Quantum algorithms for estimating the ground state energy of a quantum system often operate by preparing a classically accessible quantum state and then applying quantum phase estimation. Whether this approach yields quantum advantage hinges on the state's energy spectrum, that is, the sequence of the state's overlaps with the energy eigenstates of the system Hamiltonian. We show that the energy spectrum of any entanglement-compressed quantum state must have large support if most energy eigenstates are highly entangled, an assumption supported by the eigenstate thermalization hypothesis. Furthermore, we show that if the compressed quantum state minimizes expected energy, then its energy spectrum decays with the inverse-squared energy eigenvalues under a convex relaxation of the compression constraint. This explains the main empirical finding of Silvester et al. [Phys. Rev. Lett. 134, 126503 (2025).PRLTAO0031-900710.1103/PhysRevLett.134.126503] that the energy spectra of matrix product states do not decay exponentially.
Quantum algorithms for estimating the ground state energy of a quantum system often operate by preparing a classically accessible quantum state and then applying quantum phase estimation. Whether this approach yields quantum advantage hinges on the state's energy spectrum, that is, the sequence of the state's overlaps with the energy eigenstates of the system Hamiltonian. We show that the energy spectrum of any entanglement-compressed quantum state must have large support if most energy eigenstates are highly entangled, an assumption supported by the eigenstate thermalization hypothesis. Furthermore, we show that if the compressed quantum state minimizes expected energy, then its energy spectrum decays with the inverse-squared energy eigenvalues under a convex relaxation of the compression constraint. This explains the main empirical finding of Silvester et al. [Phys. Rev. Lett. 134, 126503 (2025).PRLTAO0031-900710.1103/PhysRevLett.134.126503] that the energy spectra of matrix product states do not decay exponentially.
In approximate ground states obtained from imaginary-time evolution, the spectrum of the state-its decomposition into exact energy eigenstates-falls off exponentially with the energy. Here we consider the energy spectra of approximate matrix product ground states, such as those obtained with the density matrix renormalization group. Despite the high accuracy of these states, contributions to the spectra are roughly constant out to surprisingly high energy, with an increase in the bond dimension reducing the amplitude but not the extent of these high-energy tails. The unusual spectra appear to be a general feature of compressed wavefunctions, independent of boundary or dimensionality, and are also observed in neural network wavefunctions. The unusual spectra can have a strong effect on sampling-based methods, yielding large fluctuations. The energy variance, which can be used to extrapolate observables to eliminate truncation error, is subject to these large fluctuations when sampled. Nevertheless, we devise a sampling-based variance approach which gives excellent and efficient extrapolations.
Abstract We present an efficient method for estimating the eigenvalues of a Hamiltonian H from the expectation values of the evolution operator for various times. For a given quantum state ρ , our method outputs a list of eigenvalue estimates and approximate probabilities. Each probability depends on the support of ρ in those eigenstates of H associated with eigenvalues within an arbitrarily small range. The complexity of our method is polynomial in the inverse of a given precision parameter ϵ , which is the gap between eigenvalue estimates. Unlike the well-known quantum phase estimation algorithm that uses the quantum Fourier transform, our method does not require large ancillary systems, large sequences of controlled operations, or preserving coherence between experiments, and is therefore more attractive for near-term applications. The output of our method can be used to estimate spectral properties of H and other expectation values efficiently, within additive error proportional to ϵ .
Experimental characterizations of a quantum system involve the measurement of expectation values of observables for a preparable state $\ensuremath{\mid}\ensuremath{\psi}⟩$ of the quantum system. Such expectation values can be measured by repeatedly preparing $\ensuremath{\mid}\ensuremath{\psi}⟩$ and coupling the system to an apparatus. For this method, the precision of the measured value scales as N1 for N repetitions of the experiment. For the problem of estimating the parameter $\ensuremath{\phi}$ in an evolution ${e}^{\ensuremath{-}i\ensuremath{\phi}H}$, it is possible to achieve precision N1 [the quantum metrology limit; see Giovannetti et al., Phys. Rev. Lett. 96, 010401 (2006)] provided that sufficient information about H and its spectrum is available. We consider the more general problem of estimating expectations of operators A with minimal prior knowledge of A. We give explicit algorithms that approach precision N1 given a bound on the eigenvalues of A or on their tail distribution. These algorithms are particularly useful for simulating quantum systems on quantum computers because they enable efficient measurement of observables and correlation functions. Our algorithms are based on a method for efficiently measuring the complex overlap of $\ensuremath{\mid}\ensuremath{\psi}⟩$ and $U\ensuremath{\mid}\ensuremath{\psi}⟩$, where U is an implementable unitary operator. We explicitly consider the issue of confidence levels in measuring observables and overlaps and show that, as expected, confidence levels can be improved exponentially with linear overhead. We further show that the algorithms given here can typically be parallelized with minimal increase in resource usage.
