Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2208.04244 · Physica Scripta

Measurement of hyperfine constants and the isotope shift of rubidium 5P1/2 excited-state using saturated absorption spectroscopy

P. M. Rupasinghe, Fiona Wee, Thomas Bullock, Jiaxing Liu

Published Mar 16, 2023• 6 citations
arXivHTMLPDF

Abstract

Abstract The Saturated Absorption Spectroscopy (SAS) was performed to measure the hyperfine constants of rubidium 5P1/2 excited state using an external-cavity diode laser (ECDL) operating at 795 nm. We report our measurements for the magnetic dipole coupling constants 120.79(29) and 407.75(57) for 85 Rb and 87 Rb respectively. Our measurement of the 85 Rb hyperfine constant shows a good agreement with previous results and our measurement of the 87 Rb hyperfine constant resolves the discrepancy of results that exists in the literature.

DOI
10.1088/1402-4896/acc4f3

Related papers

Precision Measurement of the Saturation Intensity in Rubidium at 420 nm

Shivam Sinha, Sumit Achar, Sankar Satheesh +1 more

The $5S_{1/2} \rightarrow 6P_{3/2}$ transition of rubidium at $420$ nm is a promising candidate for a portable warm-vapor all-optical atomic clock. Despite recent precision spectroscopy studies at $420$ nm in Rb, an experimental determination of the saturation intensity of this transition has not yet been reported. The saturation intensity is a fundamental parameter that influences the identification of a potential clock transition frequency in terms of optimizing various intensity-dependent parameters and connected systematics. In this work, we report the first experimental measurement of the saturation intensity of the $420$ nm transition in Rb, obtaining $(23.18 \pm 0.28)$ mW/cm$^2$ for the $^{87}$Rb $F = 2 \rightarrow F' = 3$ transition and $(25.56 \pm 0.37)$ mW/cm$^2$ for the $^{85}$Rb $F = 3 \rightarrow F' = 4$ transition, in excellent agreement with theoretical predictions. We further investigate the temperature dependence of the Doppler-free Lamb-dip amplitude and linewidth over $59.03~\pm~0.37$ - $91.20~\pm~0.90^\circ$C in a $100$ mm commercial vapor cell, identifying around $82.02~\pm~ 0.73^\circ$C as the optimal operating temperature, where the signal-to-noise ratio of the Lamb-dip amplitude with temperature reaches a maximum and the observed Lamb-dip linewidth exhibits a minimum. We also present precise measurements of the magnetic-dipole ($A$) and electric-quadrupole ($B$) hyperfine constants of the $6P_{3/2}$ state for both isotopes, with the measured values being consistent with previously reported values for the hyperfine constants.

physics.atom-phCross-listedarXiv:2606.30871•Jul 1, 2026•1 citation

Spectroscopy of the 85Rb 4 D3/2 state for hyperfine-structure determination

Alisher Duspayev, Georg A. Raithel

Abstract We report a measurement of the hyperfine-structure constants of the 85Rb 4 D 3 / 2 state using two-photon optical spectroscopy of the 5 S 1 / 2 → 4 D 3 / 2 transition. The spectra are acquired by measuring the transmission of the low-power 795 nm lower-stage laser beam through a cold-atom sample as a function of laser frequency, with the frequency of the upper-stage, 1476 nm laser fixed. All 4 hyperfine components of the 4 D 3 / 2 state are well-resolved in the experimental data. The dominant systematic is the light shift from the 1476 nm laser, which is addressed by extrapolating line positions measured for a set of 1476 nm laser powers to zero laser power. The analysis of our experimental data yields both the magnetic-dipole and electric-quadrupole constants for the 85Rb 4 D 3 / 2 level, without using earlier hyperfine measurements of other atomic levels. The respective results, A = 7.419(35) MHz and B = 4.19(19) MHz, are discussed in context with previous works. Our investigation may be useful for optical atomic clocks for precision metrology and emerging atom-based quantum technologies, all-infrared excitation of Rb Rydberg levels, and molecular physics.

arXiv:2305.00265•New Journal of Physics•Aug 25, 2023•5 citations

Measuring the Hyperfine Splittings of Lowest Energy Atomic Transitions in Rubidium

