Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Quantum Electronics and Laser Science Conference

Quantum gate characterization in an extended Hilbert space

Peter P. Rohde, Geoff J. Pryde, Jeremy L. O’Brien, Timothy C. Ralph

Published Dec 10, 2005• 3 citations
Publisher

Abstract

We describe an approach for characterizing optical quantum gates, by constructing models which incorporate mode-matching effects. Quantum process tomography is then performed on the model. The techniques can be generalized to other quantum computing architectures.
DOI
10.1109/qels.2005.1548656

Related papers

Quantum-gate characterization in an extended Hilbert space

Peter P. Rohde, Geoff J. Pryde, Jeremy L. O’Brien +1 more

We describe an approach for characterizing the process performed by a quantum gate using quantum process tomography, by first modeling the gate in an extended Hilbert space, which includes nonqubit degrees of freedom. To prevent unphysical processes from being predicted, present quantum process tomography procedures incorporate mathematical constraints, which make no assumptions as to the actual physical nature of the system being described. By contrast, the procedure presented here assumes a particular class of physical processes, and enforces physicality by fitting the data to this model. This allows quantum process tomography to be performed using a smaller experimental data set, and produces parameters with a direct physical interpretation. The approach is demonstrated by example of mode matching in an all-optical controlled-NOT gate. The techniques described are general and could be applied to other optical circuits or quantum computing architectures.

arXiv:quant-ph/0411144•Physical Review A•Sep 6, 2005•35 citations

Process characterization of experimental photonic one-way quantum computing

Yuuki Tokunaga, Shin Kuwashiro, Takashi Yamamoto +2 more

We demonstrate process characterization of basic gates of an optical cluster-state quantum computing. We present complete process tomography of a single-qubit gate and evaluate the bounds on the process fidelity of a two-qubit gate.

Conference on Lasers and Electro-Optics•May 4, 2008•0 citations

Towards Quantum Process Tomography of an Optical Quantum Gate

Connor Kupchak, Z. Burkley, Bertus Jordaan +2 more

Here, we investigate the slowdown of low-light intensity pulses under the conditions of electromagnetically induced transparency (EIT) using homodyne tomography measurement techniques. This technique is necessary for performing quantum process tomography for characterizing quantum systems.

Latin America Optics and Photonics Conference•Jan 1, 2014•0 citations

Process Characterization of Experimental Photonic One-Way Quantum Computing

Yuuki Tokunaga, Shin Kuwashiro, Takashi Yamamoto +3 more

We demonstrate process characterization of basic gates of an optical cluster‐state quantum computing. We present complete process tomography of a single‐qubit gate and evaluate the bounds on the process fidelity of a two‐qubit gate.

AIP conference proceedings•Jan 1, 2009•0 citations

Matchgate quantum computing and non-local process analysis

Sven Ramelow, Alessandro Fedrizzi, Aephraim M. Steinberg +1 more

In the circuit model, quantum computers rely on the availability of a universal quantum gate set. A particularly intriguing example is a set of two-qubit-only gates: 'matchgates', along with swap (the exchange of two qubits). In this paper, we show a simple decomposition of arbitrary matchgates into better-known elementary gates and implement a matchgate in a single-photon linear optics experiment. The gate performance is fully characterized via quantum process tomography. Moreover, we represent the resulting reconstructed quantum process in a novel way, as a fidelity map in the space of all possible non-local two-qubit unitaries. We propose the non-local distance —which is independent of local imperfections such as uncorrelated noise or uncompensated local rotations—as a new diagnostic process measure for the non-local properties of the implemented gate.

arXiv:0909.3016•New Journal of Physics•Aug 11, 2010•4 citations

Complete characterization of the single-qubit quantum gates used in the IBM quantum processors

Abhishek Shukla, Mitali Sisodia, Anirban Pathak

Quantum process tomography of each single-qubit quantum gate used in the IBM quantum processors is performed to compute gate error in order to check viability of complex quantum operations in the superconductivity-based quantum computers introduced by IBM and to compare the quality of these gates with the corresponding gates implemented using other technologies. Gate fidelities for all the allowed gates for every allowed position (i.e., by placing the gates in different qubit lines) have been obtained and reported for IBM QX4 architecture. Gate fidelities are observed to be lower than the corresponding values obtained in the other technologies, like NMR. Further, gate fidelities for all the single-qubit gates are obtained for IBM QX2 architecture by placing the gates in the third qubit line ($q[2]$). It's observed that the IBM QX4 architecture yields better gate fidelity compared to IBM QX2 in all cases except the case of $\operatorname{Y}$ gate as far as the gate fidelity corresponding to the third qubit line is concerned. In general, the analysis performed here leads to a conclusion that a considerable technological improvement would be inevitable to achieve the desired scalability required for the realization of complex quantum operations.

•May 18, 2018•5 citations
We describe an approach for characterizing the process performed by a quantum gate using quantum process tomography, by first modeling the gate in an extended Hilbert space, which includes nonqubit degrees of freedom. To prevent unphysical processes from being predicted, present quantum process tomography procedures incorporate mathematical constraints, which make no assumptions as to the actual physical nature of the system being described. By contrast, the procedure presented here assumes a particular class of physical processes, and enforces physicality by fitting the data to this model. This allows quantum process tomography to be performed using a smaller experimental data set, and produces parameters with a direct physical interpretation. The approach is demonstrated by example of mode matching in an all-optical controlled-NOT gate. The techniques described are general and could be applied to other optical circuits or quantum computing architectures.
In the circuit model, quantum computers rely on the availability of a universal quantum gate set. A particularly intriguing example is a set of two-qubit-only gates: 'matchgates', along with swap (the exchange of two qubits). In this paper, we show a simple decomposition of arbitrary matchgates into better-known elementary gates and implement a matchgate in a single-photon linear optics experiment. The gate performance is fully characterized via quantum process tomography. Moreover, we represent the resulting reconstructed quantum process in a novel way, as a fidelity map in the space of all possible non-local two-qubit unitaries. We propose the non-local distance —which is independent of local imperfections such as uncorrelated noise or uncompensated local rotations—as a new diagnostic process measure for the non-local properties of the implemented gate.
Quantum process tomography of each single-qubit quantum gate used in the IBM quantum processors is performed to compute gate error in order to check viability of complex quantum operations in the superconductivity-based quantum computers introduced by IBM and to compare the quality of these gates with the corresponding gates implemented using other technologies. Gate fidelities for all the allowed gates for every allowed position (i.e., by placing the gates in different qubit lines) have been obtained and reported for IBM QX4 architecture. Gate fidelities are observed to be lower than the corresponding values obtained in the other technologies, like NMR. Further, gate fidelities for all the single-qubit gates are obtained for IBM QX2 architecture by placing the gates in the third qubit line (q[2]q[2]q[2]). It's observed that the IBM QX4 architecture yields better gate fidelity compared to IBM QX2 in all cases except the case of Y⁡\operatorname{Y}Y gate as far as the gate fidelity corresponding to the third qubit line is concerned. In general, the analysis performed here leads to a conclusion that a considerable technological improvement would be inevitable to achieve the desired scalability required for the realization of complex quantum operations.