Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Photoexcitation and cooling of positronium

CHARLES D. DERMER, Richard H. Howell, K. M. Jones, Edison Liang, F. Magnotta, Klaus P. Ziock

Published Aug 1, 1988• 0 citations
OpenAlex

Abstract

Our demonstration of multiple-photon resonant cycling between the 1/sup 3/S and 2/sup 3/P states of ortho-Positronium (oPs) makes possible the production of cold positronium (Ps) through the technique of laser cooling. A simplified analysis of magnetic mixing in excited-state Ps is given. This effect is important both as a diagnostic of resonant cycling and Ps cooling. The significance of cold Ps in fine structure measurements and the formation of a Bose-Einstein condensate is discussed. 13 refs., 3 figs.

Related papers

Laser Excitation of Positronium in the Paschen-Back Regime

D. B. Cassidy, T. H. Hisakado, Harry W. K. Tom +1 more

Zeeman mixing of singlet and triplet 2P states of positronium (Ps) atoms, followed by decay back to the ground state, can effectively turn a long-lived triplet atom into a short-lived singlet state, which would seem to preclude laser cooling of Ps in a magnetic field. Here we report experiments which show that, in fact, because of the large splitting of the n=2 states in a high magnetic field (the Paschen-Back regime), the amount of such mixing diminishes approximately exponentially with an increasing magnetic field >0.01 T and is essentially eliminated above ∼2 T. Thus, laser cooling of Ps should be feasible at high fields, which will facilitate the production of a Ps Bose-Einstein condensate.

Physical Review Letters•Apr 28, 2011•24 citations

LASER COOLING OF ORTHO-POSITRONIUM: TOWARD REALIZATION OF BOSE-EINSTEIN CONDENSATION

T. Hirose, Takashi Asonuma, H. Iijima +8 more

Experimental and theoretical investigations of laser cooling of ortho-Positronium (o-Ps) are reported and feasibilities of Bose-Einstein condensation are discussed. It is shown that in spite of the short lifetime of o-Ps, i.e. 142 nsec, thermally produced o-Ps with a room temperature 300 K can be cooled down to the recoil limit of 0.1 K by ultraviolet laser with a wave-length of 243 nm corresponding to the 1S-2P transition energy of o-Ps. In order to conduct proof-of-principle experiments, we have constructed a laser cooling facility which consists of a slow positron beam generator and a laser system to produce long pulse, wide line-width laser lights. For the examination of how efficiently laser cooling is achieved, we have developed a three dimensional Monte Carlo program, which incorporates various parameters of laser beam and positronium distributions expected in the current laser cooling apparatus. This simulation revealed that 7% of o-Ps was able to be cooled down to the recoil limit as well as to be confined in a relatively small volume without employing a special trap. We also discuss related issues such as optical trapping and loss of o-Ps due to ionization, two body and three body interactions.

Quantum Aspects of Beam Physics•May 1, 2002•1 citation

Study on Bose-Einstein condensation of positronium

Kenji Shu, Tomoyuki Murayoshi, Xing Fan +9 more

A new method to realize Bose-Einstein condensation (BEC) of positronium (Ps) is proposed and a Monte-Carlo simulation was performed to evaluate the cooling efficiency of Ps atoms. Ps-BEC was found to be possible by a method including laser cooling of Ps. Laser specifications for Ps cooling are challenging and development is ongoing. A new temperature measurement method for cold Ps and development of an intense, pulsed, slow-positron microbeam are also necessary. They are under study as outlined in this contribution.

Journal of Physics Conference Series•Jan 1, 2017•5 citations

Monte Carlo Study of Ortho-Positronium Laser Cooling

Hokuto Iijima, T. Hirose, M. Irako +4 more

On the basis of three dimensional (3-D) Monte Carlo simulation, we studied details of laser cooling (Doppler cooling) of ortho-Positronium ( o -Ps) which would be applied to the achievement of Bose–Einstein condensation of positronium. The cooling is carried out by an ultraviolet laser with a wavelength of 243 nm being equivalent to the 1 S –2 P transition energy of o -Ps. For this purpose, we have constructed a laser cooling apparatus which consists of a slow positron generator and a long pulse, wide linewidth laser. A 3-D Monte Carlo calculation, which incorporated various parameters of laser beam and positronium distributions expected in the current laser cooling apparatus, revealed that 7% of o -Ps was able to be cool down to 1 K and to be confined in a relatively small volume without employing a special trap.

