Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Journal of Solid-State Circuits

Proposal of dual-powered superconducting logic circuits

Hironao YAMADA, Toshiro Tanaka

Published Aug 1, 1985• 4 citations
Publisher

Abstract

A novel structure of high-speed Josephson logic circuits is proposed. Josephson logic gates have latching characteristics and can hold data as long as bias currents are supplied. Through effective use of these latching characteristics, logic circuits can be constructed with wide operating margins. Dual power supplies, properly phased, separately drive logic circuits divided into two groups. Logic signals are transferred from one logic group to the other or vice versa, and one group is reset into a zero voltage state when the other group is active for logic operation. For combinational circuits, the basic configuration of an astable flip-flop and a delay circuit are presented to prevent the logic circuit from `racing'. As an example of sequential circuits, a bistable flip-flop to store data is constructed without any superconducting loop.

DOI
10.1109/jssc.1985.1052396

Related papers

High-speed Josephson processor technology

S. Hasuo, Seigo Kotani, A. Inoue +1 more

High-speed operation of Josephson processors is demonstrated. They are a 4-b microprocessor, a 4-b processor, and an 8-b digital signal processor. Key technologies to realize these circuits are described from the viewpoint of circuit design. The technologies are a high-speed logic gate, named MVTL (modified variable threshold logic), and a three-phase sinusoidal power supply system. The MVTL gate has a large operating margin and high sensitivity. The MVTL gate family consists of OR, AND, 2/3 majority (MJ), and timed inverter (TI). Using these gates a variety of processors have been designed. These processors operate with three-phase power. The waveform is sinusoidal with DC-offset. This power supply system needs no latch and regulator circuit. This makes the processor very simple, and thus results in high-speed operation. To fabricate these processors, niobium junctions are very important, because they are reliable, uniform, controllable, and reproducible. High-speed gates, three-phase power supplies, and niobium junctions are indispensable for high-speed Josephson processors.

IEEE Transactions on Magnetics•Mar 1, 1991•25 citations

Current-injection Josephson latch employing a single-flux quantum. I

J. Sone, Toshishige Yamada

A new current-injection Josephson latch employing a single-flux quantum is proposed. It has a master-slave circuit configuration and operates under ac power supply. In the circuit, data are stored as a circulating current in a superconducting loop consisting of a single junction and inductances. A two-junction interferometer gate directly coupled to the loop reads out the stored data. Dual-rail signals are generated from the read-out data by Josephson junctions and resister-coupled Josephson logic gates. The isolation between a master circuit and a slave circuit is realized using high-impedance states in the Josephson junctions. The circuit design and computer-simulation results on the circuit operation are described in this paper.

Journal of Applied Physics•May 1, 1986•2 citations

Direct-coupled Josephson full adder

J. H. Magerlein, L. N. Dunkleberger

We describe a one-bit full adder circuit constructed from direct-coupled Josephson logic elements. The basic gate, which can perform various logic functions, consists of two Josephson junctions and two resistors connected in a loop. Switching the junctions into the finite-voltage state diverts the bias current into a parallel output line, which is directly coupled through the junctions of successive logic elements. The adder is constructed with a 100 μm basic linewidth and 25 μm square tin tunnel junctions. It operates under all input data conditions with an add time of about 1 nS and a power dissipation of 1 μW per gate.

IEEE Transactions on Magnetics•Jan 1, 1977•7 citations

Design Approach of Dynamically Reconfigurable Single Flux Quantum Logic Gates

Yuki Yamanashi, 一朗 大河, Nobuyuki Yoshikawa

Novel reconfigurable superconductive single flux quantum (SFQ) logic devices, the functions of which can be dynamically reconfigured by inputting control signals, have been investigated. The characteristics of single flux quantum circuits can be easily modulated by applying currents or magnetic fields because of the high sensitivity of superconductive circuits. We investigated several design approaches for the realization of dynamically reconfigurable SFQ logic devices. We employed direct current injection to the logic gate using a non-destructive read-out flip-flop. By changing the internal state of the non-destructive read-out flip-flop, the logic function can be dynamically reconfigured. We have designed and tested a dynamically reconfigurable Josephson transmission line (JTL)/delay flip-flop (DFF) circuit. The measured dc bias margin was 72.5-107.2%. Furthermore, we have demonstrated the operation of a variable bit-length shift register, composed of the dynamically reconfigurable JTL/DFF circuits. The investigated design approach can be applied to more sophisticated dynamically reconfigurable single flux quantum logic gates.

IEEE Transactions on Applied Superconductivity•Dec 14, 2010•12 citations

A Josephson dc-powered latch

Sang H. Dhong, Tushar R. Gheewala

A new dc-powered Josephson latch has been designed and experimentally investigated.A latch is defined as a digital circuit in which information can be stored in a controlled manner. The latch we describe here consists of a nonlatching interferometer in series with a superconducting storage loop containing a second interferometer. Within the nominal operating region the latch has only two stable states and it does not display the problem of falling into a stable faulty state, in which the latch would respond to neither of its inputs (SET or RESET). Computer simulations using nominal 2.5-μm technology-device models indicate that the latch changes state in about 80 ps.

