Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Physical Review

The Reflection of Atoms from Crystals

A. Ellett, Harry F. Olson, Harold A. Zahl

Published Aug 1, 1929• 19 citations
Publisher

Abstract

Beams of mercury, cadmium, and arsenic incident upon clean cleavage surfaces of rock-salt give rise to specularly reflected beams. Measurement shows that the velocity of the beam of cadmium atoms reflected from rock-salt may be represented by $\ensuremath{\lambda}=\frac{h}{\mathrm{mv}}=2d{\left(2.26\ensuremath{-}\frac{\ensuremath{\varphi}}{\frac{1}{2}m{v}^{2}}\ensuremath{-}{cos}^{2}\ensuremath{\theta}\right)}^{\frac{1}{2}}.$ A beam specularly reflected from a first crystal is specularly reflected at a second if incident upon it at the same angle at which reflection from the first took place. If the angles are nearly equal there is still some specular reflection at the second crystal but the intensity of the specular beam drops off with increasing difference of angles and the incident beam is scattered at random. A beam of cadmium atoms issuing from a boiler at 440\ifmmode^\circ\else\textdegree\fi{}C and striking a rock-salt crystal at an angle of 45\ifmmode^\circ\else\textdegree\fi{} gives rise to a specular beam containing about 17 percent of the incident atoms. The intensity of the beams specularly reflected at 22.5\ifmmode^\circ\else\textdegree\fi{} and 67.5\ifmmode^\circ\else\textdegree\fi{} are in the ratio 1:1.38. These facts indicate that associated with motion of translation of uncharged atoms and molecules there is a wave phenomenon of the type postulated by de Broglie.

DOI
10.1103/physrev.34.493

Related papers

VELOCITY OF CADMIUM ATOMS REGULARLY REFLECTED FROM A ROCK SALT CRYSTAL

A. Ellett, Harry F. Olson

We have previously shown that a beam of Cadmium atoms incident upon a cleavage face of a rock salt crystal is reflected so that the incident and reflected beams make equal angles with the normal to the crystal surface. At that time we suggested that this phenomenon could be interpreted in terms of the phase waves of de Broglie. The existence of a reflected beam making the same angle with the normal as does the incident beam suggests at once the possibility that we have here a situation in which the phase waves behave as X-rays do in the Bragg type of reflection.

Science•Jul 27, 1928•0 citations

High-resolution roughness measurements using cold atom reflection

V. Savalli, P. D. Featonby, Vincent Josse +5 more

Summary form only given. Evanescent wave atomic mirrors have been shown to be very sensitive to the surface roughness of the glass substrate on which the evanescent wave is formed. Non-specular reflection of slow atoms at normal incidence has been observed for surface roughness as low as 0.1 nm. We interpret this behaviour in terms of diffraction of the atomic De Broglie wave on the modulated potential created by the interference of the evanescent wave with light scattered by the rough surface. However these experiments could not separate the specular peak of reflected atoms from the diffuse part. We have developed a new method to measure the velocity distribution of the atoms after the bounce with a much better resolution, using Raman transitions. Two phase locked counterpropagating laser beams induce a Raman transition between the ground state hyperfine levels of the /sup 85/Rb atoms falling from a magneto-optical trap. The resonance condition is only fulfilled for atoms with a transverse velocity controlled by the interaction time between the atoms and the beams. These velocity selected atoms bounce on the mirror and their velocity distribution after reflection can be measured using the same Raman beams, by scanning their difference in frequency.

Conference on Lasers and Electro-Optics•Jan 1, 2000•0 citations

Specular Reflection of Very Slow Metastable Neon Atoms from a Solid Surface

Fujio Shimizu

An ultracold narrow atomic beam of metastable neon in the 1s3[(2s)(5)3p:1P0] state is used to study specular reflection of atoms from a solid surface at extremely slow incident velocity. The reflectivity on a silicon (1,0,0) surface and a BK7 glass surface is measured at the normal incident velocity between 1 mm/s and 3 cm/s. The reflectivity above 30% is observed at about 1 mm/s. The observed velocity dependence is explained semiquantitatively by the quantum reflection that is caused by the attractive Casimir-van der Waals potential of the atom-surface interaction.

Physical Review Letters•Feb 5, 2001•302 citations

Magnetic Velocity Analysis of Potassium Atoms Scattered by a Magnesium Oxide Crystal

A. Ellett, Victor W. Cohen

A beam of neutral potassium atoms is directed to the surface of an MgO crystal, incident at an adjustable angle of from 20 to 80 degrees. Perpendicular to this beam is a slit system which defines a second beam of atoms which have been scattered by the crystal. This second beam is directed to the region between a pair of Stern-Gerlach magnet pole pieces. The intensity of the beam is measured by means of a Langmuir-Taylor surface ionization detector.

Proceedings of the Iowa Academy of Science•Jan 1, 1936•0 citations

Crystal Atom Spacing and the Wavelength of an Incident Atom Beam

R. E. Davidson

A beam of atoms is assumed to be incident on a crystal, and a certain aspect of the energy exchange is investigated insofar as is possible without elaborate experiments or calculations. The interaction potential is assumed to be that for helium and lithium fluoride and is known from other sources. By taking account of thermal motion of the crystal atoms tangentially to the surface of the crystal, it is deduced that the probability that the beam will give up energy to the surface becomes relatively large when the de Broglie wavelength of the tangential component of beam moment is decreased to the same order of magnitude as the spacing of atoms in the crystal.

