Abstract While usually the optical diffraction limit is setting a limit for the lengthscales on which a typical alkali Bose–Einstein condensate can be controlled, we show that in certain situations control via matter waves can achieve smaller resolutions. For this we consider a small number of impurity atoms which are trapped inside the density dip of a dark soliton state and show that any grey soliton state can be obtained by selectively driving the impurity atoms. This allows to fully control the position and velocity of the dark soliton, and also study controlled collisions between these non-linear objects.
Abstract While usually the optical diffraction limit is setting a limit for the lengthscales on which a typical alkali Bose–Einstein condensate can be controlled, we show that in certain situations control via matter waves can achieve smaller resolutions. For this we consider a small number of impurity atoms which are trapped inside the density dip of a dark soliton state and show that any grey soliton state can be obtained by selectively driving the impurity atoms. This allows to fully control the position and velocity of the dark soliton, and also study controlled collisions between these non-linear objects.
We examine the spectral properties of single and multiple matter-wave dark solitons in Bose–Einstein condensates confined in parabolic traps, where the scattering length is periodically modulated. In addition to the large density limit picture previously established for homogeneous nonlinearities, we explore a perturbative analysis in the vicinity of the linear limit, which provides good agreement with the observed spectral modes. Between these two analytically tractable limits, we use numerical computations to fill in the relevant intermediate regime. We find that the scattering length modulation can cause a variety of features absent for homogeneous nonlinearities. Among them, we note the potential oscillatory instability even of the single dark soliton, the potential absence of instabilities in the immediate vicinity of the linear limit for two dark solitons, and the existence of an exponential instability associated with the in-phase motion of three dark solitons.
To engineer the wavefunction of a Bose–Einstein condensate is to exert control over both the density and phase of the Bose–Einstein condensate order parameter. Having the ability to engineer the condensate order parameter down to the smallest length scale relevant to condensate dynamics—the healing length scale—would enable the study of new combinations of topological defects and may pave the way to using Bose–Einstein condensates as versatile, precise quantum simulators. In this thesis, we present a new wavefunction engineering technique which reaches the sub-optical healing length scale. Influenced by magnetic resonance imaging, we name this technique magnetic resonance control. This technique uses time-varying coupling between internal spin states of a spinor Bose–Einstein condensate within a magnetic field gradient to address spatial regions of the condensate, enabling control over both the phase and the density of the condensate order parameter down to the healing length scale. Techniques already exist to engineer condensate wavefunctions, but not with such a fine degree of control. These techniques primarily rely on either the intensity variation of a laser beam, which limits the resolution to the diffraction limit (larger than the typically sub-optical healing length scale), or the adiabatic inversion of a magnetic trapping potential, which can not be easily changed to produce a variety of structures in the condensate wavefunction. To develop our magnetic resonance control technique, we simulate a spinor condensate in one dimension with time-dependent coupling between spin states and time-dependent external magnetic field gradients using the Gross–Pitaevskii equation. We show that magnetic resonance control can engineer a single black soliton using experimentally feasible parameters. A black soliton is an ideal target state to select for this demonstration because engineering such a state requires control over both the phase and density of the condensate with healing-length resolution. We demonstrate that magnetic resonance control can be extended to engineer more complicated target states by simulating the creation of multiple solitons in a condensate, with control over the initial positions and trajectories of the solitons. When magnetic resonance control is applied to Bose–Einstein condensates in the laboratory, it will be necessary to have an imaging system capable of resolving the fine structures created. As an alternative to high-cost, custom-manufactured lenses, and in-vacuum optical systems, I have designed and bench-tested an objective lens with a high numerical aperture (0.36) and a long working distance (35 mm) consisting of standard catalogue lenses. Using 780 nm light, suitable for imaging rubidium condensates, this objective can achieve a resolution of 1.3 μm across a diffraction-limited field of view of 360 μm through a 5 mm thick glass window of a science cell. By changing the spacing between the lens elements, this objective lens can compensate for the aberrations produced by a glass window up to 15 mm thick, and by changing the aperture size the objective becomes suitable for diffraction-limited monochromatic imaging on the D2 line of all the alkalis. Before performing proof-of-principle magnetic resonance control experiments on real Bose–Einstein condensates, we needed to construct an experimental apparatus capable of producing spinor Bose–Einstein condensates. In this thesis I summarise my main contributions to this group endeavour, including: constructing the ultra-high vacuum system; supervising the bakeout of our vacuum system; designing and aligning the optical systems to produce laser beams of different, tunable frequencies to trap, cool, and image rubidium gas; trapping a cloud of rubidium atoms in a magneto-optical trap; constructing laser beam shutters, photodetectors, and photodetector signal filters; and designing and constructing our side imaging and top imaging systems. Using our spinor Bose–Einstein condensate apparatus, I performed the first proof-of-principle magnetic resonance control experiments. With a pair of condensates side-by-side, separated by 200 μm, we can use magnetic resonance control to invert the spin of one condensate only, while leaving the other condensate unaffected. We anticipate magnetic resonance control being used in the laboratory to engineer the first black soliton in a Bose–Einstein condensate. Looking beyond solitons, magnetic resonance control could have applications to the field of magnon spintronics, and extending the technique to higher dimensions could enable the study of exotic topological defects such as spin knots in a quantum fluid.