Applied Physics Letters•Jun 1, 1981•6 citations

Bit-serial multiplier based on Josephson latching logic

A. Moopenn, E.R. Arambula, M.J. Lewis +1 more

The authors have designed, fabricated, and tested a Josephson bit serial multiplier based on voltage latching logic. The bit serial implementation takes advantage of high-speed characteristics of Josephson circuits to achieve higher circuit functionality per gate by reducing gate complexity. To facilitate the multiplier design, logic simulation was performed using transistor-transistor-logic (TTL) equivalent gate models of voltage latching modified-variable-threshold-logic (MVTL) gates. A 4-b serial-parallel multiplier based on MVTL gates has been designed and fabricated in niobium. The basic timed-XOR and full adder circuits used in the multiplier were successfully tested. Preliminary testing of the multiplier indicated inadequate operating margin for a full functional test.>

IEEE Transactions on Applied Superconductivity•Mar 1, 1993•6 citations
A novel structure of high-speed Josephson logic circuits is proposed. Josephson logic gates have latching characteristics and can hold data as long as bias currents are supplied. Through effective use of these latching characteristics, logic circuits can be constructed with wide operating margins. Dual power supplies, properly phased, separately drive logic circuits divided into two groups. Logic signals are transferred from one logic group to the other or vice versa, and one group is reset into a zero voltage state when the other group is active for logic operation. For combinational circuits, the basic configuration of an astable flip-flop and a delay circuit are presented to prevent the logic circuit from `racing'. As an example of sequential circuits, a bistable flip-flop to store data is constructed without any superconducting loop.
High-speed operation of Josephson processors is demonstrated. They are a 4-b microprocessor, a 4-b processor, and an 8-b digital signal processor. Key technologies to realize these circuits are described from the viewpoint of circuit design. The technologies are a high-speed logic gate, named MVTL (modified variable threshold logic), and a three-phase sinusoidal power supply system. The MVTL gate has a large operating margin and high sensitivity. The MVTL gate family consists of OR, AND, 2/3 majority (MJ), and timed inverter (TI). Using these gates a variety of processors have been designed. These processors operate with three-phase power. The waveform is sinusoidal with DC-offset. This power supply system needs no latch and regulator circuit. This makes the processor very simple, and thus results in high-speed operation. To fabricate these processors, niobium junctions are very important, because they are reliable, uniform, controllable, and reproducible. High-speed gates, three-phase power supplies, and niobium junctions are indispensable for high-speed Josephson processors.
A new current-injection Josephson latch employing a single-flux quantum is proposed. It has a master-slave circuit configuration and operates under ac power supply. In the circuit, data are stored as a circulating current in a superconducting loop consisting of a single junction and inductances. A two-junction interferometer gate directly coupled to the loop reads out the stored data. Dual-rail signals are generated from the read-out data by Josephson junctions and resister-coupled Josephson logic gates. The isolation between a master circuit and a slave circuit is realized using high-impedance states in the Josephson junctions. The circuit design and computer-simulation results on the circuit operation are described in this paper.
We describe a one-bit full adder circuit constructed from direct-coupled Josephson logic elements. The basic gate, which can perform various logic functions, consists of two Josephson junctions and two resistors connected in a loop. Switching the junctions into the finite-voltage state diverts the bias current into a parallel output line, which is directly coupled through the junctions of successive logic elements. The adder is constructed with a 100 μm basic linewidth and 25 μm square tin tunnel junctions. It operates under all input data conditions with an add time of about 1 nS and a power dissipation of 1 μW per gate.
Novel reconfigurable superconductive single flux quantum (SFQ) logic devices, the functions of which can be dynamically reconfigured by inputting control signals, have been investigated. The characteristics of single flux quantum circuits can be easily modulated by applying currents or magnetic fields because of the high sensitivity of superconductive circuits. We investigated several design approaches for the realization of dynamically reconfigurable SFQ logic devices. We employed direct current injection to the logic gate using a non-destructive read-out flip-flop. By changing the internal state of the non-destructive read-out flip-flop, the logic function can be dynamically reconfigured. We have designed and tested a dynamically reconfigurable Josephson transmission line (JTL)/delay flip-flop (DFF) circuit. The measured dc bias margin was 72.5-107.2%. Furthermore, we have demonstrated the operation of a variable bit-length shift register, composed of the dynamically reconfigurable JTL/DFF circuits. The investigated design approach can be applied to more sophisticated dynamically reconfigurable single flux quantum logic gates.
A new dc-powered Josephson latch has been designed and experimentally investigated.A latch is defined as a digital circuit in which information can be stored in a controlled manner. The latch we describe here consists of a nonlatching interferometer in series with a superconducting storage loop containing a second interferometer. Within the nominal operating region the latch has only two stable states and it does not display the problem of falling into a stable faulty state, in which the latch would respond to neither of its inputs (SET or RESET). Computer simulations using nominal 2.5-μm technology-device models indicate that the latch changes state in about 80 ps.
The authors have designed, fabricated, and tested a Josephson bit serial multiplier based on voltage latching logic. The bit serial implementation takes advantage of high-speed characteristics of Josephson circuits to achieve higher circuit functionality per gate by reducing gate complexity. To facilitate the multiplier design, logic simulation was performed using transistor-transistor-logic (TTL) equivalent gate models of voltage latching modified-variable-threshold-logic (MVTL) gates. A 4-b serial-parallel multiplier based on MVTL gates has been designed and fabricated in niobium. The basic timed-XOR and full adder circuits used in the multiplier were successfully tested. Preliminary testing of the multiplier indicated inadequate operating margin for a full functional test.>