Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Quarterly Report

Applications of Josephson Junction SQUIDs and Arrays.

Arnold H. Silver

Published Jan 15, 1982• 0 citations
OpenAlex

Abstract

This is a new contract for a projected multi-year investigation of Superconducting Quantum Interference Device (SQUID) arrays and their application to microwave technology. The focus of this contract is the investigation and demonstration of a SQUID voltage-controlled oscillator (VCO). The array is then projected to increase the available power and operating impedance. The approach adopted will utilize monolithic superconducting integrated circuits which will be designed, fabricated, and tested at TRW. The project has three tasks: (1) Analysis of dc SQUID Arrays; (2) Design of dc SQUID Generator; and (3) SQUID VCO Fabrication and Measurement which are being carried out.

Related papers

Applications of Josephson junction SQUIDs Superconducting Quantum Interference Device) and Arrays

Arnold H. Silver

This is the first Annual Report for an effort to demonstrate the application of SQUIDs (Superconducting Quantum Interference Device) and SQUID arrays to microwave systems. The application considered here is a microwave voltage-controlled oscillator. We report on the circuit design, numerical simulation, experimental design, and fabrication of the device including tests of the monolithic impedance transformer. Predicted available power is approximately 10 nW into a load impedance of ohm.

•Nov 1, 1982•0 citations

SQUID voltage-controlled-oscillator

Arnold H. Silver, Robert D. Sandell, J. Wilcox

We have investigated the SQUID as a voltage-controlled source of microwaves. The low impedance "resistive" SQUID can be a relatively high power (\sim nW), tunable, and monochromatic source for both on-chip and off-chip applications. Studies of the time-dependent junction phase and the available power spectra as they vary with such device parameters as loaded Q and the SQUID-β= 2πLic/φoestablish design rules for a well-behaved oscillator. For a VCO βQ\beta Q\geq2degenerate parametric subharmonic oscillations and chaotic instabilities are observed. Power increase is suggested by the use of voltage-clamped dc SQUIDs and arrays.

IEEE Transactions on Magnetics•May 1, 1983•6 citations

Demonstration of SQUID (Superconducting Quantum Interference Device) parametric amplifier. Interim report 1 Oct 83-15 Mar 84

Arnold H. Silver, Robert D. Sandell, Reggie Phillips +1 more

TRW has been developing low noise microwave parametric amplifier with Josephson junction SQUIDs (Superconducting Quantum Interference Devices). This report summarizes the second phase of the program which includes measurement of the amplifier performance at X-band, and design and fabrication of a SQUID array amplifier. We have demonstrated gain in excess of 10 dB at 8.4 GHz and a measured noise temperature equal to 6K with an uncertainty of (+15/-7)K. Arrays with both 25 and 50 elements and 50 ohmi impedance have been designed and fabricated. These arrays should increase the dynamic range of the amplifier.

•May 15, 1984•0 citations

Controllable π SQUID

J. J. A. Baselmans, Bart Jan van Wees, T. M. Klapwijk

We have fabricated and studied a promising kind of direct current superconducting quantum interference device (dc-SQUID) in which the magnitude and sign of the critical current of the individual Josephson junctions can be controlled by additional voltage probes connected to the junctions. We show that the amplitude of the voltage oscillations of the SQUID as a function of the applied magnetic field can be tuned and that the phase of the oscillations can be switched between 0 and π in the temperature range of 0.1–4.2 K using a suitable control voltage. This is equivalent to the external application of (n+1/2) flux quantum.

arXiv:cond-mat/0107292•Applied Physics Letters•Oct 29, 2001•28 citations

Quasioptical Josephson oscillator

Michael J. Wengler, A. Pance, B. Liu +1 more

Work with large two-dimensional arrays of Josephson junctions for submillimeter power generation is discussed. The basic design of the quasioptical Josephson oscillator (QJO) is presented. The reasons for each design decision are discussed. Superconducting devices have not yet been fabricated, but scale models and computer simulations have been done. A novel method for characterizing array RF coupling structures is described, and initial results with this model are presented. Microwave scale models of the radiation structure were built, and a series of measurements was made with a network analyzer. These measurements were summed in a computer to find properties of the structure when all elements in it are operating in phase. The goal of these measurements was to develop structures for oscillators which are tunable over a very broad band. Computer programs simulating a Josephson junction in any frequency-dependent coupling structure have been developed. An iterative harmonic balance technique finds the time-domain current and voltage waveforms across the junction for an arbitrary frequency-dependent RF load impedance. DC bias, and therefore oscillator frequency, can be held fixed in this technique, in contrast to time-domain techniques where the oscillation frequency is found after the waveform is found. With these programs design goals for maximum oscillator power and design limits to achieve tolerable harmonic distortion were found.

