Simultaneous ideal quantum measurements of multiple single-photon-level signals would advance applications in quantum information processing, metrology, and astronomy but require the first amplifier to be simultaneously broadband, quantum limited, and directional.However, conventional traveling-wave parametric amplifiers support broadband amplification at the cost of increased added noise and are not genuinely directional due to non-negligible nonlinear backward-wave generation.In this work, we introduce a new class of amplifiers that encode the information in the Floquet modes of the system.Such Floquetmode amplifiers prevent information leakage and overcome the trade-off between quantum efficiency (QE) and bandwidth.Crucially, Floquet-mode amplifiers strongly suppress the nonlinear forward-backward wave coupling and are therefore genuinely directional and readily integrable with qubits, clearing another major obstacle toward broadband ideal quantum measurements.Furthermore, Floquet-mode amplifiers are insensitive to out-of-band impedance mismatch, which otherwise may lead to gain ripples, parametric oscillations, and instability in conventional traveling-wave parametric amplifiers.Finally, we show that a Floquet-mode Josephson traveling-wave parametric amplifier implementation can simultaneously achieve > 20 dB gain and a QE of η/η ideal > 99.9% of the quantum limit over more than an octave of bandwidth.The proposed Floquet scheme is also widely applicable to other platforms, such as kinetic inductance traveling-wave amplifiers and optical parametric amplifiers.
Simultaneous ideal quantum measurements of multiple single-photon-level signals would advance applications in quantum information processing, metrology, and astronomy but require the first amplifier to be simultaneously broadband, quantum limited, and directional.However, conventional traveling-wave parametric amplifiers support broadband amplification at the cost of increased added noise and are not genuinely directional due to non-negligible nonlinear backward-wave generation.In this work, we introduce a new class of amplifiers that encode the information in the Floquet modes of the system.Such Floquetmode amplifiers prevent information leakage and overcome the trade-off between quantum efficiency (QE) and bandwidth.Crucially, Floquet-mode amplifiers strongly suppress the nonlinear forward-backward wave coupling and are therefore genuinely directional and readily integrable with qubits, clearing another major obstacle toward broadband ideal quantum measurements.Furthermore, Floquet-mode amplifiers are insensitive to out-of-band impedance mismatch, which otherwise may lead to gain ripples, parametric oscillations, and instability in conventional traveling-wave parametric amplifiers.Finally, we show that a Floquet-mode Josephson traveling-wave parametric amplifier implementation can simultaneously achieve > 20 dB gain and a QE of η/η ideal > 99.9% of the quantum limit over more than an octave of bandwidth.The proposed Floquet scheme is also widely applicable to other platforms, such as kinetic inductance traveling-wave amplifiers and optical parametric amplifiers.
Advancing error-corrected quantum computing and fundamental science necessitates quantum-limited amplifiers with near-ideal quantum efficiency and multiplexing capability. However, existing solutions achieve one at the expense of the other; for example, Josephson traveling wave parametric amplifiers (JTWPAs) are highgain, broadband, and chip-based quantum amplifiers that conventionally incur a bandwidth-noise tradeoff. When operated at 20-dB gain and instantaneous bandwidths of a few GHz, JTWPAs typically reach near-quantum limited intrinsic efficiencies of 70% - 85% relative to that of an ideal phase-preserving quantum amplifier. This is due to information leakage to the sidebands of the JTWPA, which can be recovered by adiabatically transforming the input modes to Floquet modes of the system within the device. In this thesis, we experimentally demonstrate the first Floquet-mode travelingwave parametric amplifier (Floquet TWPA). Fabricated in a superconducting qubit process, this Floquet TWPA achieves minimal dissipation, quantum-limited noise performance, and broadband operation. Our device exhibits > 20-dB amplification over a 3-GHz instantaneous bandwidth, <0.5 -dB average in-band insertion loss, and the highest-reported intrinsic quantum efficiency for a TWPA of 92.1±7.6%, relative to an ideal phase-preserving amplifier. When measuring a superconducting qubit, our Floquet TWPA enables a system measurement efficiency of 65.1 ± 5.8%, the highest-reported in a superconducting qubit readout experiment utilizing phase-preserving amplifiers to the best of our knowledge. Finally, we discuss the noise limitations of our current experimental setup, as well as impedance matching strategies that will enable us to push towards ideal JTWPA performance. These general-purpose Floquet TWPAs are suitable for fast, high-fidelity multiplexed readout in large-scale quantum systems and future monolithic integration with quantum processors.
