Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2410.23162 · Optics Express

Kinetic inductance and jitter dependence of intrinsic photon-number resolution in superconducting nanowire single-photon detectors

Roland Jaha, Connor A. Graham-Scott, Adrian S. Abazi, Wolfram H. P. Pernice, Carsten Schuck, Simone Ferrari

Published Aug 5, 2025• 7 citations
arXivHTMLPDF

Abstract

Photon-number resolution (PNR) is crucial in quantum information technology. Time-resolved measurements applied to superconducting nanowire single-photon detectors (SNSPDs) have recently demonstrated intrinsic PNR capabilities, complementing their superior efficiency, speed, and timing precision. Using waveguide-integrated SNSPDs, we investigate the impact of nanowire kinetic inductance and system jitter on intrinsic PNR, identifying the trade-off between intrinsic PNR and detector speed. Increasing the kinetic inductance from 165 nH to 872 nH enhances the PNR quality by 12%, 31%, and 23% for the first three photon numbers but reduces the maximum count rate from 165 Mcps to 19 Mcps.

DOI
10.1364/oe.564311

Related papers

Characterize the Speed of a Photon-Number-Resolving Superconducting Nanowire Detector

Tao Xu, Hao Hao, Xiang Li +8 more

Superconducting series nanowire single-photon detectors (SNDs) have been used for resolving photon numbers. But it can also exhibit a higher counting rate than a single superconducting nanowire single-photon detector (SNSPD), because the serial architecture allows multiple detectors working in parallel and the inductance of each pixel is reduced. In this paper, we found each pixel of the SND could reset fast although the whole detector took a much longer time for recovering. Therefore, the speed of an SND with a large kinetic inductance of 1.25 μH was characterized and compared to a standard SNSPD with the same total inductance. By measuring the detected photon rate over the input photon rate, we obtained a photon counting rate enhancement by 7.5 times. Meanwhile, the timing jitter of the SND was 63 ps at single photon detection regime. Our results show that the series structure and the readout scheme are quite practical in realizing high speed single-photon detectors besides resolving photon numbers.

IEEE photonics journal•Jul 28, 2020•12 citations

Intrinsically-limited timing jitter in molybdenum silicide superconducting nanowire single-photon detectors

Misael Caloz, Boris A. Korzh, Edward Ramirez +5 more

Recent progress in the development of superconducting nanowire single-photon detectors (SNSPDs) has delivered excellent performance and has had a great impact on a range of research fields. The timing jitter, which denotes the temporal resolution of the detection, is a crucial parameter for many applications. Despite extensive work since their apparition, the lowest jitter achievable with SNSPDs is still not clear, and the origin of the intrinsic limits is not fully understood. Understanding its intrinsic behavior and limits is a mandatory step toward improvements. Here, we report our experimental study on the intrinsically-limited timing jitter in molybdenum silicide SNSPDs. We show that to reach intrinsic jitter, crucial properties such as the latching current and the kinetic inductance of the devices have to be understood. The dependence on the nanowire thickness and the energy dependence of the intrinsic jitter are quantified, and the origin of the limits is exhibited. System timing jitter of 6.0 ps at 532 nm and 10.6 ps at 1550 nm photon wavelength has been obtained.

arXiv:1906.02073•Journal of Applied Physics•Oct 22, 2019•30 citations

Resolving Photon Numbers Using Ultra-High-Resolution Timing of a Single Low-Jitter Superconducting Nanowire Detector

Sauer, Gregor, Mirco Kolarczik, Rodrigo Gómez +2 more

Photon-number-resolving (PNR) detectors are a key enabling technology in photonic quantum information processing. Here, we demonstrate the PNR capacity of conventional superconducting nanowire single-photon detectors by performing ultra-high-resolution time-tagging of the detector-generated electrical pulses. This method provides a viable approach for PNR with high detection efficiency and a high operational repetition rate. We present the implementation of such a PNR detector in the telecom C-band and its characterization by measuring the photon-number statistics of coherent light with tunable intensity. Additionally, we demonstrate the capabilities of the detection method by measuring photon-number correlations of non-classical states.

