Persistent spectral hole-burning in the R-lines of tetravalent manganese in X-irradiated submicron corundum powder is reported for the first time. Two samples were investigated, namely, nominally 0.4 atom % Mn 3+ -doped and 0.4 atom % Mn 4+, Mg 2+ -codoped α-Al 2 O 3 . The samples were produced by a simple combustion reaction method at 600 °C. Spectral hole-burning properties of Mn 4+ ions burned via the R 1 and R 2 lines were measured either by the photoluminescence excitation mode via monitoring the luminescence signal of a vibrational sideband at ∼694 nm or in luminescence, with blue light excitation after the burn period. The hole widths were studied as a function of burn fluence and temperature in the range from 2 to 90 K. We propose a photochemical hole-burning mechanism for both samples based on photoionization and photoreduction of the tetravalent manganese ion. Interestingly, the 0.4 atom % Mn 4+, Mg 2+ sample displayed a higher hole-burning efficiency than the Mn 3+ sample. The hole widths obtained for the persistent spectral holes in the present powder samples were approximately 300 times broader at 2.2 ± 0.1 GHz compared to the ∼6 MHz width observed in transient hole-burning in a macroscopic crystal [ Riesen, H. Chem. Phys. Lett. 2011, 515 (44), 241−244]. We assign this effect to the disruption of the crystal lattice upon the valence state change of the Mn 4+ ion in the hole-burning process. From the hole width, we obtained a decay time of 0.72 ns for the 2 A̅ → E̅ one-phonon relaxation process within the split 2 E excited state. The stability of the spectral holes burned via the R 1 and R 2 lines was investigated for both samples, and we observed a decay of about 20% within 2 h, indicating slow spontaneous hole-filling. A hole area recovery of ∼70 and ∼64% was observed after a temperature cycle from 2.5 to 70 and 90 K for the 0.4 atom % Mn 3+ and 0.4 atom % Mn 4+, Mg 2+ samples, respectively.
Time-resolved transient spectral hole-burning experiments in zero field and in low magnetic fields B( parallelc) are reported for the chromium(III) R(1)-line, 2A((2)E)<-- 2A((4)A(2)) of Chatham lab created emerald, Be(3)Al(2)Si(6)O(18)ratio Cr(III)(0.0017% per weight), in the temperature range of 3 to 12 K. In low magnetic fields and temperatures >5 K conversion of side-holes to anti-holes is observed with progressing time. Anti-holes are due to the population stored in ground state levels. The dynamics of the hole pattern can be well modelled by a set of coupled differential equations for the levels of the (4)A(2) and (2)E multiplets. The measurements allow the simultaneous determination of g-factors and spin-lattice relaxation rates in the excited state and the ground state. At 6 K the relaxation times between the split +/-1/2 2A((2)E) excited state levels and +/-3/2 2A((4)A(2)) levels of the ground state are about 0.16 ms and 9 ms, respectively. From the temperature dependence it follows that the spin-lattice relaxation rates are dominated by Orbach processes in the experimental temperature range.
Persistent and time-resolved transient holes were burnt into the
1D2${\ensuremath{\leftarrow}}^{3}$
H4 transition of
Pr3+ and the
5D0${\ensuremath{\leftarrow}}^{7}$
F0 transition of
Eu3+ in silicate glasses. The holewidths were studied as a function of burning-fluence density, wavelength, and temperature between 0.4 and 12 K. Transient holes arising from optical pumping of ground-state nuclear hyperfine levels were found for both ions at T3 K. Their lifetime decreases with increasing temperature. They are accompanied by symmetrically placed antiholes. For
Eu3+, two pairs of antiholes were found which are attributed to the two europium isotopes,
151Eu and
153Eu. For
Pr3+, an additional mechanism leading to persistent hole burning dominates above 3 K. The holewidth follows a ${\mathit{T}}^{(1.3\ifmmode\pm\else\textpm\fi{}0.1)}$ dependence for
Pr3+ and a ${\mathit{T}}^{(1.0\ifmmode\pm\else\textpm\fi{}0.1)}$ dependence for
Eu3+. The temperature dependence is the same as that of the contribution of the two-level systems to the specific heat measured on the same samples and in the same temperature range. The quadrupole splittings of the
7F0 ground state and the crystal-field splittings of the
7F1 and
7F2 levels of
Eu3+ as a function of excitation wavelength indicate that the strength of the noncubic component of the crystal field varies monotonically for excitation across the
5D0${\ensuremath{\leftarrow}}^{7}$
F0 absorption band, falling to zero at the long-wavelength edge. The hole width shows a similar variation with excitation frequency. No influence of the experimental time scale on the hole width was detected for either sample between ${10}^{\mathrm{\ensuremath{-}}2}$ and
102 s.
Wavelength-selective excited-state lifetime measurements and absorption, luminescence, and hole-burning spectra of a natural African emerald crystal are reported. The (2)E excited-state lifetime displays an extreme wavelength dependence, varying from 190 to 37 μs within 1.8 nm of the R(1)-line. Overall, the excited state is strongly quenched, in comparison to laboratory-created emerald (τ=1.3 ms), with an average quenching rate of ∼6 × 10(3) s(-1) at 2.5 K. This quenching is attributed to photoinduced electron transfer caused by a relatively high concentration of Fe(2+) ions. The forward electron-transfer rate, k(f), from the nearest possible Fe(2+) sites at around 5 Å is estimated to be ∼20 × 10(3) s(-1) at 2.5 K. The photoreductive quenching of the excited Cr(3+) ions by Fe(2+) is followed by rapid electron back-transfer in the ground state upon deactivation. The exchange interaction based quenching can be modeled by assuming a random quencher distribution within the possible Fe(2+) sites with the forward electron-transfer rate, k(f), given as a function of acceptor-donor separation R by exp[(R(f)-R)/a(f)]; R(f) and a(f) values of 13.5 and 2.7 Å are obtained at 2.5 K. The electron transfer/back-transfer reorganizes the local crystal lattice, occasionally leading to a minor variation of the short-range structure around the Cr(3+) ions. This provides a mechanism for spectral hole-burning for which a moderately high quantum efficiency of about ∼0.005% is observed. Spectral holes are subject to spontaneous hole-filling and spectral diffusion, and both effects can be quantified within the standard two-level systems for non-photochemical hole-burning. Importantly, the absorbance increases on both sides of broad spectral holes, and isosbestic points are observed, in accord with the expected distribution of the "photoproduct" in a non-photochemical hole-burning process.
We report transient spectral hole-burning experiments conducted in the R1(±1/2) line of 53-chromium(III) doped Al2O3 in zero field and low magnetic fields B∥c at 3 K. These facile experiments enable, in principle, the simultaneous determination of the hyperfine coupling parameters for both the 4A2 ground state and the Ē(E2) excited state, and in both directions to the crystal caxis. In order to determine these parameters we have applied a global fit by simulated spectra to the experimental data and good agreement between calculated and measured hole-burning patterns is achieved. The relevant resulting parameters for the Ē(E2) excited state are A∥=18±4 MHz and A⊥=40±4 MHz.