Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Buffer gas cooled beams and cold molecular collisions

David Patterson

Published Jan 1, 2010• 3 citations
OpenAlex

Related papers

Cold atomic and molecular beams using buffer-gas cooling

Nathaniel Brahms, David R. Glenn, Robert deCarvalho +4 more

APS•May 1, 2004•0 citations

A new cold molecule source: The buffer gas cooled molecular beam

Jessie A. Petricka

•Jan 1, 2007•5 citations

A cryogenic buffer gas cooled beam of BaH for molecular laser cooling and ultracold fragmentation

Geoffrey Z. Iwata, Marco G. Tarallo, Fabian Sörensen +1 more

Bulletin of the American Physical Society•Jun 11, 2015•0 citations

Intense atomic and molecular beams via neon buffer-gas cooling

David Patterson, Julia Rasmussen, John M. Doyle

We realize a continuous, intense, cold molecular and atomic beam source based on buffer-gas cooling. Hot vapor (up to 600 K) from an oven is mixed with cold (15 K) neon buffer gas, and then emitted into a high-flux beam. The novel use of cold neon as a buffer gas produces a forward velocity distribution and low-energy tail that is comparable to much colder helium-based sources. We expect this source to be trivially generalizable to a very wide range of atomic and molecular species with significant vapor pressure below 1000 K. The source has properties that make it a good starting point for laser cooling of molecules or atoms, cold collision studies, trapping, or nonlinear optics in buffer-gas-cooled atomic or molecular gases. A continuous guided beam of cold deuterated ammonia with a flux of 3 × 10 11 ND 3 molecules s −1 and a continuous free-space beam of cold potassium with a flux of 1 × 10 16 K atoms s −1 are realized.

arXiv:0812.2212•New Journal of Physics•May 14, 2009•82 citations

Cooling and collisions of large gas phase molecules

David Patterson, Edem Tsikata, John M. Doyle

Cold and dense samples of naphthalene (C(10)H(8)) are produced using buffer gas cooling in combination with rapid, high flow molecule injection. The observed naphthalene density is n approximately 10(11) cm(-3) over a volume of a few cm(3) at a temperature of 6 K. We observe naphthalene-naphthalene collisions through two-body loss of naphthalene with a loss cross section of sigma(N-N) = 1.4 x 10(-14) cm(2). Analysis is presented that indicates that this combination of techniques will be applicable to many comparably sized molecules. This technique can also be combined with cryogenic beam methods(1) to produce cold, high flux, continuous molecular beams.

Physical Chemistry Chemical Physics•Jan 1, 2010•54 citations

Cold collisions of atoms and molecules

Marius Lysebo

•Jan 1, 2010•0 citations
We realize a continuous, intense, cold molecular and atomic beam source based on buffer-gas cooling. Hot vapor (up to 600 K) from an oven is mixed with cold (15 K) neon buffer gas, and then emitted into a high-flux beam. The novel use of cold neon as a buffer gas produces a forward velocity distribution and low-energy tail that is comparable to much colder helium-based sources. We expect this source to be trivially generalizable to a very wide range of atomic and molecular species with significant vapor pressure below 1000 K. The source has properties that make it a good starting point for laser cooling of molecules or atoms, cold collision studies, trapping, or nonlinear optics in buffer-gas-cooled atomic or molecular gases. A continuous guided beam of cold deuterated ammonia with a flux of 3 × 10 11 ND 3 molecules s −1 and a continuous free-space beam of cold potassium with a flux of 1 × 10 16 K atoms s −1 are realized.
Cold and dense samples of naphthalene (C(10)H(8)) are produced using buffer gas cooling in combination with rapid, high flow molecule injection. The observed naphthalene density is n approximately 10(11) cm(-3) over a volume of a few cm(3) at a temperature of 6 K. We observe naphthalene-naphthalene collisions through two-body loss of naphthalene with a loss cross section of sigma(N-N) = 1.4 x 10(-14) cm(2). Analysis is presented that indicates that this combination of techniques will be applicable to many comparably sized molecules. This technique can also be combined with cryogenic beam methods(1) to produce cold, high flux, continuous molecular beams.