Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2211.16661 · Radiation effects and defects in solids

Some comments on unitary qubit lattice algorithms for classical problems

P. B. Anderson, Lillian Finegold-Sachs, George Vahala, Linda L. Vahala, Abhay K. Ram, Min Soe, Efstratios Koukoutsis, Kyriakos Hizandis

Published Jan 2, 2023• 2 citations
arXivHTMLPDF

Abstract

A qubit lattice algorithm (QLA), which consists of a set of interleaved unitary collision-streaming operators, is developed for electromagnetic wave propagation in tensor dielectric media. External potential operators are required to handle gradients in the refractive indices, and these operators are typically non-unitary but sparse. A similar problem arises in the QLA for the Korteweg–de Vries equation, as the potential operator that models the KdV nonlinear term is also non-unitary. Several QLAs are presented here that avoid the need of this non-unitary potential operator by perturbing the collision operator. These QLAs are fully unitary.

DOI
10.1080/10420150.2023.2186871

Related papers

Qubit Lattice Algorithms Based on the Schrödinger-Dirac Representation of Maxwell Equations and Their Extensions

George Vahala, Min Soe, Efstratios Koukoutsis +3 more

It is well known that Maxwell equations can be expressed in a unitary Schrodinger-Dirac representation for homogeneous media. However, difficulties arise when considering inhomogeneous media. A Dyson map points to a unitary field qubit basis, but the standard qubit lattice algorithm of interleaved unitary collision-stream operators must be augmented by some sparse non-unitary potential operators that recover the derivatives on the refractive indices. The effect of the steepness of these derivatives on two-dimensional scattering is examined with simulations showing quite complex wavefronts emitted due to transmissions/reflections within the dielectric objects. Maxwell equations are extended to handle dissipation using Kraus operators. Then, our theoretical algorithms are extended to these open quantum systems. A quantum circuit diagram is presented as well as estimates on the required number of quantum gates for implementation on a quantum computer.

arXiv:2307.13182•IntechOpen eBooks•Oct 11, 2023•5 citations

One- and two-dimensional quantum lattice algorithms for Maxwell equations in inhomogeneous scalar dielectric media. II: Simulations

George Vahala, Min Soe, Linda L. Vahala +1 more

Long-time quantum lattice algorithm (QLA) simulations are performed for the multiple reflection–transmission of an initial electromagnetic pulse propagating normally to a boundary layer region joining two media of different refractive index. For these one-dimensional (1D) simulations, there is excellent agreement between x-, y- and z-representations, as well as very good agreement with nearly all the standard plane wave boundary condition results for reflection and transmission off a dielectric discontinuity. In the QLA simulation, no boundary conditions are imposed at the continuous, but sharply increasing, dielectric boundary layers. Two-dimensional (2D) QLA scattering simulations in the x–z plane are performed for an electromagnetic pulse interacting with a conical dielectric obstacle for the 8–16 qubit model.

Radiation effects and defects in solids•Feb 1, 2021•11 citations

One- and two-dimensional quantum lattice algorithms for Maxwell equations in inhomogeneous scalar dielectric media I: theory

George Vahala, Linda L. Vahala, Min Soe +1 more

A quantum lattice algorithm (QLA) is developed for Maxwell equations in scalar dielectric media using the Riemann–Silberstein representation on a Cartesian grid. For x-dependent and y-dependent dielectric inhomogeneities, the corresponding QLA requires a minimum of 8 qubits/spatial lattice site. This is because the corresponding Pauli spin matrices have off-diagonal components which permit the local collisional entanglement of these qubits. However, z-dependent inhomogeneities require a QLA with a minimum of 16 qubits/lattice site since the Pauli spin matrix σz is diagonal. For two-dimensional inhomogeneities, one can readily couple the 8–8 qubit schemes for x−y variations. z−x and y−z variations can be treated by either a 16–8 qubit scheme or a 16–16 qubit representation.