We propose a new method of creating solitons in elongated Bose-Einstein condensates (BECs) by sweeping three laser beams through the BEC.If one of the beams is in the first order (TEM10) Hermite-Gaussian mode, its amplitude has a transversal π phase slip which can be transferred to the atoms creating a soliton.Using this method it is possible to circumvent the restriction set by the diffraction limit inherent to conventional methods such as phase imprinting.The method allows one to create multicomponent (vector) solitons of the dark-bright form as well as the dark-dark combination.In addition it is possible to create in a controllable way two or more dark solitons with very small velocity and close to each other for studying their collisional properties.
Summary form only given. Bose-Einstein condensates (BEC) of weakly interacting gases allow for the new regime of nonlinear atom optics. Of special interest are macroscopically excited states like dark solitons or vortices. Solitons, as particle like excitations of matter wave fields, provide a link from condensate physics to fluid mechanics, nonlinear optics and fundamental particle physics. Dark solitons in matter waves are characterized by a local density minimum and, a steep phase gradient of the wavefunction at the position of the minimum. We report on experimental and theoretical investigation of dark solitons in BECs of /sup 87/Rb which are produced by the method of phase imprinting. A highly anisotropic confining potential allows us to be close to the (quasi) 1D situation where dark solitons are expected to be dynamically stable. By monitoring the evolution of the density profile we observe the evolution of density minima travelling at a smaller velocity than the speed of sound. By comparison to analytical and numerical solutions of the 3D Gross-Pitaevskii equation for our experimental conditions we identify these density minima to be moving dark solitons. We have studied in detail the creation and the dynamics of dark solitons as a function of evolution time and imprinted phase.
Dilute atomic Bose-Einstein condensates are inherently nonlinear systems and support solitary wave solutions. An important distinction from optical systems is the inhomogeneous background density, which results from the traps used to confine the atoms. As in optical systems, dark solitary waves in three-dimensional geometries are unstable to transverse excitations, which lead to a bending of the dark soliton plane and decay into vortex rings. Highly elon-gated geometries can now be achieved experimentally, in which the condensate dynamics are effectively one-dimensional, and the motion of the dark soliton is governed by the inhomogeneous longitudinal density. We show that a dark soliton is fundamentally unstable to such a changing background density, by means of numerical simulations of the soliton under various potentials (e.g. steps, ramps, harmonic traps, and optical lattices). This leads to the emission of radiation in the form of sound waves. The power emitted is found to be proportional to the square of the soliton acceleration. The latter quantity is shown to be proportional to the deformation of the apparent soliton profile, arising from the sound field in the region of the soliton. We demonstrate that the ensuing interactions between the soliton and sound field, and therefore the dynamics of the soliton, can be controlled experimentally via manipulation of the emitted sound, achieved by modifying the trap geometry. In this manner, it is possible to induce a rapid decay of the soliton, stabilise the soliton, or even pump energy into the soliton by means of parametric driving. 1
We demonstrate the possibility of drastically reducing the velocity of phonons in quasi-one-dimensional Bose-Einstein condensates. Our scheme consists of a dilute dark soliton ``gas'' that provide the trapping for the impurities that surround the condensate. We tune the interaction between the impurities and the condensate particles in such a way that the dark solitons result in an array of qutrits (three-level structures). We compute the phonon-soliton coupling and investigate the decay rates of these three-level qutrits inside the condensate. As such, we are able to reproduce the phenomenon of acoustic transparency based purely on matter-wave phononics, in analogy with the electromagnetically induced transparency effect in quantum optics. Thanks to the unique properties of transmission and dispersion of dark solitons, we show that the speed of an acoustic pulse can be brought down to \ensuremath{\sim}5 $\ensuremath{\mu}\mathrm{m}$/s, \ensuremath{\sim}103 times lower than the condensate sound speed. This is a value that greatly underdoes most of the reported studies for phononic platforms. We believe the present work could pave the stage for a new generation of ``stopped-sound''-based quantum information protocols.