Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2106.03883 · Physical Review Research

Cooling and state preparation in an optical lattice via Markovian feedback control

Ling-Na Wu, André Eckardt

Published May 24, 2022• 19 citations
arXivHTMLPDF

Abstract

This paper presents a scheme based on Markovian feedback control that allows for the preparation of single targeted eigenstates of a system of bosonic atoms in a one-dimensional optical lattice with high fidelity.
DOI
10.1103/physrevresearch.4.l022045

Related papers

Quantum engineering of a synthetic thermal bath for bosonic atoms in a one-dimensional optical lattice via Markovian feedback control

Ling-Na Wu, André Eckardt

We propose and investigate a scheme for engineering a synthetic thermal bath for a bosonic quantum gas in a one-dimensional optical lattice based on Markovian feedback control. The performance of our scheme is quantified by the fidelity between the steady state of the system and the effective thermal state. For double-well and triple-well systems with non-interacting particles, the steady state is found to be an exact thermal state, which is attributed to the fact that the transfer rates between all pairs of coupled eigenstates satisfy detailed balance condition. The scenario changes when there are more lattice sites, where the detailed balance condition does not hold any more, but remains an accurate approximation. Remarkably, our scheme performs very well at low and high temperature regimes, with the fidelity close to one. The performance at intermediate temperatures~(where a crossover into a Bose condensed regime occurs) is slightly worse, and the fidelity shows a gentle decrease with increasing system size. We also discuss the interacting cases. In contrast to the non-interacting cases, the scheme is found to perform better at a higher temperature. Another difference is that the minimal temperature that can be engineered is nonzero and increases with the interaction strength.

arXiv:2203.15670•SciPost Physics•Sep 21, 2022•6 citations

Quantum State Control of a Bose-Einstein Condensate in an Optical Lattice

Nathan Dupont, Gabriel Chatelain, Lucas Gabardos +5 more

We report on the efficient design of quantum optimal-control protocols to manipulate the motional states of an atomic Bose-Einstein condensate (BEC) in a one-dimensional optical lattice.Our protocols operate on the momentum comb associated with the lattice.In contrast to previous works also dealing with control in discrete and large Hilbert spaces, our control schemes allow us to reach a wide variety of targets by varying a single parameter, the lattice position.With this technique, we experimentally demonstrate a precise, robust, and versatile control: we optimize the transfer of the BEC to a single or multiple quantized momentum states with full control on the relative phase between the different momentum components.This also allows us to prepare the BEC in a given eigenstate of the lattice band structure, or superposition thereof.

arXiv:2105.05667•PRX Quantum•Oct 5, 2021•60 citations

Many-body state engineering using measurements and fixed unitary dynamics

Mads Kock Pedersen, Jens Jakob W H Sørensen, Malte C Tichy +1 more

We develop a scheme to prepare a desired state or subspace in high-dimensional Hilbert-spaces using repeated applications of a single static projection operator onto the desired target and fixed unitary dynamics. Benchmarks against other control schemes, performed on generic Hamiltonians and on Bose--Hubbard systems, establish the competitiveness of the method. As a concrete application of the control of mesoscopic atomic samples in optical lattices we demonstrate the near deterministic preparation of Schrödinger cat states of all atoms residing on either the odd or the even sites.

arXiv:1406.0667•New Journal of Physics•Nov 19, 2014•33 citations

Feedback control of atomic motion in optical lattices

Natalya V. Morrow, S.K. Dutta, Georg A. Raithel

Summary form only given. Atoms in an optical lattice, though very slow, perform a slight random motion that reflects the non-zero temperature of the trapped atoms. We are proposing a way of reducing such random motion using real-time feedback. The method is related to the stochastic cooling used to transversely cool particle beams. Another stochastic cooling method for laser-cooled atoms has been proposed in "Stochastic cooling of atoms using lasers," see Phys. Rev. A, vol. 58, p. 4757 (1998). Our scheme involves a measurement of the coherent redistribution of photons between different laser beams of the optical lattice.

Quantum Electronics and Laser Science Conference•Nov 13, 2002•1 citation

Single-qubit rotations in two-dimensional optical lattices with multiqubit addressing

Jaewoo Joo, Yuan Liang Lim, Almut Beige +1 more

Optical lattices with one atom on each site and interacting via cold controlled collisions provide an efficient way to entangle a large number of qubits with high fidelity. It has already been demonstrated experimentally that this approach is especially suited for the generation of cluster states [O. Mandel et al., Nature 425, 937 (2003)] which reduce the resource requirement for quantum computing to the ability to perform single-qubit rotations and qubit read out. In this paper, we describe how to implement these rotations in one-dimensional and two-dimensional optical lattices without having to address the atoms individually with a laser field.