Advancing fault-tolerant quantum computing and fundamental science necessitates quantum-limited amplifiers with near-ideal quantum efficiency and multiplexing capability. However, existing solutions typically achieve one at the expense of the other. In this work, we experimentally demonstrate the first Floquet-mode traveling-wave parametric amplifier (Floquet TWPA), which achieves nearly quantum-limited noise performance, minimal dissipation, and broadband operation, breaking the presumption that broadband amplifiers introduce higher noise. We achieve a system measurement efficiency of 65.1±5.8% when measuring a superconducting qubit, which to our knowledge is the highest-reported in a superconducting qubit readout experiment utilizing phase-preserving amplifiers. Our device exhibits >20-dB amplification over a 3-GHz instantaneous bandwidth, <0.5-dB average in-band insertion loss, and the highest reported intrinsic quantum efficiency for a TWPA of 92.1±7.6%, relative to an ideal phase-preserving amplifier. Fabricated in a superconducting qubit process, these general-purpose Floquet TWPAs are suitable for fast, high-fidelity multiplexed readout in large-scale quantum systems and future monolithic integration with quantum processors.
Low-noise microwave amplifiers are crucial for detecting weak signals in fields such as quantum technology and radio astronomy. However, designing an ideal amplifier is challenging, as it must cover a wide frequency range, add minimal noise, and operate directionally - amplifying signals only in the observer's direction while protecting the source from environmental interference. In this work, we demonstrate that an array of non-linearly coupled Josephson parametric amplifiers (JPAs) can collectively function as a directional, broadband quantum amplifier by harnessing topological effects. By applying a collective four-wave-mixing pump with inhomogeneous amplitudes and linearly increasing phase, we break time-reversal symmetry in the JPA array and stabilize a topological amplification regime where signals are exponentially amplified in one direction and exponentially suppressed in the opposite. We show that compact devices with few sites N∼11−17 can achieve exceptional performance, with gains exceeding 20 dB over a bandwidth ranging from hundreds of MHz to GHz, and reverse isolation suppressing backward noise by more than 30 dB across all frequencies. The device also operates near the quantum noise limit and provides topological protection against up to 15% fabrication disorder, effectively suppressing gain ripples. The amplifier's intrinsic directionality eliminates the need for external isolators, paving the way for fully on-chip, near-ideal superconducting pre-amplifiers.
One of the primary requirements for superconducting quantum information processors is high-fidelity, quantum non-demolition qubit readout. In superconducting circuits, we perform measurements with quantum-limited microwave amplifiers. These amplifiers are based on microwave cavities and powered by Josephson-junction based nonlinearities, which we drive to parametrically modulate the circuit and generate gain. However, cavity-based amplifiers generally suffer from a fixed gain-bandwidth product, a limited dynamic range, and the absence of directionality, and so they must be operated with external lossy microwave commercial components such as circulators. Many of these limitations can be circumvented by combining multiple parametric processes in a few-mode device, in particular by combining parametric drives which produce gain and those which produce gainless photon conversion. By combining balanced gain and conversion processes between a pair of modes, we have demonstrated transmission-only, phase-sensitive, gain-bandwidth-free amplification. We have also used measurements of transmon qubits with this mode of amplification to demonstrate its practical utility. More, by combining multiple instances of imbalanced gain and conversion processes among three modes, we have realized devices with non-reciprocal, transmission-only amplification, matched ports, and a large, gain-independent bandwidth. One of the biggest challenges in tuning multiple parametric processes is both inherent and dynamically-generated higher order nonlinearities in the device, which shift mode frequencies and parametric coupling strengths with pump power, preventing accurate balancing of the parametric processes. These can be controlled through engineering the Hamiltonian of the nonlinear element, in this thesis either a linearly-shunted Josephson Ring Modulator or SNAIL (Superconducting Nonlinear Asymmetric Inductive eLements), which for certain applied flux values can minimize or even change the sign of higher-order even nonlinearities. Additionally, we have explored a range of circuit parameters, allowing us to also control the relative size of odd-order nonlinearities. We have developed a series of prototypes which implement these concepts, and have achieved both high-dynamic range singly pumped amplifiers, and a promising platform for multi-parametric devices. We conclude by presenting recent progress towards implementing multiple parametric schemes that generates a practical directional amplifier, and discuss the remaining obstacles to a truly ideal parametric amplifiers.
