Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IBM Journal of Research and Development

Investigations for a Josephson Computer Main Memory with Single-Flux-Quantum Cells

Pierre Guéret, A. Moser, P. Wolf

Published Mar 1, 1980• 27 citations
Publisher

Abstract

The paper first summarizes requirements for a main memory with Josephson junctions and reviews the work carried out on an experimental main memory model containing an array of single-flux-quantum cells, line drivers, and address decoders with a total of nearly 4500 Josephson junctions. In the second part, theoretical and experimental investigations on the y drive system, including sense circuit, are presented. The investigations deal with both the read and write phases. Finally, the on-chip logic circuits and the address decoders are discussed, and the experimental results presented. Drivers and decoders based on the principle of current steering in superconducting loops are intended to be used on a fully populated main-memory chip.

DOI
10.1147/rd.242.0155

Related papers

Model for a 15 ns 16K RAM with Josephson junctions

Ronald F. Broom, Pierre Guéret, W. Kotyczka +4 more

An experimental memory model for investigating the feasibility of a 16K RAM memory with Josephson junctions was fabricated and tested. There are nearly 4500 Josephson junctions in the design which includes array, line drivers, and address decoders. Storage element is a single flux-quantum (SFQ) cell arranged in a 2K array. Drivers and decoders are based on the principle of current steering in superconducting loops, which is a medium speed but low power approach. The measured read-access time of the model is approximately 10 ns. Power dissipation of the unselected chip is zero, whereas for a read/write cycle time of 30 ns, it amounts to about 10 /spl mu/W. Results indicate that a 16K chip is feasible electrically. The estimated access time and power dissipation are 15 ns and 40 /spl nu/W, respectively.

IEEE Journal of Solid-State Circuits•Aug 1, 1979•47 citations

AC-and DC-powered subnanosecond 1-kbit Josephson cache memory design

Y. Wada, Mutsuo Hidaka, Shuichi Nagasawa +1 more

The address decoders, address line drivers, and sense circuits of the fully decoded memory consist of resistor-coupled Josephson logic circuits to realize fast access. The memory cell is constructed from two three-junction symmetric SQUID (superconducting quantum interface device) gates, and a four-flux-quanta storage loop for enabling bipolar current drive. This memory configuration has intrinsic advantages in regard to magnetic flux trapping in address lines and a gate circuit latch-up problem over a DC-powered memory constructed from inductor coupled gates. Individual control and cell circuits were fabricated, using a lead-alloy process, and their operation was verified. A 570-ps read access time is estimated as the sum measured 280-ps decoding time, and calculated 130-ps address line current rising time, 110-ps sense time, and 50-ps signal propagation time. The 1-kb chip is designed to consume 9 mW without voltage regulators.>

IEEE Journal of Solid-State Circuits•Aug 1, 1988•7 citations

Access Time and Power Dissipation of a Model 256-Bit Single Flux Quantum RAM

Thomas Ortlepp, T. Van Duzer

Superconductor electronics offers logic circuits for high-speed data processing and high-performance computing. The main barrier to practical application is the lack of high-speed and low-power memory. It is widely believed that the most reliable and functional bit cell for superconducting memory is the vortex transitional bit cell, which was successfully used by Nagasawa in a 4-kb memory. This paper reviews existing challenges in this type of Josephson memory devices and discusses engineering issues in implementing a model single flux quantum random access memory. We evaluate the contributions that various components of the memory system make to delay and power dissipation. The 256-bit memory provides an experimentally confirmed read access time of 190 ps. As a result, we found that delay and power dissipation are found largely in the address decoder, line drivers, bit-selection scheme, and the data readout circuitry. With these circuits being similar for various magnetic memory devices, our findings provide essential data for a comprehensive assessment of new concepts for bit cells, readout, and write in superconducting memories.

IEEE Transactions on Applied Superconductivity•Apr 22, 2014•23 citations

Experimental demonstration of a Josephson cryogenic memory cell based on coupled Josephson junction arrays

Niketh Nair, Amir Jafari-Salim, Anthony J. D’Addario +2 more

Abstract In this paper, experimental verification for a cryogenic memory cell consisting of three inductively coupled Josephson junctions is presented. Design and operational logic of this type of cell was recently introduced. The basic memory cell operations (read, write, reset) can be implemented on the same simple circuit and this type of memory cell is fundamentally different from the existing single flux quantum-based memory cells. Here, we present design principles and experimental validation for write operations and readout operation for four versions of the design, each with different parameters. Our experimental results show excellent resemblance with the previously presented memory cell operational logic and also show an excellent fit with simulations of the entire memory cell circuit that includes the memory cell and all the peripheral circuitry.

Superconductor Science and Technology•Sep 4, 2019•15 citations

Memories with Josephson Junctions

Peter Wolf

The talk is based on an overview which was published recently (1). For this reason, only an abstract is given here, which includes Later results not contained in the aforementioned overview. The presently-known Josephson memory cells store information as persistent currents in superconducting loops, or what is equivalent as a magnetic flux in the area of the ring. This method of storage is nonvolatile and has no power consumption in the storing state. In a superconducting ring system, the magnetic flux is quantized, and cells have been built which operate either with only one flux quantum, or with many of them. For the Latter cells with many flux quanta (ring cells), quite a number of designs exist. They have one or two Josephson junctions in the ring, which allow writing. An external junction which is controlled by the ring current serves for non-destructive reading of the information. The smallest cell realized had an area of 900 ?m2 with a 2 ?m minimum line width. Switching speed was ? 80 ps. Cells which store information as a single-flux quantum (single flux-quantum cells = SFQ cells) in the ring, usually contain two Josephson junctions used for reading and writing. Read-out in most of these cells is destructive, but methods of reading non-destructively have also been proposed. The smallest device made had an area of ? 150 ?m2 with a minimum line width of 2 ?m. The read signal had a rise time ? 100 ps.

