Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2311.13515 · New Journal of Physics

Photon number resolving detection with a single-photon detector and adaptive storage loop

Nicholas M. Sullivan, Boris Braverman, Jeremy Upham, Robert W. Boyd

Published Apr 1, 2024• 9 citations
arXivHTMLPDF

Abstract

Abstract Photon number resolving (PNR) measurements are beneficial or even necessary for many applications in quantum optics. Unfortunately, PNR detectors are usually large, slow, expensive, and difficult to operate. However, if the input signal is multiplexed, photon ‘click’ detectors, that lack an intrinsic PNR capability, can still be used to realize photon number resolution. Here, we investigate the operation of a single click detector, together with a storage line with tunable outcoupling. Using adaptive feedback to adjust the storage outcoupling rate, the dynamic range of the detector can in certain situations be extended by up to an order of magnitude relative to a purely passive setup. An adaptive approach can thus allow for photon number variance below the quantum shot noise limit under a wider range of conditions than using a passive multiplexing approach. This can enable applications in quantum enhanced metrology and quantum computing.

DOI
10.1088/1367-2630/ad3be5

Related papers

Photon Counting with an Adaptive Storage Loop

Boris Braverman, Nicholas M. Sullivan, Robert W. Boyd

Single-photon detectors can be used to resolve photon number by storing the photons in a delay loop. We consider a loop with adaptive, detection-record dependent out-coupling, finding that the dynamic range and effective speed of the detector can be enhanced compared to a purely passive setup.

Frontiers in Optics•Jan 1, 2023•0 citations

Evaluating the performance of photon-number-resolving detectors

Mattias Jönsson, Gunnar G. Bjork

We analyze the performance of photon-number-resolving (PNR) detectors and introduce a figure of merit for the accuracy of such detectors. This figure of merit is the (worst-case) probability that the photon-number-resolving detector correctly predicts the input photon number. Simulations of various PNR detectors based on multiplexed single-photon ``click detectors'' is performed. We conclude that the required quantum efficiency is very high in order to achieve even moderate (up to a handful) photon resolution, we derive the required quantum efficiency as a function of the the maximal photon number one wants to resolve, and we show that the number of click detectors required grows quadratically with the maximal number of photons resolvable.

arXiv:1812.05422•Physical Review A•Apr 16, 2019•53 citations

Theory framework of multiplexed photon-number-resolving detectors

Xiaobin Zhao, Hezheng Qin, Hong X. Tang +2 more

Photon counting is a fundamental component in quantum optics and quantum information. However, implementing ideal photon-number-resolving (PNR) detectors remains experimentally challenging. Multiplexed PNR detection offers a scalable and practical alternative by distributing photons across multiple modes and detecting their presence using simple ON-OFF detectors, thereby enabling approximate photon-number resolution. In this work, we establish a theoretical model for such detectors and prove that the estimation error in terms of photon number moments decreases inverse proportionally to the number of detectors. Thanks to the enhanced PNR capability, multiplexed PNR detector provides an advantage in cat-state breeding protocols. Assuming a two-photon subtraction case, $7$dB of squeezing, and an array of 20 detectors of efficiency $95\%$, our calculation predicts fidelity $\sim0.88$ with a success probability $\sim 3.8\%$, representing orders-of-magnitude improvement over previous works. Similar enhancement also extends to cat-state generation with the generalized photon number subtraction. With experimentally feasible parameters, our results suggest that megahertz-rate cat-state generation is achievable using an on-chip array of \emph{tens} of ON-OFF detectors.

arXiv:2507.05554•Physical Review A•Jan 9, 2026•0 citations

Towards linear optical detection with single photon sensitivity at telecom wavelengths