arXiv:2310.12472•Oct 19, 2023•18 citations

Practical considerations for assignment of photon numbers with SNSPDs

Timon Schapeler, Isabell Mischke, Fabian Schlue +4 more

Superconducting nanowire single-photon detectors (SNSPDs) can enable photon-number resolution (PNR) based on accurate measurements of the detector’s response time to few-photon optical pulses. In this work, we investigate the impact of the optical pulse shape and duration on the accuracy of this method. We find that Gaussian temporal pulse shapes yield cleaner arrival-time histograms and, thus, more accurate PNR, compared to bandpass-filtered pulses of equal bandwidth. For low system jitter and an optical pulse duration comparable to the other jitter contributions, photon numbers can be discriminated in our system with a commercial SNSPD. At 60 ps optical pulse duration, photon-number discrimination is significantly reduced. Furthermore, we highlight the importance of using the correct arrival-time histogram model when analyzing photon-number assignment. Using exponentially modified Gaussian distributions, instead of the commonly used Gaussian distributions, we can more accurately determine photon-number misidentification probabilities. Finally, we reconstruct the positive operator-valued measures of the detector, revealing sharp features that indicate the intrinsic PNR capabilities.

arXiv:2510.00714•APL Quantum•Jan 2, 2026•7 citations

Optimizing photon-number resolution with superconducting nanowire multi-photon detectors

Timon Schapeler, Fabian Schlue, Michael Stefszky +3 more

In this paper we briefly review the state-of-the-art of intrinsic photon-number resolution (PNR) with superconducting nanowire single-photon detectors (SNSPDs) and will provide an overview of the various experimental techniques employed to achieve PNR. Additionally, we introduce a resolvability criterion to PNR based on SNSPDs.

arXiv:2505.09271•May 30, 2025•3 citations

Photon-Number-Resolving Single-Photon Detector with a System Detection Efficiency of 98% and Photon-Number Resolution of 32

Chaomeng Ding, Xing-Yu Zhang, Jia-Min Xiong +8 more

High Resolution Image Download MS PowerPoint Slide Efficiently distinguishing photon numbers is a crucial yet challenging technology for various quantum information and quantum metrology applications. While superconducting transition edge sensors offer good photon-number-resolving (PNR) capabilities, they are hampered by low detection speed, timing jitter, and complex cooling and readout requirements. In this work, we present a significant advancement toward achieving high-fidelity PNR single-photon detectors by combing high efficiency superconducting nanowire single-photon detector and spatial multiplexing technology. The unique twin-layer configuration of superconducting nanowire atop a dielectric mirror ensures the near-unity detection efficiency. The segmented design, where each section is shunted by a resistor, enables spatial multiplexing, establishing a mapping relationship between pulse amplitude and registered photons. The fabricated detector exhibits impressive performance metrics, including a single-photon system detection efficiency (SDE) of ∼98% at a dark count rate of 20 cps and photon-number resolution capability up to 32. Further characterization through detector tomography reveals high fidelities for two-, three-, and four-photon events, approximately 87%, 73%, and 40% respectively. Moreover, the detector operates at a high count rate of 41 MHz at 3 dB-SDE, with a low timing jitter of as low as 40 ps. With its near-unity efficiency, high photon-number resolution, low dark count rate, fast detection speed, and superior timing resolution, we expect significant interest in these detectors, promising substantial benefits for weak light detection and optical quantum information applications.

