arXiv:2610.21652
Theory of Dispersion and Exchange Interactions Subjected to Surface Roughness in Application to Signal Transmission through a Nanoswitch
Galina L. Klimchitskaya, Alexander S. Korotkov, Vera V. Loboda, Vladimir M. Mostepanenko
Abstract
We present the theoretical description of a resistive nanoswitch designated for a change-over between the two operation modes by calculating the electri elastic, dispersion (van der Waals and Casimir), and also exchange repulsive forces in its configuration with an account of surface roughness. The dispersion forces are described by means of the Lifshitz theory and, at the shortest separations between the interacting bodies, where this theory is inapplicable, by the method of additive summation of the interatomic potentials corrected for the role of the effects of nonadditivity. The exchange repulsion is also found by a summation of the interatomic potentials and using the proximity force approximation. It is shown that the nanoswitch possesses the equilibrium closest separation between a cantilever tip and a ground plate calculated as a function of the actuation voltage and operates in a cyclic manner with no pull-in when this voltage is switched on and off. We have found the tunnel current between a cantilever tip and a plate and investigated distortions appearing in the signal transmitted through a nanoswitch. According to our results, the amplitude distortions arising in the low-frequency information signal can be made sufficiently small by increasing a difference between the amplitudes of the carrier and information signals. Possible applications of the obtained results are discussed.
AI Summary
The paper models whether a resistive cantilever nanoswitch can repeatedly approach and leave an electrode without sticking, and how tunnelling across its near-contact gap distorts transmitted signals. It extends previously reported force-balance calculations to carrier and information-signal transmission. The model combines electrostatic attraction, elastic restoration, dispersion attraction and short-range exchange repulsion, including surface roughness by geometrical averaging. Dispersion forces use Lifshitz theory above $3\,\mathrm{nm}$ and integrated interatomic potentials below that distance, normalized to match the Lifshitz result. Repulsion uses the integrated $r^{-12}$ Lennard–Jones term. For a doped-Si spherical tip of radius $5\,\mu\mathrm{m}$ facing Au, with rms roughnesses of $1$ and $10\,\mathrm{nm}$, respectively, a restoring force of $0.5\,\mu\mathrm{N}$ permits release when the voltage is removed. At $5\,\mathrm{V}$, the calculated stable local equilibrium gap is $2.4\,\text{Å}$; equilibrium gaps are calculated over $5$–$25\,\mathrm{V}$. Sphere–plate tunnelling currents are derived from planar-barrier expressions using the proximity approximation. At a $15\,\mathrm{V}$ bias, calculations predict substantial carrier-wave distortion. Fitting sinusoidal curves to the current’s peak envelope gives information-signal deviations of approximately $13\%$ for carrier/information amplitudes of $7/3\,\mathrm{V}$ and $5\%$ for $9/1\,\mathrm{V}$. Stated limitations include phenomenological repulsion parameters, approximately separation-independent screening below $3\,\mathrm{nm}$, and roughness-correlation assumptions requiring experimental verification. Image-charge corrections remain unresolved; band bending and charge accumulation require further investigation. Predicted large currents also motivate consideration of heating, electromigration and structural changes in practical devices.
Error found: The two Section 6 examples change both carrier and information amplitudes, so they do not establish amplitude difference itself as the parameter controlling distortion. Section 5 omits the carrier's mean-square voltage contribution when determining the mechanical equilibrium gap, despite the electrostatic force being proportional to voltage squared. Equation (34c) incorrectly adds the slowly varying information voltage after taking the carrier-averaged square root, rather than averaging the square of the total voltage. Near 9.9 V at the stated 1.971-angstrom gap, the term discarded from Equation (26) is approximately 52% of the retained term, contradicting the claimed near-equivalence with Equation (28).
Written by gpt-6.1-sol from the paper's full text. Automated: it can be wrong.
- Journal reference
- Physics, v.8, N4, 71 (2026)
- Comments
- 22 pages, 8 figures