Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2208.07866 · Nanoscale

The dependence of timing jitter of superconducting nanowire single-photon detectors on the multi-layer sample design and slew rate

Rasmus Flaschmann, Lucio Zugliani, Christian Schmid, Simone Spedicato, Stefan Strohauer, Fabian Wietschorke, Fabian Flassig, Jonathan James Finley, Kai Müller

Published Dec 16, 2022• 10 citations
arXivHTMLPDF

Abstract

We investigated the timing jitter of superconducting nanowire single-photon detectors (SNSPDs) and found a strong dependence on the detector response. By varying the multi-layer structure, we observed changes in pulse shape which are attributed to capacitive behaviour affecting the pulse heights, rise times and consequently timing jitter. Moreover, we developed a technique to predict the timing jitter of a single device within certain limits by capturing only a single detector pulse, eliminating the need for detailed jitter measurement using a pulsed laser when a rough estimate of the timing jitter is sufficient.

DOI
10.1039/d2nr04494c

Related papers

Jitter analysis of a superconducting nanowire single photon detector

Lixing You, Xiaoyan Yang, Yuhao He +9 more

Jitter is one of the key parameters for a superconducting nanowire single photon detector (SNSPD). Using an optimized time-correlated single photon counting system for jitter measurement, we extensively studied the dependence of system jitter on the bias current and working temperature. The signal-to-noise ratio of the single-photon-response pulse was proven to be an important factor in system jitter. The final system jitter was reduced to 18 ps by using a high-critical-current SNSPD, which showed an intrinsic SNSPD jitter of 15 ps. A laser ranging experiment using a 15-ps SNSPD achieved a record depth resolution of 3 mm at a wavelength of 1550 nm.

arXiv:1308.0763•AIP Advances•Jul 1, 2013•131 citations

Improving superconducting nanowire single-photon detectors made of NbTiN using a novel method to characterize the timing jitter (Conference Presentation)

Rasmus Flaschmann, Lucio Zugliani, Christian Schmid +10 more

In recent years, Superconducting Nanowire Single-Photon Detectors (SNSPDs) have obtained tremendous attention as a possible key technology for photonic quantum processing and faint light detection. Here, we present our recent progress on engineering of the properties of NbTiN SNSPDs fabricated on various substrates measured. We discuss approaches to simultaneously improve the most important figures of merit (DCR, dead time, timing jitter, efficiency) as well as efficient characterization methods. Specifically, for the latter we investigate the impact of the substrate material on the performance parameters as well as the fundamental interrelation of the resulting voltage pulse properties, such as pulse height, rise time and timing jitter, and their dependence on the applied bias current.

Quantum Nanophotonic Materials, Devices, and Systems•Oct 4, 2022•0 citations

Timing Jitter Induced by Stochastic Baseline Fluctuations in High-Count-Rate Superconducting Nanowire Single-Photon Detectors

Dianpeng Wang, You Xiao, Jiamin Xiong +7 more

Superconducting nanowire single-photon detectors (SNSPDs) have demonstrated timing jitter in the few-picosecond regime, yet their timing resolution deteriorates substantially under high-count-rate operation. Existing interpretations mainly attribute this degradation to deterministic waveform distortions, such as multiphoton responses and pulse pile-up, yet the experimentally observed jitter broadening at high count rates cannot be fully accounted for within this picture. Here, we show that stochastic baseline fluctuations arising from finite-memory readout dynamics constitute an intrinsic source of the count-rate-dependent timing jitter in SNSPD systems. For stochastically arriving photons, overlapping recovery responses accumulate in the readout chain and generate statistically fluctuating baselines, which are converted into timing uncertainty through threshold-based timing extraction. We develop a stochastic-process framework that quantitatively connects photon statistics, readout dynamics, and timing jitter. The framework predicts characteristic scaling behaviors, including a nonmonotonic dependence of baseline fluctuations under pulsed excitation with a maximum near half of the repetition frequency. These predictions are quantitatively verified through systematic variations of count rate, circuit time constant, and detector dynamical properties. Our results identify stochastic baseline dynamics as a fundamental mechanism limiting timing resolution in high-count-rate SNSPD operation and provide a general framework for optimizing finite-memory high-speed photon-counting systems.

