Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEICE Transactions on Electronics

Flux-Quantum Transitions in a Three-Junction SQUID Controlled by Two RF Signals

Yoshinao Mizugaki

Published Mar 1, 2002• 2 citations
OpenAlex

Related papers

Two-Junction SQUID Controlled by Both DC and RF Magnetic Flux

Yoshinao Mizugaki, Kei Saito, Tadayuki Kondo +4 more

Springer eBooks•Jan 1, 2000•0 citations

Quantum transitions and zero-crossing current steps in a SQUID controlled by multi-phase RF fields

Yoshinao Mizugaki, Jian Chen, Kensuke Nakajima +1 more

Physica C Superconductivity•Aug 1, 2002•1 citation

Zero-crossing shapiro step in a three-junction SQUID magnetically coupled with two phase-shifted RF signals

Yoshinao Mizugaki, Jian Chen, S. Nishikata +3 more

We demonstrate a zero-crossing Shapiro step in a three-junction SQUID (3J-SQUID) coupled with two phase-shifted RF signals. The operation is based on periodic flux quantum transitions in the 3J-SQUID under the zero- and negatively-biasing conditions. A test circuit is fabricated using a Nb/AlO/sub x//Nb junction technology. When we feed RF signals up to 10.5 GHz, we observe a Shapiro step crossing the zero-current axis at the voltage position of the 1st order. The experimental current-voltage characteristics are quantitatively reproduced by simulation. Zero-crossing conditions for the DC offset flux and the RF power are obtained experimentally, which is also confirmed by simulation. A programmable Josephson voltage standard is discussed as one of the possible applications.

IEEE Transactions on Applied Superconductivity•Jun 1, 2003•3 citations

Zero-Crossing Shapiro Step in Asymmetric Two-Junction Superconducting Quantum Interference Device

Yoshinao Mizugaki, Kazuyuki Katoh, Masataka Moriya +2 more

We demonstrate a zero-crossing Shapiro step in an asymmetric two-junction superconducting quantum interference device (SQUID) driven by one sinusoidal RF signal. The operation is based on the imbalanced evolution of the junction phases due to the tilted interference diagrams. A test circuit was fabricated using Nb/AlO x /Nb junction technology. When we applied an RF signal of 10 GHz, we observed a Shapiro step crossing the zero-current axis at the voltage position of the first order. The polarity of the step voltage was switched by a DC control flux to the SQUID loop. The experimental current–voltage curves were quantitatively reproduced by simulation.

Japanese Journal of Applied Physics•Jun 16, 2006•3 citations

Controlled Stochastic Amplification of a Weak Signal in a Superconducting Quantum Interferometer

Oleg G. Turutanov, V. Yu. Lyakhno, M. E. Pivovar +1 more

In a single-junction niobium superconducting quantum interferometer (RF SQUID loop), a weak low-frequency harmonic signal is amplified when quasi-white Gaussian noise magnetic flux is applied to the loop; such amplification is due to stochastic resonance (SR). We have experimentally shown that if the suboptimal flux noise intensity is insufficient for SR, the mean rate of transitions between the metastable states of the loop, and thus the signal gain, can be controlled by an additional deterministic alternating magnetic flux with frequency being much higher than that of the useful signal to provide the maximal possible gain. The frequency characteristics of a multi-tone composite signal amplification in the cases of controlled stochastic amplification and “pure” SR are compared to each other.

Low Temperature Physics•Jan 1, 2019•3 citations

Quantum transitions in a two-hole SQUID

N. F. Masharov

•Jul 1, 1978•0 citations
We demonstrate a zero-crossing Shapiro step in a three-junction SQUID (3J-SQUID) coupled with two phase-shifted RF signals. The operation is based on periodic flux quantum transitions in the 3J-SQUID under the zero- and negatively-biasing conditions. A test circuit is fabricated using a Nb/AlO/sub x//Nb junction technology. When we feed RF signals up to 10.5 GHz, we observe a Shapiro step crossing the zero-current axis at the voltage position of the 1st order. The experimental current-voltage characteristics are quantitatively reproduced by simulation. Zero-crossing conditions for the DC offset flux and the RF power are obtained experimentally, which is also confirmed by simulation. A programmable Josephson voltage standard is discussed as one of the possible applications.
We demonstrate a zero-crossing Shapiro step in an asymmetric two-junction superconducting quantum interference device (SQUID) driven by one sinusoidal RF signal. The operation is based on the imbalanced evolution of the junction phases due to the tilted interference diagrams. A test circuit was fabricated using Nb/AlO x /Nb junction technology. When we applied an RF signal of 10 GHz, we observed a Shapiro step crossing the zero-current axis at the voltage position of the first order. The polarity of the step voltage was switched by a DC control flux to the SQUID loop. The experimental current–voltage curves were quantitatively reproduced by simulation.
In a single-junction niobium superconducting quantum interferometer (RF SQUID loop), a weak low-frequency harmonic signal is amplified when quasi-white Gaussian noise magnetic flux is applied to the loop; such amplification is due to stochastic resonance (SR). We have experimentally shown that if the suboptimal flux noise intensity is insufficient for SR, the mean rate of transitions between the metastable states of the loop, and thus the signal gain, can be controlled by an additional deterministic alternating magnetic flux with frequency being much higher than that of the useful signal to provide the maximal possible gain. The frequency characteristics of a multi-tone composite signal amplification in the cases of controlled stochastic amplification and “pure” SR are compared to each other.