Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2409.18349 · Applied Physics Letters

Influence of bias-voltage noise on the inelastic cooper-pair tunneling amplifier (ICTA)

Ulrich Martel, Romain Albert, Florian Blanchet, J. Griesmar, G. Ouellet, Hugo Therrien, N. Nehra, Nicolas Bourlet, A. Peugeot, M. Hofheinz

Published Feb 17, 2025• 3 citations
arXivHTMLPDF

Abstract

We experimentally show that the inelastic cooper-pair tunneling amplifier (ICTA), implementing a DC-powered parametric amplification scheme, can achieve gain and noise performance similar to that of AC-powered Josephson parametric amplifiers. Using experimental data and simulations, we show that the ICTA has near-quantum-limited noise as long as low-frequency voltage noise, expressed as broadening of the Josephson frequency line, is narrower than the amplification bandwidth. We observe a gain of 20 dB across a 11 MHz bandwidth with noise below 1.7 times the quantum limit when the full width at half maximum of the Josephson frequency linewidth is 5.6 MHz.

DOI
10.1063/5.0240842

Related papers

DC-powered broadband quantum-limited microwave amplifier

N. Nehra, N. Bourlet, A. H. Esmaeili +7 more

Fast, high-fidelity, single-shot readout of superconducting qubits in quantum processors demands quantum-limited amplifiers to preserve the optimal signal-to-noise ratio. Typically, quantum-limited amplification is achieved with parametric down-conversion of a strong pump tone, which imposes significant hardware overhead and severely limits scalability. Here, we demonstrate the first DC-powered broadband amplifier operating within 0.2 photons of the quantum limit. Our impedance-engineered Inelastic Cooper-pair Tunneling Amplifier (ICTA)-a voltage-biased SQUID in which Cooper pairs tunnel inelastically by emitting signal-idler photon pairs-operates in reflection, delivering 13 dB of average gain across a 3.5 GHz bandwidth in a single stage. Semiclassical simulations accurately predict the gain and saturation power, enabling further design improvements. By eliminating the pump-tone infrastructure, the broadband ICTA promises to dramatically reduce the hardware complexity of quantum-limited amplification in superconducting quantum processors.

quant-pharXiv:2512.19902•Physical Review Applied•Dec 24, 2025•2 citations

Phase-stable voltage bias for Josephson photonics devices

Amir Hosein Esmaeili, Naveen Nehra, Alexandre Paquette +8 more

Parametric interactions are foundational to superconducting quantum technologies, yet conventional microwave-driven pumping introduces parasitic Kerr nonlinearities and higher-order harmonics that limit device performance. Josephson Photonics (JP) avoids these parasitics by utilizing dc-biased junctions but has remained constrained by high phase noise and the absence of a stable phase reference. Here, we overcome this limitation by integrating a Josephson voltage standard (JVS) to establish a noise-tolerant phase reference, and demonstrate that this reference is coherently transferred to an inelastic Cooper-pair tunneling amplifier (ICTA) via the superconducting order parameter. The resulting low-phase-noise architecture yields a 14-dB enhancement in averaged gain and better quantum-limited noise performance. Critically, the phase reference enables the first observation of phase-sensitive gain and squeezing in a dc-biased amplifier. By reconciling clean, Kerr-free nonlinearities with phase-coherent drive, our architecture establishes a robust platform for high-purity parametric processes in superconducting circuits.

quant-pharXiv:2609.17165•Sep 16, 2026•1 citation

Shunted Josephson tunnel junctions: High-frequency, self-pumped low noise amplifiers

Nils P. Calander, T. Claeson, S. Rudner

The high-frequency amplification properties of transformer coupled, resistively shunted Josephson tunnel junctions have been investigated. The importance of the shunt loop inductance is stressed. It allows a high cutoff frequency, of significance for good high-frequency performance. The self-pumped parametric amplifier showed none of the excessive noise rise, which has hitherto plagued the development of externally pumped Josephson junction amplifiers. Around 10 GHz, we estimated a noise temperature less than 30 K for an amplifier pumped by a Josephson oscillation with a frequency well above twice the signal frequency. The corresponding gain of 5 dB may be increased in a better impedance matched circuit. The gain was very stable against variations in the bias conditions. A gain-bandwidth product as high as 0.3 was registered. The experimental results agreed well with the established theory for self-pumped parametric Josephson amplifiers. It should be possible to extend the low noise amplification by this device to mm wave frequencies. A relaxation oscillation occurred at a subharmonic of the Josephson frequency when the shunt loop inductance became large. The amplification in this mode followed closely the predictions of a simple model, where the signal modulated the switching of the sawtooth-like (relatively low frequency) relaxation current. Gains of about 15 dB were measured around 10 GHz, but the amplification was sensitive to bias conditions and noisy in this case where the relaxation frequency fell well below the signal frequency. Much improved properties were registered when the inductance was decreased so that the relaxation frequency approached the Josephson frequency and exceeded twice the signal frequency. The behavior then resembled that of a Josephson mode parametric amplifier, but the high content of harmonics of a relaxation oscillation meant that the amplifier became noisier due to converted noise from the many idler frequencies.

