Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Photonics

Single‐Molecule Detection and Spectroscopy

Michel Orrit

Published Feb 23, 2015• 1 citation
Publisher

Abstract

This chapter briefly reviews the principles of optical microscopy and of the fluorescence method, as these two techniques are the workhorses of single-molecule studies. It discusses particular implementations of the fluorescence technique and gives examples of the results that can be obtained with them. The associated technique, known as fluorescence correlation spectroscopy (FCS) is described in the chapter. In the special case of cryogenic experiments at low temperatures, much information can be obtained from fluorescence excitation spectroscopy. These conditions give rise to narrow resonance lines, which make it possible to perform highly accurate quantum optics experiments. Finally, single molecules and single nano-objects can be detected by other far-field optical techniques such as scattering or photothermal detection.

DOI
10.1002/9781119011804.ch2

Related papers

Optical Spectroscopy on Single Molecules in Solids

Daniel Walser

Experiments with single quantum systems are at the frontier of modern physics. Probing single molecules allows for very precise control of light-matter interaction and for quantum optical studies. Moreover, a single guest molecule in a solid host matrix is a very sensitive probe of local dynamics in its nano-environment. Fluorescence excitation spectroscopy on single molecules is a powerful tool for spectroscopic characterizations at highest resolution, as information can be revealed that is not accessible in experiments on ensembles of molecules. The detection of the fluorescence signal of a single absorber is achieved by exploiting the high spectral selectivity given by the ratio (10 10) of homogeneous to inhomogeneous linewidths of optical transitions at cryogenic temperatures (zero-phonon transitions). Two-photon fluorescence excitation, a fundamental nonlinear optical process, was observed on a single quantum system [1]. Single diphenyl-octatetraene molecules trapped in an n-tetradecane matrix were excited from the 1Ag ground to the lowest excited singlet state by simultaneous absorption of two photons using a single-mode cw laser. Excited molecules were observed through weak one-photon emission resulting from a symmetry breaking induced by the crystal field. The fundamental principles and the experimental technique of single molecule spectroscopy will be introduced briefly and some particular single molecule experiments presented. This work was done in collaboration with T. Plakhotnik, A. Renn and U.P. Wild

Kluwer Academic Publishers eBooks•Mar 5, 2006•1 citation

Optical Microscopy and Spectroscopy of Single Molecules

Christian Gerhard Hübner, Thomas Basché

This chapter contains sections titled: Introduction Photophysical Principles of Single-Molecule Fluorescence Detection The Single Molecule as a Three-Level System Dipole–Dipole Coupled Oscillators Weak Coupling Strong Coupling Experimental Techniques Signal-to-Noise Considerations Room-Temperature Single-Molecule Spectroscopy Epifluorescence Microscopy Total Internal Reflection (TIR) Microscopy Scanning Confocal Optical Microscopy Two-Photon-, 4π- and STED Microscopy Scanning Near-Field Optical Microscopy Single-Molecule Spectroscopy at Cryogenic Temperatures The Laser System Applications Photon Antibunching Photon Bunching Electronic Coupling Between Molecules Single Molecules as Antennas: Orientation

Wiley eBooks•Nov 25, 2005•0 citations

Single molecule spectroscopy in solids: Quantum optics and spectral dynamics

Th. Basché, Christoph Bräuchle

Abstract In recent years different microscopic and spectroscopic techniques were successfully employed to detect the fluorescence signals of single dye molecules in the condensed phase. In low temperature solids the fluorescence excitation line of a single dopant molecule is a high resolution optical probe of its local nanoenvironment. As inhomogeneous contributions and ensemble averaging are absent, many effects hidden when looking at large populations of molecules become observable. Two important research areas in single molecule spectroscopy deal with the investigation of quantum optical effects and the spectral jumping behaviour of single molecule excitation lines caused by fluctuations of two‐level systems inherent to disordered solids. Rather than delivering a complete presentation, we will focus on some selected examples which emphasize the unique features of spectroscopy with a single absorber.

