This dissertation presents the development and implementation of two novel experimental techniques for controlling atom number and phase-space density in cold atomic gases. The first experiment demonstrates the method of single-photon cooling, an optical realization of Maxwell's demon, using an ensemble of rubidium atoms. Single-photon cooling increases the phase-space density of a cloud of magnetically trapped atoms, reducing the entropy of the ensemble by irreversibly transferring atoms through a one-way wall via a single-photon scattering event. While traditional laser cooling methods are limited in their applicability to a small number of atoms, single-photon cooling is much more general and should in principle be applicable to almost all atoms in the periodic table. The experiment described in this dissertation demonstrates a one-dimensional implementation of the cooling scheme. Complete phase-space compression along this dimension is observed. The limitations on the cooling performance are shown to be given by trap dynamics in the magnetic trap. The second part of this dissertation is dedicated to the experiment built to control the atom number of a degenerate Fermi gas on a single particle level. Creating Fock states of atoms with ultra-high fidelity is a mandatory step for studying quantum entanglement on a single atom level. The experimental technique implemented to control the atom number in this experiment is called laser culling. Decreasing the trapping potential reduces the atom number in a controlled way, giving precise control over the number of atoms remaining in the trap. This dissertation details the design and construction of this experiment and reports on the progress towards the creation of neutral lithium Fock states.
This dissertation presents the development and implementation of two novel experimental techniques for controlling atom number and phase-space density in cold atomic gases. The first experiment demonstrates the method of single-photon cooling, an optical realization of Maxwell's demon, using an ensemble of rubidium atoms. Single-photon cooling increases the phase-space density of a cloud of magnetically trapped atoms, reducing the entropy of the ensemble by irreversibly transferring atoms through a one-way wall via a single-photon scattering event. While traditional laser cooling methods are limited in their applicability to a small number of atoms, single-photon cooling is much more general and should in principle be applicable to almost all atoms in the periodic table. The experiment described in this dissertation demonstrates a one-dimensional implementation of the cooling scheme. Complete phase-space compression along this dimension is observed. The limitations on the cooling performance are shown to be given by trap dynamics in the magnetic trap. The second part of this dissertation is dedicated to the experiment built to control the atom number of a degenerate Fermi gas on a single particle level. Creating Fock states of atoms with ultra-high fidelity is a mandatory step for studying quantum entanglement on a single atom level. The experimental technique implemented to control the atom number in this experiment is called laser culling. Decreasing the trapping potential reduces the atom number in a controlled way, giving precise control over the number of atoms remaining in the trap. This dissertation details the design and construction of this experiment and reports on the progress towards the creation of neutral lithium Fock states.
This dissertation details the development and implementation of novel experimental techniques for cooling neutral atoms. Based on a method first proposed by Maxwell in a nineteenth century thought experiment, these techniques reduce the entropy of an ensemble by allowing unidirectional transmission through a barrier and thus compressing the ensemble without doing work or increasing its temperature. Because of their general nature, these techniques are much more broadly applicable than traditional laser and evaporative cooling methods, with the potential to cool the vast majority of the periodic table and even molecules. \n \nAn implementation that cools in one dimension is demonstrated for an ensemble of magnetically trapped rubidium atoms which are irreversibly transferred to a gravito-optical trap. Analysis of the experimental results confirms that phase-space is completely compressed in one dimension. The results also indicate that the overall cooling performance is limited only by the dynamics of atoms in the magnetic trap and may be improved with a more ergodic system. \n \nThree-dimensional cooling may be accomplished with a modified technique which substitutes a radio-frequency-dressed magnetic trap for the gravito-optical trap. Application of this technique to atomic hydrogen and progress toward building an experimental apparatus are discussed.
