Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Advances in quantum chemistry

Atoms in Optical Lattices: Cooling, Trapping and Squeezing Atoms with Light

William D. Phillips

Published Jan 1, 1998• 1 citation
Publisher
DOI
10.1016/s0065-3276(08)60501-8

Related papers

Setup of a Transportable Yb Optical Lattice Clock

C. Abou-Jaoudeh

In this thesis, a transportable setup of an Yb atomic source for a lattice optical clock is built and characterized. All three laser setups for cooling and trapping the Yb atoms, together with the vacuum system, are contained on a transportable optical table. The preparation of the atomic sample before doing spectroscopy on the clock transition starts by slowing the atoms in the Zeeman slower. This is followed by trapping the atoms in the pre-cooling and the post-cooling MOTs, before loading the atoms into the optical lattice. Slowing and pre-cooling the atoms is done using the strong transition at 399 nm. This cools the atoms down to around a mK. To successfully load the atoms in the optical lattice, we have to cool the atoms further to beyond 50 μK. This is done by exciting the weak transition at 556 nm. The atoms that are transferred into the post-cooling stage are cooled down to a few tens of μK. The atoms are then ready to be loaded into the optical lattice at the magic wavelength. The amplified laser light at 760 nm inside the 1-D intra-vacuum cavity results in a lattice trapping potential of approximately 50 μK. A transfer efficiency, from the MOT into the optical lattice, of more than 25% was measured. The spectroscopy on the clock transition was done for 171Yb. A step-by-step mechanism was adopted, starting by exciting the forbidden transition at 578 nm inside the post-cooling stage MOT, by using the ”chopped-MOT” method. The 300 kHz Doppler-broadened line is then narrowed down to 3 kHz by switching on the light at 760 nm, while keeping the MOT on. The so-called ”chopped-lattice” technique helped suppress the Doppler-broadening; however the other effects due to the light and the magnetic fields of the MOT were still present. By switching off the MOT’s light and magnetic fields, the Yb atoms are completely trapped in the optical lattice. As a result, the FWHM of the spectroscopy line was reduced by a factor of 10.

•Jan 1, 2016•0 citations

Cooling and diffusion of atoms in optical lattices

Laurent Sanchez-Palencia, G. Grynberg

•Nov 1, 2000•0 citations

Cold Atoms in Optical Lattices

W. Zwerger

Advances in solid state physics•Dec 7, 2004•8 citations

Laser cooling at high density in deep far-detuned optical lattices

S. Lukman Winoto, Marshall T. DePue, Nathan E. Bramall +1 more

We report a way to overcome heating due to the reabsorption of scattered light when relatively many atoms are laser cooled at high density. A sample of $8\ifmmode\times\else\texttimes\fi{}{10}^{7}\mathrm{Cs}$ atoms, with $6\ifmmode\times\else\texttimes\fi{}{10}^{11}{\mathrm{atoms}\mathrm{}\mathrm{cm}}^{\mathrm{\ensuremath{-}}3},$ is loaded into a deep far-detuned one-dimensional optical lattice, which acts as a large volume three-dimensional (3D) trap. Polarization gradient cooling with a separate set of cooling beams is found to work well in this trap, populating the trap's vibrational ground state with more than half the atoms. After cooling, the lattice is shut off adiabatically, leaving a still dense sample at 1.2 \ensuremath{\mu}K. We propose and demonstrate a generalization to a 3D lattice, which will allow many more atoms to be loaded into conservative light traps, and can greatly increase the initial phase-space density for loading magnetic traps.

