Strongly disordered superconductors (SDSCs) are widely used in qubits, microwave resonators, photon detectors, and other superconducting quantum devices. In SDSC-based devices, coherence times are limited by low-temperature microwave dissipation in the material. However, the standard Mattis-Bardeen theory fails in SDSCs because their single-particle spectrum exhibits a hard pseudogap Δ_{P} both below and above the transition temperature T_{c}. We develop a novel microscopic theory of the dependence of ac dissipation in such systems on temperature T and frequency ω. We analyze the resonator quality factor Q(ω,T) in the practically relevant range ℏω,T≪Δ≤Δ_{P}, where Δ is the typical superconducting order parameter, distinct from Δ_{P}. We show that low-ω dissipation is dominated by a new type of bulk localized collective modes arising from spatial inhomogeneity of the superconducting state. Consequently, Q(ω) decreases strongly with ω and exhibits two-level-system-like growth with T for T≪T_{c}. Our theory provides a microscopic understanding of existing and future experiments on thin films of InO_{x}, TiN, NbN, and similar SDSCs, and is phenomenologically relevant to granular aluminum films. The results suggest strategies to mitigate intrinsic microwave losses in SDSC-based quantum devices.
Strongly disordered superconductors (SDSCs) are widely used in qubits, microwave resonators, photon detectors, and other superconducting quantum devices. In SDSC-based devices, coherence times are limited by low-temperature microwave dissipation in the material. However, the standard Mattis-Bardeen theory fails in SDSCs because their single-particle spectrum exhibits a hard pseudogap Δ_{P} both below and above the transition temperature T_{c}. We develop a novel microscopic theory of the dependence of ac dissipation in such systems on temperature T and frequency ω. We analyze the resonator quality factor Q(ω,T) in the practically relevant range ℏω,T≪Δ≤Δ_{P}, where Δ is the typical superconducting order parameter, distinct from Δ_{P}. We show that low-ω dissipation is dominated by a new type of bulk localized collective modes arising from spatial inhomogeneity of the superconducting state. Consequently, Q(ω) decreases strongly with ω and exhibits two-level-system-like growth with T for T≪T_{c}. Our theory provides a microscopic understanding of existing and future experiments on thin films of InO_{x}, TiN, NbN, and similar SDSCs, and is phenomenologically relevant to granular aluminum films. The results suggest strategies to mitigate intrinsic microwave losses in SDSC-based quantum devices.
Improving the coherence of superconducting qubits is essential for advancing quantum technologies. While superconductors are theoretically perfect conductors, they consistently exhibit residual energy dissipation when driven by microwave currents, limiting coherence times. Here, we report an empirical scaling relation between microwave dissipation and the superfluid density, a bulk property of superconductors related to charge carrier density and disorder. Our analysis spans a wide range of superconducting materials and device geometries, from highly disordered amorphous films to ultraclean systems with record-high quality factors, including resonators, three-dimensional cavities, and transmon qubits. This scaling reveals an intrinsic bulk dissipation channel, independent of surface dielectric losses, which we attribute to nonequilibrium quasiparticles trapped within disorder-induced spatial variations of the superconducting gap, with a density set by a universal material parameter. Our findings identify an empirical coherence limit associated with intrinsic material properties and provide a data-driven basis for materials selection in future superconducting quantum circuits.
In this thesis, we first demonstrate that a disordered superconductor with high kinetic inductance can realise a microwave low-loss, non-dissipative circuit element with impedance greater than the quantum resistance. This element, known as a superinductor, can suppress the fluctuations of charge in a quantum circuit.For this purpose, we fabricated and characterised 20 nm thick, 40 nm wide niobium-nitride nanowires and determined the impedance to 6.795 kΩ. We demonstrate internal quality factors Qi = 2.5e4 in nanowire resonators at single photon excitation, which is significantly higher than values reported in devices with similar materials and geometries. Moreover, we show that the dominant dissipation in our nanowires is not an intrinsic property of the disordered films, but can instead be fully understood within the framework of two-level systems.To further characterise these losses, we then explore the geometrical scaling, toward nanowire dimensions, of dielectric losses in superconducting microwave resonators fabricated with the same techniques and from the same NbN thin-film as the nanowire superinductors. For this purpose, we perform an experimental and numerical study of dielectric loss at low temperatures. Using 3D finite-element simulation of the Maxwell--London equations, we compute the geometric filling factors of the lossy regions in our resonator structures and fit the experimental data to determine the intrinsic loss tangents of its interfaces and dielectrics. Finally, we study the effect of two-level systems on the performance of various superconducting quantum circuits. For this purpose, we measure coherence-time fluctuations in qubits and frequency fluctuations in resonators. In all devices, through statistical analysis, we identify the signature of individual Lorentzian fluctuators in the noise. We find that fluctuations in qubit relaxation are local to the qubit and are caused by instabilities of near-resonant two-level-systems. Furthermore, when examining the low-frequency noise of three different types of superconducting resonator - one NbN nanowire, one Al coplanar waveguide, and one Al 3D cavity - we observe a similar power-law dependence of the Lorentzian switching time and amplitude on the circulating power in the resonators, suggesting a common noise mechanism in the three different types of devices.
