Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Optical Fiber Communication Conference

12-GHz-Bandwidth SBS Slow Light in Optical Fibers

Zhaoming Zhu, Andrew M. C. Dawes, Daniel J. Gauthier, Lin Zhang, Alan Eli Willner

Published Jan 1, 2006• 82 citations
Publisher

Abstract

We increased the bandwidth of SBS slow light in an optical fiber to 12.6 GHz. We delayed 75-ps pulses by up to 47 ps and studied the data pattern dependence of the broadband SBS slow-light system.
DOI
10.1109/ofc.2006.216037

Related papers

Broadband SBS Slow Light in an Optical Fiber

Zhaoming Zhu, Andrew M. C. Dawes, Daniel J. Gauthier +2 more

In this paper, we investigate slow light via stimulated Brillouin scattering (SBS) in a room temperature optical fiber that is pumped by a spectrally broadened laser. Broadening the spectrum of the pump field increases the linewidth Deltaomegapof the Stokes amplifying resonance, thereby increasing the slow-light bandwidth. One physical bandwidth limitation occurs when the linewidth becomes several times larger than the Brillouin frequency shift OmegaBso that the anti-Stokes absorbing resonance substantially cancels out the Stokes amplifying resonance and, hence, the slow-light effect. We find that partial overlap of the Stokes and anti-Stokes resonances can actually lead to an enhancement of the slow-light delay-bandwidth product when Deltaomegapsime1.3OmegaB. Using this general approach, we increase the Brillouin slow-light bandwidth to over 12 GHz from its nominal linewidth of ~30 MHz obtained for monochromatic pumping. We controllably delay 75-ps-long pulses by up to 47 ps and study the data-pattern dependence of the broadband SBS slow-light system

Journal of Lightwave Technology•Jan 1, 2007•200 citations

Nearly transparent SBS slow light in an optical fiber

Zhaoming Zhu, Daniel J. Gauthier

Slow-light delay via stimulated Brillouin scattering (SBS) in optical fibers is usually achieved with delay-dependent amplification that degrades system performance. To address this problem, we propose a SBS slow-light method that makes use of two widely separated anti-Stokes absorption resonances, and achieve nearly transparent slow light in an optical fiber. We demonstrate the method in a highly nonlinear optical fiber, and achieve a slow-light bandwidth of approximately 150 MHz and a relative of delay of approximately 0.3 for approximately 9-ns pulses with a signal attenuation of approximately 4.8 dB.

arXiv:physics/0607169•Optics Express•Jan 1, 2006•41 citations

Optimizing Broadband SBS Slow Light in an Optical Fiber

Daniel J. Gauthier, Zhaoming Zhu, Andrew M. C. Dawes +2 more

We describe how to optimize slow-light via stimulated Brillouin scattering in a room temperature optical fiber that is pumped with a spectrally broadened laser. Our recent experimental results on broadband SBS slow-light will be discussed.

Frontiers in Optics•Jan 1, 2006•1 citation

Data bit distortion induced by slow light in optical communication systems

Alan Eli Willner, Lin Zhang, Ting Luo +3 more

Slow-light components will degrade the data bits in an optical communication system due to narrow-band amplitude and phase responses. A bit-pattern dependence is produced in the output data stream. These effects are observed in simulation as well as in an experiment based on slow light induced by stimulated Brillouin scattering (SBS) in an optical fiber. We define figure of merit involving pulse delay and data degradation to optimize slow-light components. It is demonstrated experimentally and numerically that the pattern dependence can be reduced by detuning the slow-light devices.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Feb 9, 2006•5 citations

Phase Locking of SBS Slow Light in a 2.2-km Single-Mode Fiber

Joseph E. Vornehm, Aaron Schweinsberg, Zhimin Shi +1 more

A stimulated Brillouin scattering (SBS) slow light system in a 2.2-km single-mode fiber is phase locked to a reference signal. Optical pulses of 6.5 ns duration are delayed 0.9 pulse width while maintaining lock.