Physical Review•Aug 1, 1959•1 citation

Specular Reflection of Matter Waves from a Rough Mirror

V. Savalli, D. Stevens, Jérôme Estève +5 more

We present a high resolution study of the specularity of the atomic reflection from an evanescent wave mirror using velocity selective Raman transitions. We observed a double structure in the velocity distribution after reflection: a peak consistent with specular reflection and a diffuse reflection pedestal whose contribution decreases rapidly with increasing detuning. The diffuse reflection is due to two distinct effects: spontaneous emission in the evanescent wave and roughness in the evanescent wave potential whose amplitude is smaller than the de Broglie wavelength of the reflected atoms.

arXiv:physics/0202059•Physical Review Letters•Jun 10, 2002•26 citations
Beams of mercury, cadmium, and arsenic incident upon clean cleavage surfaces of rock-salt give rise to specularly reflected beams. Measurement shows that the velocity of the beam of cadmium atoms reflected from rock-salt may be represented by \ensuremathλ=hmv=2d(2.26\ensuremath−\ensuremathφ12mv2\ensuremath−cos2\ensuremathθ)12.\ensuremath{\lambda}=\frac{h}{\mathrm{mv}}=2d{\left(2.26\ensuremath{-}\frac{\ensuremath{\varphi}}{\frac{1}{2}m{v}^{2}}\ensuremath{-}{cos}^{2}\ensuremath{\theta}\right)}^{\frac{1}{2}}.\ensuremathλ=mvh​=2d(2.26\ensuremath−21​mv2\ensuremathφ​\ensuremath−cos2\ensuremathθ)21​. A beam specularly reflected from a first crystal is specularly reflected at a second if incident upon it at the same angle at which reflection from the first took place. If the angles are nearly equal there is still some specular reflection at the second crystal but the intensity of the specular beam drops off with increasing difference of angles and the incident beam is scattered at random. A beam of cadmium atoms issuing from a boiler at 440\ifmmode^\circ\else\textdegree\fi{}C and striking a rock-salt crystal at an angle of 45\ifmmode^\circ\else\textdegree\fi{} gives rise to a specular beam containing about 17 percent of the incident atoms. The intensity of the beams specularly reflected at 22.5\ifmmode^\circ\else\textdegree\fi{} and 67.5\ifmmode^\circ\else\textdegree\fi{} are in the ratio 1:1.38. These facts indicate that associated with motion of translation of uncharged atoms and molecules there is a wave phenomenon of the type postulated by de Broglie.
We have previously shown that a beam of Cadmium atoms incident upon a cleavage face of a rock salt crystal is reflected so that the incident and reflected beams make equal angles with the normal to the crystal surface. At that time we suggested that this phenomenon could be interpreted in terms of the phase waves of de Broglie. The existence of a reflected beam making the same angle with the normal as does the incident beam suggests at once the possibility that we have here a situation in which the phase waves behave as X-rays do in the Bragg type of reflection.
Summary form only given. Evanescent wave atomic mirrors have been shown to be very sensitive to the surface roughness of the glass substrate on which the evanescent wave is formed. Non-specular reflection of slow atoms at normal incidence has been observed for surface roughness as low as 0.1 nm. We interpret this behaviour in terms of diffraction of the atomic De Broglie wave on the modulated potential created by the interference of the evanescent wave with light scattered by the rough surface. However these experiments could not separate the specular peak of reflected atoms from the diffuse part. We have developed a new method to measure the velocity distribution of the atoms after the bounce with a much better resolution, using Raman transitions. Two phase locked counterpropagating laser beams induce a Raman transition between the ground state hyperfine levels of the /sup 85/Rb atoms falling from a magneto-optical trap. The resonance condition is only fulfilled for atoms with a transverse velocity controlled by the interaction time between the atoms and the beams. These velocity selected atoms bounce on the mirror and their velocity distribution after reflection can be measured using the same Raman beams, by scanning their difference in frequency.
An ultracold narrow atomic beam of metastable neon in the 1s3[(2s)(5)3p:1P0] state is used to study specular reflection of atoms from a solid surface at extremely slow incident velocity. The reflectivity on a silicon (1,0,0) surface and a BK7 glass surface is measured at the normal incident velocity between 1 mm/s and 3 cm/s. The reflectivity above 30% is observed at about 1 mm/s. The observed velocity dependence is explained semiquantitatively by the quantum reflection that is caused by the attractive Casimir-van der Waals potential of the atom-surface interaction.
A beam of atoms is assumed to be incident on a crystal, and a certain aspect of the energy exchange is investigated insofar as is possible without elaborate experiments or calculations. The interaction potential is assumed to be that for helium and lithium fluoride and is known from other sources. By taking account of thermal motion of the crystal atoms tangentially to the surface of the crystal, it is deduced that the probability that the beam will give up energy to the surface becomes relatively large when the de Broglie wavelength of the tangential component of beam moment is decreased to the same order of magnitude as the spacing of atoms in the crystal.
We present a high resolution study of the specularity of the atomic reflection from an evanescent wave mirror using velocity selective Raman transitions. We observed a double structure in the velocity distribution after reflection: a peak consistent with specular reflection and a diffuse reflection pedestal whose contribution decreases rapidly with increasing detuning. The diffuse reflection is due to two distinct effects: spontaneous emission in the evanescent wave and roughness in the evanescent wave potential whose amplitude is smaller than the de Broglie wavelength of the reflected atoms.