arXiv:2504.02202•ACS Photonics•Jul 4, 2025•24 citations
Photon-number resolution (PNR) is crucial in quantum information technology. Time-resolved measurements applied to superconducting nanowire single-photon detectors (SNSPDs) have recently demonstrated intrinsic PNR capabilities, complementing their superior efficiency, speed, and timing precision. Using waveguide-integrated SNSPDs, we investigate the impact of nanowire kinetic inductance and system jitter on intrinsic PNR, identifying the trade-off between intrinsic PNR and detector speed. Increasing the kinetic inductance from 165 nH to 872 nH enhances the PNR quality by 12%, 31%, and 23% for the first three photon numbers but reduces the maximum count rate from 165 Mcps to 19 Mcps.
Superconducting series nanowire single-photon detectors (SNDs) have been used for resolving photon numbers. But it can also exhibit a higher counting rate than a single superconducting nanowire single-photon detector (SNSPD), because the serial architecture allows multiple detectors working in parallel and the inductance of each pixel is reduced. In this paper, we found each pixel of the SND could reset fast although the whole detector took a much longer time for recovering. Therefore, the speed of an SND with a large kinetic inductance of 1.25 μH was characterized and compared to a standard SNSPD with the same total inductance. By measuring the detected photon rate over the input photon rate, we obtained a photon counting rate enhancement by 7.5 times. Meanwhile, the timing jitter of the SND was 63 ps at single photon detection regime. Our results show that the series structure and the readout scheme are quite practical in realizing high speed single-photon detectors besides resolving photon numbers.
Recent progress in the development of superconducting nanowire single-photon detectors (SNSPDs) has delivered excellent performance and has had a great impact on a range of research fields. The timing jitter, which denotes the temporal resolution of the detection, is a crucial parameter for many applications. Despite extensive work since their apparition, the lowest jitter achievable with SNSPDs is still not clear, and the origin of the intrinsic limits is not fully understood. Understanding its intrinsic behavior and limits is a mandatory step toward improvements. Here, we report our experimental study on the intrinsically-limited timing jitter in molybdenum silicide SNSPDs. We show that to reach intrinsic jitter, crucial properties such as the latching current and the kinetic inductance of the devices have to be understood. The dependence on the nanowire thickness and the energy dependence of the intrinsic jitter are quantified, and the origin of the limits is exhibited. System timing jitter of 6.0 ps at 532 nm and 10.6 ps at 1550 nm photon wavelength has been obtained.
Photon-number-resolving (PNR) detectors are a key enabling technology in photonic quantum information processing. Here, we demonstrate the PNR capacity of conventional superconducting nanowire single-photon detectors by performing ultra-high-resolution time-tagging of the detector-generated electrical pulses. This method provides a viable approach for PNR with high detection efficiency and a high operational repetition rate. We present the implementation of such a PNR detector in the telecom C-band and its characterization by measuring the photon-number statistics of coherent light with tunable intensity. Additionally, we demonstrate the capabilities of the detection method by measuring photon-number correlations of non-classical states.
Superconducting nanowire single-photon detectors (SNSPDs) can enable photon-number resolution (PNR) based on accurate measurements of the detector’s response time to few-photon optical pulses. In this work, we investigate the impact of the optical pulse shape and duration on the accuracy of this method. We find that Gaussian temporal pulse shapes yield cleaner arrival-time histograms and, thus, more accurate PNR, compared to bandpass-filtered pulses of equal bandwidth. For low system jitter and an optical pulse duration comparable to the other jitter contributions, photon numbers can be discriminated in our system with a commercial SNSPD. At 60 ps optical pulse duration, photon-number discrimination is significantly reduced. Furthermore, we highlight the importance of using the correct arrival-time histogram model when analyzing photon-number assignment. Using exponentially modified Gaussian distributions, instead of the commonly used Gaussian distributions, we can more accurately determine photon-number misidentification probabilities. Finally, we reconstruct the positive operator-valued measures of the detector, revealing sharp features that indicate the intrinsic PNR capabilities.
High Resolution Image Download MS PowerPoint Slide Efficiently distinguishing photon numbers is a crucial yet challenging technology for various quantum information and quantum metrology applications. While superconducting transition edge sensors offer good photon-number-resolving (PNR) capabilities, they are hampered by low detection speed, timing jitter, and complex cooling and readout requirements. In this work, we present a significant advancement toward achieving high-fidelity PNR single-photon detectors by combing high efficiency superconducting nanowire single-photon detector and spatial multiplexing technology. The unique twin-layer configuration of superconducting nanowire atop a dielectric mirror ensures the near-unity detection efficiency. The segmented design, where each section is shunted by a resistor, enables spatial multiplexing, establishing a mapping relationship between pulse amplitude and registered photons. The fabricated detector exhibits impressive performance metrics, including a single-photon system detection efficiency (SDE) of ∼98% at a dark count rate of 20 cps and photon-number resolution capability up to 32. Further characterization through detector tomography reveals high fidelities for two-, three-, and four-photon events, approximately 87%, 73%, and 40% respectively. Moreover, the detector operates at a high count rate of 41 MHz at 3 dB-SDE, with a low timing jitter of as low as 40 ps. With its near-unity efficiency, high photon-number resolution, low dark count rate, fast detection speed, and superior timing resolution, we expect significant interest in these detectors, promising substantial benefits for weak light detection and optical quantum information applications.