Advanced Photonics•Jan 1, 2011•1 citation

Broadening-free stimulated Brillouin scattering-based slow and fast light in optical fibers

Thomas Schneider, Andrzej Wiatrek

The manipulation of the group velocity of optical signals (slow and fast light) has many possible applications in telecommunications, sensing, nonlinear optics, and so on. The exploitation of the effect of stimulated Brillouin scattering (SBS) is of special interest for the alteration of the group velocity in optical fibers, since it just requires standard telecom equipment and low-to-moderate optical power. However, each delay in one single, low-gain SBS-based slow-light system is accompanied by a pulse broadening. This is a result of the inherent Kramers–Kronig relations among the gain, the phase change, and the accompanied group velocity. For an ideal flat gain, the phase change is nonideal, and for an ideal phase change the gain curve leads to a broadening. Furthermore, if the gain bandwidth is adapted to the signal by broadening, the delay will be reduced. Thus the signal broadening can be reduced by several methods for one single low-gain slow-light system, but it cannot be zero. Here, we will show how a zero-broadening SBS-based slow light can be achieved with several methods. The basic idea is a reshaping of the original pulse in a second stage by saturation of the SBS system, or by the superposition of two gains. As will be shown, all of these systems show an almost ideal overall gain and phase function over the bandwidth of the pulses. Thus, SBS-based slow light with a delay bandwidth product of 1 bit and zero distortion is possible.

Optical Engineering•Aug 25, 2014•0 citations
In this paper, we investigate slow light via stimulated Brillouin scattering (SBS) in a room temperature optical fiber that is pumped by a spectrally broadened laser. Broadening the spectrum of the pump field increases the linewidth Deltaomegapof the Stokes amplifying resonance, thereby increasing the slow-light bandwidth. One physical bandwidth limitation occurs when the linewidth becomes several times larger than the Brillouin frequency shift OmegaBso that the anti-Stokes absorbing resonance substantially cancels out the Stokes amplifying resonance and, hence, the slow-light effect. We find that partial overlap of the Stokes and anti-Stokes resonances can actually lead to an enhancement of the slow-light delay-bandwidth product when Deltaomegapsime1.3OmegaB. Using this general approach, we increase the Brillouin slow-light bandwidth to over 12 GHz from its nominal linewidth of ~30 MHz obtained for monochromatic pumping. We controllably delay 75-ps-long pulses by up to 47 ps and study the data-pattern dependence of the broadband SBS slow-light system
Slow-light delay via stimulated Brillouin scattering (SBS) in optical fibers is usually achieved with delay-dependent amplification that degrades system performance. To address this problem, we propose a SBS slow-light method that makes use of two widely separated anti-Stokes absorption resonances, and achieve nearly transparent slow light in an optical fiber. We demonstrate the method in a highly nonlinear optical fiber, and achieve a slow-light bandwidth of approximately 150 MHz and a relative of delay of approximately 0.3 for approximately 9-ns pulses with a signal attenuation of approximately 4.8 dB.
Slow-light components will degrade the data bits in an optical communication system due to narrow-band amplitude and phase responses. A bit-pattern dependence is produced in the output data stream. These effects are observed in simulation as well as in an experiment based on slow light induced by stimulated Brillouin scattering (SBS) in an optical fiber. We define figure of merit involving pulse delay and data degradation to optimize slow-light components. It is demonstrated experimentally and numerically that the pattern dependence can be reduced by detuning the slow-light devices.
The manipulation of the group velocity of optical signals (slow and fast light) has many possible applications in telecommunications, sensing, nonlinear optics, and so on. The exploitation of the effect of stimulated Brillouin scattering (SBS) is of special interest for the alteration of the group velocity in optical fibers, since it just requires standard telecom equipment and low-to-moderate optical power. However, each delay in one single, low-gain SBS-based slow-light system is accompanied by a pulse broadening. This is a result of the inherent Kramers–Kronig relations among the gain, the phase change, and the accompanied group velocity. For an ideal flat gain, the phase change is nonideal, and for an ideal phase change the gain curve leads to a broadening. Furthermore, if the gain bandwidth is adapted to the signal by broadening, the delay will be reduced. Thus the signal broadening can be reduced by several methods for one single low-gain slow-light system, but it cannot be zero. Here, we will show how a zero-broadening SBS-based slow light can be achieved with several methods. The basic idea is a reshaping of the original pulse in a second stage by saturation of the SBS system, or by the superposition of two gains. As will be shown, all of these systems show an almost ideal overall gain and phase function over the bandwidth of the pulses. Thus, SBS-based slow light with a delay bandwidth product of 1 bit and zero distortion is possible.