Ultracold atoms have been successfully used to study numerous systems, previously unaccessible, but a precise control over the atom number of the sample still remains a challenge. This dissertation describes our progress towards achieving Fock states of atoms. The first three chapters cover the basic physics necessary to understand the techniques we use in our lab to manipulate atoms. We then summarize our experimental results from an earlier setup where we did two experiments. In the first experiment we compare the transport of cold atoms and a Bose Einstein Condensate (BEC) in a periodic potential. We find a critical potential height beyond which the condensate behavior deviates significantly from that of thermal atoms. In the second experiment we study the effect of periodic temporal kicks by a spatially periodic potential on a BEC in a quasi one dimensional trap. We observe a limit on the energy that the system can absorb from the kicks, which we conclude is due to the finite height of the trap rather than quantum effects. The majority of the dissertation discusses our experimental setup designed to produce Fock states. The setup is designed to use the method of laser culling to produce Fock states. We are able to create a BEC and transport it into a glass cell 25 cm away. We tried different innovative methods to reduce vibrations during transport before finally settling to a commercial air bearing translation stage. We create a high confinement one dimensional optical trap using the Hermite Gaussian TEM₀₁ mode of a laser beam. Such a trap gives trapping frequencies comparable to an optical lattice and allows us to create a single one dimensional trap. We creating the TEM₀₁ mode using an appropriate phase object (phase plate) in the path of a TEM₀₀ mode beam. The method for producing the phase plate was very well controlled to obtain a good quality mode. Once the atoms are loaded into this one dimensional trap we can proceed to do laser culling to observe Sub-Poissonian number statistics and eventually create Fock states of few atoms. Finally, we describe a novel method to create a real time tunable optical lattice which would provide us with the ability of spatially resolved single atom detection. The majority of the dissertation discusses our experimental setup designed to produce Fock states. The setup is designed to use the method of laser culling to produce Fock states. We are able to create a BEC and transport it into a glass cell 25 cm away. We tried different innovative methods to reduce vibrations during tr₀ansport before finally settling to a commercial air bearing translation stage. We create a high confinement one dimensional optical trap using the Hermite Gaussian TEM₀₁ mode of a laser beam. Such a trap gives trapping frequencies comparable to an optical lattice and allows us to create a single one dimensional trap. We creating the TEM₀₁ mode using an appropriate phase object (phase plate) in the path of a TEM₀₀ mode beam. The method for producing the phase plate was very well controlled to obtain a good quality mode. Once the atoms are loaded into this one dimensional trap we can proceed to do laser culling to observe Sub-Poissonian number statistics and eventually create Fock states of few atoms. Finally, we describe a novel method to create a real time tunable optical lattice which would provide us with the ability of spatially resolved single atom detection. The majority of the dissertation discusses our experimental setup designed to produce Fock states. The setup is designed to use the method of laser culling to produce Fock states. We are able to create a BEC and transport it into a glass cell 25 cm away. We tried different innovative methods to reduce vibrations during transport before finally settling to a commercial air bearing translation stage. We create a high confinement one dimensional optical trap using the Hermite Gaussian TEM₀₁ mode of a laser beam. Such a trap gives trapping frequencies comparable to an optical lattice and allows us to create a single one dimensional trap. We creating the TEM₀₁ mode using an appropriate phase object (phase plate) in the path of a TEM₀₀ mode beam. The method for producing the phase plate was very well controlled to obtain a good quality mode. Once the atoms are loaded into this one dimensional trap we can proceed to do laser culling to observe Sub-Poissonian number statistics and eventually create Fock states of few atoms. Finally, we describe a novel method to create a real time tunable optical lattice which would provide us with the ability of spatially resolved single atom detection. The majority of the dissertation discusses our experimental setup designed to produce Fock states. The setup is designed to use the method of laser culling to produce Fock states. We are able to create a BEC and transport it into a glass cell 25 cm away. We tried different innovative methods to reduce vibrations during transport before finally settling to a commercial air bearing translation stage. We create a high confinement one dimensional optical trap using the Hermite Gaussian TEM₀₁ mode of a laser beam. Such a trap gives trapping frequencies comparable to an optical lattice and allows us to create a single one dimensional trap. We creating the TEM₀₁ mode using an appropriate phase object (phase plate) in the path of a TEM₀₀ mode beam. The method for producing the phase plate was very well controlled to obtain a good quality mode. Once the atoms are loaded into this one dimensional trap we can proceed to do laser culling to observe Sub-Poissonian number statistics and eventually create Fock states of few atoms. Finally, we describe a novel method to create a real time tunable optical lattice which would provide us with the ability of spatially resolved single atom detection.
The work described in this thesis is related to various projects that I worked on towards the production of ultra-cold ensembles of ⁸⁵Rb, ⁸⁷Rb and fermionic ⁶Li. In the past few years, ultra-cold atomic gases have evolved into a mature field of research, driving various theoretical and experimental groups towards new possibilities. This thesis starts with an overview of the research direction of the field and the lab in particular, to use ultra-cold fermionic atoms as quantum simulators for several condensed matter problems. It discusses the experimental route to quantum degeneracy in a sample of ultra-cold atoms and techniques to get there. The rest of the thesis primarily discusses the first step to degeneracy- production of ultra-cold ensembles of rubidium and lithium. It starts with the theoretical concepts that enable laser cooling and trapping. The interaction between light and atoms and how it leads to a decrease in temperature of the ensemble is discussed. The limits of different cooling mechanism with relevance of the atoms of interest are described. The starting point for all laser cooling experiments is an atomic source, the details of the requirements and efficiency of different atomic sources is discussed, emphasizing our choice of sources for the two atoms. Other technical details such as the vacuum system and the control system for the experiment are briefly discussed. Preliminary data from our first ensembles of ultra-cold lithium and rubidium is shown. At the end, the planning and progress of the first experiments that we aim to achieve with these ultra-cold atoms namely looking for Feshbach resonances and studying the effect of DC electric fields on them, and studies with ultra-cold lithium atoms in optical lattices, is discussed.