Journal of Applied Physics•Jul 1, 1982•26 citations

Low-noise self-pumped Josephson tunnel junction amplifier

Nils P. Calander, T. Claeson, S. Rudner

We have studied the parametric amplification properties of an internally pumped Josephson tunnel junction, where the shunt contained resistive and inductive components. The amplification was, in this case, limited by circuit component values to less than 8 dB at 10 GHz, but it was very stable against variations in bias conditions. The amplifier gain-bandwidth product was large and the noise level very low. We estimated the noise temperature to be less than 50 K, which should make the device attractive for mm-wave amplification.

Applied Physics Letters•Oct 15, 1981•10 citations

Arrays of Josephson tunnel junctions as parametric amplifiers

S. Wahlsten, S. Rudner, T. Claeson

Arrays of 10 or 40 series-connected small densely packed Josephson tunnel junctions were successfully operated as parametric amplifiers at 10 GHz. Between 50 and 90% of the junctions in an array were observed to work coherently in the amplification process. Signal gain exceeding 24 dB was achieved with a pump power as low as −50 to −70 dBm. A power width (i.e., the range of the pump power for a gain within 3 dB of the peak gain) of 0.25 dB and a bandwidth of 15 MHz were measured for 20-dB gain. The power width was in accordance with theory but the bandwidth was reduced, probably due to noise saturation effects. The latter effects can be reduced by lowering the input noise temperature or by including an external band limitation. The noise temperature was also increased by saturation; however, with an external bandwidth of 60 MHz, a noise temperature of 30±20 K was measured. The application of a magnetic field has proved extremely useful as a means of tuning the amplifiers to stable high-gain operating points. This tuning was also utilized in evaluating the amplifier parameters, and the theory by Feldman, Parrish, and Chiao has been verified. The upper frequency limit for a lead tunnel junction amplifier ought to be well above 300 GHz.

Journal of Applied Physics•Jul 1, 1978•61 citations

Low noise parametric upconversion with a self-pumped Josephson junction

Helmut Kanter

Experimental results are reported on a Josephson parametric upconverting amplifier which is self-pumped via the internal Josephson oscillations derived from a dc bias voltage. A niobium point-contact SQUID is simultaneously coupled to a 115-MHz tank circuit and a 9-GHz cavity. Josephson oscillations at 9 GHz produce parametric upconversion of power in the 115-MHz circuit to sidebands at 9±0.115 GHz with measured power gain of 25. The amplifier noise temperature, referred to the input at 115 MHz, was established to be <15 K by varying the temperature of an input termination from 4.2 to 300 K. This result establishes the behavior of self-pumped SQUID upconverters at microwave frequencies and demonstrates that the achievable noise performance is not greatly in excess of the thermal limit.

