Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2606.21348 · APL Engineering Physics

Enhanced electron-beam lithography to reduce the frequency scatter of 200–400 GHz superconducting microstrip resonators for on-chip filterbank spectrometers

Leon G. G. Olde Scholtenhuis, David Johannes Thoen, J. Baselmans, K. Karatsu, L. H. Martin, S. Vollebregt, Akira Endo

Published Nov 6, 2026• 1 citation
arXivHTMLPDF

Abstract

Integrated superconducting spectrometers provide the instantaneous bandwidth, sensitivity, and scalable architecture required for large-scale spectroscopic surveys in submillimeter-wave astronomy and cosmology. However, the accuracy with which the resonant frequencies of superconducting microstrip bandpass filters can be spaced has limited the spectral resolution of these spectrometers with continuous spectral coverage to F/ΔF < 500. The origin of this frequency scatter has been largely unknown. In this work, we demonstrate a fourfold improvement in the frequency spacing of superconducting microstrip resonators by optimizing electron-beam lithography. We find that reducing the electron-beam step size also reduces the random frequency scatter and that avoiding main-field stitching across filter patterns can eliminate a systematic frequency shift between groups of resonators, indicating the different origins of these two modes of frequency deviation. These findings demonstrate that nanometer-scale control of lithographic processes is imperative for the realization of next-generation integrated superconducting spectrometers with higher spectral resolution.

DOI
10.1063/5.0345761

Related papers

On-chip filter bank spectroscopy at 600–700 GHz using NbTiN superconducting resonators

Akira Endo, Cristina Sfiligoj, S. J. C. Yates +6 more

We experimentally demonstrate the principle of an on-chip submillimeter wave filter bank spectrometer, using superconducting microresonators as narrow band-separation filters. The filters are made of NbTiN/SiNx/NbTiN microstrip line resonators, which have a resonance frequency in the range of 614-685 GHz, two orders of magnitude higher in frequency than what is currently studied for use in circuit quantum electrodynamics and photodetectors. The frequency resolution of the filters decreases from 350 to 140 with increasing frequency, most likely limited by dissipation of the resonators.

arXiv:1303.7151•Applied Physics Letters•Jul 15, 2013•39 citations

The Simulation and Design of an On-Chip Superconducting Millimetre Filter-Bank Spectrometer

G. Robson, Adam J. Anderson, Peter S. Barry +2 more

Abstract Superconducting on-chip filter banks provide a scalable, space saving solution to create imaging spectrometers at millimetre and submillimetre wavelengths. We present an easy to realise, lithographed superconducting filter design with a high tolerance to fabrication error. Using a capacitively coupled $$\lambda /2$$ λ / 2 microstrip resonator to define a narrow ( $$\lambda /\Delta \lambda = 300$$ λ / Δ λ = 300 ) spectral pass band, the filtered output of a given spectrometer channel directly connects to a lumped-element kinetic inductance detector. We show the tolerance analysis of our design, demonstrating $$<11\%$$ < 11 % change in filter quality factor to any one realistic fabrication error and a full filter-bank efficiency forecast to be 50% after accounting for fabrication errors and dielectric loss tangent.

arXiv:2111.04632•Journal of Low Temperature Physics•Jun 11, 2022•4 citations

High efficiency superconducting filterbank with impedance-defined resolution for millimeter-wave spectroscopy

Oliver B. Jeong, M. Piat, Aritoki Suzuki

We present a high efficiency, moderate resolution on-chip superconducting filterbank spectrometer designed for line intensity mapping and broadband wave-like dark matter searches. Existing implementations used by the millimeter-wave community rely on resistive feedline termination for standing wave mitigation which caps the per-channel efficiency $η_\mathrm{ch}$ at 50\% and utilize microstrip resonators which highly couple the resolving power $\mathcal{R}=ν/δν$ and $η_\mathrm{ch}$ to thin-film dielectric loss. The architecture presented in this paper addresses these limitations by eliminating the termination resistor and employing niobium coplanar waveguide resonators patterned directly on single-crystal silicon, which fixes the resonator's internal quality factor by the silicon substrate property rather than by the loss tangent of a deposited film. The resolving power is set by the impedance ratio between the resonator and feedline. Electromagnetic and circuit simulations of a ten-channel filterbank near 90~GHz at unity oversampling show $\mathcal{R}=1170$ and $η_\mathrm{ch}> 78\%$, with no significant trend in efficiency across channels. A ten-channel prototype, designed for $\mathcal{R}=92\pm5$ and $η_\mathrm{ch}=(81\pm3)\%$ over 90--106~GHz with a 560~nm interlayer based on simulations, was fabricated and optically characterized, yielding $\mathcal{R}=208\pm74$ and $η_\mathrm{ch}=(77\pm6)\%$. Measured $η_\mathrm{ch}$ well above the 50\% termination limit, together with demonstrated impedance tuning of $\mathcal{R}$, validate the design principles of this filterbank spectrometer and establishes a route to high-efficiency, high-resolution on-chip spectrometer arrays.