Radiation effects and defects in solids•Feb 1, 2021•14 citations

The Effect of the Pauli Spin Matrices on the Quantum Lattice Algorithm for Maxwell Equations in Inhomogeneous Media

George Vahala, Linda L. Vahala, Min Soe +1 more

A quantum lattice algorithm (QLA) is developed for the solution of Maxwell equations in scalar dielectric media using the Riemann-Silberstein representation. For x-dependent and y-dependent inhomogeneities, the corresponding QLA requries 8 qubits/spatial lattice site. This is because the corresponding Pauli spin matrices have off-diagonal components which permit the collisional entanglement of two qubits. However, z-dependent inhomogeneities require a QLA with 16 qubits/lattice site since the Pauli spin matrix $σ_z$ is diagonal. QLA simulations are performed for the time evolution of an initial electromagnetic pulse propagating normally to a boundary layer region joining two media of different refractive index. There is excellent agreement between all three representations, as well as very good agreement with nearly all the standard plane wave boundary condition results for reflection and transmission off a dielectric discontinuity. In the QLA simulation, no boundary conditions are imposed at the continuous, but sharply increasing, boundary layer.

arXiv:2010.12264•Oct 23, 2020•5 citations

Quantum computing perspective for electromagnetic wave propagation in cold magnetized plasmas

Efstratios Koukoutsis, Kyriakos Hizanidis, George Vahala +3 more

Electromagnetic waves are an inherent part of all plasmas—laboratory fusion plasmas or astrophysical plasmas. The conventional methods for studying properties of electromagnetic waves rely on discretization of Maxwell equations suitable for implementing on classical, present day, computers. The traditional methodology is not efficient for quantum computing implementation—a future computational source offering a tantalizing possibility of enormous speed up and a significant reduction in computational cost. This paper addresses two topics relevant to implementing Maxwell equations on a quantum computer. The first is on formulating a quantum Schrödinger representation of Maxwell equations for wave propagation in a cold, inhomogeneous, and magnetized plasma. This representation admits unitary, energy preserving, evolution and conveniently lends itself to appropriate discretization for a quantum computer. Riding on the coattails of these results, the second topic is on developing a sequence of unitary operators which form the basis for a qubit lattice algorithm (QLA). The QLA, suitable for quantum computers, can be implemented and tested on existing classical computers for accuracy as well as scaling of computational time with the number of available processors. In order to illustrate the QLA for Maxwell equations, results are presented from a time evolving, full wave simulation of propagation and scattering of an electromagnetic wave packet by non-dispersive dielectric medium localized in space.

arXiv:2309.12492•Physics of Plasmas•Dec 1, 2023•16 citations

Unitary quantum lattice gas algorithm generated from the Dirac collision operator for 1D soliton–soliton collisions

Armen Oganesov, George Vahala, Linda L. Vahala +3 more

A new unitary quantum lattice gas (QLG) algorithm is proposed as a mesoscopic unitary perturbative representation of the mean field Gross Pitaevskii equation for Bose–Einstein Condensates (BECs). This consists of an interleaved sequence of unitary collide-stream operators and is tested on the 1D nonlinear Schrödinger (NLS) equation since exact soliton solutions are well known. An earlier QLG algorithm, based on the collision operator has been found to have limited application to spinor-BECs. Here, a new unitary collision operator, based on the recent QLG of Yepez for the Dirac particle, is used to model the 1D NLS soliton–soliton problem. It is found that this new unitary algorithm can handle parameters (soliton amplitudes and speeds) a factor of over 20 greater than those under the previous algorithm.[Re: (v.07) To be submitted to special issue ‘Plasma and Fluid Dynamics: Computational, Experimental and Theoretical Advancement’]