Broadband quantum-limited parametric amplifiers (PAs) are essential components in quantum information science and technology. Impedance-engineered resonator-based PAs and traveling-wave PAs are the primary approaches taken to overcome the gain-bandwidth constraint. While the former PAs are simpler to fabricate, the target characteristic impedance ZNR of the nonlinear resonator has been restricted to be below $10\phantom{\rule{0.2em}{0ex}}\mathrm{\ensuremath{\Omega}}$, requiring large capacitance. Moreover, these PAs have only been implemented with aluminum-based Josephson junctions (JJs), hindering their operation at high temperatures or strong magnetic fields. To address these issues, we propose a three-stage impedance-transformer scheme, showcased with a 20 nm thick, 250 nm wide, high-kinetic-inductance niobium-titanium-nitride (NbTiN) film. Our scheme enables ZNR up to several tens of ohms---a tenfold improvement over conventional designs, achieved through an additional quarter-wavelength transmission line with a characteristic impedance of 180 $\mathrm{\ensuremath{\Omega}}$. Our kinetic-inductance impedance-engineered parametric amplifiers (KIMPAs), featuring a 330 fF shunt capacitor, demonstrate a phase-preserving amplification with a 450-MHz bandwidth at 17 dB gain, and added noise ranging from 0.5 to 1.3 quanta near the center frequency of 8.4 GHz. Owing to the high critical current of the NbTiN nanowire, the KIMPA also achieves an output saturation power of up to $\ensuremath{-}51\ifmmode\pm\else\textpm\fi{}3$ dBm, approximately 25 dB higher than that of JJ-based PAs. This scheme also opens new possibilities for other three-wave-mixing building blocks.
Optical parametric amplifiers (OPAs) are promising to overcome the wavelength coverage and noise limitations in conventional optical amplifiers based on rare-earth doping and semiconductor gain. However, the high power requirement remains a major obstacle to the widespread use of OPAs. Integrated OPAs can in principle improve the pump efficiency with tight mode confinement; however, challenges associated with propagation loss, limited nonlinearity, and susceptibility to nanoscale fabrication imperfections prevent them from competing with conventional bulk and fiber-based OPAs. Here, we demonstrate a highly efficient integrated OPAs with continuous-wave net gain. The pump efficiency is improved by over one order of magnitude. Phase-sensitive gain of 23.5 dB is demonstrated, significantly exceeding previous integrated OPAs, using only 110 mW pump power and no cavity enhancement. This is achieved with parametric down-conversion in thin-film lithium niobate waveguides using the adapted poling technique to maintain the coherence of nonlinear interactions. Moreover, the high parametric gain exceeds fibre-chip-fibre losses, leading to appreciable net gain up to 10 dB. The 3 dB bandwidth is approximately 120 nm, covering telecommunication S-, C-, and Lbands. Quantum-limited noise performance is confirmed through the measurement of output field fluctuation below the classical limit. We further demonstrate that signalto-noise ratio in noisy optical communications can be increased by leveraging this efficient integrated OPA. Our work marks a significant step towards ideal optical amplifiers with strong amplification, high efficiency, quantum-limited noise, large bandwidth, and continuous-wave operation, unlocking new possibilities for next-generation photonic information processing systems.