The research presented in this dissertation aims to contribute to the field of atom optics via the implementation and demonstration of an all-optical one-way barrier for 87 Rb atoms--a novel tool for controlling atomic motion. This barrier--a type of atomic turnstile--transmits atoms traveling in one direction but hinders their passage in the other direction. We create the barrier with two laser beams, generating its unidirectional behavior by exploiting the two hyperfine ground states of 87 Rb. In particular, we judiciously choose the frequency of one beam to present a potential well to atoms in one ground state (the transmitting state) and a potential barrier to atoms in the other state (the reflecting state). The second beam optically pumps the atoms from the transmitting state to the reflecting state. \n \nA significant component of the experimental work presented here involves generating ultra-cold rubidium atoms for demonstrating the one-way barrier. To this end, we have designed and constructed a sophisticated 87 Rb cooling and trapping apparatus. This apparatus comprises an extensive ultra-high vacuum system, four home-built, frequency-stabilized diode laser systems, a high-power Yb:fiber laser, a multitude of supporting optics, and substantial timing and control electronics. This system allows us to cool and trap rubidium atoms at a temperature of about 30 μK. \n \nThe results presented in this dissertation are summarized as follows. We successfully implemented a one-way barrier for neutral atoms and demonstrated its asymmetric nature. We used this new tool to compress the phase-space volume of an atomic sample and examined its significance as a physical realization of Maxwell's demon. We also demonstrated the robustness of the barrier's functionality to variations in several important experimental parameters. Lastly, we demonstrated the barrier's ability to cool an atomic sample, substantiating its potential application as a new cooling tool. \n \nThis dissertation includes previously published coauthored material.
In this habilitation-thesis a collection of 14 experiments is presented. In these experiments we have developed and used novel techniques to control ultracold gases on the quantum level. In brief, Bose-Einstein condensates (BEC) and degenerate Fermi gases of laser-cooled alkali atoms are subjected to specially designed optical and magnetic fields. The fields influence in a coherent way the behavior, properties and dynamics of the gases. On this basis we developed tools to prepare, coherently manipulate, and analyze pre-defined quantum states. With this high level of control, it was possible to investigate interesting physics phenomena, and we were able to achieve several breakthroughs in the field of ultracold atoms. Highlights of our experimental results include the demonstration of phase engineering of a BEC wavefunction where we created solitons in a BEC and studied their propagation. In another experiment we constructed a spatially resolved matter wave interferometer with which we mapped out the phase distribution on a condensate. Illuminating the BEC with a periodic pattern, i.e. an optical lattice, allowed us to study solid states physics phenomena. In a second set of experiments we demonstrated optically tuning of the interaction between atoms with optical Feshbach resonances. Employing either magnetically tunable Feshbach resonances or laser radiation, we were able to produce ground state molecules in well defined quantum states. This led to the production of the first molecular BEC. By tuning the coupling of atom pairs in a Fermi gas of atoms, we could for the first time investigate the so-called BEC-BCS crossover which describes the continuous change from a BEC superfluid to a Bardeen-Cooper Schrieffer (BCS) superfluid. Due to the excellent control on the quantum level, the developed cold atom techniques open up intriguing prospects for future applications and experiments. They represent a general tool box to investigate fundamental physical phenomena in a pure and undisturbed environment. In the future, cold atoms might serve as a testing ground for fundamental theories or as quantum simulators for complex systems.
This dissertation discusses several recently developed experimental techniques for controlling the motion of neutral atoms. While laser cooling and evaporative cooling have been extremely successful and have been in widespread use for many years, these techniques are only applicable to a few atomic species. Supersonic beams provide a general method of producing cold atoms in the co-moving frame, but their speeds are typically several hundreds of meters per second in the lab frame. Methods to slow and control atoms cooled by supersonic expansion are detailed. A method for controlling the velocity of a cold beam of ground state helium using specular reflection from single crystal surfaces is demonstrated. The velocity of the beam is shown to be continuously tunable, and beam velocities as slow as 265m/s are created from an initial beam speed of 511 m/s. Magnetism is a nearly universal atomic phenomenon, making magnetic control of atomic motion a very general technique. Magnetic stopping of supersonic beams of metastable neon and molecular oxygen is demonstrated using a series of pulsed electromagnetic coils. Neon is slowed from 446 m/s to 56 m/s, and oxygen is slowed from 389 m/s to 83 m/s, removing over 95% of the kinetic energy. The experimental technique is described in detail, and the theory and principle are discussed. An experiment for slowing and trapping of atomic hydrogen isotopes at around 100 mK using a room temperature apparatus is described. A method for further cooling of magnetically trapped hydrogen ensembles, single-photon cooling, is proposed.