European Solid-State Circuits Conference (ESSCIRC)•Sep 1, 1978•0 citations

Operation of Strings of Single Flux-Quantum Memory Cells using Josephson Junctions

Pierre Guéret, Th. O. Mohr, A. Moser +1 more

Experimental and theoretical investigations have been carried out on strings with 98 series-connected memory cells with Josephson junctions. The cells store binary information in single flux quanta. These strings can be considered as basic building blocks of a memory array. Our results indicate that such arrays are feasible electrically.

European Solid-State Circuits Conference (ESSCIRC)•Jan 1, 1977•2 citations
The paper first summarizes requirements for a main memory with Josephson junctions and reviews the work carried out on an experimental main memory model containing an array of single-flux-quantum cells, line drivers, and address decoders with a total of nearly 4500 Josephson junctions. In the second part, theoretical and experimental investigations on the y drive system, including sense circuit, are presented. The investigations deal with both the read and write phases. Finally, the on-chip logic circuits and the address decoders are discussed, and the experimental results presented. Drivers and decoders based on the principle of current steering in superconducting loops are intended to be used on a fully populated main-memory chip.
An experimental memory model for investigating the feasibility of a 16K RAM memory with Josephson junctions was fabricated and tested. There are nearly 4500 Josephson junctions in the design which includes array, line drivers, and address decoders. Storage element is a single flux-quantum (SFQ) cell arranged in a 2K array. Drivers and decoders are based on the principle of current steering in superconducting loops, which is a medium speed but low power approach. The measured read-access time of the model is approximately 10 ns. Power dissipation of the unselected chip is zero, whereas for a read/write cycle time of 30 ns, it amounts to about 10 /spl mu/W. Results indicate that a 16K chip is feasible electrically. The estimated access time and power dissipation are 15 ns and 40 /spl nu/W, respectively.
The address decoders, address line drivers, and sense circuits of the fully decoded memory consist of resistor-coupled Josephson logic circuits to realize fast access. The memory cell is constructed from two three-junction symmetric SQUID (superconducting quantum interface device) gates, and a four-flux-quanta storage loop for enabling bipolar current drive. This memory configuration has intrinsic advantages in regard to magnetic flux trapping in address lines and a gate circuit latch-up problem over a DC-powered memory constructed from inductor coupled gates. Individual control and cell circuits were fabricated, using a lead-alloy process, and their operation was verified. A 570-ps read access time is estimated as the sum measured 280-ps decoding time, and calculated 130-ps address line current rising time, 110-ps sense time, and 50-ps signal propagation time. The 1-kb chip is designed to consume 9 mW without voltage regulators.>
Superconductor electronics offers logic circuits for high-speed data processing and high-performance computing. The main barrier to practical application is the lack of high-speed and low-power memory. It is widely believed that the most reliable and functional bit cell for superconducting memory is the vortex transitional bit cell, which was successfully used by Nagasawa in a 4-kb memory. This paper reviews existing challenges in this type of Josephson memory devices and discusses engineering issues in implementing a model single flux quantum random access memory. We evaluate the contributions that various components of the memory system make to delay and power dissipation. The 256-bit memory provides an experimentally confirmed read access time of 190 ps. As a result, we found that delay and power dissipation are found largely in the address decoder, line drivers, bit-selection scheme, and the data readout circuitry. With these circuits being similar for various magnetic memory devices, our findings provide essential data for a comprehensive assessment of new concepts for bit cells, readout, and write in superconducting memories.
Abstract In this paper, experimental verification for a cryogenic memory cell consisting of three inductively coupled Josephson junctions is presented. Design and operational logic of this type of cell was recently introduced. The basic memory cell operations (read, write, reset) can be implemented on the same simple circuit and this type of memory cell is fundamentally different from the existing single flux quantum-based memory cells. Here, we present design principles and experimental validation for write operations and readout operation for four versions of the design, each with different parameters. Our experimental results show excellent resemblance with the previously presented memory cell operational logic and also show an excellent fit with simulations of the entire memory cell circuit that includes the memory cell and all the peripheral circuitry.
The talk is based on an overview which was published recently (1). For this reason, only an abstract is given here, which includes Later results not contained in the aforementioned overview. The presently-known Josephson memory cells store information as persistent currents in superconducting loops, or what is equivalent as a magnetic flux in the area of the ring. This method of storage is nonvolatile and has no power consumption in the storing state. In a superconducting ring system, the magnetic flux is quantized, and cells have been built which operate either with only one flux quantum, or with many of them. For the Latter cells with many flux quanta (ring cells), quite a number of designs exist. They have one or two Josephson junctions in the ring, which allow writing. An external junction which is controlled by the ring current serves for non-destructive reading of the information. The smallest cell realized had an area of 900 ?m2 with a 2 ?m minimum line width. Switching speed was ? 80 ps. Cells which store information as a single-flux quantum (single flux-quantum cells = SFQ cells) in the ring, usually contain two Josephson junctions used for reading and writing. Read-out in most of these cells is destructive, but methods of reading non-destructively have also been proposed. The smallest device made had an area of ? 150 ?m2 with a minimum line width of 2 ?m. The read signal had a rise time ? 100 ps.