Journal of the Physical Society of Japan•Nov 1, 2001•4 citations

Study on cooling of positronium for Bose–Einstein condensation

K Shu, X Fan, T Yamazaki +4 more

Abstract A proposed new method of cooling positronium is to realize the Bose–Einstein condensation (BEC) of positronium. We perform detailed studies of three processes: (1) thermalization processes between positronium and the silica walls of a cavity, (2) Ps–Ps scattering and (3) laser cooling. The thermalization process is shown to be not sufficient for BEC. Ps–Ps collision is shown to have a big effect on the cooling performance. We combine both methods and establish an efficient cooling process for BEC. We also propose a new optical laser system for the cooling.

arXiv:1511.07924•Journal of Physics B Atomic Molecular and Optical Physics•Apr 22, 2016•33 citations

Laser excitation of positronium produced in various materials at a range of temperatures

B. S. Cooper

Methods and techniques in the production, manipulation, and accumulation of positrons in a `Surko-type' buffer-gas trap are presented. The pulsed output of the trap is optimised for laser excitation of positronium (Ps). The techniques of positron time compression and single-shot positron annihilation lifetime spectroscopy (SSPALS) are discussed in detail and used throughout the study. A small array or Ps converter materials have been characterised at various temperatures. Ps cooling as a function of positron implantation is presented and discussed. Direct laser irradiation of the samples, and the effect on the Ps yield has also been studied. In some cases, particularly at cryogenic temperatures, laser induced paramagnetic centres are formed and this has a detrimental effect on the Ps yield as they cause triplet Ps to convert to the shorter-lived singlet state. Whereas in single crystal semiconductors, the laser has an enhancing effect due to an exciton-like positron-electron surface state. Many of the Ps converter materials studied here are formed from porous structures. The long term confinement of Ps within isolated cavities has also been observed, where a lifetime measurement technique using an excitation laser is presented. General methods of Ps-laser spectroscopy are also presented and the applications of which are discussed including laser-enhanced time-of-flight spectroscopy (LEPTOF), and the production, and electrostatic guiding of highly excited Rydberg Ps. Using these techniques a crossed beam scattering experiment involving Rydberg Ps, electrons, and Argon ions was carried out. This work presents important considerations for experiments to create a laser-cooled Bose-Einstein condensate (BEC) of Ps in an engineered porous material at cryogenic temperatures.