arXiv:2603.19142•Mar 19, 2026•1 citation

Superconducting Coplanar Waveguide Filters for Submillimeter Wave On-Chip Filterbank Spectrometers

Akira Endo, S. J. C. Yates, Juan Bueno +6 more

We show the first experimental results which prove that superconducting NbTiN coplanar–waveguide resonators can achieve a loaded Q factor in excess of 800 in the 350 GHz band. These resonators can be used as narrow band pass filters for on-chip filter bank spectrometers for astronomy. Moreover, the low-loss coplanar waveguide technology provides an interesting alternative to microstrip lines for constructing large scale submillimeter wave electronics in general.

Journal of Low Temperature Physics•Mar 24, 2016•4 citations

Superconducting On-Chip Spectrometery for Millimeter-submillimeter Wave Astronomy

Akira Endo

Since the birth of astrophysics, astronomers have been using free-space optics to analyze light falling on Earth. In the future however, thanks to the advances in photonics and nanoscience/nanotechnology, much of the manipulation of light might be carried out using not optics but confined waveguides, or circuits, on a chip. This new generation of instruments will be not only extremely compact, but also powerful in performance because the integration enables a greater degree of multiplexing. The benefit is especially profound for space- or air-borne observatories, where size, weight, and mechanical reliability are of top priority. Recently, several groups around the world are trying to integrate ultra-wideband (UWB), low-resolution spectrometers for millimeter-submillimeter waves onto microchips, using superconducting microelectronics. The scope of this Paper is to provide a general introduction and a review of the state-of-the-art of this rapidly advancing field.

IEICE Transactions on Electronics•Jan 1, 2015•4 citations

Directional Filter Design and Simulation for Superconducting On-Chip Filter-Banks

Louis H. Marting, K. Karatsu, Akira Endo +2 more

Many superconducting on-chip filter-banks suffer from poor coupling to the detectors behind each filter. This is a problem intrinsic to the commonly used half-wavelength filter, which has a maximum theoretical coupling of 50 %. In this paper, we introduce a phase-coherent filter, called a directional filter, which has a theoretical coupling of 100 %. In order to study and compare different types of filter-banks, we first analyze the measured filter frequency scatter, losses, and spectral resolution of a DESHIMA 2.0 filter-bank chip. Based on measured fabrication tolerances and losses, we adapt the input parameters for our circuit simulations, quantitatively reproducing the measurements. We find that the frequency scatter is caused by nanometer-scale line width variations and that variances in the spectral resolution is caused by losses in the dielectric only. Finally, we include these realistic parameters in a full filter-bank model and simulate a wide range of spectral resolutions and oversampling values. For all cases, the directional filter-bank has significantly higher coupling to the detectors than the half-wave resonator filter-bank. The directional filter eliminates the need to use oversampling as a method to improve the total efficiency, instead capturing nearly all the power remaining after dielectric losses.