Radiation effects and defects in solids•Jan 2, 2015•7 citations
A qubit lattice algorithm (QLA), which consists of a set of interleaved unitary collision-streaming operators, is developed for electromagnetic wave propagation in tensor dielectric media. External potential operators are required to handle gradients in the refractive indices, and these operators are typically non-unitary but sparse. A similar problem arises in the QLA for the Korteweg–de Vries equation, as the potential operator that models the KdV nonlinear term is also non-unitary. Several QLAs are presented here that avoid the need of this non-unitary potential operator by perturbing the collision operator. These QLAs are fully unitary.
It is well known that Maxwell equations can be expressed in a unitary Schrodinger-Dirac representation for homogeneous media. However, difficulties arise when considering inhomogeneous media. A Dyson map points to a unitary field qubit basis, but the standard qubit lattice algorithm of interleaved unitary collision-stream operators must be augmented by some sparse non-unitary potential operators that recover the derivatives on the refractive indices. The effect of the steepness of these derivatives on two-dimensional scattering is examined with simulations showing quite complex wavefronts emitted due to transmissions/reflections within the dielectric objects. Maxwell equations are extended to handle dissipation using Kraus operators. Then, our theoretical algorithms are extended to these open quantum systems. A quantum circuit diagram is presented as well as estimates on the required number of quantum gates for implementation on a quantum computer.
Long-time quantum lattice algorithm (QLA) simulations are performed for the multiple reflection–transmission of an initial electromagnetic pulse propagating normally to a boundary layer region joining two media of different refractive index. For these one-dimensional (1D) simulations, there is excellent agreement between x-, y- and z-representations, as well as very good agreement with nearly all the standard plane wave boundary condition results for reflection and transmission off a dielectric discontinuity. In the QLA simulation, no boundary conditions are imposed at the continuous, but sharply increasing, dielectric boundary layers. Two-dimensional (2D) QLA scattering simulations in the x–z plane are performed for an electromagnetic pulse interacting with a conical dielectric obstacle for the 8–16 qubit model.
A quantum lattice algorithm (QLA) is developed for Maxwell equations in scalar dielectric media using the Riemann–Silberstein representation on a Cartesian grid. For x-dependent and y-dependent dielectric inhomogeneities, the corresponding QLA requires a minimum of 8 qubits/spatial lattice site. This is because the corresponding Pauli spin matrices have off-diagonal components which permit the local collisional entanglement of these qubits. However, z-dependent inhomogeneities require a QLA with a minimum of 16 qubits/lattice site since the Pauli spin matrix σz is diagonal. For two-dimensional inhomogeneities, one can readily couple the 8–8 qubit schemes for x−y variations. z−x and y−z variations can be treated by either a 16–8 qubit scheme or a 16–16 qubit representation.
A quantum lattice algorithm (QLA) is developed for the solution of Maxwell equations in scalar dielectric media using the Riemann-Silberstein representation. For x-dependent and y-dependent inhomogeneities, the corresponding QLA requries 8 qubits/spatial lattice site. This is because the corresponding Pauli spin matrices have off-diagonal components which permit the collisional entanglement of two qubits. However, z-dependent inhomogeneities require a QLA with 16 qubits/lattice site since the Pauli spin matrix σzσ_zσz​ is diagonal. QLA simulations are performed for the time evolution of an initial electromagnetic pulse propagating normally to a boundary layer region joining two media of different refractive index. There is excellent agreement between all three representations, as well as very good agreement with nearly all the standard plane wave boundary condition results for reflection and transmission off a dielectric discontinuity. In the QLA simulation, no boundary conditions are imposed at the continuous, but sharply increasing, boundary layer.
Electromagnetic waves are an inherent part of all plasmas—laboratory fusion plasmas or astrophysical plasmas. The conventional methods for studying properties of electromagnetic waves rely on discretization of Maxwell equations suitable for implementing on classical, present day, computers. The traditional methodology is not efficient for quantum computing implementation—a future computational source offering a tantalizing possibility of enormous speed up and a significant reduction in computational cost. This paper addresses two topics relevant to implementing Maxwell equations on a quantum computer. The first is on formulating a quantum Schrödinger representation of Maxwell equations for wave propagation in a cold, inhomogeneous, and magnetized plasma. This representation admits unitary, energy preserving, evolution and conveniently lends itself to appropriate discretization for a quantum computer. Riding on the coattails of these results, the second topic is on developing a sequence of unitary operators which form the basis for a qubit lattice algorithm (QLA). The QLA, suitable for quantum computers, can be implemented and tested on existing classical computers for accuracy as well as scaling of computational time with the number of available processors. In order to illustrate the QLA for Maxwell equations, results are presented from a time evolving, full wave simulation of propagation and scattering of an electromagnetic wave packet by non-dispersive dielectric medium localized in space.
A new unitary quantum lattice gas (QLG) algorithm is proposed as a mesoscopic unitary perturbative representation of the mean field Gross Pitaevskii equation for Bose–Einstein Condensates (BECs). This consists of an interleaved sequence of unitary collide-stream operators and is tested on the 1D nonlinear Schrödinger (NLS) equation since exact soliton solutions are well known. An earlier QLG algorithm, based on the collision operator has been found to have limited application to spinor-BECs. Here, a new unitary collision operator, based on the recent QLG of Yepez for the Dirac particle, is used to model the 1D NLS soliton–soliton problem. It is found that this new unitary algorithm can handle parameters (soliton amplitudes and speeds) a factor of over 20 greater than those under the previous algorithm.[Re: (v.07) To be submitted to special issue ‘Plasma and Fluid Dynamics: Computational, Experimental and Theoretical Advancement’]