Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Bulletin of the American Physical Society

Low-loss superconducting microwave resonators with NbN films

Chengkun Song, B. P. Xiao, Matthew Ware, B. L. T. Plourde

Published Mar 25, 2011• 0 citations
OpenAlex

Related papers

Broadband microwave response of superconducting NbN and TaN thin films

M. Maximilian Felger, Uwe Santiago Pracht, Martin Dressel +3 more

Verhandlungen der Deutschen Physikalischen Gesellschaft•Jan 1, 2015•0 citations

Superconducting Microwave Resonators

Charles Neill, A. Megrant, M. Lenander +17 more

Bulletin of the American Physical Society•Mar 1, 2012•0 citations

Dielectric Loss in Superconducting NbN (200) CPW Resonator Developed on Si Substrate

Wei Qiu, Kazumasa Makise, Hirotaka Terai

In current superconducting qubit circuit development, coherence time is limited by low-frequency flux noise introduced from localized two-level systems (TLSs) in the fabricated superconducting circuit, including superconducting materials, the interface between thin films, and the substrate. As a part of the effect to tackle this issue from a substrate standpoint, we succeed in fabricating NbN (200) oriented coplanar waveguide resonator (CPWR) on a thin titanium nitride (TiN) (200) buffered Si (100) substrate. The internal loss is close to 3 × 10-5nearphoton> ~1, improved from ~2 × 10-4in NbN (200) CPWR fabricated on MgO (100). For NbN (200) resonators grown on Si (100), the internal loss shows microwave energy independent. To further clarity if this energy independence is due to the change of substrate material, we also fabricated TiN (200) CPWR on Si (100). In contrast to NbN (200) CPWR, the loss of TiN (200) resonator shows a strong microwave dependent, an indication of TLSs originated from the interface and the surface. We suggest TLSs in NbN (200) CPWR are dominated from different mechanism other than arising from the interface and surface.

IEEE Transactions on Applied Superconductivity•Jan 9, 2017•5 citations

Nonlinear behavior of NbN and YBa2Cu3O7-x superconductive films at microwaves

Andrey B. Kozyrev, T. B. Samoǐlova, S.Yu. Shaferova

Some results of an investigation of nonlinear behavior of NbN and YBa2Cu3O7-x films at microwaves are presented. Nonlinear microwave properties of superconducting films are analyzed on the basis of dynamic Current Voltage Characteristics (CVC) measured from the film response to the short duration video pulse. Conversion loss of the microwave signal into the intermediate frequency signal under various local oscillator power has been obtained from this analysis. The experimental data for the mixing of two microwave signals are described. Mixing effect was observed on superconducting NbN and YBa2Cu3O7-x film elements in microbridge and coplanar line forms. Conversion loss of about 20 dB was obtained in the running-wave regime.

European Microwave Conference (EuMC)•Oct 1, 1993•0 citations

Superconducting microwave resonators - low loss, tunability, and coupling

Haohua Wang, Radoslaw C. Bialczak, M. Lenander +11 more

Bulletin of the American Physical Society•Mar 17, 2010•0 citations

Dielectric Loss in Superconducting Microwave Resonators

圭正 牧瀬, 弘高 寺井, Hirotaka Terai

IEICE Technical Report; IEICE Tech. Rep.•Apr 15, 2015•0 citations
In current superconducting qubit circuit development, coherence time is limited by low-frequency flux noise introduced from localized two-level systems (TLSs) in the fabricated superconducting circuit, including superconducting materials, the interface between thin films, and the substrate. As a part of the effect to tackle this issue from a substrate standpoint, we succeed in fabricating NbN (200) oriented coplanar waveguide resonator (CPWR) on a thin titanium nitride (TiN) (200) buffered Si (100) substrate. The internal loss is close to 3 × 10-5nearphoton> ~1, improved from ~2 × 10-4in NbN (200) CPWR fabricated on MgO (100). For NbN (200) resonators grown on Si (100), the internal loss shows microwave energy independent. To further clarity if this energy independence is due to the change of substrate material, we also fabricated TiN (200) CPWR on Si (100). In contrast to NbN (200) CPWR, the loss of TiN (200) resonator shows a strong microwave dependent, an indication of TLSs originated from the interface and the surface. We suggest TLSs in NbN (200) CPWR are dominated from different mechanism other than arising from the interface and surface.
Some results of an investigation of nonlinear behavior of NbN and YBa2Cu3O7-x films at microwaves are presented. Nonlinear microwave properties of superconducting films are analyzed on the basis of dynamic Current Voltage Characteristics (CVC) measured from the film response to the short duration video pulse. Conversion loss of the microwave signal into the intermediate frequency signal under various local oscillator power has been obtained from this analysis. The experimental data for the mixing of two microwave signals are described. Mixing effect was observed on superconducting NbN and YBa2Cu3O7-x film elements in microbridge and coplanar line forms. Conversion loss of about 20 dB was obtained in the running-wave regime.