Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2205.01503 · Globecom

Uniform vs. Non-Uniform Coarse Quantization in Mutual Information Maximizing LDPC Decoding

Philipp H. Mohr, Gerhard Bauch

Published Dec 4, 2022• 4 citations
arXivHTMLPDF

Abstract

Recently, low-resolution LDPC decoders have been introduced that perform mutual information maximizing signal processing. However, the optimal quantization in variable and check nodes requires expensive non-uniform operations. Instead, we propose to use uniform quantization with a simple hardware structure, which reduces the complexity of individual node operations approximately by half and shortens the decoding delay significantly. Our analysis shows that the loss of preserved mutual information resulting from restriction to uniform quantization is very small. Furthermore, the error rate simulations with regular LDPC codes confirm that the uniform quantization causes only minor performance degradation within 0.01 dB compared to the non-uniform alternative. Due to the complexity reduction, especially the proposed 3-bit decoder is a promising candidate to replace 4-bit conventional decoders.

DOI
10.1109/globecom48099.2022.10001452

Related papers

A Variable Node Design with Check Node Aware Quantization Leveraging 2-Bit LDPC Decoding

Philipp H. Mohr, Gerhard Bauch

For improving coarsely quantized decoding of LDPC codes, we propose a check node aware design of the variable node update. In contrast to previous works, we optimize the variable node to explicitly maximize the mutual information preserved in the check-to-variable instead of the variable-to-check node messages. The extended optimization leads to a significantly different solution for the compression operation at the variable node. Simulation results for regular LDPC codes confirm that the check node aware design, especially for very coarse quantization with 2- or 3-bit messages, achieves performance gains of up to 0.2 dB - without additional hardware costs. We also show that the 2-bit message resolution enables a very efficient implementation of the check node update, which requires only 2/9 of the 3-bit check node's transistor count and reduces the signal propagation delay by a factor of 4.

arXiv:2211.06973•Globecom•Dec 4, 2022•4 citations

Memory-efficient decoding of LDPC codes

J.K.-S. Lee, Jeremy Thorpe

We present a low-complexity quantization scheme for the implementation of regular (3,6) LDPC codes. The quantization parameters are optimized to maximize the mutual information between the source and the quantized messages. Using this non-uniform quantized belief propagation algorithm, we have simulated that an optimized 3-bit quantizer operates with 0.2 dB implementation loss relative to a floating point decoder, and an optimized 4-bit quantizer operates less than 0.1 dB quantization loss

IEEE International Symposium on Information Theory (ISIT)•Jan 1, 2005•67 citations

Memory-Assisted Quantized LDPC Decoding

Philipp H. Mohr, Gerhard Bauch

We enhance coarsely quantized LDPC decoding by reusing computed check node messages from previous iterations. Typically, variable and check nodes update and replace old messages every iteration. We show that, under coarse quantization, discarding old messages entails a significant loss of mutual information. The loss is avoided with additional memory, improving performance by up to 0.23 dB. We optimize quantization with a modified information bottleneck algorithm that considers the statistics of old messages. A simple merge operation reduces memory requirements. Depending on channel conditions and code rate, memory assistance enables up to 32% better area efficiency for 2-bit decoding.

arXiv:2408.07437•IEEE Communications Letters•Feb 10, 2025•1 citation

Performance Analysis of Normalized Min-Sum Decoder for LDPC using non-uniform Quantization

K Pargunarajan, R Gandhiraj, Madaswamy Jayakumar

Very high data rates and decoding computational complexity place strict constraints in 5G and 6G communications. In this paper, non-uniform Quantized Decoding algorithm is proposed for Low-density Parity Check codes (LDPC). In the proposed algorithm, the check node updating process is carried out using quantization, which reduces complexity. The Sum Product Algorithm (SPA) is iterative message passing decoding techniques offer the optimal performance for LDPC codes. Implementations use message-passing decoding with more precision, results extremely high complexity. In Iterative, message-passing (MP), trapping sets and absorbing sets causes low error floor. In this article non-uniform quantization proposed to overcome dynamic range of values over uniform quantization. Simulation results provide coding gain increases closer to of 0.5 dB in higher SNR and has good error floor at 10−5.

