Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Bulletin of the American Physical Society

Proposal for application of coherent control to qubit readout in circuit QED

Eran Ginossar, Lev S. Bishop, David Schuster, S. M. Girvin

Published Mar 17, 2010• 0 citations
OpenAlex

Related papers

Coherent control of two qubits in coaxial circuit QED

Andrew Patterson, Joseph Rahamim, Takahiro Tsunoda +5 more

Bulletin of the American Physical Society•Mar 7, 2018•0 citations

Coherent control in circuit QED

Alexandre Blais, Jay Gambetta, Andreas J. Wallraff +5 more

Bulletin of the American Physical Society•Mar 15, 2006•0 citations

Readout of fluxonium qubits in circuit QED

Konstantin Nesterov, Long B. Nguyen, Aaron Somoroff +7 more

Bulletin of the American Physical Society•Mar 2, 2020•0 citations

Protocol for high-fidelity readout in the photon-blockade regime of circuit QED

Eran Ginossar, Lev S. Bishop, David Schuster +1 more

The driven-damped Jaynes-Cummings model in the regime of strong coupling is found to exhibit a coexistence between the quantum photon blockaded state and a quasicoherent bright state. We characterize the slow time scales and the basin of attraction of these metastable states using full quantum simulations. This form of bistability can be useful for implementing a qubit readout scheme that does not require additional circuit elements. We propose a coherent control sequence that makes use of a simple linear chirp of drive amplitude and frequency as well as qubit frequency. By optimizing the parameters of the system and the control pulse, we demonstrate theoretically very high readout fidelities ($>$$98%$) and high contrast with experimentally realistic parameters for qubits implemented in the circuit QED architecture.

arXiv:1004.4385•Physical Review A•Aug 31, 2010•24 citations

Qubit readout enabled by qubit cloaking

Manuel H. Muñoz-Arias, Cristóbal Lledó, Alexandre Blais

Time-dependent drives play a crucial role in quantum computing efforts with circuit quantum electrodynamics. They enable single-qubit control and entangling logical operations, as well as qubit readout. However, their presence can lead to deleterious effects such as large ac-Stark shifts and unwanted qubit transitions ultimately reflected into reduced control or readout fidelities. Qubit cloaking was introduced by Lled\'o et al. [C. Lled\'o, R. Dassonneville, A. Moulinas et al., Nat. Commun. 14, 6313 (2023)] to temporarily decouple the qubit from the coherent photon population of a driven cavity, allowing for the application of arbitrary displacements to the cavity field while avoiding the deleterious effects on the qubit. For qubit readout, cloaking permits us to prearm the cavity with an, in principle, arbitrarily large number of photons, in anticipation of the qubit-state-dependent evolution of the cavity field, allowing for improved readout strategies. Here, we take a closer look at two such strategies: first, arm-and-release readout, introduced together with qubit cloaking, where after arming the cavity, the cloaking mechanism is released and the cavity field evolves under the application of a constant drive amplitude; and, second, an arm-and-longitudinal readout scheme, where the cavity drive amplitude is slowly modulated after the release. We show that the two schemes complement each other, offering an improvement over standard dispersive readout for any values of the dispersive interaction and the cavity decay rate, as well as any target measurement integration time. Our results provide a recommendation for improving qubit readout without changes to the standard circuit-QED architecture.

arXiv:2305.00895•Physical Review Applied•Nov 6, 2023•13 citations

Development of a Silicon Semiconductor Quantum Dot Qubit with Dispersive Microwave Readout

Edward Henry

Semiconductor quantum dots in silicon demonstrate exceptionally long spin lifetimes as qubits and are therefore promising candidates for quantum information processing. However, control and readout techniques for these devices have thus far employed low frequency electrons, in contrast to high speed temperature readout techniques used in other qubit architectures, and coupling between multiple quantum dot qubits has not been satisfactorily addressed.This dissertation presents the design and characterization of a semiconductor charge qubit based on double quantum dot in silicon with an integrated microwave resonator for control and readout. The 6 GHz resonator is designed to achieve strong coupling with the quantum dot qubit, allowing the use of circuit QED control and readout techniques which have not previously been applicable to semiconductor qubits. To achieve this coupling, this document demonstrates successful operation of a novel silicon double quantum dot design with a single active metallic layer and a coplanar stripline resonator with a bias tee for dc excitation.Experiments presented here demonstrate quantum localization and measurement of both electrons on the quantum dot and photons in the resonator. Further, it is shown that the resonator-qubit coupling in these devices is sufficient to reach the strong coupling regime of circuit QED. The details of a measurement setup capable of performing simultaneous low noise measurements of the resonator and quantum dot structure are also presented here.The ultimate aim of this research is to integrate the long coherence times observed in electron spins in silicon with the sophisticated readout architectures available in circuit QED based quantum information systems. This would allow superconducting qubits to be coupled directly to semiconductor qubits to create hybrid quantum systems with separate quantum memory and processing components.

