Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Science

Förster Energy Transfer in an Optical Microcavity

Piers Andrew, William L. Barnes

Published Oct 27, 2000• 358 citations
Publisher

Abstract

By studying the transfer of excitation energy between dye molecules confined within an optical microcavity, we demonstrate experimentally that Förster energy transfer is influenced by the local photonic mode density. Locating donor and acceptor molecules at well-defined positions allows the transfer rate to be determined as a function of both mutual separation and cavity length. The results show that the Förster transfer rate depends linearly on the donor emission rate and hence photonic mode density, providing the potential to control energy transfer by modification of the optical environment.

DOI
10.1126/science.290.5492.785

Related papers

Single dye molecule laser via energy transfer mechanism

Guangcun Shan, Wei Huang

Motivated by the recent progresses in one-atom laser and single-molecule manipulation, this work presents the model and simulations of a single dye molecule laser device, which consists of a single dye molecule as an acceptor in a microcavity pumped by multiple donors via the intermolecular resonance energy transfer mechanism. The photon intensity is calculated at the emission peaks of donor and acceptor dyes for different pump rates and donor numbers. Finally, it is demonstrated that stimulated emission gains a distinct advantage over spontaneous emission under appropriate conditions. This work would have many important applications in a wide range of fields from physics and chemistry to nanotechnology in future.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Oct 20, 2008•0 citations

Optically controlled resonance energy transfer: Mechanism and configuration for all-optical switching

David S. Bradshaw, Davıd L. Andrews

In a molecular system of energy donors and acceptors, resonance energy transfer is the primary mechanism by means of which electronic energy is redistributed between molecules, following the excitation of a donor. Given a suitable geometric configuration it is possible to completely inhibit this energy transfer in such a way that it can only be activated by application of an off-resonant laser beam: this is the principle of optically controlled resonance energy transfer, the basis for an all-optical switch. This paper begins with an investigation of optically controlled energy transfer between a single donor and acceptor molecule, identifying the symmetry and structural constraints and analyzing in detail the dependence on molecular energy level positioning. Spatially correlated donor and acceptor arrays with linear, square, and hexagonally structured arrangements are then assessed as potential configurations for all-optical switching. Built on quantum electrodynamical principles the concept of transfer fidelity, a parameter quantifying the efficiency of energy transportation, is introduced and defined. Results are explored by employing numerical simulations and graphical analysis. Finally, a discussion focuses on the advantages of such energy transfer based processes over all-optical switching of other proposed forms.

The Journal of Chemical Physics•Apr 10, 2008•42 citations

The single-molecule dye laser

Zhen Wang, HERSCHEL A. RABITZ, Marlan O. Scully

This work explores the feasibility of inducing lasing action in a single dye molecule using an optical microcavity. A single-molecule light source is proposed, in which a microcavity-coupled dye molecule is pumped by multiple energy donors via an intermolecular resonance energy transfer mechanism. A quantitative model based on realistic parameters for microcavities and for organic dyes shows that stimulated emission may become dominant over spontaneous fluorescence under optimal yet technically reachable conditions, suggesting the likelihood of achieving a single-molecule lasing photon source with the proposed device. Lasing of a single dye molecule generates signals much brighter than spontaneous fluorescence, and may find applications in a wide range of fields from physics and chemistry to biology.

Laser Physics•Jan 1, 2005•4 citations

Förster transfer and the local optical density of states in erbium-doped silica

M. J. A. de Dood, Jasper Knoester, A. Tip +1 more

Optically excited erbium ions incorporated near the surface of a silica glass decay by spontaneous emission and---at high Er concentration---via F\"orster energy transfer to quenching sites. By externally modifying the photonic microstructure we vary the local optical density of states (LDOS) in samples with different degrees of F\"orster transfer. Changes in spontaneous emission rate are consistent with calculated variations in LDOS at $1.5\phantom{\rule{0.3em}{0ex}}\ensuremath{\mu}\mathrm{m}$, while F\"orster energy transfer is not affected by the LDOS. The latter is attributed to the fact that F\"orster transfer involves virtual photons with a broad energy spectrum, excluding a special role for the LDOS at the atom's transition frequency.

