We have experimentally demonstrated a general method to perform high-precision refractive index spectrum measurement using phase-shifting interferometry in a phase-tunable Mach–Zehnder interferometer. We observed coherent amplification on the refractive spectrum, across the Lamb dips of ground hyperfine states in a Doppler-broadened Rb87 vapor. Most importantly, the spectrum still has a large signal-to-noise ratio when the probe power is in the dark light level under which the method using a single interferogram fails. This experimental scheme is efficient for refractive spectrum measurements and could be extended for 2D phase imaging. It provides many potential applications for optical phase measurements in linear, nonlinear, and quantum optics.
We report the experimental observation of steady-state electromagnetically induced transparency and sub-Doppler linewidth in a Doppler-broadened \ensuremath{\Lambda}-type Rb atomic system formed on the
87Rb D2 transitions. The \ensuremath{\Lambda} system is coupled on one transition by a strong laser and probed on the other transition by a weak laser. The observed sub-Doppler linewidth decreases with the increasing detuning of the strong-coupling laser from the atomic transition frequency and is in good agreement with the theoretical calculations of G. Vemuri, G. S. Agarwal, and B. D. N. Rao [Phys. Rev. A 53, 2842 (1996)]. \textcopyright{} 1996 The American Physical Society.
The commonly quoted saturation intensity of rubidium (Rb) for D2 transitions is 16.7
W.m−2. This value, however, is only accurate for the cycling transition, which renders the Rb atom to resemble a two-level system. In practice, the effective saturation intensity is influenced by various factors, such as the polarization of light, optical pumping, and atom collision which can redistribute the population. As a result, it is crucial to experimentally determine the effective saturation intensity. In this context, we demonstrate a novel yet simple experimental method to measure the effective saturation intensities of Doppler-broadened transitions in atomic vapours. Our method only requires on-resonance absorbance data for various input laser intensities, which can be obtained with a tunable CW laser without the need for precise frequency locking. We applied this method to measure the effective saturation intensities of all four Doppler-broadened D2 transitions in natural rubidium (Rb) vapour (27.8%87Rb and 72.2 %
85Rb) at
r=35∘C. The results show that the effective saturation intensities for Rb range from 0.752 to 16.8
W.m−2. Notably, for certain transitions (specifically, repump transitions), the effective saturation intensities were smaller than 16.7 W.
m−2(up to an order of magnitude), with potentially important implications for optical pumping in Doppler-broadened transitions.
We report an experimental measurement of giant group index in the 85 Rb atomic medium at room temperature via a four-level V-type scheme on the D 2 line. Our experiment uses co-propagation configuration of probe and coupling lasers through an atomic sample. In this configuration, three sharp EIT windows with significant transparency depths are observed on the probe absorption spectrum. By establishing a Mach–Zehnder interferometer, we measure the dispersive curve and hence obtain the group index curve with three enhanced positive peaks at the locations of the EIT windows, interspersed with negative peaks. The amplitude of the group index curve is increased as the temperature decreases and is decreased as the temperature increases. We estimate from our experimental results the good values of the group index to be n g = 5.8 × 10 4 (slow light regime) and n g = −4.0 × 10 4 (fast light regime). We also show that the experimental measurements are in good agreement with the theoretical results.
This paper describes experiments performed by undergraduate physics majors to measure the temperature dependence of Doppler-broadening in Rb absorption lines over the interval 290–500 K. We report measurements made with a laser-diode spectrometer on the resolved hyperfine transitions of Rb87 (5 2S1/2 F=1 to 5 2P1/2, F=1 and 2) near 795 nm, and on the unresolved envelope of the transitions of Rb85 (5 2S1/2 F=2 to 5 2P3/2, F=1, 2 and 3) near 780 nm. Agreement between measured and predicted linewidths is very good.
The
5S1/2→6P3/2 transition of rubidium at
420 nm is a promising candidate for a portable warm-vapor all-optical atomic clock. Despite recent precision spectroscopy studies at
420 nm in Rb, an experimental determination of the saturation intensity of this transition has not yet been reported. The saturation intensity is a fundamental parameter that influences the identification of a potential clock transition frequency in terms of optimizing various intensity-dependent parameters and connected systematics. In this work, we report the first experimental measurement of the saturation intensity of the
420 nm transition in Rb, obtaining
(23.18±0.28) mW/cm
2 for the
87Rb
F=2→F′=3 transition and
(25.56±0.37) mW/cm
2 for the
85Rb
F=3→F′=4 transition, in excellent agreement with theoretical predictions. We further investigate the temperature dependence of the Doppler-free Lamb-dip amplitude and linewidth over
59.03 ± 0.37 -
91.20 ± 0.90∘C in a
100 mm commercial vapor cell, identifying around
82.02 ± 0.73∘C as the optimal operating temperature, where the signal-to-noise ratio of the Lamb-dip amplitude with temperature reaches a maximum and the observed Lamb-dip linewidth exhibits a minimum. We also present precise measurements of the magnetic-dipole (
A) and electric-quadrupole (
B) hyperfine constants of the
6P3/2 state for both isotopes, with the measured values being consistent with previously reported values for the hyperfine constants.