IEEE Transactions on Magnetics•Mar 1, 1991•18 citations

Submillimeter Quasioptical Josephson Junction Oscillator with Integrated Tuning Elements

A. Pance, Andrew T. Barfknecht

The goal of this program was to demonstrate a Quasioptical Josephson Oscillator with Integrated Tuning Elements using standard Conductus niobium technology. This device is based on a novel approach that incorporates integrated tuning and impedance-matching structures at every Josephson junction/ antenna pair. The device has been designed, fabricated and successfully tested. A new, unit cell has been devised, incorporating a sub-array of 1 to 16 Josephson junctions. Microstrip transformers are used locally between each sub- array and its antenna. The oscillator with 110 Josephson junctions and bow-tie antennas was found to radiate close to its maximum available power at 115 GHz. The on-chip SIS radiation detector has detected 2.64 nW of power. The oscillator was tuned across 19 GHz, or 16% of fractional bandwidth, in reasonable agreement with the predicted value of 19%. This is the first demonstration of a distributed array Josephson oscillator, where each junction feeds its own antenna and phase-locks to the radiation of other junctions. It is also the first demonstration of using integrated microstrip tuning and impedance matching elements at every Josephson junction of an oscillator. Finally, this is the first distributed Josephson oscillator reported to date that appears to radiate close to its maximum available power. Submillimeter, Oscillators, Antenna arrays, Superconducting electronics, Quasioptical.

Final Report•Apr 30, 1994•0 citations
This is a new contract for a projected multi-year investigation of Superconducting Quantum Interference Device (SQUID) arrays and their application to microwave technology. The focus of this contract is the investigation and demonstration of a SQUID voltage-controlled oscillator (VCO). The array is then projected to increase the available power and operating impedance. The approach adopted will utilize monolithic superconducting integrated circuits which will be designed, fabricated, and tested at TRW. The project has three tasks: (1) Analysis of dc SQUID Arrays; (2) Design of dc SQUID Generator; and (3) SQUID VCO Fabrication and Measurement which are being carried out.
We have investigated the SQUID as a voltage-controlled source of microwaves. The low impedance "resistive" SQUID can be a relatively high power (\sim nW), tunable, and monochromatic source for both on-chip and off-chip applications. Studies of the time-dependent junction phase and the available power spectra as they vary with such device parameters as loaded Q and the SQUID-β= 2πLic/φoestablish design rules for a well-behaved oscillator. For a VCO βQ\beta Q\geq2degenerate parametric subharmonic oscillations and chaotic instabilities are observed. Power increase is suggested by the use of voltage-clamped dc SQUIDs and arrays.
TRW has been developing low noise microwave parametric amplifier with Josephson junction SQUIDs (Superconducting Quantum Interference Devices). This report summarizes the second phase of the program which includes measurement of the amplifier performance at X-band, and design and fabrication of a SQUID array amplifier. We have demonstrated gain in excess of 10 dB at 8.4 GHz and a measured noise temperature equal to 6K with an uncertainty of (+15/-7)K. Arrays with both 25 and 50 elements and 50 ohmi impedance have been designed and fabricated. These arrays should increase the dynamic range of the amplifier.
We have fabricated and studied a promising kind of direct current superconducting quantum interference device (dc-SQUID) in which the magnitude and sign of the critical current of the individual Josephson junctions can be controlled by additional voltage probes connected to the junctions. We show that the amplitude of the voltage oscillations of the SQUID as a function of the applied magnetic field can be tuned and that the phase of the oscillations can be switched between 0 and π in the temperature range of 0.1–4.2 K using a suitable control voltage. This is equivalent to the external application of (n+1/2) flux quantum.
Work with large two-dimensional arrays of Josephson junctions for submillimeter power generation is discussed. The basic design of the quasioptical Josephson oscillator (QJO) is presented. The reasons for each design decision are discussed. Superconducting devices have not yet been fabricated, but scale models and computer simulations have been done. A novel method for characterizing array RF coupling structures is described, and initial results with this model are presented. Microwave scale models of the radiation structure were built, and a series of measurements was made with a network analyzer. These measurements were summed in a computer to find properties of the structure when all elements in it are operating in phase. The goal of these measurements was to develop structures for oscillators which are tunable over a very broad band. Computer programs simulating a Josephson junction in any frequency-dependent coupling structure have been developed. An iterative harmonic balance technique finds the time-domain current and voltage waveforms across the junction for an arbitrary frequency-dependent RF load impedance. DC bias, and therefore oscillator frequency, can be held fixed in this technique, in contrast to time-domain techniques where the oscillation frequency is found after the waveform is found. With these programs design goals for maximum oscillator power and design limits to achieve tolerable harmonic distortion were found.
The goal of this program was to demonstrate a Quasioptical Josephson Oscillator with Integrated Tuning Elements using standard Conductus niobium technology. This device is based on a novel approach that incorporates integrated tuning and impedance-matching structures at every Josephson junction/ antenna pair. The device has been designed, fabricated and successfully tested. A new, unit cell has been devised, incorporating a sub-array of 1 to 16 Josephson junctions. Microstrip transformers are used locally between each sub- array and its antenna. The oscillator with 110 Josephson junctions and bow-tie antennas was found to radiate close to its maximum available power at 115 GHz. The on-chip SIS radiation detector has detected 2.64 nW of power. The oscillator was tuned across 19 GHz, or 16% of fractional bandwidth, in reasonable agreement with the predicted value of 19%. This is the first demonstration of a distributed array Josephson oscillator, where each junction feeds its own antenna and phase-locks to the radiation of other junctions. It is also the first demonstration of using integrated microstrip tuning and impedance matching elements at every Josephson junction of an oscillator. Finally, this is the first distributed Josephson oscillator reported to date that appears to radiate close to its maximum available power. Submillimeter, Oscillators, Antenna arrays, Superconducting electronics, Quasioptical.