The ability to characterise a Hamiltonian with high precision is crucial for the implementation of quantum technologies. In addition to the well-developed approaches utilising optimal probe states and optimal measurements, the method of optimal control can be used to identify time-dependent pulses applied to the system to achieve higher precision in the estimation of Hamiltonian parameters, especially in the presence of noise. Here, we extend optimally controlled estimation schemes for single qubits to non-commuting dynamics as well as two interacting qubits, demonstrating improvements in terms of maximal precision, time-stability, as well as robustness over uncontrolled protocols.
The ability to characterise a Hamiltonian with high precision is crucial for the implementation of quantum technologies. In addition to the well-developed approaches utilising optimal probe states and optimal measurements, the method of optimal control can be used to identify time-dependent pulses applied to the system to achieve higher precision in the estimation of Hamiltonian parameters, especially in the presence of noise. Here, we extend optimally controlled estimation schemes for single qubits to non-commuting dynamics as well as two interacting qubits, demonstrating improvements in terms of maximal precision, time-stability, as well as robustness over uncontrolled protocols.
A pivotal task in quantum metrology, and quantum parameter estimation in general, is to design schemes that achieve the highest precision with the given resources. Standard models of quantum metrology usually assume that the dynamics is fixed and that the highest precision is achieved by preparing the optimal probe states and performing optimal measurements. However, in many practical experimental settings, additional controls are usually available to alter the dynamics. Here we propose to use optimal control methods for further improvement of the precision limit of quantum parameter estimation. We show that, by exploring the additional degree of freedom offered by the controls, a higher-precision limit can be achieved. In particular, we show that the precision limit under the controlled schemes can go beyond the constraints put by the coherent time, which is in contrast with the standard scheme where the precision limit is always bounded by the coherent time.
Abstract Quantum multi-parameter estimation has recently attracted increased attention due to its wide applications, with a primary goal of designing high-precision measurement schemes for unknown parameters. While existing research has predominantly concentrated on time-independent Hamiltonians, little has been known about quantum multi-parameter estimation for time-dependent Hamiltonians due to the complexity of quantum dynamics. This work bridges the gap by investigating the precision limit of multi-parameter quantum estimation for a qubit in an oscillating magnetic field model with multiple unknown frequencies. As the well-known quantum Cramér–Rao bound is generally unattainable due to the potential incompatibility between the optimal measurements for different parameters, we use the most informative bound instead which is always attainable and equivalent to the Holevo bound in the asymptotic limit. Moreover, we apply additional Hamiltonian to the system to engineer the dynamics of the qubit. By utilizing the quasi-Newton method, we explore the optimal schemes to attain the highest precision for the unknown frequencies of the magnetic field, including the simultaneous optimization of initial state preparation, the control Hamiltonian and the final measurement. The results indicate that the optimization can yield much higher precisions for the field frequencies than those without the optimizations. Finally, we study the robustness of the optimal control scheme with respect to the fluctuation of the interested frequencies, and the optimized scheme exhibits superior robustness to the scenario without any optimization.
Abstract Multi-parameter quantum estimation has attracted considerable attention due to its broad applications. Due to the complexity of quantum dynamics, existing research places significant emphasis on estimating parameters in time-independent Hamiltonians. Here, our work makes an effort to explore multi-parameter estimation with time-dependent Hamiltonians. In particular, we focus on the discrimination of two close frequencies of a magnetic field by using a single qubit. We optimize the quantum controls by employing both traditional optimization methods and reinforcement learning to improve the precision for estimating the frequencies of the two magnetic fields. In addition to the estimation precision, we also evaluate the robustness of the optimization schemes against the shift of the control parameters. The results demonstrate that the hybrid reinforcement learning approach achieves the highest estimation precision, and exhibits superior robustness. Moreover, a fundamental challenge in multi-parameter quantum estimation stems from the incompatibility of the optimal control strategies for different parameters. We demonstrate that the hybrid control strategies derived through numerical optimization remain effective in enhancing the precision of multi-parameter estimation in spite of the incompatibilities, thereby mitigating incompatibilities between control strategies on the estimation precision. Finally, we investigate the trade-offs in estimation precision among different parameters for different scenarios, revealing the inherent challenges in balancing the optimization of multiple parameters simultaneously and providing insights into the fundamental distinction between quantum single-parameter estimation and multi-parameter estimation.
