Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2012.08797

Tilted Nanofiber Bragg Grating as an efficient photon collector from single quantum emitters: A new avenue

Subrat Sahu, Rajan Jha

Published Dec 16, 2020• 0 citations
arXivHTMLPDF

Abstract

We report a new gateway to enhance the sponatnesous emission rate of single quantum emitters by introducing a cavity in tilted nanofiber Bragg grating (TNFBG). We found that light emitter's coupling efficiency into the tilted grating structure's guided mode is 65%, with 70 grating periods. This novel tilted structure has a high Q factor ~ 1408.71 and low mode volume ~ 0.66 microm3- an important requirement. Further, the Purcell factor of a quantum light emitter inside the nanofiber is nine times more than that of an emitter on the cavity's surface. The further optimized system with enhanced perfromance can be used the next generation quantum information and quantum metrology application.

DOI
10.48550/arxiv.2012.08797

Related papers

Tailoring a nanofiber for enhanced photon emission and coupling efficiency from single quantum emitters

Wenfang Li, Jinjin Du, Síle Nic Chormaic

We present a novel approach to enhance the spontaneous emission rate of single quantum emitters in an optical nanofiber-based cavity by introducing a narrow air-filled groove into the cavity. Our results show that the Purcell factor for single quantum emitters inside the groove of the nanofiber-based cavity can be at least six times greater than for such an emitter on the fiber surface when using an optimized cavity mode and groove width. Moreover, the coupling efficiency of single quantum emitters into the guided mode of this nanofiber-based cavity can reach up to ∼80% with only 35 cavity-grating periods. This new system has the potential to act as an all-fiber platform to realize efficient coupling of photons from single emitters into an optical fiber for quantum information applications.

arXiv:1801.05953•Optics Letters•Apr 3, 2018•34 citations

Cavity Quantum Electrodynamics on a Nanofiber Using a Composite Photonic Crystal Cavity

Ramachandrarao Yalla, Mark Sadgrove, K. P. Nayak +1 more

We demonstrate cavity QED conditions in the Purcell regime for single quantum emitters on the surface of an optical nanofiber. The cavity is formed by combining an optical nanofiber and a nanofabricated grating to create a composite photonic crystal cavity. By using this technique, significant enhancement of the spontaneous emission rate into the nanofiber guided modes is observed for single quantum dots. Our results pave the way for enhanced on-fiber light-matter interfaces with clear applications to quantum networks.

arXiv:1409.3298•Physical Review Letters•Sep 29, 2014•153 citations

Optimization of nanofiber gratings for efficient single-photon collection

Subrat Sahu, K. P. Nayak, Rajan Jha

Abstract We report on a simulation of a nanophotonic cavity constructed by designing periodic holes on an optical nanofiber to realize light–matter interaction. The cavity is designed using finite-difference time-domain simulations to maximize the coupling of spontaneous emission from a quantum emitter into fiber-guided modes. We systematically analyze the dependence of spontaneous emission on the quantum emitter position, polarization, and the grating strength (number of periods). We show that coupling efficiencies as high as 87% and 83% can be realized for a dipole emitter placed at the center of the nanofiber with polarization perpendicular ( x -pol) and parallel ( y -pol) to the hole-axis, respectively. This system may attract various quantum photonic applications based on single-photon sources.

Journal of Optics•Sep 29, 2022•20 citations

Realization of a high-g factor nanofiber Bragg cavity using a He focused ion beam milling system

Hideaki Takashima, Atsushi Fukuda, Yusuke Iwabata +3 more

Efficient coupling of photons emitted from single light emitters into the single guided mode of an optical fiber is important to realize photonic quantum network devices [1], such as single photon sources [2] and quantum phase gates [3]. For this purpose, we have developed nanofiber Bragg cavities (NFBCs) and observed the enhanced photon emission from the single light emitter [4]. Here, we report the development of the NFBC with the Q-factor of 1560, which is about 5 times larger than our previous NFBC fabricated by a gallium focused ion beam (FIB) milling system [4]. According to numerical simulation, the NFBC with such high-ß factor can be realized Purcell factor of about 18 and the coupling efficiency of about 80 %.

Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)•Jun 1, 2017•0 citations

Enhancement of Single Quantum Emitters Using Ultra-Widely Tunable Nanofiber Bragg Cavities

Andreas Wolfgang Schell, Hideaki Takashima, Shunya Kamioka +5 more

We introduce nanofiber Bragg cavities fulfilling three important requirements: small mode-volume, wide tuning-range, and efficient fiber-coupling. In a first application, we show enhancement of single quantum emitters such as quantum dots and nitrogen vacancy centers.