physics.app-phCross-listedarXiv:2605.14316•May 15, 2026

Time-walk and jitter correction in SNSPDs at high count rates

Andrew Mueller, Emma E. Wollman, Boris A. Korzh +5 more

Superconducting nanowire single-photon detectors (SNSPDs) are a leading detector type for time correlated single photon counting, especially in the near-infrared. When operated at high count rates, SNSPDs exhibit increased timing jitter caused by internal device properties and features of the RF amplification chain. Variations in RF pulse height and shape lead to variations in the latency of timing measurements. To compensate for this, we demonstrate a calibration method that correlates delays in detection events with the time elapsed between pulses. The increase in jitter at high rates can be largely canceled in software by applying corrections derived from the calibration process. We demonstrate our method with a single-pixel tungsten silicide SNSPD and show it decreases high count rate jitter. The technique is especially effective at removing a long tail that appears in the instrument response function at high count rates. At a count rate of 11.4 MCounts/s, we reduce the full width at 1% maximum level (FW1%M) by 45%. The method, therefore, enables certain quantum communication protocols that are rate-limited by the FW1%M metric to operate almost twice as fast.

arXiv:2210.01271•Applied Physics Letters•Jan 23, 2023•29 citations

Vortex-crossing-induced timing jitter of superconducting nanowire single-photon detectors

Hao Wu, Chao Gu, Yuhao Cheng +1 more

We investigate the timing properties of single-photon-triggered vortex (or anti-vortex) crossing in a current-biased superconducting nanowire and find that the time delays caused in the vortex-crossing process vary with the transverse positions on the nanowire where the photons are absorbed. The position-dependent time delays indicate that the vortex-crossing process induces timing jitter of a superconducting nanowire single-photon detector (SNSPD). The magnitude of this timing jitter further depends on various parameters, including the polarization of the incident photon, the bias current, and the width of the nanowire. This vortex-crossing-induced timing jitter might represent the lower bound of the timing jitter of the SNSPD and fundamentally limit its time-resolving capability.

Applied Physics Letters•Aug 7, 2017•31 citations

Superconducting nanowire detector jitter limited by detector geometry

Niccolò Calandri, Qingyuan Zhao, Di Zhu +2 more

Detection jitter quantifies variance introduced by the detector in the determination of photon arrival time. It is a crucial performance parameter for systems using superconducting nanowire single photon detectors (SNSPDs). In this work, we have demonstrated that the detection timing jitter is limited in part by the spatial variation of the photon detection events along the length of the wire. We define this jitter source as a geometric jitter since it is related to the length and area of the SNSPD. To characterize the geometric jitter, we have constructed a differential cryogenic readout with less than 7 ps of an electronic jitter that can amplify the pulses generated from the two ends of an SNSPD. By differencing the measured arrival times of the two electrical pulses, we were able to partially cancel out the difference of the propagation times and thus reduce the uncertainty of the photon arrival time. We proved that the variation of the differential propagation time was a few ps for a 3 μm × 3 μm device, while it increased up to 50 ps for a 20 μm × 20 μm device. In a 20 μm × 20 μm large SNSPD, we achieved a 20% reduction in the overall detection timing jitter for detecting the telecom-wavelength photons by using the differential cryogenic readout.

