. By using ultrafast laser pulses and short (∼10 cm) fibers, this technique can achieve a switching duration of ≲1 ps, at the repetition rate of 80 MHz or above. This high repetition rate is well-suited to quantum optics where experiments operate in the photon-counting regime. The switch efficiency can be ≳99% with a noise floor of just ∼10−4 photons/pulse, enabling high fidelity operations on quantum states of light, with negligible generation of spurious noise photons. We highlight the capabilities of this technique in four early applications: switching of heralded single photons, time-bin to polarization conversion of photonic qubits, noise gating for quantum key distribution, and pulse carving.
Ultrafast quantum optics with time-frequency entangled photons is at the forefront of progress towards future quantum technologies. However, to unravel the time domain structure of entangled photons and exploit fully their rich dimensionality, a single-photon detector with sub-picosecond temporal resolution is required. Here, we present ultrafast single-photon detection using an optical Kerr gate composed of a photonic crystal fiber (PCF) placed inside a Sagnac interferometer. A near-rectangle temporal waveform of a heralded single-photon generated via spontaneous parametric down-conversion is measured with temporal resolution as high as 224 ± 9 fs. The large nonlinearity and long effective interaction length of the PCF enables maximum detection efficiency to be achieved with only 30.5 mW gating pulse average power, demonstrating an order-of-magnitude improvement compared to optical gating with sum-frequency generation. Also, we discuss the trade-off relationship between detection efficiency and temporal resolution.