Benjamin Graber

The goal of this experiment was to measure the hyperfine energy splittings of the ground to first excited state transitions in rubidium using saturated absorption spectroscopy. Using this technique, we measured these transition energy spectra by taking the difference of two photodiode outputs due to multiple beams of a single laser scanned over a range of frequencies and shone through a cell of Rb vapor. When the laser frequency was resonant with an atomic transition, photons of those frequencies were absorbed, leaving a dip in intensity of the beam measured at the photodiode. One of the two laser beams had its excitations saturated by a more intense, counter-propagating pump beam from the same laser. The pump beam saturated the absorption of the velocity equal zero atoms that the counter-propagating probe beam could have also interacted with due to no Doppler shift. At these frequencies the probe beam experienced less absorption that was measured by a photodiode. The photodiode output was calibrated to the change in frequency of the scanned laser using a Fabry-Pérot interferometer. The output of this interferometer served as a reference for how the laser frequency changed. Final results for the 87Rb F=1 spectrum accounted for the largest error with a maximum of 12.2% deviation from accepted energy spacing values due in part to systematic error. Other spectra measurements were in better agreement, possessing error ranging from 2.1% to 10.1% and some agreeing with accepted values to within our uncertainty.

•Jan 1, 2015•0 citations

Rubidium Absorption Spectroscopy

Ignacio E. Olivares

In this chapter, we present a study of laser absorption in neutral rubidium vapor at a wavelength of 780 nm. The experiments were conducted using a tunable external cavity diode laser tuned to the https://www.w3.org/1998/Math/MathML" display="inline"> 85 Rb − D 2 transition line. We modeled the dependence of the laser transmission on the incident intensity using the optical Bloch equations described previously, comparing the theoretical results with the experimental data. Furthermore, the calculations were extended to the regime of saturated absorption spectroscopy, where the theoretical predictions were rigorously compared with the measured saturated absorption spectra.

CRC Press eBooks•Nov 6, 2026•0 citations

Saturated-absorption spectroscopy of weak-field Zeeman splittings in rubidium

Jason L. Bowie, Jack Boyce, R. Y. Chiao

Using an external cavity-tuned diode laser in Doppler-free saturation spectroscopy, we are able to resolve the weak-field Zeeman splittings in the hyperfine levels of the rubidium D1 line. The number of lines observed in the Zeeman structure of rubidium and their measured energy-level splittings are as expected from theory. The measured amplitudes of the saturated-absorption signals, crossover resonances, and velocity-selective optical pumping signals are used in the analysis of various theories concerning saturated-absorption spectroscopy.

Journal of the Optical Society of America B•Oct 1, 1995•12 citations

Hyperfine structure and absolute frequency of the ^87Rb 5P_3/2 state

Jun Ye, Steve Swartz, Peter Jungner +1 more

We have constructed two highly stable and reproducible (87)Rb D(2)-saturated-absorption spectrometers at 780 nm, using dither/third-harmonic lock-in detection and radio-frequency sideband techniques, respectively. We achieved +/-3-kHz reproducibility and agreement between these two independent systems. Heterodyne measurements of the hyperfine splittings of the 5P(3/2) state give its magnetic dipole (A) and electric quadrupole (B) hyperfine constants with a 10-fold reduction in uncertainty.