Saeedeh Jahanmirinejad, Andrea Fiore

Standard linear optical detectors have a maximum sensitivity in the few hundreds of photons range, limited by amplifier noise. On the other hand, single photon detectors, which are the most sensitive detectors, are strongly nonlinear: One or more photons result in the same output signal. Photon number resolving (PNR) detectors, which have the ability to discriminate the number of photons in a weak optical pulse, are of great importance in the field of quantum information processing and quantum cryptography. Moreover, a PNR detector with large dynamic range can cover the gap between these two detection modes. Such detectors are greatly desirable not only in quantum information science and technology, but also in any application dealing with low light levels. In this work, we propose a novel approach to photon number resolving detectors based on spatial multiplexing of nanowire superconducting single-photon detectors. In the proposed approach, N superconducting nanowires, each connected in parallel to an integrated resistor, are connected in series. Photon absorption in a nanowire switches its bias current to the parallel resistor, forming a voltage pulse across it. The sum of these voltages, proportional to the number of absorbed photons, is measured at the output. The use of a cryogenic preamplifier with high input impedance for the read-out increases the linearity, the signal to noise ratio, and the speed. With this combination, we expect to be able to count up to few tens of photons with high fidelity, excellent timing resolution, and very high sensitivity in the telecommunication wavelength range.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Apr 21, 2012•2 citations

Photon discerner: adaptive quantum optical sensing near the shot noise limit

Fanglin Bao, Leif Bauer, A. López +3 more

Abstract Photon statistics of an optical field can be used for quantum optical sensing in low light level scenarios free of bulky optical components. However, photon-number-resolving detection to unravel the photon statistics is challenging. Here, we propose a novel detection approach, that we call ‘photon discerning’, which uses adaptive photon thresholding for photon statistical estimation without recording exact photon numbers. Our photon discerner is motivated by the field of neural networks where tunable thresholds have proven efficient for information extraction in machine learning tasks. The photon discerner maximizes Fisher information per photon by iteratively choosing the optimal threshold in real-time to approach the shot noise limit. Our proposed scheme of adaptive photon thresholding leads to unique remote-sensing applications of quantum degree of linear polarization camera and quantum LiDAR. We investigate optimal thresholds and show that the optimal photon threshold can be counter-intuitive (not equal to 1) even for weak signals (mean photon number much less than 1), due to the photon bunching effect. We also put forth a superconducting nanowire realization of the photon discerner which can be experimentally implemented in the near-term. We show that the adaptivity of our photon discerner enables it to beat realistic photon-number-resolving detectors with limited photon-number resolution in certain applications. Our work suggests a new class of detectors for information-theory driven, compact, and learning-based quantum optical sensing.

arXiv:2307.15141•New Journal of Physics•Jul 1, 2024•6 citations

Measurement of photon number statistics using photon-number resolving detectors

Nicola N Low, Sai Sreesh Venuturumilli, Michal Bajcsy

We investigate the use of a photon-number resolving (PNR) detector as an alternative method for measuring the second-order correlation function g2(0). Our implementation employs four spatially multiplexed single-photon detectors to reconstruct the photon number distribution P(n) from click statistics. We estimate g2(0) for both coherent and quantum dot excition emission, and compare the results to those obtained from a conventional Hanbury Brown-Twiss (HBT) setup. In the single-mode regime, we observe close agreement between both approaches. We additionally compare the acquisition times required for each method and find that PNR-based measurements enable faster estimation of g2(0), offering potential advantages for scalable characterisation of quantum light sources.