Berichte der Bunsengesellschaft für physikalische Chemie•Aug 1, 1996•11 citations

Room Temperature Extinction Imaging of Single Emitters: Fluorescence-Free Detection Down to the Single Molecule Level

Michele Celebrano

Since its first development and applications in the early 1990s, single molecule detection demonstrated to be a powerful tool for a wide range of studies, ranging from biophysics to quantum optics. However, this approach has been limited so far to species with high fluorescence quantum yield. Over the past few years, we have developed extinction detection and spectroscopy as an alternative to fluorescence for investigating single nano-objects such as metallic nanoparticles, viruses, dye molecules, and quantum dots [1-5]. The contrast mechanism at work in this coherent scheme can be understood as the interference between the incident beam and the light scattered by the nano-object. We showed that the sensitivity of this technique can be pushed to detect single semiconductor nanocrystals at room temperature and measured the absorption cross section of a single quantum dot before and after photobleaching as well as during the on and off photo-blinking times [4]. Here, I will concentrate on the recent improvements of such technique which allowed the direct detection and imaging of a single molecule by optical absorption at room temperature [6, 7]. Through a transmission microscopy setup in an index-matched configuration we were able to suppress the background scattering and shot-noise fluctuations below the part per million. Additionally, by means of three distinct approaches, the residual background fluctuations produced by the environment could be suppressed to about 1 × 10 -6 RMS. This allowed us to recover the extinction/absorption dip produced by a single molecule (Terrylene Diimide, TDI) on an impinging laser beam which can be evaluated to be about 3 × 10 -6 . Thanks to these background-subtraction methods, which allowed to extract the pure absorption signal, we could also exactly determine exactly the absorption cross section of TDI [7], which turned to be in good agreement with an evaluation made upon the ensemble cross-section. In this framework, we also demonstrated that spectroscopy at the single molecule level is within reach [7]. This simple contrast technique will allow interrogating a large class of nano-object and studying the photophysics of all the species which do not fluoresce or do so with very low quantum efficiency.

•Jan 1, 2010•0 citations

Excitation spectroscopy on single molecules in solids at low temperatures

L. Fleury, H. Talon, J. Bernard +1 more

By severely reducing the number of solute molecules in the illuminated sample, the optical resonances of individual molecules can be resolved in a fluorescence excitation spectrum. Single molecule lines can be studied as a function of time and temperature: sudden jumps of their resonance frequencies are due to spectral diffusion processes. The signal from a single molecule displays specific correlations which makes time-resolved studies possible. Here, emphasis is put on photon-bunching arising from intersystem crossing (ISC). ISC rates are deduced from the observed decay rates of the correlation and are found to differ from molecule to molecule. A single molecule is a truly local probe of its environment by means of which fundamental studies of the matrix dynamics as well as nanophysics experiments may be undertaken.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Sep 24, 1993•0 citations

Looking back on 28 years of cryogenic single-molecule experiments

Michel Orrit

Starting with the first single-molecule fluorescence experiments in 1990, the field of cryogenic single-molecule spectroscopy exploits the narrow zero-phonon lines of single molecules, usually in molecular crystals and glasses. Occasionally, similar experiments can also be done at room temperature, as illustrated by the case of the NV- center in diamond. In this review contribution, I shall illustrate the variety and scope of the experiments performed in the past 28 years, highlighting some important points and outlooks.