Optics Letters•Aug 15, 1996•240 citations
Abstract The Saturated Absorption Spectroscopy (SAS) was performed to measure the hyperfine constants of rubidium 5P1/2 excited state using an external-cavity diode laser (ECDL) operating at 795 nm. We report our measurements for the magnetic dipole coupling constants 120.79(29) and 407.75(57) for 85 Rb and 87 Rb respectively. Our measurement of the 85 Rb hyperfine constant shows a good agreement with previous results and our measurement of the 87 Rb hyperfine constant resolves the discrepancy of results that exists in the literature.
The 5S1/2→6P3/25S_{1/2} \rightarrow 6P_{3/2}5S1/2​→6P3/2​ transition of rubidium at 420420420 nm is a promising candidate for a portable warm-vapor all-optical atomic clock. Despite recent precision spectroscopy studies at 420420420 nm in Rb, an experimental determination of the saturation intensity of this transition has not yet been reported. The saturation intensity is a fundamental parameter that influences the identification of a potential clock transition frequency in terms of optimizing various intensity-dependent parameters and connected systematics. In this work, we report the first experimental measurement of the saturation intensity of the 420420420 nm transition in Rb, obtaining (23.18±0.28)(23.18 \pm 0.28)(23.18±0.28) mW/cm2^22 for the 87^{87}87Rb F=2→F′=3F = 2 \rightarrow F' = 3F=2→F′=3 transition and (25.56±0.37)(25.56 \pm 0.37)(25.56±0.37) mW/cm2^22 for the 85^{85}85Rb F=3→F′=4F = 3 \rightarrow F' = 4F=3→F′=4 transition, in excellent agreement with theoretical predictions. We further investigate the temperature dependence of the Doppler-free Lamb-dip amplitude and linewidth over 59.03 ± 0.3759.03~\pm~0.3759.03 ± 0.37 - 91.20 ± 0.90∘91.20~\pm~0.90^\circ91.20 ± 0.90∘C in a 100100100 mm commercial vapor cell, identifying around 82.02 ± 0.73∘82.02~\pm~ 0.73^\circ82.02 ± 0.73∘C as the optimal operating temperature, where the signal-to-noise ratio of the Lamb-dip amplitude with temperature reaches a maximum and the observed Lamb-dip linewidth exhibits a minimum. We also present precise measurements of the magnetic-dipole (AAA) and electric-quadrupole (BBB) hyperfine constants of the 6P3/26P_{3/2}6P3/2​ state for both isotopes, with the measured values being consistent with previously reported values for the hyperfine constants.
Abstract We report a measurement of the hyperfine-structure constants of the 85Rb 4 D 3 / 2 state using two-photon optical spectroscopy of the 5 S 1 / 2 → 4 D 3 / 2 transition. The spectra are acquired by measuring the transmission of the low-power 795 nm lower-stage laser beam through a cold-atom sample as a function of laser frequency, with the frequency of the upper-stage, 1476 nm laser fixed. All 4 hyperfine components of the 4 D 3 / 2 state are well-resolved in the experimental data. The dominant systematic is the light shift from the 1476 nm laser, which is addressed by extrapolating line positions measured for a set of 1476 nm laser powers to zero laser power. The analysis of our experimental data yields both the magnetic-dipole and electric-quadrupole constants for the 85Rb 4 D 3 / 2 level, without using earlier hyperfine measurements of other atomic levels. The respective results, A = 7.419(35) MHz and B = 4.19(19) MHz, are discussed in context with previous works. Our investigation may be useful for optical atomic clocks for precision metrology and emerging atom-based quantum technologies, all-infrared excitation of Rb Rydberg levels, and molecular physics.
The goal of this experiment was to measure the hyperfine energy splittings of the ground to first excited state transitions in rubidium using saturated absorption spectroscopy. Using this technique, we measured these transition energy spectra by taking the difference of two photodiode outputs due to multiple beams of a single laser scanned over a range of frequencies and shone through a cell of Rb vapor. When the laser frequency was resonant with an atomic transition, photons of those frequencies were absorbed, leaving a dip in intensity of the beam measured at the photodiode. One of the two laser beams had its excitations saturated by a more intense, counter-propagating pump beam from the same laser. The pump beam saturated the absorption of the velocity equal zero atoms that the counter-propagating probe beam could have also interacted with due to no Doppler shift. At these frequencies the probe beam experienced less absorption that was measured by a photodiode. The photodiode output was calibrated to the change in frequency of the scanned laser using a Fabry-Pérot interferometer. The output of this interferometer served as a reference for how the laser frequency changed. Final results for the 87Rb F=1 spectrum accounted for the largest error with a maximum of 12.2% deviation from accepted energy spacing values due in part to systematic error. Other spectra measurements were in better agreement, possessing error ranging from 2.1% to 10.1% and some agreeing with accepted values to within our uncertainty.
In this chapter, we present a study of laser absorption in neutral rubidium vapor at a wavelength of 780 nm. The experiments were conducted using a tunable external cavity diode laser tuned to the https://www.w3.org/1998/Math/MathML" display="inline"> 85 Rb − D 2 transition line. We modeled the dependence of the laser transmission on the incident intensity using the optical Bloch equations described previously, comparing the theoretical results with the experimental data. Furthermore, the calculations were extended to the regime of saturated absorption spectroscopy, where the theoretical predictions were rigorously compared with the measured saturated absorption spectra.
Using an external cavity-tuned diode laser in Doppler-free saturation spectroscopy, we are able to resolve the weak-field Zeeman splittings in the hyperfine levels of the rubidium D1 line. The number of lines observed in the Zeeman structure of rubidium and their measured energy-level splittings are as expected from theory. The measured amplitudes of the saturated-absorption signals, crossover resonances, and velocity-selective optical pumping signals are used in the analysis of various theories concerning saturated-absorption spectroscopy.