Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2203.08682 · APL Photonics

Fast and efficient demultiplexing of single photons from a quantum dot with resonantly enhanced electro-optic modulators

Julian Münzberg, Franz Draxl, Saimon Filipe Covre da Silva, Yusuf Karli, Santanu Manna, Armando Rastelli, Gregor Weihs, Robert Keil

Published Jun 23, 2022• 18 citations
arXivHTMLPDF

Abstract

We report on a multi-photon source based on active demultiplexing of single photons emitted from a resonantly excited GaAs quantum dot. Active temporal-to-spatial mode demultiplexing is implemented via resonantly enhanced free-space electro-optic modulators, making it possible to route individual photons at high switching rates of 38 MHz. We demonstrate routing into four spatial modes with a high end-to-end efficiency of ≈ 79% and measure a four-photon coincidence rate of 0.17 Hz mostly limited by the single-photon source brightness and not by the efficiency of the demultiplexer itself. We use the demultiplexer to characterize the pairwise indistinguishability of consecutively emitted photons from the quantum dot with variable delay time.

DOI
10.1063/5.0091867

Related papers

Single-active-element demultiplexed multi-photon source

L. M. Hansen, Lorenzo Carosini, Lennart Jehle +5 more

Temporal-to-spatial mode demultiplexing routes non-simultaneous events of the same spatial mode to distinct output trajectories. This technique has now been widely adopted, because it gives access to higher-number multi-photon states when exploiting solid-state quantum emitters. However, implementations so far have required an always-increasing number of active elements and are therefore rapidly facing resource constraints. Here, we propose and demonstrate a demultiplexing approach that uses only a single active element for routing to, in principle, an arbitrary number of outputs. We employ our device in combination with a high-efficiency single-photon source based on a quantum dot, and measure up to eight demultiplexed highly indistinguishable single photons. We discuss the practical limitations of our approach, and describe in which conditions it can be used to demultiplex, e.g., tens of outputs. Our scheme thus provides a path for the preparation of resource-efficient larger-scale multi-photon sources.

arXiv:2304.12956•Optica Quantum•Sep 28, 2023•8 citations

Passive demultiplexed two-photon state generation from a quantum dot

Yusuf Karli, Iker Avila Arenas, Christian Schimpf +11 more

High-purity multi-photon states are essential for photonic quantum computing. Among existing platforms, semiconductor quantum dots offer a promising route to scalable and deterministic multi-photon state generation. However, to fully realize their potential, we require a suitable optical excitation method. Current approaches to multi-photon generation rely on active polarization-switching elements (e.g., electro-optic modulators, EOMs) to spatio-temporally demultiplex single photons. Yet, the achievable multi-photon rate is fundamentally limited by the switching speed of the EOM. Here, we introduce a fully passive demultiplexing technique that leverages a stimulated two-photon excitation process to achieve switching rates only limited by the quantum dot lifetime. We demonstrate this method by generating two-photon states from a single quantum dot without requiring active switching elements. Our approach significantly reduces the cost of demultiplexing while shifting it to the excitation stage, enabling loss-free demultiplexing and effectively doubling the achievable multi-photon generation rate when combined with existing active demultiplexing techniques.

arXiv:2502.14806•npj Quantum Information•Aug 11, 2025•3 citations

Active demultiplexing of single photons from a solid‐state source

Francesco Lenzini, Ben Haylock, J. C. Loredo +11 more

Abstract A scheme for active temporal‐to‐spatial demultiplexing of single photons generated by a solid‐state source is introduced. The scheme scales quasi‐polynomially with photon number, providing a viable technological path for routingnphotons in the one temporal stream from a single emitter tondifferent spatial modes. Active demultiplexing is demonstrated using a state‐of‐the‐art photon source—a quantum‐dot deterministically coupled to a micropillar cavity—and a custom‐built demultiplexer—a network of electro‐optically reconfigurable waveguides monolithically integrated in a lithium niobate chip. The measured demultiplexer performance can enable a six‐photon rate three orders of magnitude higher than the equivalent heralded SPDC source, providing a platform for intermediate quantum computation protocols. image

arXiv:1611.02294•Laser & Photonics Review•Apr 11, 2017•69 citations

Resource-efficient low-loss four-channel active demultiplexer for single photons

Mikhail Dryazgov, Yu. A. Biriukov, I. V. Dyakonov +12 more

We report a design and implementation of a resource-efficient spatial demultiplexer which produces four indistinguishable photons with efficiency of 39.7% per channel. Our scheme is based on a free-space storage/delay line which accumulates four photons and releases them by a controlled polarization rotation using a single Pockels cell.

arXiv:2304.09622•Optica Quantum•Sep 28, 2023•3 citations

Active demultiplexing of single photons from a solid‐state source (Laser Photonics Rev. 11(3)/2017)

Francesco Lenzini, Ben Haylock, J. C. Loredo +11 more

Single photons from a solid state source are deterministically routed into different output modes by a fully integrated active optical switch network. Using a state-of-the-art single photon source made of a single quantum dot in a micropillar cavity and an innovative integrated optical demultiplexer, this scheme is capable of creating manifold single photon states. Such states are a crucial resource for photonic quantum information applications including linear optics quantum computation and quantum communications. (Picture: Mirko Lobino, Ph.D. et al., article number 1600297, in this issue)