•Jan 1, 2013•0 citations
The driven-damped Jaynes-Cummings model in the regime of strong coupling is found to exhibit a coexistence between the quantum photon blockaded state and a quasicoherent bright state. We characterize the slow time scales and the basin of attraction of these metastable states using full quantum simulations. This form of bistability can be useful for implementing a qubit readout scheme that does not require additional circuit elements. We propose a coherent control sequence that makes use of a simple linear chirp of drive amplitude and frequency as well as qubit frequency. By optimizing the parameters of the system and the control pulse, we demonstrate theoretically very high readout fidelities (>>>9898%98) and high contrast with experimentally realistic parameters for qubits implemented in the circuit QED architecture.
Time-dependent drives play a crucial role in quantum computing efforts with circuit quantum electrodynamics. They enable single-qubit control and entangling logical operations, as well as qubit readout. However, their presence can lead to deleterious effects such as large ac-Stark shifts and unwanted qubit transitions ultimately reflected into reduced control or readout fidelities. Qubit cloaking was introduced by Lled\'o et al. [C. Lled\'o, R. Dassonneville, A. Moulinas et al., Nat. Commun. 14, 6313 (2023)] to temporarily decouple the qubit from the coherent photon population of a driven cavity, allowing for the application of arbitrary displacements to the cavity field while avoiding the deleterious effects on the qubit. For qubit readout, cloaking permits us to prearm the cavity with an, in principle, arbitrarily large number of photons, in anticipation of the qubit-state-dependent evolution of the cavity field, allowing for improved readout strategies. Here, we take a closer look at two such strategies: first, arm-and-release readout, introduced together with qubit cloaking, where after arming the cavity, the cloaking mechanism is released and the cavity field evolves under the application of a constant drive amplitude; and, second, an arm-and-longitudinal readout scheme, where the cavity drive amplitude is slowly modulated after the release. We show that the two schemes complement each other, offering an improvement over standard dispersive readout for any values of the dispersive interaction and the cavity decay rate, as well as any target measurement integration time. Our results provide a recommendation for improving qubit readout without changes to the standard circuit-QED architecture.
Semiconductor quantum dots in silicon demonstrate exceptionally long spin lifetimes as qubits and are therefore promising candidates for quantum information processing. However, control and readout techniques for these devices have thus far employed low frequency electrons, in contrast to high speed temperature readout techniques used in other qubit architectures, and coupling between multiple quantum dot qubits has not been satisfactorily addressed.This dissertation presents the design and characterization of a semiconductor charge qubit based on double quantum dot in silicon with an integrated microwave resonator for control and readout. The 6 GHz resonator is designed to achieve strong coupling with the quantum dot qubit, allowing the use of circuit QED control and readout techniques which have not previously been applicable to semiconductor qubits. To achieve this coupling, this document demonstrates successful operation of a novel silicon double quantum dot design with a single active metallic layer and a coplanar stripline resonator with a bias tee for dc excitation.Experiments presented here demonstrate quantum localization and measurement of both electrons on the quantum dot and photons in the resonator. Further, it is shown that the resonator-qubit coupling in these devices is sufficient to reach the strong coupling regime of circuit QED. The details of a measurement setup capable of performing simultaneous low noise measurements of the resonator and quantum dot structure are also presented here.The ultimate aim of this research is to integrate the long coherence times observed in electron spins in silicon with the sophisticated readout architectures available in circuit QED based quantum information systems. This would allow superconducting qubits to be coupled directly to semiconductor qubits to create hybrid quantum systems with separate quantum memory and processing components.