Superconducting boron-doped silicon is a promising material for integrated silicon quantum devices. In particular, its low electronic density and moderate disorder make it a suitable candidate for the fabrication of large inductances with low losses at microwave frequencies. We study experimentally the electrodynamics of superconducting silicon thin layers using coplanar waveguide resonators, focusing on the kinetic inductance, the internal losses, and the variation of these quantities with the resonator readout power. We report the observation in a doped semiconductor of microwave resonances with internal quality factors of a few thousand. As expected in the BCS framework, superconducting silicon presents a large sheet kinetic inductance in the 50--500-pH range, comparable to that of strongly disordered superconductors. The temperature dependence of the kinetic inductance is well described by the Mattis-Bardeen theory. However, we find an unexpectedly strong nonlinearity in the complex surface impedance that cannot be satisfactorily explained either by depairing or by quasiparticle heating.
Disordered superconducting materials with high kinetic inductance are an important resource for generating nonlinearity in quantum circuits and creating high-impedance environments. In thin films fabricated from these materials, the combination of disorder and low effective dimensionality leads to increased order parameter fluctuations and enhanced kinetic inductance values. Among the challenges of harnessing these compounds in coherent devices are their proximity to the superconductor-insulator phase transition and the two-level systems located in the disordered structure. Here, we fabricate tungsten silicide wires from quasi-two-dimensional films and embed them into microwave resonators and fluxonium qubits, where the kinetic inductance provides the inductive part of the circuits. In this work, we study the dependence of loss on the frequency, disorder, and geometry of the devices, and find that the loss increases with the level of disorder and is dominated by the localized quasiparticles trapped in the spatial variations of the superconducting gap. High kinetic inductance materials are widely used in superconducting circuits, yet their loss mechanisms are not fully understood. Here the authors study quantum circuits incorporating nanowires made of quasi-2D disordered superconductor WSi and identify localized quasiparticles as the dominant source of loss.
Research on spatially inhomogeneous weakly coupled superconductors has recently received a boost of interest because of the experimental observation of a dramatic enhancement of the kinetic inductance with relatively low losses. Here, we study the kinetic inductance and the quality factor of a strongly disordered, weakly coupled superconducting thin film. We employ a gauge-invariant random-phase approximation capable of describing collective excitations and other fluctuations. In line with the experimental findings, we have found that in the range of frequencies of interest, and for sufficiently low temperatures, an exponential increase of the kinetic inductance with disorder coexists with a still large quality factor of ∼10^{4}. More interestingly, on the metallic side of the superconductor-insulator transition, we have identified a range of frequencies and temperatures, T∼0.1T_{c}, where quantum coherence effects induce a broad statistical distribution of the quality factor with an average value that increases with disorder. We expect these findings to further stimulate experimental research on the design and optimization of superinductors for a better performance and miniaturization of quantum devices such as qubit circuits and microwave detectors.
Superconducting quantum devices have gained increasing interest over the past 15 years because of their role as promising candidates for implementing a large-scale quantum computer and as ultra-sensitive detectors. Superconducting resonators are one type of superconducting device which are used in a variety of applications including quantum computing and radioastronomy. They can achieve large quality factors which are important for these applications and a variety of others. Specific examples of these applications include the readout and coupling of superconducting qubits and also microwave kinetic inductance detector arrays for sub-mm wavelength astronomical measurements. High quality factors also enable the study of very subtle features in the electromagnetic response of the resonator. This feature in turn offers provides a method to characterize loss mechanisms which affect the performance of superconducting qubits, by measuring the quality factor of a resonator. Dielectric loss is an example of such a loss mechanism, and is considered to be one of, if not \\it the \\rm major obstacle to overcome in order to construct scalable quantum technologies based on superconducting devices. This type of loss arises from the coupling of the electric field in the device to spurious degrees of freedom which arise naturally the dielectric environment of the device. The fast-growing interest in the physics and applications of superconducting resonators has renewed interest in an improving our fundamental understanding of dielectric loss. This interest involves the study of a much bigger and older question in condensed matter physics; namely, what is the microscopic physics which governs the behaviour and of an amorphous material at low-temperatures? \n \nIn this thesis, we present a systematic study of dielectric loss in amorphous aluminum oxide using superconducting microwave resonators. Measurements of the intrinsic loss tangent over a large temperature range of 40~mK to 1~K are presented and analyzed in detail. Some aspects of the data are well understood in terms of the standard tunnelling two-level system model, while others require a deeper analysis of the electrodynamics of the resonator and insights from more advanced theories. We employ a consistent approach using numerical simulations of the resonator to understand loss mechanisms arising from both an inhomogeneous electric field and multiple dielectric layers. We measure saturation effects which provide insight into coherent properties of two-level system ensembles and the mutual interaction between them. Excellent agreement with the two-level system model is found for intrinsic losses, however the strong dependence on temperature which we observe for saturation effects is not predicted in the standard form of the model. We find that this dependence can be understood in terms of the theory of spectral diffusion which is consistent with a strong mutual interaction between two-level systems contributes to broadening of their spectral linewidths.