Physical Review A•Jan 1, 1999•72 citations

Experiments with Cold Atoms in Optical Lattices

William D. Phillips

AIP conference proceedings•Jan 1, 2005•0 citations

Characterization of a two-color magneto-optical trap for a spin-squeezed optical lattice clock

Qinqin Yu

We experimentally realize a magneto-optical trap (MOT) for ytterbium that simultaneously scatters light from two atomic transitions, in order to reduce the minimum magnetic field gradient required for trapping atoms. From the experimental data, we propose a model of the MOT where one transition is responsible for trapping the atoms the other transition is responsible for cooling the atoms. In order to test this model and to better understand the dynamics of this two-color MOT, we perform numerical simulations of the contributions of each transition to the steady-state number of trapped atoms. We then compare the results of the simulations with the experimental results and conclude that the model of the separated trapping and cooling functions is a good model for the two-color MOT. Finally, we examine other elements for which the two-color MOT is possible and derive a condition for the linewidths of the two transitions such that the atoms are trapped.

•Jan 1, 2015•0 citations
In this thesis, a transportable setup of an Yb atomic source for a lattice optical clock is built and characterized. All three laser setups for cooling and trapping the Yb atoms, together with the vacuum system, are contained on a transportable optical table. The preparation of the atomic sample before doing spectroscopy on the clock transition starts by slowing the atoms in the Zeeman slower. This is followed by trapping the atoms in the pre-cooling and the post-cooling MOTs, before loading the atoms into the optical lattice. Slowing and pre-cooling the atoms is done using the strong transition at 399 nm. This cools the atoms down to around a mK. To successfully load the atoms in the optical lattice, we have to cool the atoms further to beyond 50 μK. This is done by exciting the weak transition at 556 nm. The atoms that are transferred into the post-cooling stage are cooled down to a few tens of μK. The atoms are then ready to be loaded into the optical lattice at the magic wavelength. The amplified laser light at 760 nm inside the 1-D intra-vacuum cavity results in a lattice trapping potential of approximately 50 μK. A transfer efficiency, from the MOT into the optical lattice, of more than 25% was measured. The spectroscopy on the clock transition was done for 171Yb. A step-by-step mechanism was adopted, starting by exciting the forbidden transition at 578 nm inside the post-cooling stage MOT, by using the ”chopped-MOT” method. The 300 kHz Doppler-broadened line is then narrowed down to 3 kHz by switching on the light at 760 nm, while keeping the MOT on. The so-called ”chopped-lattice” technique helped suppress the Doppler-broadening; however the other effects due to the light and the magnetic fields of the MOT were still present. By switching off the MOT’s light and magnetic fields, the Yb atoms are completely trapped in the optical lattice. As a result, the FWHM of the spectroscopy line was reduced by a factor of 10.
We report a way to overcome heating due to the reabsorption of scattered light when relatively many atoms are laser cooled at high density. A sample of $8\ifmmode\times\else\texttimes\fi{}{10}^{7}\mathrm{Cs}$ atoms, with $6\ifmmode\times\else\texttimes\fi{}{10}^{11}{\mathrm{atoms}\mathrm{}\mathrm{cm}}^{\mathrm{\ensuremath{-}}3},$ is loaded into a deep far-detuned one-dimensional optical lattice, which acts as a large volume three-dimensional (3D) trap. Polarization gradient cooling with a separate set of cooling beams is found to work well in this trap, populating the trap's vibrational ground state with more than half the atoms. After cooling, the lattice is shut off adiabatically, leaving a still dense sample at 1.2 \ensuremath{\mu}K. We propose and demonstrate a generalization to a 3D lattice, which will allow many more atoms to be loaded into conservative light traps, and can greatly increase the initial phase-space density for loading magnetic traps.
We experimentally realize a magneto-optical trap (MOT) for ytterbium that simultaneously scatters light from two atomic transitions, in order to reduce the minimum magnetic field gradient required for trapping atoms. From the experimental data, we propose a model of the MOT where one transition is responsible for trapping the atoms the other transition is responsible for cooling the atoms. In order to test this model and to better understand the dynamics of this two-color MOT, we perform numerical simulations of the contributions of each transition to the steady-state number of trapped atoms. We then compare the results of the simulations with the experimental results and conclude that the model of the separated trapping and cooling functions is a good model for the two-color MOT. Finally, we examine other elements for which the two-color MOT is possible and derive a condition for the linewidths of the two transitions such that the atoms are trapped.