arXiv:1607.06713•Applied Physics Letters•Oct 10, 2016•114 citations
We investigated the timing jitter of superconducting nanowire single-photon detectors (SNSPDs) and found a strong dependence on the detector response. By varying the multi-layer structure, we observed changes in pulse shape which are attributed to capacitive behaviour affecting the pulse heights, rise times and consequently timing jitter. Moreover, we developed a technique to predict the timing jitter of a single device within certain limits by capturing only a single detector pulse, eliminating the need for detailed jitter measurement using a pulsed laser when a rough estimate of the timing jitter is sufficient.
Jitter is one of the key parameters for a superconducting nanowire single photon detector (SNSPD). Using an optimized time-correlated single photon counting system for jitter measurement, we extensively studied the dependence of system jitter on the bias current and working temperature. The signal-to-noise ratio of the single-photon-response pulse was proven to be an important factor in system jitter. The final system jitter was reduced to 18 ps by using a high-critical-current SNSPD, which showed an intrinsic SNSPD jitter of 15 ps. A laser ranging experiment using a 15-ps SNSPD achieved a record depth resolution of 3 mm at a wavelength of 1550 nm.
In recent years, Superconducting Nanowire Single-Photon Detectors (SNSPDs) have obtained tremendous attention as a possible key technology for photonic quantum processing and faint light detection. Here, we present our recent progress on engineering of the properties of NbTiN SNSPDs fabricated on various substrates measured. We discuss approaches to simultaneously improve the most important figures of merit (DCR, dead time, timing jitter, efficiency) as well as efficient characterization methods. Specifically, for the latter we investigate the impact of the substrate material on the performance parameters as well as the fundamental interrelation of the resulting voltage pulse properties, such as pulse height, rise time and timing jitter, and their dependence on the applied bias current.
Superconducting nanowire single-photon detectors (SNSPDs) have demonstrated timing jitter in the few-picosecond regime, yet their timing resolution deteriorates substantially under high-count-rate operation. Existing interpretations mainly attribute this degradation to deterministic waveform distortions, such as multiphoton responses and pulse pile-up, yet the experimentally observed jitter broadening at high count rates cannot be fully accounted for within this picture. Here, we show that stochastic baseline fluctuations arising from finite-memory readout dynamics constitute an intrinsic source of the count-rate-dependent timing jitter in SNSPD systems. For stochastically arriving photons, overlapping recovery responses accumulate in the readout chain and generate statistically fluctuating baselines, which are converted into timing uncertainty through threshold-based timing extraction. We develop a stochastic-process framework that quantitatively connects photon statistics, readout dynamics, and timing jitter. The framework predicts characteristic scaling behaviors, including a nonmonotonic dependence of baseline fluctuations under pulsed excitation with a maximum near half of the repetition frequency. These predictions are quantitatively verified through systematic variations of count rate, circuit time constant, and detector dynamical properties. Our results identify stochastic baseline dynamics as a fundamental mechanism limiting timing resolution in high-count-rate SNSPD operation and provide a general framework for optimizing finite-memory high-speed photon-counting systems.
Superconducting nanowire single-photon detectors (SNSPDs) are a leading detector type for time correlated single photon counting, especially in the near-infrared. When operated at high count rates, SNSPDs exhibit increased timing jitter caused by internal device properties and features of the RF amplification chain. Variations in RF pulse height and shape lead to variations in the latency of timing measurements. To compensate for this, we demonstrate a calibration method that correlates delays in detection events with the time elapsed between pulses. The increase in jitter at high rates can be largely canceled in software by applying corrections derived from the calibration process. We demonstrate our method with a single-pixel tungsten silicide SNSPD and show it decreases high count rate jitter. The technique is especially effective at removing a long tail that appears in the instrument response function at high count rates. At a count rate of 11.4 MCounts/s, we reduce the full width at 1% maximum level (FW1%M) by 45%. The method, therefore, enables certain quantum communication protocols that are rate-limited by the FW1%M metric to operate almost twice as fast.
We investigate the timing properties of single-photon-triggered vortex (or anti-vortex) crossing in a current-biased superconducting nanowire and find that the time delays caused in the vortex-crossing process vary with the transverse positions on the nanowire where the photons are absorbed. The position-dependent time delays indicate that the vortex-crossing process induces timing jitter of a superconducting nanowire single-photon detector (SNSPD). The magnitude of this timing jitter further depends on various parameters, including the polarization of the incident photon, the bias current, and the width of the nanowire. This vortex-crossing-induced timing jitter might represent the lower bound of the timing jitter of the SNSPD and fundamentally limit its time-resolving capability.
Detection jitter quantifies variance introduced by the detector in the determination of photon arrival time. It is a crucial performance parameter for systems using superconducting nanowire single photon detectors (SNSPDs). In this work, we have demonstrated that the detection timing jitter is limited in part by the spatial variation of the photon detection events along the length of the wire. We define this jitter source as a geometric jitter since it is related to the length and area of the SNSPD. To characterize the geometric jitter, we have constructed a differential cryogenic readout with less than 7 ps of an electronic jitter that can amplify the pulses generated from the two ends of an SNSPD. By differencing the measured arrival times of the two electrical pulses, we were able to partially cancel out the difference of the propagation times and thus reduce the uncertainty of the photon arrival time. We proved that the variation of the differential propagation time was a few ps for a 3 μm × 3 μm device, while it increased up to 50 ps for a 20 μm × 20 μm device. In a 20 μm × 20 μm large SNSPD, we achieved a 20% reduction in the overall detection timing jitter for detecting the telecom-wavelength photons by using the differential cryogenic readout.