In ab-initio quantum chemistry, solving the electronic structure problem of a molecular system of interest to obtain an approximation of the ground and, in some cases, the excited state energies is a core and central task in various quantum chemistry processes. These include, but certainly not limited to, the calculation of the activation energy–that is the minimal energy required to launch a given chemical reaction–, the dipole and multipole moments which describe the polarity of the molecule, performing the optimization of the geometry of the molecule and searching for transition states. Furthermore, many quantum chemistry applications are predicated, not merely on the approximation of the ground state energy, but also on the corresponding first order derivatives. The body of literature of classical algorithms approximating the ground state energy and its first order derivative is extensively rich with a plethora of methods such as self-consistent mean-field methods, coupled-cluster methods, density matrix renormalization group and many more, each of which has intrinsic set of properties and characteristics that makes it suitable for specific tasks and cases. However, classical methods face a practically insurmountable challenge: the efficient computation of high accuracy approximation of ground state energies of large system sizes. This is fundamentally because the electronic structure problem provably belongs to the complexity class of QMA-hard problems. Which also means that it is out of reach for quantum algorithms as well in general. However, with certain assumptions that are expected to hold molecules of interest–that so far proved to be classically challenging because the required accuracy set by the standard of chemical accuracy threshold (generally held in quantum chemistry)– quantum algorithms can efficiently treat such cases. While originally theorized by Richard Feynmann as a potentially efficient way of simulating some classically intractable many-body systems, quantum computing has since proven to have a stronger and richer potential paving the way for the inception of new algorithms such as Shor’s algorithm for integer factorization, HHL for solving linear system of equation and Grover’s algorithm for constrained binary search, just to name a few. These algorithms provably exhibit an improvement rate that goes respectively exponentially and quadratically in the time complexity. Quantum chemistry is considered a prominent candidate to benefit from quantum computing given the variety of quantum algorithms put forth to solve the electronic structure problem of particular systems of interest. These quantum algorithm proposals can be broadly categorized in three main categories that span the spectrum: from noisy intermediate scale quantum (NISQ) computers to early and full scale fault tolerant quantum ((E)FTQC) computers. Firstly, the variational quantum eigensolver (VQE) family of quantum algorithms which variationally search for the ground state energy through the optimization of the energy of a parametrized state prepared in a quantum computer using an ansatz. Secondly, the quantum Krylov subspace diagonalization (QKSD) methods, which generate a subspace of the original Hilbert space and efficiently produce the lowest energy in said subspace as its output. Lastly, we have the quantum phase estimation (QPE) algorithms, which provably produce the ground state energy in Heisenberg scaling presenting hence a provable efficient solution. In this thesis, we firstly set to work on the problem of efficient Hamiltonian linear combination of unitaries (LCU) representation. This is mainly motivated by the wide-range impact an efficient compression of the Hamiltonian can potentially have on several quantum algorithms such as VQE, QPE...etc. We designed a method that efficiently compress the Hamiltonian representation in a way that is beneficially impactful across the set of the aforementioned quantum algorithms. Namely, we motivate and present in Sections 1.3 and 1.4 respectively, the regularized compressed double-factorization (RC-DF) and show how it reduces the energy measurement complexity both in terms of number of distinct observables and number of samples. Moreover, it also reduces the total depth of the quantum phase estimation circuit thanks to its low normalization factor. Secondly, given the importance of the energy derivatives, in Sections 2.1 and 2.2, we introduce and present an efficient quantum algorithm for the calculation of the analytic gradient of VQE energies of double-factorized Hamiltonians. Furthermore, in Section 2.1, we expand on the utility of RC-DF by presenting a quantum algorithm that determines the analytic gradient of energies measured with respect to RC-DF Hamiltonains. Third, in Section 3.1, we summarize the theoretical results of purification error-mitigation techniques, namely echo verification and virtual distillation. In Section 3.2, we report on the results of the experimental bench mark, of said techniques, performed on on Google’s Sycamore device to validate the theoretical scaling of error suppression and extrapolate the resources needed for classically intractable system sizes. Fourth, in Section 4 we establish the challenges of computing energy gradients in a quantum Krylov frame work. To overcome the problem, we provide, in Section 4.3, an efficient quantum algorithm for calculating energy derivative obtained through QKSD procedures. Our approach shows how the QKSD ground state can be prepared using quantum signal processing (QSP) and reduces the number of observables to O(1) per reduced density matrix (RDM). Lastly, in light of the importance of quantum RAMs due to their utility in a variety of quantum algorithms that require efficient initial state preparation, as explained in Section 5.5, we address the problematic exponential depth of the bucket-brigade QRAM (when decomposed). We present in Section 5.6 a very efficient Clifford+T decomposition of the bucket-brigade QRAM, which preserves the linear scaling of the depth of the circuit without introducing any additional ancilla.
Preparing the ground state of a given Hamiltonian and estimating its ground energy are important but computationally hard tasks. However, given some additional information, these problems can be solved efficiently on a quantum computer. We assume that an initial state with non-trivial overlap with the ground state can be efficiently prepared, and the spectral gap between the ground energy and the first excited energy is bounded from below. With these assumptions we design an algorithm that prepares the ground state when an upper bound of the ground energy is known, whose runtime has a logarithmic dependence on the inverse error. When such an upper bound is not known, we propose a hybrid quantum-classical algorithm to estimate the ground energy, where the dependence of the number of queries to the initial state on the desired precision is exponentially improved compared to the current state-of-the-art algorithm proposed in [Ge et al. 2019]. These two algorithms can then be combined to prepare a ground state without knowing an upper bound of the ground energy. We also prove that our algorithms reach the complexity lower bounds by applying it to the unstructured search problem and the quantum approximate counting problem.
In the problem of ground-state energy estimation, one aims to estimate the smallest eigenvalue of a Hamiltonian, often given a guiding state, with some promised overlap γ with the ground space. The main approach to this problem is to simulate its evolution, and estimate the smallest (or equivalently, largest) eigenphase of the resulting unitary U. We give a quantum algorithm that estimates the largest eigenphase of a unitary U in this guided setting using a factor of logγ1 fewer queries to U than the previous best approach. The result matches an existing lower bound, and answers an open question from Mande and de Wolf. The algorithm is based on transducers, which often allow composition of quantum algorithms without overhead from error reduction.