Physical Review B•Mar 4, 2005•113 citations

Controlling molecular broadband-emission by optical confinement

Mathias Bernhard Steiner, Antonio Virgilio Failla, Achim Hartschuh +3 more

We investigate experimentally and theoretically the fluorescence emitted by molecular ensembles as well as spatially isolated, single molecules of an organic dye immobilized in a quasi-planar optical microresonator at room temperature. The optically excited dipole emitters couple simultaneously to on- and off-axis cavity resonances of the microresonator. The multi-spectral radiative contributions are strongly modified with respect to free (non-confined) space due to enhancement and inhibition of the molecular spontaneous emission (SpE) rate. By varying the mirror spacing of the microresonator on the nanometer-scale, the SpE rate of the cavity-confined molecules and, consequently, the spectral line width of the microresonator-controlled broadband fluorescence can be tuned by up to one order of magnitude. Stepwise reducing the optical confinement, we observe that the microresonator-controlled molecular fluorescence line shape converges towards the measured fluorescence line shape in free space. Our results are important for research on and application of broadband emitters in nano-optics and -photonics as well as microcavity-enhanced (single molecule) spectroscopy.

New Journal of Physics•Dec 16, 2008•23 citations

Detection of Single Molecules in Microcavities

N. Lermer, Michael D. Barnes, C-Y. Kung +2 more

A significant limitation in the detection and spectroscopy of individual dye molecules in liquid room temperature samples is the loss of fluorescence signal through chromophore photobleaching. Although often considered a fundamental restriction on sensitivity, it has been shown that the probability per excitation cycle of photobleaching may be reduced by enhancing the spontaneous emission rate of the chromophore located inside a microdroplet, which acts as a optical cavity. Studies of glycerol microdroplets containing R6G dye molecules, and levitated in a three-dimensional electrodynamic trap, have demonstrated a significant enhancement of both the fluorescence decay rate [1] and the total fluorescence yield [2] of the chromophore. Modification of the emission rate is greatest for molecules located near the surface of small (< 10 μm) microdroplets, where the influence of the droplet cavity modes of the droplet is most significant. To exploit this surface sensitivity, surfactant forms of rhodamine dyes were recently studied [3]. Fluorescence emission of the dye molecules, constrained to the droplet surface and with fixed transition moments perpendicular to the surface normal, were shown to be significantly enhanced at small droplet sizes. Additionally, at larger droplet sizes corresponding to higher droplet Q’s, preferential emission into the cavity modes was observed, however the detection of fluorescence photons was delayed by the storage time of the cavity, which may be on the same order as the fluorescence lifetime. These measurements, performed on relatively concentrated dye solutions, suggest that microcavity effects may be exploited to greatly enhance single molecule detection sensitivity in glycerol microdroplets. Furthermore, the large cavity storage time of the high-Q droplets opens the possibility for re-excitation of the molecule following emission into the droplet resonance, and subsequent stimulated emission, that is, single-molecule lasing.

