arXiv:2610.06279
Electro-Optical Metalens for Near-Surface Cooling of a Levitated Particle
Pedro Rosso Gomez, Bruno Melo, Adeel Afridi, Mohamed Sabry Mohamed, Nadine Meyer, Romain Quidant
Abstract
Advanced levitation optomechanics in the quantum regime requires sophisticated quantumengineered protocols operating at shorter length and time scales, demanding an increasing control over both optical and electrical potentials. Integrated chip-scale platforms offer a natural route toward such control. Here, we demonstrate optical levitation in vacuum using a miniaturized hybrid electro-optical metalens. Motion control is achieved using a high numerical aperture metalens combined with electrical active feedback using planar electrodes, enabling cooling to low phonon occupations. Reheating measurements enable us to rule out any significant influence from electric field noise; an encouraging result for the future development of on-chip levitation platforms operating close to surfaces. This compact integrated platform facilitates the precise manipulation and control of levitated nanoparticles while laying the ground toward exploiting the full capacity of metaoptics to engineer complex optical potentials, marking a significant step forward in technologies for quantum levitation optomechanics.
AI Summary
The paper asks whether a chip integrating optical focusing and electrical feedback can trap and cool a levitated nanoparticle near a surface without surface-associated electrical noise dominating its motion. It combines a silicon metalens of radius $250\,\mu\mathrm{m}$, nominal numerical aperture $0.9$, and focal length $125\pm5\,\mu\mathrm{m}$ with surrounding planar gold electrodes. A $1064$-nm beam traps a charged silica nanosphere; optical position measurements drive electrical cold damping. The measured metalens transmission is $58.4\%$, with $67\%$ of transmitted power within the defined focal region. At $270$ mW transmitted power, mechanical frequencies reach approximately $(280,348,106)$ kHz. For a sphere of radius $109$ nm carrying 13 elementary charges, feedback yields inferred minimum occupations $(\bar n_x,\bar n_y,\bar n_z)=(34,27,12)$ at $1.5\times10^{-7}$ mbar. These occupations are extracted from fits to in-loop displacement spectra incorporating measurement noise and noise squashing; no independent out-of-loop thermometry is used. Heating is characterized by switching off feedback and averaging 300 trajectories while varying pressure, optical power, charge, and particle size. The results are consistent with photon recoil dominating below roughly $10^{-6}$ mbar, with no significant additional electrical heating resolved in the tested parameter range. The lowest reported heating rates are approximately $(87,55,420)\times10^3$ phonons/s. Calibration and particle-mass uncertainties limit quantitative comparisons with heating predictions. The demonstration does not reach ground-state occupation; dynamic potential shaping, smaller-scale confinement, and many-particle operation remain proposed extensions.
Error found: The abstract's categorical exclusion of significant electric-field noise is stronger than the supplied experimental analysis, which supports a conditional conclusion without reporting an experimental upper bound and its uncertainty. The numerical-aperture formula has a factor-of-two error for the stated Airy radii, and correcting it gives the reported NA values with their axis assignments reversed. The quoted gas-plus-recoil heating predictions exceed the measured transverse heating rates by factors of approximately 1.94 and 2.89, making the description 'slightly below' misleading without quantitative uncertainty justification.
Written by gpt-6.1-sol from the paper's full text. Automated: it can be wrong.