EPJ Web of Conferences•Jan 1, 2018•0 citations
This chapter briefly reviews the principles of optical microscopy and of the fluorescence method, as these two techniques are the workhorses of single-molecule studies. It discusses particular implementations of the fluorescence technique and gives examples of the results that can be obtained with them. The associated technique, known as fluorescence correlation spectroscopy (FCS) is described in the chapter. In the special case of cryogenic experiments at low temperatures, much information can be obtained from fluorescence excitation spectroscopy. These conditions give rise to narrow resonance lines, which make it possible to perform highly accurate quantum optics experiments. Finally, single molecules and single nano-objects can be detected by other far-field optical techniques such as scattering or photothermal detection.
Experiments with single quantum systems are at the frontier of modern physics. Probing single molecules allows for very precise control of light-matter interaction and for quantum optical studies. Moreover, a single guest molecule in a solid host matrix is a very sensitive probe of local dynamics in its nano-environment. Fluorescence excitation spectroscopy on single molecules is a powerful tool for spectroscopic characterizations at highest resolution, as information can be revealed that is not accessible in experiments on ensembles of molecules. The detection of the fluorescence signal of a single absorber is achieved by exploiting the high spectral selectivity given by the ratio (10 10) of homogeneous to inhomogeneous linewidths of optical transitions at cryogenic temperatures (zero-phonon transitions). Two-photon fluorescence excitation, a fundamental nonlinear optical process, was observed on a single quantum system [1]. Single diphenyl-octatetraene molecules trapped in an n-tetradecane matrix were excited from the 1Ag ground to the lowest excited singlet state by simultaneous absorption of two photons using a single-mode cw laser. Excited molecules were observed through weak one-photon emission resulting from a symmetry breaking induced by the crystal field. The fundamental principles and the experimental technique of single molecule spectroscopy will be introduced briefly and some particular single molecule experiments presented. This work was done in collaboration with T. Plakhotnik, A. Renn and U.P. Wild
This chapter contains sections titled: Introduction Photophysical Principles of Single-Molecule Fluorescence Detection The Single Molecule as a Three-Level System Dipole–Dipole Coupled Oscillators Weak Coupling Strong Coupling Experimental Techniques Signal-to-Noise Considerations Room-Temperature Single-Molecule Spectroscopy Epifluorescence Microscopy Total Internal Reflection (TIR) Microscopy Scanning Confocal Optical Microscopy Two-Photon-, 4π- and STED Microscopy Scanning Near-Field Optical Microscopy Single-Molecule Spectroscopy at Cryogenic Temperatures The Laser System Applications Photon Antibunching Photon Bunching Electronic Coupling Between Molecules Single Molecules as Antennas: Orientation
Abstract In recent years different microscopic and spectroscopic techniques were successfully employed to detect the fluorescence signals of single dye molecules in the condensed phase. In low temperature solids the fluorescence excitation line of a single dopant molecule is a high resolution optical probe of its local nanoenvironment. As inhomogeneous contributions and ensemble averaging are absent, many effects hidden when looking at large populations of molecules become observable. Two important research areas in single molecule spectroscopy deal with the investigation of quantum optical effects and the spectral jumping behaviour of single molecule excitation lines caused by fluctuations of two‐level systems inherent to disordered solids. Rather than delivering a complete presentation, we will focus on some selected examples which emphasize the unique features of spectroscopy with a single absorber.
Since its first development and applications in the early 1990s, single molecule detection demonstrated to be a powerful tool for a wide range of studies, ranging from biophysics to quantum optics. However, this approach has been limited so far to species with high fluorescence quantum yield. Over the past few years, we have developed extinction detection and spectroscopy as an alternative to fluorescence for investigating single nano-objects such as metallic nanoparticles, viruses, dye molecules, and quantum dots [1-5]. The contrast mechanism at work in this coherent scheme can be understood as the interference between the incident beam and the light scattered by the nano-object. We showed that the sensitivity of this technique can be pushed to detect single semiconductor nanocrystals at room temperature and measured the absorption cross section of a single quantum dot before and after photobleaching as well as during the on and off photo-blinking times [4]. Here, I will concentrate on the recent improvements of such technique which allowed the direct detection and imaging of a single molecule by optical absorption at room temperature [6, 7]. Through a transmission microscopy setup in an index-matched configuration we were able to suppress the background scattering and shot-noise fluctuations below the part per million. Additionally, by means of three distinct approaches, the residual background fluctuations produced by the environment could be suppressed to about 1 × 10 -6 RMS. This allowed us to recover the extinction/absorption dip produced by a single molecule (Terrylene Diimide, TDI) on an impinging laser beam which can be evaluated to be about 3 × 10 -6 . Thanks to these background-subtraction methods, which allowed to extract the pure absorption signal, we could also exactly determine exactly the absorption cross section of TDI [7], which turned to be in good agreement with an evaluation made upon the ensemble cross-section. In this framework, we also demonstrated that spectroscopy at the single molecule level is within reach [7]. This simple contrast technique will allow interrogating a large class of nano-object and studying the photophysics of all the species which do not fluoresce or do so with very low quantum efficiency.
By severely reducing the number of solute molecules in the illuminated sample, the optical resonances of individual molecules can be resolved in a fluorescence excitation spectrum. Single molecule lines can be studied as a function of time and temperature: sudden jumps of their resonance frequencies are due to spectral diffusion processes. The signal from a single molecule displays specific correlations which makes time-resolved studies possible. Here, emphasis is put on photon-bunching arising from intersystem crossing (ISC). ISC rates are deduced from the observed decay rates of the correlation and are found to differ from molecule to molecule. A single molecule is a truly local probe of its environment by means of which fundamental studies of the matrix dynamics as well as nanophysics experiments may be undertaken.
Starting with the first single-molecule fluorescence experiments in 1990, the field of cryogenic single-molecule spectroscopy exploits the narrow zero-phonon lines of single molecules, usually in molecular crystals and glasses. Occasionally, similar experiments can also be done at room temperature, as illustrated by the case of the NV- center in diamond. In this review contribution, I shall illustrate the variety and scope of the experiments performed in the past 28 years, highlighting some important points and outlooks.