Laser Applications to Chemical, Security and Environmental Analysis•Jan 1, 1998•0 citations
By studying the transfer of excitation energy between dye molecules confined within an optical microcavity, we demonstrate experimentally that Förster energy transfer is influenced by the local photonic mode density. Locating donor and acceptor molecules at well-defined positions allows the transfer rate to be determined as a function of both mutual separation and cavity length. The results show that the Förster transfer rate depends linearly on the donor emission rate and hence photonic mode density, providing the potential to control energy transfer by modification of the optical environment.
Motivated by the recent progresses in one-atom laser and single-molecule manipulation, this work presents the model and simulations of a single dye molecule laser device, which consists of a single dye molecule as an acceptor in a microcavity pumped by multiple donors via the intermolecular resonance energy transfer mechanism. The photon intensity is calculated at the emission peaks of donor and acceptor dyes for different pump rates and donor numbers. Finally, it is demonstrated that stimulated emission gains a distinct advantage over spontaneous emission under appropriate conditions. This work would have many important applications in a wide range of fields from physics and chemistry to nanotechnology in future.
In a molecular system of energy donors and acceptors, resonance energy transfer is the primary mechanism by means of which electronic energy is redistributed between molecules, following the excitation of a donor. Given a suitable geometric configuration it is possible to completely inhibit this energy transfer in such a way that it can only be activated by application of an off-resonant laser beam: this is the principle of optically controlled resonance energy transfer, the basis for an all-optical switch. This paper begins with an investigation of optically controlled energy transfer between a single donor and acceptor molecule, identifying the symmetry and structural constraints and analyzing in detail the dependence on molecular energy level positioning. Spatially correlated donor and acceptor arrays with linear, square, and hexagonally structured arrangements are then assessed as potential configurations for all-optical switching. Built on quantum electrodynamical principles the concept of transfer fidelity, a parameter quantifying the efficiency of energy transportation, is introduced and defined. Results are explored by employing numerical simulations and graphical analysis. Finally, a discussion focuses on the advantages of such energy transfer based processes over all-optical switching of other proposed forms.
This work explores the feasibility of inducing lasing action in a single dye molecule using an optical microcavity. A single-molecule light source is proposed, in which a microcavity-coupled dye molecule is pumped by multiple energy donors via an intermolecular resonance energy transfer mechanism. A quantitative model based on realistic parameters for microcavities and for organic dyes shows that stimulated emission may become dominant over spontaneous fluorescence under optimal yet technically reachable conditions, suggesting the likelihood of achieving a single-molecule lasing photon source with the proposed device. Lasing of a single dye molecule generates signals much brighter than spontaneous fluorescence, and may find applications in a wide range of fields from physics and chemistry to biology.
Optically excited erbium ions incorporated near the surface of a silica glass decay by spontaneous emission and---at high Er concentration---via F\"orster energy transfer to quenching sites. By externally modifying the photonic microstructure we vary the local optical density of states (LDOS) in samples with different degrees of F\"orster transfer. Changes in spontaneous emission rate are consistent with calculated variations in LDOS at $1.5\phantom{\rule{0.3em}{0ex}}\ensuremath{\mu}\mathrm{m}$, while F\"orster energy transfer is not affected by the LDOS. The latter is attributed to the fact that F\"orster transfer involves virtual photons with a broad energy spectrum, excluding a special role for the LDOS at the atom's transition frequency.
We investigate experimentally and theoretically the fluorescence emitted by molecular ensembles as well as spatially isolated, single molecules of an organic dye immobilized in a quasi-planar optical microresonator at room temperature. The optically excited dipole emitters couple simultaneously to on- and off-axis cavity resonances of the microresonator. The multi-spectral radiative contributions are strongly modified with respect to free (non-confined) space due to enhancement and inhibition of the molecular spontaneous emission (SpE) rate. By varying the mirror spacing of the microresonator on the nanometer-scale, the SpE rate of the cavity-confined molecules and, consequently, the spectral line width of the microresonator-controlled broadband fluorescence can be tuned by up to one order of magnitude. Stepwise reducing the optical confinement, we observe that the microresonator-controlled molecular fluorescence line shape converges towards the measured fluorescence line shape in free space. Our results are important for research on and application of broadband emitters in nano-optics and -photonics as well as microcavity-enhanced (single molecule) spectroscopy.
A significant limitation in the detection and spectroscopy of individual dye molecules in liquid room temperature samples is the loss of fluorescence signal through chromophore photobleaching. Although often considered a fundamental restriction on sensitivity, it has been shown that the probability per excitation cycle of photobleaching may be reduced by enhancing the spontaneous emission rate of the chromophore located inside a microdroplet, which acts as a optical cavity. Studies of glycerol microdroplets containing R6G dye molecules, and levitated in a three-dimensional electrodynamic trap, have demonstrated a significant enhancement of both the fluorescence decay rate [1] and the total fluorescence yield [2] of the chromophore. Modification of the emission rate is greatest for molecules located near the surface of small (< 10 μm) microdroplets, where the influence of the droplet cavity modes of the droplet is most significant. To exploit this surface sensitivity, surfactant forms of rhodamine dyes were recently studied [3]. Fluorescence emission of the dye molecules, constrained to the droplet surface and with fixed transition moments perpendicular to the surface normal, were shown to be significantly enhanced at small droplet sizes. Additionally, at larger droplet sizes corresponding to higher droplet Q’s, preferential emission into the cavity modes was observed, however the detection of fluorescence photons was delayed by the storage time of the cavity, which may be on the same order as the fluorescence lifetime. These measurements, performed on relatively concentrated dye solutions, suggest that microcavity effects may be exploited to greatly enhance single molecule detection sensitivity in glycerol microdroplets. Furthermore, the large cavity storage time of the high-Q droplets opens the possibility for re-excitation of the molecule following emission into the droplet resonance, and subsequent stimulated emission, that is, single-molecule lasing.