We propose a quantum imaging-inspired setup for measuring gravitational fields using an atom that emits a photon at one of two possible locations. The atom acquires a gravitationally induced quantum phase that it shares with the photon. By restoring the path identity of the atom after its interaction with the gravitational field, the gravitationally induced phase can be measured using photon interferometry without the need for additional measurements on the atom. Through repeated measurements with varying interferometric setups, the gravitational potential and inertial acceleration can be deduced.
We propose a quantum imaging-inspired setup for measuring gravitational fields using an atom that emits a photon at one of two possible locations. The atom acquires a gravitationally induced quantum phase that it shares with the photon. By restoring the path identity of the atom after its interaction with the gravitational field, the gravitationally induced phase can be measured using photon interferometry without the need for additional measurements on the atom. Through repeated measurements with varying interferometric setups, the gravitational potential and inertial acceleration can be deduced.
A transportable atom interferometer-based gravity gradiometer has been developed at JPL to carry out measurements of Earth's gravity field at ever finer spatial resolutions, and to facilitate high-resolution monitoring of temporal variations in the gravity field from ground- and flight-based platforms. Existing satellite-based gravity missions such as CHAMP and GRACE measure the gravity field via precise monitoring of the motion of the satellites; i.e. the satellites themselves function as test masses. JPL's quantum gravity gradiometer employs a quantum phase measurement technique, similar to that employed in atomic clocks, made possible by recent advances in laser cooling and manipulation of atoms. This measurement technique is based on atomwave interferometry, and individual laser-cooled atoms are used as drag-free test masses. The quantum gravity gradiometer employs two identical atom interferometers as precision accelerometers to measure the difference in gravitational acceleration between two points (Figure 1). By using the same lasers for the manipulation of atoms in both interferometers, the accelerometers have a common reference frame and non-inertial accelerations are effectively rejected as common mode noise in the differential measurement of the gravity gradient. As a result, the dual atom interferometer-based gravity gradiometer allows gravity measurements on a moving platform, while achieving the same long-term stability of the best atomic clocks. In the laboratory-based prototype (Figure 2), the cesium atoms used in each atom interferometer are initially collected and cooled in two separate magneto-optic traps (MOTs). Each MOT, consisting of three orthogonal pairs of counter-propagating laser beams centered on a quadrupole magnetic field, collects up to 10(exp 9) atoms. These atoms are then launched vertically as in an atom fountain by switching off the magnetic field and introducing a slight frequency shift between pairs of lasers to create a moving rest frame for the trapped atoms. While still in this moving-frame molasses, the laser frequencies are further detuned from the atomic resonance (while maintaining this relative frequency shift) to cool the atom cloud's temperature to 2 K or below, corresponding to an rms velocity of less than 2 cm/s. After launch, the cold atoms undergo further state and velocity selection to prepare for atom interferometry. The atom interferometers are then realized using laser-induced stimulated Raman transitions to perform the necessary manipulations of each atom, and the resulting interferometer phase is measured using laser-induced fluorescence for state-normalized detection. More than 20 laser beams with independent controls of frequency, phase, and intensity are required for this measurement sequence. This instrument can facilitate the study of Earth's gravitational field from surface and air vehicles, as well as from space by allowing gravity mapping from a low-cost, single spacecraft mission. In addition, the operation of atom interferometer-based instruments in space offers greater sensitivity than is possible in terrestrial instruments due to the much longer interrogation times available in the microgravity environment. A space-based quantum gravity gradiometer has the potential to achieve sensitivities similar to the GRACE mission at long spatial wavelengths, and will also have resolution similar to GOCE for measurement at shorter length scales.
The effect of the Earth's gravitational potential on a quantum wave function has only been observed for massive particles. In this paper we present a scheme to measure a gravitationally induced phase shift on a single photon traveling in a coherent superposition along different paths of an optical fiber interferometer. To create a measurable signal for the interaction between the static gravitational potential and the wave function of the photon, we propose a variant of a conventional Mach–Zehnder interferometer. We show that the predicted relative phase difference of 10 −5 rad is measurable even in the presence of fiber noise, provided additional stabilization techniques are implemented for each arm of a large-scale fiber interferometer. Effects arising from the rotation of the Earth and the material properties of the fibers are analysed. We conclude that optical fiber interferometry is a feasible way to measure the gravitationally induced phase shift on a single-photon wave function, and thus provides a means to corroborate the equivalence of the energy of the photon and its effective gravitational mass.
