arXiv:2610.26082
LIDAR with Optically Amplified Thermal Light
Darren Ming Zhi Koh, Peng Kian Tan, Christian Kurtsiefer
Abstract
Thermal light exhibits intensity fluctuations or photon bunching that has been used as a source of entropy or temporally correlated light. However, its low spectral density limits its use in practical applications like LIDAR. One method of remedying this is optical amplification to boost its brightness. In this paper, we show that the normalized second order coherence function $g^{(2)}(τ)$ of a thermal light source is preserved after amplification. We then use amplified thermal light to demonstrate a LIDAR raster scan of a building at 1.3 km with a depth resolution of 2 cm.
AI Summary
The paper investigates whether optical amplification preserves the intensity correlations needed for thermal-light LIDAR, and whether the resulting brightness supports ranging from distant, diffusely reflecting targets. It measures cross-correlations between an unamplified reference and amplified light, then demonstrates outdoor raster imaging. The source combines a 1550 nm laser with an unbalanced fiber interferometer, producing partially thermal-like intensity statistics with $g^{(2)}(0)=1.5$ ideally. Two erbium-doped fiber amplifiers increase brightness; spectral filtering and polarization selection suppress amplified spontaneous emission (ASE). Photon-counting measurements fit the correlations to $g^{(2)}(\tau)=1+b\exp(-2|\tau|/\tau_c)$. Before amplification, $b=0.417\pm0.006$ and $\tau_c=4.02\pm0.07$ ns. After both amplifiers, unfiltered ASE reduces $b$ to $0.196\pm0.005$; filtering restores it to $0.401\pm0.006$, with $\tau_c=3.98\pm0.08$ ns. Using 50 mW transmitted power and separate illumination and collection telescopes, the experiment obtains a $21\times21$-pixel nighttime scan of a building approximately 1.3 km away and foreground floodlights. Distances are extracted from the delay of the correlation peak. With 60 s integration per pixel, the reported depth uncertainty is approximately $\pm2$ cm; some pixels have insufficient return signal. The stated limitations are ASE contamination, which restricts suitable input sources, and detector dead times, which constrain acquisition speed. Narrower filtering is proposed to reduce residual ASE and enable daylight operation; faster photon counters or analog reference detection are proposed to shorten integration times.
Central claim may not hold: The observed preservation of reference–output correlations requires ASE suppression, so the experimental support is conditional rather than a general noise-independent property of optical amplification. The reference–output cross-correlations measured in the experiment do not directly establish preservation of the amplified light's autocorrelation function. The demonstrated one-interferometer source is not the Gaussian thermal-field limit, limiting the direct experimental support for the general thermal-light claim. The reported 2 cm result is supported as isolated-return ranging precision, not demonstrated two-return depth resolution; the measured correlation peak has an approximately 42 cm range FWHM. The ASE correlation equation has an incorrect long-delay normalization and does not describe the measured cross-correlation, while the stated ASE-coherence-time inequality is reversed.
Written by gpt-6.1-sol from the paper's full text. Automated: it can be wrong.
- Comments
- 6 pages, 5 figures