arXiv:2609.31598
Scalable Hybrid Device Architecture on Thin-Film Lithium Tantalate for Long Distance Quantum Network Nodes with Atomic Frequency Comb Quantum Memories
Ayed Sayem, Towsif Taher
Abstract
Scalable photonic circuits are essential for realizing practical quantum networks beyond proof-of-principle demonstrations. Although diamond-based integrated photonics has been extensively investigated over the past two decades for quantum networking applications, its integration into scalable photonic platforms remains challenging. Quantum memories based on rare-earth-ion atomic frequency combs (AFCs) offer an attractive alternative; however, most demonstrations to date have relied on bulk free-space crystals, limiting their scalability for practical implementations. In this work, we systematically investigate the potential for hybrid integration of AFC-based quantum memories with a scalable integrated photonic platform. We propose a device architecture combining thin-film lithium tantalate (TFLT) nanophotonic circuits with ytterbium-doped yttrium orthosilicate (Yb:YSO) crystals for long-distance quantum communication. Our analysis shows that the hybrid TFLT-YSO platform offers a promising and scalable pathway toward integrated quantum memories and, ultimately, large-scale quantum networks.
AI Summary
The paper asks whether rare-earth atomic-frequency-comb (AFC) memories can be integrated with photonic circuitry for multiplexed quantum-repeater nodes. It proposes a hybrid thin-film lithium tantalate (TFLT)–$^{171}\mathrm{Yb}:\mathrm{YSO}$ architecture combining photon-pair sources, electro-optic routing, cavity-enhanced memories and integrated detectors. TFLT is selected through a comparison of transparency, nonlinearity, switching and bias stability. Numerical optical modeling examines a triply resonant, periodically poled ring–Mach–Zehnder source producing approximately 979-nm memory photons and telecom photons, and evanescent coupling between TFLT waveguides and bonded YSO. Simulated useful absorption reaches approximately $0.9\,\mathrm{dB/cm}$ for one geometry, against assumed waveguide losses of $0.1$–$0.2\,\mathrm{dB/cm}$. An impedance-matched cavity analysis separates recoverable AFC absorption from parasitic attenuation. It finds an efficiency ceiling $\eta\leq D(F)/(1+bF)^2$, where $b$ is parasitic loss divided by effective rare-earth absorption and $D(F)$ is comb dephasing. For absorption $2\,\mathrm{dB/cm}$ and parasitic loss $0.10\,\mathrm{dB/cm}$, the optimum finesse is approximately 4.36, giving 56.5% efficiency and a calculated 279-MHz cavity linewidth. Link calculations combine multipair statistics, optimized temporal multiplexing and renewal Monte Carlo simulations for one-, two- and four-link chains. Baseline assumptions include a 100-MHz clock, 80% zero-delay AFC efficiency, $307\,\mu\mathrm{s}$ AFC coherence and 10-ms spin coherence. The architecture is proposed rather than demonstrated. Hybrid spin-wave storage and several integrated components remain future experimental work. The network model uses one memory per link direction; memory-bank gains are not calculated. Fabrication, packaging, preparation dead time and memory occupancy are identified as scaling limitations.
Error found: The highlighted hybrid-memory example is limited by the paper's own efficiency bound to approximately 39.3%, contradicting its claim that this absorption and propagation loss support near-unity efficiency. The network model assumes 80% zero-delay AFC efficiency without tying it to an established hybrid-device operating point, whereas the explicit design table peaks at 56.5%. The long-distance network projections depend on hybrid spin-wave transfer and coherence performance that the device analysis explicitly leaves for future work. The stated cavity linewidth formula is too small by a factor of two in the short-cavity limit of the paper's own round-trip model.
Written by gpt-6.1-sol from the paper's full text. Automated: it can be wrong.
- Comments
- 20 pages, 6 figures