Journal of Applied Physics•May 1, 1975•3 citations
We experimentally show that the inelastic cooper-pair tunneling amplifier (ICTA), implementing a DC-powered parametric amplification scheme, can achieve gain and noise performance similar to that of AC-powered Josephson parametric amplifiers. Using experimental data and simulations, we show that the ICTA has near-quantum-limited noise as long as low-frequency voltage noise, expressed as broadening of the Josephson frequency line, is narrower than the amplification bandwidth. We observe a gain of 20 dB across a 11 MHz bandwidth with noise below 1.7 times the quantum limit when the full width at half maximum of the Josephson frequency linewidth is 5.6 MHz.
Fast, high-fidelity, single-shot readout of superconducting qubits in quantum processors demands quantum-limited amplifiers to preserve the optimal signal-to-noise ratio. Typically, quantum-limited amplification is achieved with parametric down-conversion of a strong pump tone, which imposes significant hardware overhead and severely limits scalability. Here, we demonstrate the first DC-powered broadband amplifier operating within 0.2 photons of the quantum limit. Our impedance-engineered Inelastic Cooper-pair Tunneling Amplifier (ICTA)-a voltage-biased SQUID in which Cooper pairs tunnel inelastically by emitting signal-idler photon pairs-operates in reflection, delivering 13 dB of average gain across a 3.5 GHz bandwidth in a single stage. Semiclassical simulations accurately predict the gain and saturation power, enabling further design improvements. By eliminating the pump-tone infrastructure, the broadband ICTA promises to dramatically reduce the hardware complexity of quantum-limited amplification in superconducting quantum processors.
Parametric interactions are foundational to superconducting quantum technologies, yet conventional microwave-driven pumping introduces parasitic Kerr nonlinearities and higher-order harmonics that limit device performance. Josephson Photonics (JP) avoids these parasitics by utilizing dc-biased junctions but has remained constrained by high phase noise and the absence of a stable phase reference. Here, we overcome this limitation by integrating a Josephson voltage standard (JVS) to establish a noise-tolerant phase reference, and demonstrate that this reference is coherently transferred to an inelastic Cooper-pair tunneling amplifier (ICTA) via the superconducting order parameter. The resulting low-phase-noise architecture yields a 14-dB enhancement in averaged gain and better quantum-limited noise performance. Critically, the phase reference enables the first observation of phase-sensitive gain and squeezing in a dc-biased amplifier. By reconciling clean, Kerr-free nonlinearities with phase-coherent drive, our architecture establishes a robust platform for high-purity parametric processes in superconducting circuits.
The high-frequency amplification properties of transformer coupled, resistively shunted Josephson tunnel junctions have been investigated. The importance of the shunt loop inductance is stressed. It allows a high cutoff frequency, of significance for good high-frequency performance. The self-pumped parametric amplifier showed none of the excessive noise rise, which has hitherto plagued the development of externally pumped Josephson junction amplifiers. Around 10 GHz, we estimated a noise temperature less than 30 K for an amplifier pumped by a Josephson oscillation with a frequency well above twice the signal frequency. The corresponding gain of 5 dB may be increased in a better impedance matched circuit. The gain was very stable against variations in the bias conditions. A gain-bandwidth product as high as 0.3 was registered. The experimental results agreed well with the established theory for self-pumped parametric Josephson amplifiers. It should be possible to extend the low noise amplification by this device to mm wave frequencies. A relaxation oscillation occurred at a subharmonic of the Josephson frequency when the shunt loop inductance became large. The amplification in this mode followed closely the predictions of a simple model, where the signal modulated the switching of the sawtooth-like (relatively low frequency) relaxation current. Gains of about 15 dB were measured around 10 GHz, but the amplification was sensitive to bias conditions and noisy in this case where the relaxation frequency fell well below the signal frequency. Much improved properties were registered when the inductance was decreased so that the relaxation frequency approached the Josephson frequency and exceeded twice the signal frequency. The behavior then resembled that of a Josephson mode parametric amplifier, but the high content of harmonics of a relaxation oscillation meant that the amplifier became noisier due to converted noise from the many idler frequencies.
We have studied the parametric amplification properties of an internally pumped Josephson tunnel junction, where the shunt contained resistive and inductive components. The amplification was, in this case, limited by circuit component values to less than 8 dB at 10 GHz, but it was very stable against variations in bias conditions. The amplifier gain-bandwidth product was large and the noise level very low. We estimated the noise temperature to be less than 50 K, which should make the device attractive for mm-wave amplification.
Arrays of 10 or 40 series-connected small densely packed Josephson tunnel junctions were successfully operated as parametric amplifiers at 10 GHz. Between 50 and 90% of the junctions in an array were observed to work coherently in the amplification process. Signal gain exceeding 24 dB was achieved with a pump power as low as −50 to −70 dBm. A power width (i.e., the range of the pump power for a gain within 3 dB of the peak gain) of 0.25 dB and a bandwidth of 15 MHz were measured for 20-dB gain. The power width was in accordance with theory but the bandwidth was reduced, probably due to noise saturation effects. The latter effects can be reduced by lowering the input noise temperature or by including an external band limitation. The noise temperature was also increased by saturation; however, with an external bandwidth of 60 MHz, a noise temperature of 30±20 K was measured. The application of a magnetic field has proved extremely useful as a means of tuning the amplifiers to stable high-gain operating points. This tuning was also utilized in evaluating the amplifier parameters, and the theory by Feldman, Parrish, and Chiao has been verified. The upper frequency limit for a lead tunnel junction amplifier ought to be well above 300 GHz.
Experimental results are reported on a Josephson parametric upconverting amplifier which is self-pumped via the internal Josephson oscillations derived from a dc bias voltage. A niobium point-contact SQUID is simultaneously coupled to a 115-MHz tank circuit and a 9-GHz cavity. Josephson oscillations at 9 GHz produce parametric upconversion of power in the 115-MHz circuit to sidebands at 9±0.115 GHz with measured power gain of 25. The amplifier noise temperature, referred to the input at 115 MHz, was established to be <15 K by varying the temperature of an input termination from 4.2 to 300 K. This result establishes the behavior of self-pumped SQUID upconverters at microwave frequencies and demonstrates that the achievable noise performance is not greatly in excess of the thermal limit.