A photon number resolving detector is a fundamental device for realizing quantum computing, to say nothing of improving quantum key distribution. It is considered possible to establish a multipurpose optical quantum computer by combining of a photon number resolving detector and non‐classical light such as a single photon or squeezed light in a feedback system. We are developing a photon number resolving detector at the telecommunication wavelength of 1.5 μm, in which the attenuation ratio of optical fiber is minimum. We adopt a InGaAs pin photodiode and a GaAs JFET in a charge integration amplifier, that is cooled to 4.2 K to reduce thermal noise and leak current.
A photon number resolving detector is a fundamental device for realizing quantum computing, to say nothing of improving quantum key distribution. It is considered possible to establish a multipurpose optical quantum computer by combining of a photon number resolving detector and non‐classical light such as a single photon or squeezed light in a feedback system. We are developing a photon number resolving detector at the telecommunication wavelength of 1.5 μm, in which the attenuation ratio of optical fiber is minimum. We adopt a InGaAs pin photodiode and a GaAs JFET in a charge integration amplifier, that is cooled to 4.2 K to reduce thermal noise and leak current.
We present a charge integration photon detector (CIPD) that enables the efficient measurement of photon number states at the telecom-fiber wavelengths with a quantum efficiency of 80% and a resolution less than 0.5 electrons at 1Hz sampling. The CIPD consists of an InGaAs pin photodiode and a GaAs JFET in a charge integration amplifier, which is cooled to 4.2K to reduce thermal noise and leakage current. The charge integration amplifier exhibits a low noise level of 470nV∕Hz1∕2. The dark count is as low as 500electrons∕h.
Standard linear optical detectors have a maximum sensitivity in the few hundreds of photons range, limited by amplifier noise. On the other hand, single photon detectors, which are the most sensitive detectors, are strongly nonlinear: One or more photons result in the same output signal. Photon number resolving (PNR) detectors, which have the ability to discriminate the number of photons in a weak optical pulse, are of great importance in the field of quantum information processing and quantum cryptography. Moreover, a PNR detector with large dynamic range can cover the gap between these two detection modes. Such detectors are greatly desirable not only in quantum information science and technology, but also in any application dealing with low light levels. In this work, we propose a novel approach to photon number resolving detectors based on spatial multiplexing of nanowire superconducting single-photon detectors. In the proposed approach, N superconducting nanowires, each connected in parallel to an integrated resistor, are connected in series. Photon absorption in a nanowire switches its bias current to the parallel resistor, forming a voltage pulse across it. The sum of these voltages, proportional to the number of absorbed photons, is measured at the output. The use of a cryogenic preamplifier with high input impedance for the read-out increases the linearity, the signal to noise ratio, and the speed. With this combination, we expect to be able to count up to few tens of photons with high fidelity, excellent timing resolution, and very high sensitivity in the telecommunication wavelength range.
The conventional optical detectors operate in a linear mode, but their sensitivity is limited due to the noise in the readout electronics. Single photon detectors, on the other hand, have the highest sensitivity, but are strongly nonlinear. Photon number resolving detectors, which can precisely determine the number of photons in weak optical pulses, are potential candidates to fill the gap between these two detection modes. We present the design of photon number resolving detectors with large dynamic range, based on spatial multiplexing of superconducting single photon detectors, with excellent timing resolution and very high sensitivity at the telecommunication wavelength range.
In quantum optical computing and quantum cryptography a very important problem is that of developing an efficient photon-number resolving detector. Such a device is critical for the development of linear optical quantum computing (LOQC) [1], and can be also used in quantum cryptography [2]. A recent paper claims to have demonstrated the operation of a superconducting, number-resolving photon detector, developed by a group at NIST [3]. However, this device operates with a quantum efficiency of only about 20%, and we show here that it cannot discriminate photon number, even in principal. However, the NIST device has a very low dark-count rate, much less than 1%, which means that it can quite efficiently discriminate against the absence of photons of particular numbers. We call such a device a number-discriminating non-photon detector. Interestingly enough, even though this detector cannot yield photon number—its ability to discriminate against photons of certain numbers allows it to be used, under suitable assumptions, to reconstruct the ensemble photostatistics of the incoming photon field. However, such a low-efficiency device cannot be used, say, in LOQC, where single-shot photon number discrimination is required.
We provide a direct comparison between the InGaAs avalanche photodiode (APD) and the NbN superconducting single photon detector (SSPD) for applications in fiber-based quantum cryptography. The quantum efficiency and dark count rate were measured for each detector, and used to calculate the quantum bit error rate (QBER) and shared key rate for a QKD link. The results indicate that, despite low quantum efficiency, the speed of the SSPD makes it a superior detector for quantum information applications. Finally, we present results of an initial integration of an SSPD into a receiver node of the DARPA quantum network to perform quantum key distribution. Encoding quantum information on single photons has enabled the realization of a number of unique communication schemes such as the implementation of the BB84 protocol for quantum key distribution 1 and quantum dense coding. 2 Furthermore, the implementation of these schemes using photons at telecommunication wavelengths has permitted their extension to fiber optic networks, 3,4 drastically increasing the practicality of quantum information processing. To date, the state of the art in commercially available single photon detection at telecommunication wavelengths (1550 nm) has been the thermo-electrically cooled InGaAs avalanche photodiode (APD). The cooled InGaAs APD is generally operated at T = -60°C in the reverse-biased Geiger mode. Though these detectors have been successfully implemented in operating QKD links in optical fiber, the InGaAs APD suffers from afterpulsing effects that limit the key exchange rates. New SPD (single photon detector) technologies based on superconducting materials are emerging that hold tremendous promise for drastically increasing the photon counting rate and eliminating dark noise.57 The SSPD consists of a NbN thin film (t ∼ 5 nm) patterned into a narrow (w ∼ 100 nm) microstrip meander that is ∼ 500μm in length. The detector is cooled to T < 4K in a closed cycle refrigeration unit and a bias current I b is supplied to the device just below the superconducting critical current (I c ). When a photon is incident upon the microstrip superconductivity is broken in the region local to photon absorption and a normal state region is formed in the device. The current passing through the device causes a measurable voltage pulse in the detector that can be amplified and shaped to act as an input for traditional logic circuitry. Due to the unique electronic bandstructure in a superconducting material the intrinsic response time of the device is on the order of picoseconds, so that the repetition rate may be increased above 1 GHz 8 without being susceptible to afterpulsing effects that plague the InGaAs APD. 9 To make a direct comparison between the InGaAs APD and the SSPD both were placed in a SPD characterization testbed to measure quantum efficiency and dark count rate at a variety of bias conditions. The QBER for a QKD link is calculated from the measured parameters and then compared to requirements for a provably secure QKD link. Following detector characterization, one of the nodes of the DARPA Quantum Network operated by BBN Technologies 3 utilized an SSPD in the receiver to transmit key material. The demonstration provides an in situ comparison between the InGaAs APD, normally operated in the BBN link, and the SSPD.