Photonics for Quantum (PfQ)•Jul 18, 2025•0 citations
Abstract Photon number resolving (PNR) measurements are beneficial or even necessary for many applications in quantum optics. Unfortunately, PNR detectors are usually large, slow, expensive, and difficult to operate. However, if the input signal is multiplexed, photon ‘click’ detectors, that lack an intrinsic PNR capability, can still be used to realize photon number resolution. Here, we investigate the operation of a single click detector, together with a storage line with tunable outcoupling. Using adaptive feedback to adjust the storage outcoupling rate, the dynamic range of the detector can in certain situations be extended by up to an order of magnitude relative to a purely passive setup. An adaptive approach can thus allow for photon number variance below the quantum shot noise limit under a wider range of conditions than using a passive multiplexing approach. This can enable applications in quantum enhanced metrology and quantum computing.
We analyze the performance of photon-number-resolving (PNR) detectors and introduce a figure of merit for the accuracy of such detectors. This figure of merit is the (worst-case) probability that the photon-number-resolving detector correctly predicts the input photon number. Simulations of various PNR detectors based on multiplexed single-photon ``click detectors'' is performed. We conclude that the required quantum efficiency is very high in order to achieve even moderate (up to a handful) photon resolution, we derive the required quantum efficiency as a function of the the maximal photon number one wants to resolve, and we show that the number of click detectors required grows quadratically with the maximal number of photons resolvable.
Photon counting is a fundamental component in quantum optics and quantum information. However, implementing ideal photon-number-resolving (PNR) detectors remains experimentally challenging. Multiplexed PNR detection offers a scalable and practical alternative by distributing photons across multiple modes and detecting their presence using simple ON-OFF detectors, thereby enabling approximate photon-number resolution. In this work, we establish a theoretical model for such detectors and prove that the estimation error in terms of photon number moments decreases inverse proportionally to the number of detectors. Thanks to the enhanced PNR capability, multiplexed PNR detector provides an advantage in cat-state breeding protocols. Assuming a two-photon subtraction case, 777dB of squeezing, and an array of 20 detectors of efficiency 95%95\%95%, our calculation predicts fidelity ∼0.88\sim0.88∼0.88 with a success probability ∼3.8%\sim 3.8\%∼3.8%, representing orders-of-magnitude improvement over previous works. Similar enhancement also extends to cat-state generation with the generalized photon number subtraction. With experimentally feasible parameters, our results suggest that megahertz-rate cat-state generation is achievable using an on-chip array of \emph{tens} of ON-OFF detectors.
Standard linear optical detectors have a maximum sensitivity in the few hundreds of photons range, limited by amplifier noise. On the other hand, single photon detectors, which are the most sensitive detectors, are strongly nonlinear: One or more photons result in the same output signal. Photon number resolving (PNR) detectors, which have the ability to discriminate the number of photons in a weak optical pulse, are of great importance in the field of quantum information processing and quantum cryptography. Moreover, a PNR detector with large dynamic range can cover the gap between these two detection modes. Such detectors are greatly desirable not only in quantum information science and technology, but also in any application dealing with low light levels. In this work, we propose a novel approach to photon number resolving detectors based on spatial multiplexing of nanowire superconducting single-photon detectors. In the proposed approach, N superconducting nanowires, each connected in parallel to an integrated resistor, are connected in series. Photon absorption in a nanowire switches its bias current to the parallel resistor, forming a voltage pulse across it. The sum of these voltages, proportional to the number of absorbed photons, is measured at the output. The use of a cryogenic preamplifier with high input impedance for the read-out increases the linearity, the signal to noise ratio, and the speed. With this combination, we expect to be able to count up to few tens of photons with high fidelity, excellent timing resolution, and very high sensitivity in the telecommunication wavelength range.
Abstract Photon statistics of an optical field can be used for quantum optical sensing in low light level scenarios free of bulky optical components. However, photon-number-resolving detection to unravel the photon statistics is challenging. Here, we propose a novel detection approach, that we call ‘photon discerning’, which uses adaptive photon thresholding for photon statistical estimation without recording exact photon numbers. Our photon discerner is motivated by the field of neural networks where tunable thresholds have proven efficient for information extraction in machine learning tasks. The photon discerner maximizes Fisher information per photon by iteratively choosing the optimal threshold in real-time to approach the shot noise limit. Our proposed scheme of adaptive photon thresholding leads to unique remote-sensing applications of quantum degree of linear polarization camera and quantum LiDAR. We investigate optimal thresholds and show that the optimal photon threshold can be counter-intuitive (not equal to 1) even for weak signals (mean photon number much less than 1), due to the photon bunching effect. We also put forth a superconducting nanowire realization of the photon discerner which can be experimentally implemented in the near-term. We show that the adaptivity of our photon discerner enables it to beat realistic photon-number-resolving detectors with limited photon-number resolution in certain applications. Our work suggests a new class of detectors for information-theory driven, compact, and learning-based quantum optical sensing.
We investigate the use of a photon-number resolving (PNR) detector as an alternative method for measuring the second-order correlation function g2(0). Our implementation employs four spatially multiplexed single-photon detectors to reconstruct the photon number distribution P(n) from click statistics. We estimate g2(0) for both coherent and quantum dot excition emission, and compare the results to those obtained from a conventional Hanbury Brown-Twiss (HBT) setup. In the single-mode regime, we observe close agreement between both approaches. We additionally compare the acquisition times required for each method and find that PNR-based measurements enable faster estimation of g2(0), offering potential advantages for scalable characterisation of quantum light sources.