arXiv:quant-ph/0601100•Physical Review A•Oct 31, 2006•26 citations

Quantum feedback for preparation and protection of quantum states of light

C. Sayrin, I. Dotsenko, S. Gleyzes +3 more

Aiming on the preparation of a given physical system in a particular quantum state, we can follow one of several standard approaches. The most straightforward one is to expose the system to a specific coherent evolution that will deterministically bring it into the desired final state. However, in case of microscopic few-particle systems this approach requires very good control of physical parameters at the single particle level. Another method of the state production is based on projective quantum measurements of the system: Quantum Mechanics postulates that the system is randomly projected onto one of the eigenstates of the measurement operator M. By a proper choice of M, the system can end up in the desired state after the measurement. Being less demanding this method is however inherently non-deterministic. To steer the system towards the target state and thus to overcome the randomness of the measurement, we propose to use an active feedback on the system while the measurement is being performed.

Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)•May 1, 2011•0 citations
We propose and investigate a scheme for engineering a synthetic thermal bath for a bosonic quantum gas in a one-dimensional optical lattice based on Markovian feedback control. The performance of our scheme is quantified by the fidelity between the steady state of the system and the effective thermal state. For double-well and triple-well systems with non-interacting particles, the steady state is found to be an exact thermal state, which is attributed to the fact that the transfer rates between all pairs of coupled eigenstates satisfy detailed balance condition. The scenario changes when there are more lattice sites, where the detailed balance condition does not hold any more, but remains an accurate approximation. Remarkably, our scheme performs very well at low and high temperature regimes, with the fidelity close to one. The performance at intermediate temperatures~(where a crossover into a Bose condensed regime occurs) is slightly worse, and the fidelity shows a gentle decrease with increasing system size. We also discuss the interacting cases. In contrast to the non-interacting cases, the scheme is found to perform better at a higher temperature. Another difference is that the minimal temperature that can be engineered is nonzero and increases with the interaction strength.
We report on the efficient design of quantum optimal-control protocols to manipulate the motional states of an atomic Bose-Einstein condensate (BEC) in a one-dimensional optical lattice.Our protocols operate on the momentum comb associated with the lattice.In contrast to previous works also dealing with control in discrete and large Hilbert spaces, our control schemes allow us to reach a wide variety of targets by varying a single parameter, the lattice position.With this technique, we experimentally demonstrate a precise, robust, and versatile control: we optimize the transfer of the BEC to a single or multiple quantized momentum states with full control on the relative phase between the different momentum components.This also allows us to prepare the BEC in a given eigenstate of the lattice band structure, or superposition thereof.
We develop a scheme to prepare a desired state or subspace in high-dimensional Hilbert-spaces using repeated applications of a single static projection operator onto the desired target and fixed unitary dynamics. Benchmarks against other control schemes, performed on generic Hamiltonians and on Bose--Hubbard systems, establish the competitiveness of the method. As a concrete application of the control of mesoscopic atomic samples in optical lattices we demonstrate the near deterministic preparation of Schrödinger cat states of all atoms residing on either the odd or the even sites.
Summary form only given. Atoms in an optical lattice, though very slow, perform a slight random motion that reflects the non-zero temperature of the trapped atoms. We are proposing a way of reducing such random motion using real-time feedback. The method is related to the stochastic cooling used to transversely cool particle beams. Another stochastic cooling method for laser-cooled atoms has been proposed in "Stochastic cooling of atoms using lasers," see Phys. Rev. A, vol. 58, p. 4757 (1998). Our scheme involves a measurement of the coherent redistribution of photons between different laser beams of the optical lattice.
Optical lattices with one atom on each site and interacting via cold controlled collisions provide an efficient way to entangle a large number of qubits with high fidelity. It has already been demonstrated experimentally that this approach is especially suited for the generation of cluster states [O. Mandel et al., Nature 425, 937 (2003)] which reduce the resource requirement for quantum computing to the ability to perform single-qubit rotations and qubit read out. In this paper, we describe how to implement these rotations in one-dimensional and two-dimensional optical lattices without having to address the atoms individually with a laser field.
Aiming on the preparation of a given physical system in a particular quantum state, we can follow one of several standard approaches. The most straightforward one is to expose the system to a specific coherent evolution that will deterministically bring it into the desired final state. However, in case of microscopic few-particle systems this approach requires very good control of physical parameters at the single particle level. Another method of the state production is based on projective quantum measurements of the system: Quantum Mechanics postulates that the system is randomly projected onto one of the eigenstates of the measurement operator M. By a proper choice of M, the system can end up in the desired state after the measurement. Being less demanding this method is however inherently non-deterministic. To steer the system towards the target state and thus to overcome the randomness of the measurement, we propose to use an active feedback on the system while the measurement is being performed.