Abstract Josephson junctions supply the nonlinear inductance element in superconducting qubits. In the widely used transmon configuration, where the junction is shunted by a large capacitor, the low charging energy minimizes the sensitivity of the qubit to charge noise while maintaining the necessary anharmonicity to qubit states. We report here low-frequency transport measurements on small standalone junctions and identically fabricated capacitively-shunted junctions that show two distinct features normally attributed to small capacitance junctions near zero bias: reduced switching currents and prominent finite resistance associated with phase diffusion in the current–voltage characteristic. Our transport data reveals the existence of phase fluctuations in transmons arising from intrinsic junction capacitance.
Abstract Josephson junctions supply the nonlinear inductance element in superconducting qubits. In the widely used transmon configuration, where the junction is shunted by a large capacitor, the low charging energy minimizes the sensitivity of the qubit to charge noise while maintaining the necessary anharmonicity to qubit states. We report here low-frequency transport measurements on small standalone junctions and identically fabricated capacitively-shunted junctions that show two distinct features normally attributed to small capacitance junctions near zero bias: reduced switching currents and prominent finite resistance associated with phase diffusion in the current–voltage characteristic. Our transport data reveals the existence of phase fluctuations in transmons arising from intrinsic junction capacitance.
Josephson junctions (JJs) with Josephson energy EJ≲1 K are widely employed as non-linear elements in superconducting circuits for quantum computing operating at milli-Kelvin temperatures. In the qubits with small charging energy EC ( EJ/EC≫1 ), such as the transmon, the incoherent phase slips (IPS) might become the dominant source of dissipation with decreasing EJ. In this work, a systematic study of the IPS in low-EJ JJs at milli-Kelvin temperatures is reported. Strong suppression of the critical (switching) current and a very rapid growth of the zero-bias resistance due to the IPS are observed with decreasing EJ below 1 K. With further improvement of coherence of superconducting qubits, the observed IPS-induced dissipation might limit the performance of qubits based on low-EJ junctions. These results point the way to future improvements of such qubits.
Superconducting quantum circuits rely on compact, low-loss inductive elements, strong anharmonicity, and robust flux biasing to realize coherent and controllable quantum bits. This thesis investigates how vertically stacked Josephson junction arrays can be employed to meet these requirements and enable compact flux qubits operated in the quarton regime. In the first part, stacked Al/AlOx/Al Josephson junctions are established as compact linear inductors. Their three-dimensional geometry reduces parasitic capacitance to ground while allowing multiple junctions to be integrated within a small footprint. A numerical modeling approach is used to quantify stray capacitances, Coulomb screening, and collective modes of extended stacked junction arrays. Cryogenic transport measurements confirm strongly underdamped junction dynamics with uniform junction characteristics, demonstrating their suitability as low-loss inductive elements in superconducting circuits. In the second part, these inductors are integrated into flux qubits operated in the quarton regime. In this regime, the qubit potential becomes nearly quartic around half-flux bias, resulting in positive anharmonicity and first-order insensitivity to flux noise at the operating point. Spectroscopy reveals qubit transition frequencies in the 3–5 GHz range and anharmonicities of 0.5–1.5 GHz, consistent with the expected quartic potential landscape. To distinguish intrinsic from externally induced decoherence, a persistent-current bias scheme is implemented, enabling stable and low-noise flux biasing over time scales of up to one week. A direct comparison between conventionally biased and persistently biased devices rules out external flux noise as the dominant coherence-limiting mechanism. High-resolution spectroscopy identifies avoided level crossings caused by microscopic two-level systems (TLS) in the amorphous tunnel barriers of the stacked junctions. A systematic cumulative analysis of splitting statistics across multiple devices shows that the spectral TLS density scales with the total tunnel-barrier area, while the array length determines the effective qubit–TLS coupling strength. The measured relaxation times follow scaling relations consistent with Fermi’s golden rule for a bath of weakly coupled TLS, demonstrating that TLS in the stacked junction arrays constitute the dominant intrinsic decoherence channel in quarton qubits. These results establish stacked Josephson junction arrays as compact superinductive elements and provide an understanding of coherence limitations in superconducting quantum circuits based on Josephson junction arrays, offering guidance for future device optimization.
Quantum fluctuations of the charge at a current-biased Josephson junction and of the Josephson current couple to the quasiparticle tunneling when the system is at equilibrium in the zero-voltage state. The effect of reducing the capacitance of the junction is studied by means of a model Hamiltonian. When this becomes smaller, charge fluctuations are reduced, but the effective dissipation is also lowered so that the junction displays an underdamped behavior. The Josephson branch is shifted at the voltage e/2C because of charging due to the quasiparticles. A path-integral formulation of the model leads to a high dynamical subgap resistance at I\ensuremath{\rightarrow}0, as recently found experimentally.