Conference on Lasers and Electro-Optics•Jan 1, 2015•0 citations

Geometry-driven tunable single-photon coupling into an optical nanofiber cavity

Subrat Sahu, Rajan Jha

We propose a geometry-driven strategy for achieving tunable single-photon coupling in an optical nanofiber cavity (ONFC), where the resonance wavelength is controlled by tailoring the optical nanofiber (ONF) diameter and the grating pitch. By adjusting these structural parameters, the cavity response can be systematically tuned without modifying the material platform or by using any external control schemes. There is a wide spectral resonance wavelength variation of 60, 106, and 70 nm that can be achieved by varying the ONF diameter in the range of 150 nm, the grating pitch of 60 nm, and the elongation of 400 µm, respectively. The integration of a quantum emitter (QE) within the cavity region retains the geometry-dependent tunability of the system. This enables controlled spectral alignment between the QE emission wavelength and the cavity resonance. For a typical QE placed on the ONFC operating around 640 nm, it facilitates a strong spontaneous emission enhancement with a Purcell factor of ∼20 and a coupling efficiency of ∼94% into the ONF-guided mode. The scattering-limited cavity performance yields a quality factor, finesse, and one-pass power loss of 2930, 104, and 2.9%. Owing to its geometry-controlled design, the proposed device can be readily adapted to different QE wavelengths through appropriate structural optimization, offering a compact and fiber-integrated platform for quantum information and communication applications.

Journal of the Optical Society of America B•May 20, 2026•2 citations
We report a new gateway to enhance the sponatnesous emission rate of single quantum emitters by introducing a cavity in tilted nanofiber Bragg grating (TNFBG). We found that light emitter's coupling efficiency into the tilted grating structure's guided mode is 65%, with 70 grating periods. This novel tilted structure has a high Q factor ~ 1408.71 and low mode volume ~ 0.66 microm3- an important requirement. Further, the Purcell factor of a quantum light emitter inside the nanofiber is nine times more than that of an emitter on the cavity's surface. The further optimized system with enhanced perfromance can be used the next generation quantum information and quantum metrology application.
We present a novel approach to enhance the spontaneous emission rate of single quantum emitters in an optical nanofiber-based cavity by introducing a narrow air-filled groove into the cavity. Our results show that the Purcell factor for single quantum emitters inside the groove of the nanofiber-based cavity can be at least six times greater than for such an emitter on the fiber surface when using an optimized cavity mode and groove width. Moreover, the coupling efficiency of single quantum emitters into the guided mode of this nanofiber-based cavity can reach up to ∼80% with only 35 cavity-grating periods. This new system has the potential to act as an all-fiber platform to realize efficient coupling of photons from single emitters into an optical fiber for quantum information applications.
We demonstrate cavity QED conditions in the Purcell regime for single quantum emitters on the surface of an optical nanofiber. The cavity is formed by combining an optical nanofiber and a nanofabricated grating to create a composite photonic crystal cavity. By using this technique, significant enhancement of the spontaneous emission rate into the nanofiber guided modes is observed for single quantum dots. Our results pave the way for enhanced on-fiber light-matter interfaces with clear applications to quantum networks.
Abstract We report on a simulation of a nanophotonic cavity constructed by designing periodic holes on an optical nanofiber to realize light–matter interaction. The cavity is designed using finite-difference time-domain simulations to maximize the coupling of spontaneous emission from a quantum emitter into fiber-guided modes. We systematically analyze the dependence of spontaneous emission on the quantum emitter position, polarization, and the grating strength (number of periods). We show that coupling efficiencies as high as 87% and 83% can be realized for a dipole emitter placed at the center of the nanofiber with polarization perpendicular ( x -pol) and parallel ( y -pol) to the hole-axis, respectively. This system may attract various quantum photonic applications based on single-photon sources.
Efficient coupling of photons emitted from single light emitters into the single guided mode of an optical fiber is important to realize photonic quantum network devices [1], such as single photon sources [2] and quantum phase gates [3]. For this purpose, we have developed nanofiber Bragg cavities (NFBCs) and observed the enhanced photon emission from the single light emitter [4]. Here, we report the development of the NFBC with the Q-factor of 1560, which is about 5 times larger than our previous NFBC fabricated by a gallium focused ion beam (FIB) milling system [4]. According to numerical simulation, the NFBC with such high-ß factor can be realized Purcell factor of about 18 and the coupling efficiency of about 80 %.
We propose a geometry-driven strategy for achieving tunable single-photon coupling in an optical nanofiber cavity (ONFC), where the resonance wavelength is controlled by tailoring the optical nanofiber (ONF) diameter and the grating pitch. By adjusting these structural parameters, the cavity response can be systematically tuned without modifying the material platform or by using any external control schemes. There is a wide spectral resonance wavelength variation of 60, 106, and 70 nm that can be achieved by varying the ONF diameter in the range of 150 nm, the grating pitch of 60 nm, and the elongation of 400 µm, respectively. The integration of a quantum emitter (QE) within the cavity region retains the geometry-dependent tunability of the system. This enables controlled spectral alignment between the QE emission wavelength and the cavity resonance. For a typical QE placed on the ONFC operating around 640 nm, it facilitates a strong spontaneous emission enhancement with a Purcell factor of ∼20 and a coupling efficiency of ∼94% into the ONF-guided mode. The scattering-limited cavity performance yields a quality factor, finesse, and one-pass power loss of 2930, 104, and 2.9%. Owing to its geometry-controlled design, the proposed device can be readily adapted to different QE wavelengths through appropriate structural optimization, offering a compact and fiber-integrated platform for quantum information and communication applications.