International Conference on Wireless Communications, Signal Processing and Networking (WiSPNET)•Mar 20, 2025•2 citations

Generalized Mutual Information-Maximizing Quantized Decoding of LDPC Codes.

Peng Kang, Kui Cai, Xuan He +1 more

In this paper, we propose a general framework of the mutual infomration-maximizing (MIM) quantized decoding for low-density parity-check (LDPC) codes, which can outperform the state-of-the-art lookup table (LUT) decoder by using simple mappings and fixed-point additions for the node updates. Our decoding method is generic in the sense that it can be applied to LDPC codes with arbitrary degree distributions, and it can be implemented based on either the belief propagation (BP) algorithm or the min-sum (MS) algorithm, leading to the MIM quantized BP (MIM-QBP) decoder and the MIM quantized MS (MIM-QMS) decoder, respectively. In particular, we approximate the check node (CN) update of the MIM-QBP decoder by a max-product operation and obtain the MIM-QMS decoder, which simplifies the decoder design and requires less resource consumption. To avoid the precision degradation, we introduce a dynamic reconstruction method to optimize the variable node update for different iterations. Some practical aspects of the proposed decoders such as the design and decoding complexity are also discussed. Simulation results show that the MIM-QBP decoder outperforms the LUT decoders in the waterfall region with both 3-bit and 4-bit precision. Moreover, the 4-bit MIM-QMS decoder can even surpass the floating-point BP decoder in the error-floor region.

•Nov 26, 2020•1 citation

Performance of Quantized Min-Sum Decoding Algorithms for Irregular LDPC Codes

Daesun Oh, Keshab K. Parhi

This paper analyzes the performance of quantized min-sum decoding algorithms for irregular low-density parity-check (LDPC) codes. For regular LDPC codes, it is known that the normalized or offset min-sum decoding algorithm with quantization bits less than 6 bits achieves good performances over wide range of signal-to-noise ratios (SNR). However, finite precision effects in decoding irregular LDPC codes are different from that in decoding regular LDPC codes which is caused by the difference of convergence speeds between low degree nodes and high degree nodes. This paper proposes a novel method to improve the performance of the conventional normalized or offset min-sum decoding algorithm when it is approximated with finite precision for hardware implementations. The proposed method applies down-scaling factors to intrinsic information which has effects on increasing the reliability of extrinsic information at variable nodes and compensating the quantization errors caused by finite precision. Computer simulation results for irregular LDPC codes show that the proposed normalized and offset min-sum decoding algorithms achieve better performances at high SNR compared to the conventional normalized and offset min-sum algorithms under (6:2) quantization scheme.