arXiv:2404.11417•Journal of Low Temperature Physics•May 4, 2024•6 citations
Integrated superconducting spectrometers provide the instantaneous bandwidth, sensitivity, and scalable architecture required for large-scale spectroscopic surveys in submillimeter-wave astronomy and cosmology. However, the accuracy with which the resonant frequencies of superconducting microstrip bandpass filters can be spaced has limited the spectral resolution of these spectrometers with continuous spectral coverage to F/ΔF < 500. The origin of this frequency scatter has been largely unknown. In this work, we demonstrate a fourfold improvement in the frequency spacing of superconducting microstrip resonators by optimizing electron-beam lithography. We find that reducing the electron-beam step size also reduces the random frequency scatter and that avoiding main-field stitching across filter patterns can eliminate a systematic frequency shift between groups of resonators, indicating the different origins of these two modes of frequency deviation. These findings demonstrate that nanometer-scale control of lithographic processes is imperative for the realization of next-generation integrated superconducting spectrometers with higher spectral resolution.
We experimentally demonstrate the principle of an on-chip submillimeter wave filter bank spectrometer, using superconducting microresonators as narrow band-separation filters. The filters are made of NbTiN/SiNx/NbTiN microstrip line resonators, which have a resonance frequency in the range of 614-685 GHz, two orders of magnitude higher in frequency than what is currently studied for use in circuit quantum electrodynamics and photodetectors. The frequency resolution of the filters decreases from 350 to 140 with increasing frequency, most likely limited by dissipation of the resonators.
Abstract Superconducting on-chip filter banks provide a scalable, space saving solution to create imaging spectrometers at millimetre and submillimetre wavelengths. We present an easy to realise, lithographed superconducting filter design with a high tolerance to fabrication error. Using a capacitively coupled λ/2\lambda /2λ/2 λ / 2 microstrip resonator to define a narrow ( λ/Δλ=300\lambda /\Delta \lambda = 300λ/Δλ=300 λ / Δ λ = 300 ) spectral pass band, the filtered output of a given spectrometer channel directly connects to a lumped-element kinetic inductance detector. We show the tolerance analysis of our design, demonstrating <11%<11\%<11% < 11 % change in filter quality factor to any one realistic fabrication error and a full filter-bank efficiency forecast to be 50% after accounting for fabrication errors and dielectric loss tangent.
We present a high efficiency, moderate resolution on-chip superconducting filterbank spectrometer designed for line intensity mapping and broadband wave-like dark matter searches. Existing implementations used by the millimeter-wave community rely on resistive feedline termination for standing wave mitigation which caps the per-channel efficiency ηchη_\mathrm{ch}ηch​ at 50\% and utilize microstrip resonators which highly couple the resolving power R=ν/δν\mathcal{R}=ν/δνR=ν/δν and ηchη_\mathrm{ch}ηch​ to thin-film dielectric loss. The architecture presented in this paper addresses these limitations by eliminating the termination resistor and employing niobium coplanar waveguide resonators patterned directly on single-crystal silicon, which fixes the resonator's internal quality factor by the silicon substrate property rather than by the loss tangent of a deposited film. The resolving power is set by the impedance ratio between the resonator and feedline. Electromagnetic and circuit simulations of a ten-channel filterbank near 90~GHz at unity oversampling show R=1170\mathcal{R}=1170R=1170 and ηch>78%η_\mathrm{ch}> 78\%ηch​>78%, with no significant trend in efficiency across channels. A ten-channel prototype, designed for R=92±5\mathcal{R}=92\pm5R=92±5 and ηch=(81±3)%η_\mathrm{ch}=(81\pm3)\%ηch​=(81±3)% over 90--106~GHz with a 560~nm interlayer based on simulations, was fabricated and optically characterized, yielding R=208±74\mathcal{R}=208\pm74R=208±74 and ηch=(77±6)%η_\mathrm{ch}=(77\pm6)\%ηch​=(77±6)%. Measured ηchη_\mathrm{ch}ηch​ well above the 50\% termination limit, together with demonstrated impedance tuning of R\mathcal{R}R, validate the design principles of this filterbank spectrometer and establishes a route to high-efficiency, high-resolution on-chip spectrometer arrays.
Since the birth of astrophysics, astronomers have been using free-space optics to analyze light falling on Earth. In the future however, thanks to the advances in photonics and nanoscience/nanotechnology, much of the manipulation of light might be carried out using not optics but confined waveguides, or circuits, on a chip. This new generation of instruments will be not only extremely compact, but also powerful in performance because the integration enables a greater degree of multiplexing. The benefit is especially profound for space- or air-borne observatories, where size, weight, and mechanical reliability are of top priority. Recently, several groups around the world are trying to integrate ultra-wideband (UWB), low-resolution spectrometers for millimeter-submillimeter waves onto microchips, using superconducting microelectronics. The scope of this Paper is to provide a general introduction and a review of the state-of-the-art of this rapidly advancing field.
Many superconducting on-chip filter-banks suffer from poor coupling to the detectors behind each filter. This is a problem intrinsic to the commonly used half-wavelength filter, which has a maximum theoretical coupling of 50 %. In this paper, we introduce a phase-coherent filter, called a directional filter, which has a theoretical coupling of 100 %. In order to study and compare different types of filter-banks, we first analyze the measured filter frequency scatter, losses, and spectral resolution of a DESHIMA 2.0 filter-bank chip. Based on measured fabrication tolerances and losses, we adapt the input parameters for our circuit simulations, quantitatively reproducing the measurements. We find that the frequency scatter is caused by nanometer-scale line width variations and that variances in the spectral resolution is caused by losses in the dielectric only. Finally, we include these realistic parameters in a full filter-bank model and simulate a wide range of spectral resolutions and oversampling values. For all cases, the directional filter-bank has significantly higher coupling to the detectors than the half-wave resonator filter-bank. The directional filter eliminates the need to use oversampling as a method to improve the total efficiency, instead capturing nearly all the power remaining after dielectric losses.