We address estimation of one-parameter unitary gates for qubit systems and seek optimal probes and measurements. Single- and two-qubit probes are analysed in detail focusing on precision and stability of the estimation procedure. Bayesian inference is employed and compared with the ultimate quantum limits to precision, taking into account the biased nature of the Bayes estimator in the non-asymptotic regime. In addition, through the evaluation of the asymptotic a posteriori distribution for the gate parameter and a comparison with the results of Monte Carlo simulated experiments, we show that asymptotic optimality of the Bayes estimator is actually achieved after a limited number of runs. The robustness of the estimation procedure against fluctuations of the measurement settings is investigated and the use of entanglement to improve the overall stability of the estimation scheme is also analysed in some detail.
Abstract Quantum optimal control plays a vital role in many quantum technologies, including quantum computation. One of the most important control parameters to optimise for is the evolution time (pulse duration). However, most existing works focus on finding the shortest evolution time theoretically possible without offering explicit pulse constructions under practical constraints like noise in the system. This paper addresses these limitations by introducing an efficient method to perform the chopped random basis optimisation in the presence of noise, specifically when the noise commutes with the gate Hamiltonian, i.e. when the unitary and dissipative parts of the Liouvillian commute. This noise-aware approach allows for direct optimisation of the evolution time alongside other control parameters, significantly reducing the computational cost compared to full noisy simulations. The protocol is demonstrated through numerical simulations on state-to-state transfer and gate compilation problems under several noise models. Results show that the optimised fidelity has a strong dependence on evolution time due to noise, drift Hamiltonian, and local traps in optimisation, highlighting the necessity of optimising evolution time in practical settings that can lead to a substantial gain in the fidelity. Our pulse optimisation protocol can consistently escape from many local minima in all of our examples. We hope that our protocol can be the start of many more works on the crucial topic of control pulse time optimisation in practical settings.
For several decades it has been appreciated that quantum computers hold incredible promise to perform calculations intractable to classical computation. However, this promise has be slow to realize. Dozens of quantum systems are currently being investigated for use in quantum information processing - none of which have yet demonstrated algorithms involving more than a handful of qubits and it remains unclear which, if any, of these systems will ultimately compose a scalable, robust quantum information processing architecture. In this thesis we employ analytical, optimal and algebraic control techniques to evaluate various quantum systems for their potential use in quantum information processing. In doing so, we have additionally identified several novel characterization procedures capable of probing both the coherent and incoherent dynamics of quantum systems. The first part of this thesis discusses work motivated by attempts to utilize donor qubits in silicon as quantum bits. We first propose a measurement of the state of a single donor electron spin using two-dimensional electron gas of a field-effect transistor and electrically detected magnetic resonance. We analyze the potential sensitivity of this measurement and show that it is a quantum nondemolition measurement of an electron-encoded state. We then present the first of two novel qubit characterization procedures. We consider the problem of rapidly characterizing a large number of similarly prepared qubits using techniques from optimal experiment design. All qubits are assumed to evolve according to the same physical processes, though the Hamiltonian parameters may vary from device to device - an inevitability in solid state qubits. We use the Cram\\'er-Rao bound on the variance of a point estimator to construct the optimal series of experiments to estimate these free parameters, and present a complete analysis of the optimal experimental configuration. Though applied to dipole- and exchange-coupled qubits, this technique is widely applicable to other systems. The second part of the thesis discusses the role that control can play in measuring and mitigating noise in qubit systems. Our first result describes a method for quickly simulating the effects of arbitrary markovian noise on qubit systems through the use of a numerically optimized, multi-state Markovian fluctuator. This ability to rapidly simulate the noisy qubit evolution allows us to compute control sequences capable of maximally decoupling the qubit from the noise source. We then introduce the second characterization procedure of the these, showing that a single measurable and controllable qubit may act as a spectrometer of dephasing noise. We show that the formalism of dynamical decoupling can be used to estimate the short-time correlation function of the noise source, while long time correlations may be estimated by a very simple series of free evolution experiments. This technique is applicable to the wide range of physical implementations which suffer from dephasing noise.The final part of this thesis demonstrates that trapped neutral atoms may be utilized for the robust simulation of complex systems exhibiting a topological phase. We present a method to simulate the toric code Hamiltonian stroboscopically, and demonstrate that our technique preserves the ground state degeneracy . Furthermore, we introduce a dissipative mechanism allowing for thermalization of the system to a finite temperature or direct cooling to the ground state manifold.