Abstract Josephson superconducting qubits and parametric amplifiers are prominent examples of superconducting quantum circuits that have shown rapid progress in recent years. As such devices become more complex, the requirements for reproducibility of their electrical properties across a chip are being tightened. Critical current of the Josephson junction Ic is the essential electrical parameter in a chip. So, its variation is to be minimized. According to the Ambegaokar–Baratoff formula, critical current is related to normal-state resistance, which can be measured at room temperature. In this study, we focused on the dominant source of non-uniformity for the Josephson junction critical current–junction area variation. We optimized Josephson junction fabrication process and demonstrated resistance variation of 9.8–4.4% and 4.8–2.3% across 22 × 22 mm2 and 5 × 10 mm2 chip areas, respectively. For a wide range of junction areas from 0.008 to 0.12 μm2, we ensure a small linewidth standard deviation of 4 nm measured over 4500 junctions with linear dimensions from 80 to 680 nm. We found that the dominate source of junction area variation limiting Ic I c reproducibility is the imperfection of the evaporation system. The developed fabrication process was tested on superconducting highly coherent transmon qubits (T1 > 100 μs) and a nonlinear asymmetric inductive element parametric amplifier.
Superconducting quantum computing is a solid state quantum computing technology based on Josephson junction circuits. It becomes one of the most promising candidates for realizing practical quantum computer/simulator, because of its scalability, easy to coupling and control, compatibility to semiconductor technologies, etc. As the complicated electromagnetic environment in solid state metal and insulator, superconducting quantum bits (qubits) suffered from shot coherence time since its early development. In this review, we described some recently developed superconducting qubit structures, including Transmon/Xmon, Fluxonium and C-shunt flux qubit. Although these new qubit structures have very different circuit parameters and energy scales, they all find their way to effectively suppress environmental noises. As a result, their coherence time were improved significantly. Transmon, a transmission-line shunted plasma oscillation qubit, was now among the most popular structures for building a multi-qubit superconducting quantum circuit. It introduced a relatively large shunt capacitor to remarkably reduce the charge dispersion. Although the non-linearity is also decreased, by operating in a properly chosen EJ/Ec, transmon can greatly reduce the charge noise while only sacrificing a small amount of non-linearity. Xmon can be considered as a modified version of transmon. It is designed and optimized for multi-qubit operation and measurement with separate X/Y and Z control lines for each qubit, and a readout bus (a transmission line or a low-Q bandpass filter) for simultaneous readout of all the qubits. Fluxonium provide another solution for suppressing the charge noise in Cooper-pair box (CPB). It introduces a large shunt inductance to filter low-frequency offset charge in the small capacitor of the phase-slip junction (the small junction). To keep the qubit operating in the charge region, the shunt inductor should be large enough to keep the impedance larger than the superconducting impedance quantum RQ~1 kΩ. As a result, the inductance can only be provided by a large series of Josephson junctions. Fluxonium keeps the advantage of high anharmonicity of CPB. In addition, it introduces another degree of freedom: external flux Φext. Quasiparticles (electrons or holes) tunneling at the small junction add coherently to produce a ″1+cosφ″ term. As a result, when Φext= Φ0/2, dissipation caused by quasiparticle tunneling is suppressed and the energy relaxation time (T1) increases drastically. C-shunt flux qubit (CSFQ) decreases α and EJ to suppress flux noise in the qubit. While the charge noise becomes the dominant noise source, a large shunt capacitor is added to suppress the charge noise, similar to that in a transmon qubit. It is worth to notice that in CSFQ, the α decreases to below but near 1/2. As a result, the double-well potential no longer exists. The energy structure become similar to transmon, with the anharmonicity be opposite. CSFQ can get a much improved coherence time, while its anharmonicity can be larger than that of transmon. Those new superconducting qubit structures provide different solutions to improve the coherence time. Although it looks much different in circuit models and parameters, they have ideas in common, and may act as guides to other novel designs with longer coherence time. We can summarize as below. (1) The qubit circuit should be free of small superconducting islands. Charge fluctuation in small islands is a major source of decoherence. As a result, increase the area of the islands, that is, increase the capacitance becomes a straight forward way to suppress the charge noise. In Fluxonium, the small junction is connected with a large series of large junctions that there is also no small islands in the whole loop. (2) Remove superconducting loops in the qubit circuit, or minimize the loop size and loop current to suppress flux noise. (3) Bias the phase difference of the small junction to π, where dissipation caused by quasiparticle tunneling can be suppressed coherently. (4) Decrease the coupling bandwidth of qubit to the environment. In a circuit-QED readout scheme, a high-Q readout resonator that dispersively coupled to the qubit protects the qubit from exposed to the electromagnetic environment of the readout circuit. A ″Purcell filter″ can also be added to suppress such decoherence further. In conclusion, we overviewed some qubit engineering techniques or ideas to improve the coherence time, which is a very important figure for building practical quantum computer/simulator. We hope that someone can combine and optimize these ideas, while interact with developments in materials and micro-fabrication technologies, to develop novel new generation superconducting qubit structures in the near future.
Superconducting qubits are a leading platform for quantum computing. However, simultaneously achieving low noise sensitivity to suppress decoherence and sufficient anharmonicity to enable fast gate operations remains a central challenge. Here, we introduce the concept of the ferroelectric transmon (FEmon), in which the Josephson junction is shunted by a ferroelectric, or incipient ferroelectric, capacitor. We show, in particular, that the nonlinear ferroelectric response of the capacitor provides an additional degree of freedom for optimizing qubit anharmonicity while preserving operation in the charge-noise-insensitive regime.