A promising route to testing quantum gravity in the laboratory is to look for gravitationally induced entanglement (GIE) between two or more quantum matter systems. To date, proposed tests have primarily focused on microsolid platforms prepared in highly nonclassical states, such as N00N states or strongly squeezed states. Here, we instead consider measuring GIE in atom interferometry as evidence of quantum gravity. We propose placing two atom interferometers next to each other in parallel and looking for correlations in the atom-number statistics at their output ports. Importantly, GIE is possible without challenging macroscopic superposition states, such as N00N or Schrödinger-cat states. Instead, GIE can arise using coherent, near-classical atomic states, substantially reducing the experimental complexity. Observing the effect in this regime would require the total mass of the atom interferometers to be near the Planck mass scale. However, we show that state-of-the-art quantum squeezing techniques in cold-atom systems can significantly lower this mass requirement, and outline realistic pathways by which the necessary mass scales could be achieved in the near future, placing laboratory tests of GIE with atom interferometers within reach.
We describe two experiments where atom interferometry is applied for precision measurements of gravitational effects. In the first, we measure the Newtonian gravitational constant G using an atom interferometry gravity-gradiometer which combines a rubidium fountain, a juggling scheme for fast launch of two atomic clouds, and Raman interferometry. We show that the sensor is able to detect the gravitational field produced by source masses and G is measured with better than 10-2 accuracy. In the second experiment, using ultra-cold strontium atoms in a vertical optical lattice and observing persistent Bloch oscillations for several seconds, we measure gravity acceleration with micromet-ric spatial resolution. We discuss the prospects for the study of gravitational forces at short distances and show that unexplored regions can be investigated in the search for deviations from Newtonian gravity.
Atom interferometry is a quantum sensor technology that uses ultra-cold atoms placed in entangled quantum states to detect minute changes in local fields arising from gravitational waves and ultra-light dark matter. Their extreme sensitivity to accelerations has been demonstrated for measurements of Newton’s gravitation constant, tests of the Equivalence Principle, and measurement of local gravity gradients. The search for ultra-light dark matter and measurements of gravitational waves requires interferometer baselines greater than approximately 100 m. In understanding the fundamental systematics and backgrounds of these detectors, we have discovered that atmospheric and seismic effects, even though physically decoupled from the atoms which are in vacuum and free-fall, are still detectable by the quantum phase of the atoms. From a different perspective these “noise” sources are also interesting signals that we may be able to understand better with these sensor platforms leading to cross-disciplinary studies in Earth sciences.
The creation of delocalized coherent superpositions of quantum systems experiencing different relativistic effects is an important milestone in future research at the interface of gravity and quantum mechanics.This milestone could be achieved by generating a superposition of quantum clocks that follow paths with different gravitational time dilation and investigating the consequences on the interference signal when they are eventually recombined.Light-pulse atom interferometry with elements employed in optical atomic clocks is a promising candidate for that purpose, but it suffers from major challenges including its insensitivity to the gravitational redshift in a uniform field.All of these difficulties can be overcome with the novel scheme presented here, which is based on initializing the clock when the spatially separate superposition has already been generated and performing a doubly differential measurement where the differential phase shift between the two internal states is compared for different initialization times.This scheme can be exploited to test the universality of the gravitational redshift with delocalized coherent superpositions of quantum clocks, and it is argued that its experimental implementation should be feasible with a new generation of 10-meter atomic fountains that will soon become available.Interestingly, the approach also offers significant advantages for more compact setups based on guided interferometry or hybrid configurations.Furthermore, in order to provide a solid foundation for the analysis of the various interferometry schemes and the effects that can be measured with them, a general formalism for a relativistic description of atom interferometry in curved spacetime is developed.It can describe freely falling atoms as well as the effects of external forces and guiding potentials, and it can be applied to a very wide range of situations.As an important ingredient for quantum-clock interferometry, suitable diffraction mechanisms for atoms in internal-state superpositions are investigated too.Finally, the relation of the proposed doubly differential measurement scheme to other experimental approaches and to tests of the universality of free fall is discussed in detail.