IEEE International Symposium on Circuits and Systems proceedings•May 1, 2007•15 citations
Recently, low-resolution LDPC decoders have been introduced that perform mutual information maximizing signal processing. However, the optimal quantization in variable and check nodes requires expensive non-uniform operations. Instead, we propose to use uniform quantization with a simple hardware structure, which reduces the complexity of individual node operations approximately by half and shortens the decoding delay significantly. Our analysis shows that the loss of preserved mutual information resulting from restriction to uniform quantization is very small. Furthermore, the error rate simulations with regular LDPC codes confirm that the uniform quantization causes only minor performance degradation within 0.01 dB compared to the non-uniform alternative. Due to the complexity reduction, especially the proposed 3-bit decoder is a promising candidate to replace 4-bit conventional decoders.
For improving coarsely quantized decoding of LDPC codes, we propose a check node aware design of the variable node update. In contrast to previous works, we optimize the variable node to explicitly maximize the mutual information preserved in the check-to-variable instead of the variable-to-check node messages. The extended optimization leads to a significantly different solution for the compression operation at the variable node. Simulation results for regular LDPC codes confirm that the check node aware design, especially for very coarse quantization with 2- or 3-bit messages, achieves performance gains of up to 0.2 dB - without additional hardware costs. We also show that the 2-bit message resolution enables a very efficient implementation of the check node update, which requires only 2/9 of the 3-bit check node's transistor count and reduces the signal propagation delay by a factor of 4.
We enhance coarsely quantized LDPC decoding by reusing computed check node messages from previous iterations. Typically, variable and check nodes update and replace old messages every iteration. We show that, under coarse quantization, discarding old messages entails a significant loss of mutual information. The loss is avoided with additional memory, improving performance by up to 0.23 dB. We optimize quantization with a modified information bottleneck algorithm that considers the statistics of old messages. A simple merge operation reduces memory requirements. Depending on channel conditions and code rate, memory assistance enables up to 32% better area efficiency for 2-bit decoding.
Very high data rates and decoding computational complexity place strict constraints in 5G and 6G communications. In this paper, non-uniform Quantized Decoding algorithm is proposed for Low-density Parity Check codes (LDPC). In the proposed algorithm, the check node updating process is carried out using quantization, which reduces complexity. The Sum Product Algorithm (SPA) is iterative message passing decoding techniques offer the optimal performance for LDPC codes. Implementations use message-passing decoding with more precision, results extremely high complexity. In Iterative, message-passing (MP), trapping sets and absorbing sets causes low error floor. In this article non-uniform quantization proposed to overcome dynamic range of values over uniform quantization. Simulation results provide coding gain increases closer to of 0.5 dB in higher SNR and has good error floor at 10−5.
In this paper, we propose a general framework of the mutual infomration-maximizing (MIM) quantized decoding for low-density parity-check (LDPC) codes, which can outperform the state-of-the-art lookup table (LUT) decoder by using simple mappings and fixed-point additions for the node updates. Our decoding method is generic in the sense that it can be applied to LDPC codes with arbitrary degree distributions, and it can be implemented based on either the belief propagation (BP) algorithm or the min-sum (MS) algorithm, leading to the MIM quantized BP (MIM-QBP) decoder and the MIM quantized MS (MIM-QMS) decoder, respectively. In particular, we approximate the check node (CN) update of the MIM-QBP decoder by a max-product operation and obtain the MIM-QMS decoder, which simplifies the decoder design and requires less resource consumption. To avoid the precision degradation, we introduce a dynamic reconstruction method to optimize the variable node update for different iterations. Some practical aspects of the proposed decoders such as the design and decoding complexity are also discussed. Simulation results show that the MIM-QBP decoder outperforms the LUT decoders in the waterfall region with both 3-bit and 4-bit precision. Moreover, the 4-bit MIM-QMS decoder can even surpass the floating-point BP decoder in the error-floor region.
This paper analyzes the performance of quantized min-sum decoding algorithms for irregular low-density parity-check (LDPC) codes. For regular LDPC codes, it is known that the normalized or offset min-sum decoding algorithm with quantization bits less than 6 bits achieves good performances over wide range of signal-to-noise ratios (SNR). However, finite precision effects in decoding irregular LDPC codes are different from that in decoding regular LDPC codes which is caused by the difference of convergence speeds between low degree nodes and high degree nodes. This paper proposes a novel method to improve the performance of the conventional normalized or offset min-sum decoding algorithm when it is approximated with finite precision for hardware implementations. The proposed method applies down-scaling factors to intrinsic information which has effects on increasing the reliability of extrinsic information at variable nodes and compensating the quantization errors caused by finite precision. Computer simulation results for irregular LDPC codes show that the proposed normalized and offset min-sum decoding algorithms achieve better performances at high SNR compared to the conventional normalized and offset min-sum algorithms under (6:2) quantization scheme.