•Mar 28, 2018•0 citations
Our demonstration of multiple-photon resonant cycling between the 1/sup 3/S and 2/sup 3/P states of ortho-Positronium (oPs) makes possible the production of cold positronium (Ps) through the technique of laser cooling. A simplified analysis of magnetic mixing in excited-state Ps is given. This effect is important both as a diagnostic of resonant cycling and Ps cooling. The significance of cold Ps in fine structure measurements and the formation of a Bose-Einstein condensate is discussed. 13 refs., 3 figs.
Zeeman mixing of singlet and triplet 2P states of positronium (Ps) atoms, followed by decay back to the ground state, can effectively turn a long-lived triplet atom into a short-lived singlet state, which would seem to preclude laser cooling of Ps in a magnetic field. Here we report experiments which show that, in fact, because of the large splitting of the n=2 states in a high magnetic field (the Paschen-Back regime), the amount of such mixing diminishes approximately exponentially with an increasing magnetic field >0.01 T and is essentially eliminated above ∼2 T. Thus, laser cooling of Ps should be feasible at high fields, which will facilitate the production of a Ps Bose-Einstein condensate.
Experimental and theoretical investigations of laser cooling of ortho-Positronium (o-Ps) are reported and feasibilities of Bose-Einstein condensation are discussed. It is shown that in spite of the short lifetime of o-Ps, i.e. 142 nsec, thermally produced o-Ps with a room temperature 300 K can be cooled down to the recoil limit of 0.1 K by ultraviolet laser with a wave-length of 243 nm corresponding to the 1S-2P transition energy of o-Ps. In order to conduct proof-of-principle experiments, we have constructed a laser cooling facility which consists of a slow positron beam generator and a laser system to produce long pulse, wide line-width laser lights. For the examination of how efficiently laser cooling is achieved, we have developed a three dimensional Monte Carlo program, which incorporates various parameters of laser beam and positronium distributions expected in the current laser cooling apparatus. This simulation revealed that 7% of o-Ps was able to be cooled down to the recoil limit as well as to be confined in a relatively small volume without employing a special trap. We also discuss related issues such as optical trapping and loss of o-Ps due to ionization, two body and three body interactions.
A new method to realize Bose-Einstein condensation (BEC) of positronium (Ps) is proposed and a Monte-Carlo simulation was performed to evaluate the cooling efficiency of Ps atoms. Ps-BEC was found to be possible by a method including laser cooling of Ps. Laser specifications for Ps cooling are challenging and development is ongoing. A new temperature measurement method for cold Ps and development of an intense, pulsed, slow-positron microbeam are also necessary. They are under study as outlined in this contribution.
On the basis of three dimensional (3-D) Monte Carlo simulation, we studied details of laser cooling (Doppler cooling) of ortho-Positronium ( o -Ps) which would be applied to the achievement of Bose–Einstein condensation of positronium. The cooling is carried out by an ultraviolet laser with a wavelength of 243 nm being equivalent to the 1 S –2 P transition energy of o -Ps. For this purpose, we have constructed a laser cooling apparatus which consists of a slow positron generator and a long pulse, wide linewidth laser. A 3-D Monte Carlo calculation, which incorporated various parameters of laser beam and positronium distributions expected in the current laser cooling apparatus, revealed that 7% of o -Ps was able to be cool down to 1 K and to be confined in a relatively small volume without employing a special trap.
Abstract A proposed new method of cooling positronium is to realize the Bose–Einstein condensation (BEC) of positronium. We perform detailed studies of three processes: (1) thermalization processes between positronium and the silica walls of a cavity, (2) Ps–Ps scattering and (3) laser cooling. The thermalization process is shown to be not sufficient for BEC. Ps–Ps collision is shown to have a big effect on the cooling performance. We combine both methods and establish an efficient cooling process for BEC. We also propose a new optical laser system for the cooling.
Methods and techniques in the production, manipulation, and accumulation of positrons in a `Surko-type' buffer-gas trap are presented. The pulsed output of the trap is optimised for laser excitation of positronium (Ps). The techniques of positron time compression and single-shot positron annihilation lifetime spectroscopy (SSPALS) are discussed in detail and used throughout the study. A small array or Ps converter materials have been characterised at various temperatures. Ps cooling as a function of positron implantation is presented and discussed. Direct laser irradiation of the samples, and the effect on the Ps yield has also been studied. In some cases, particularly at cryogenic temperatures, laser induced paramagnetic centres are formed and this has a detrimental effect on the Ps yield as they cause triplet Ps to convert to the shorter-lived singlet state. Whereas in single crystal semiconductors, the laser has an enhancing effect due to an exciton-like positron-electron surface state. Many of the Ps converter materials studied here are formed from porous structures. The long term confinement of Ps within isolated cavities has also been observed, where a lifetime measurement technique using an excitation laser is presented. General methods of Ps-laser spectroscopy are also presented and the applications of which are discussed including laser-enhanced time-of-flight spectroscopy (LEPTOF), and the production, and electrostatic guiding of highly excited Rydberg Ps. Using these techniques a crossed beam scattering experiment involving Rydberg Ps, electrons, and Argon ions was carried out. This work presents important considerations for experiments to create a laser-cooled Bose-Einstein condensate (BEC) of Ps in an engineered porous material at cryogenic temperatures.