Laser & Photonics Review•May 1, 2017•3 citations

Multi-photon emission from a resonantly pumped quantum dot

Francesco Giorgino, P. Zahálka, Lennart Jehle +4 more

Resonance fluorescence of natural or artificial atoms constitutes a prime method for generating non-classical light. While most efforts have focused on producing single photons, multi-photon emission is unavoidably present in the resonant driving of an atom. Here, we study the extent to which these processes occur: we quantify the multi-photon emission statistics in a resonantly driven two-level artificial atom—a semiconductor quantum dot in a micropillar cavity—when pumped by short optical pulses. By measuring auto-correlation functions up to the fourth order, we observe up to four photons emitted after a single pumping pulse and investigate the emission dynamics with finely resolved temporal measurements. Furthermore, we propose a method based on acquisition time gating to enhance the purity of a single-photon source while maintaining high efficiencies. Our results deepen the understanding of the photon emission processes in coherently driven atomic systems and suggest a simple but effective technique to reduce the multi-photon components of a single-photon source.

arXiv:2507.04843•Optica Quantum•Jul 7, 2025•3 citations
We report on a multi-photon source based on active demultiplexing of single photons emitted from a resonantly excited GaAs quantum dot. Active temporal-to-spatial mode demultiplexing is implemented via resonantly enhanced free-space electro-optic modulators, making it possible to route individual photons at high switching rates of 38 MHz. We demonstrate routing into four spatial modes with a high end-to-end efficiency of ≈ 79% and measure a four-photon coincidence rate of 0.17 Hz mostly limited by the single-photon source brightness and not by the efficiency of the demultiplexer itself. We use the demultiplexer to characterize the pairwise indistinguishability of consecutively emitted photons from the quantum dot with variable delay time.
Temporal-to-spatial mode demultiplexing routes non-simultaneous events of the same spatial mode to distinct output trajectories. This technique has now been widely adopted, because it gives access to higher-number multi-photon states when exploiting solid-state quantum emitters. However, implementations so far have required an always-increasing number of active elements and are therefore rapidly facing resource constraints. Here, we propose and demonstrate a demultiplexing approach that uses only a single active element for routing to, in principle, an arbitrary number of outputs. We employ our device in combination with a high-efficiency single-photon source based on a quantum dot, and measure up to eight demultiplexed highly indistinguishable single photons. We discuss the practical limitations of our approach, and describe in which conditions it can be used to demultiplex, e.g., tens of outputs. Our scheme thus provides a path for the preparation of resource-efficient larger-scale multi-photon sources.
High-purity multi-photon states are essential for photonic quantum computing. Among existing platforms, semiconductor quantum dots offer a promising route to scalable and deterministic multi-photon state generation. However, to fully realize their potential, we require a suitable optical excitation method. Current approaches to multi-photon generation rely on active polarization-switching elements (e.g., electro-optic modulators, EOMs) to spatio-temporally demultiplex single photons. Yet, the achievable multi-photon rate is fundamentally limited by the switching speed of the EOM. Here, we introduce a fully passive demultiplexing technique that leverages a stimulated two-photon excitation process to achieve switching rates only limited by the quantum dot lifetime. We demonstrate this method by generating two-photon states from a single quantum dot without requiring active switching elements. Our approach significantly reduces the cost of demultiplexing while shifting it to the excitation stage, enabling loss-free demultiplexing and effectively doubling the achievable multi-photon generation rate when combined with existing active demultiplexing techniques.
Abstract A scheme for active temporal‐to‐spatial demultiplexing of single photons generated by a solid‐state source is introduced. The scheme scales quasi‐polynomially with photon number, providing a viable technological path for routingnphotons in the one temporal stream from a single emitter tondifferent spatial modes. Active demultiplexing is demonstrated using a state‐of‐the‐art photon source—a quantum‐dot deterministically coupled to a micropillar cavity—and a custom‐built demultiplexer—a network of electro‐optically reconfigurable waveguides monolithically integrated in a lithium niobate chip. The measured demultiplexer performance can enable a six‐photon rate three orders of magnitude higher than the equivalent heralded SPDC source, providing a platform for intermediate quantum computation protocols. image
Single photons from a solid state source are deterministically routed into different output modes by a fully integrated active optical switch network. Using a state-of-the-art single photon source made of a single quantum dot in a micropillar cavity and an innovative integrated optical demultiplexer, this scheme is capable of creating manifold single photon states. Such states are a crucial resource for photonic quantum information applications including linear optics quantum computation and quantum communications. (Picture: Mirko Lobino, Ph.D. et al., article number 1600297, in this issue)
Resonance fluorescence of natural or artificial atoms constitutes a prime method for generating non-classical light. While most efforts have focused on producing single photons, multi-photon emission is unavoidably present in the resonant driving of an atom. Here, we study the extent to which these processes occur: we quantify the multi-photon emission statistics in a resonantly driven two-level artificial atom—a semiconductor quantum dot in a micropillar cavity—when pumped by short optical pulses. By measuring auto-correlation functions up to the fourth order, we observe up to four photons emitted after a single pumping pulse and investigate the emission dynamics with finely resolved temporal measurements. Furthermore, we propose a method based on acquisition time gating to enhance the purity of a single-photon source while maintaining high efficiencies. Our results deepen the understanding of the photon emission processes in coherently driven atomic systems and suggest a simple but effective technique to reduce the multi-photon components of a single-photon source.