Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2006.14103 · Lecture notes in computer science

Simulation Methodology for Electron Transfer in CMOS Quantum Dots

Andrii Sokolov, Dmytro Mishagli, Panagiotis Giounanlis, Imran Bashir, Dirk Leipold, Eugene Koskin, Robert Bogdan Staszewski, Elena Blokhina

Published Jan 1, 2020• 7 citations
arXivHTMLPDF
DOI
10.1007/978-3-030-50433-5_50

Related papers

Optimal point of accuracy of single-electron transfer using a dynamic quantum dot

Gento Yamahata, Nathan Johnson, Akira Fujiwara

The Japan Society of Applied Physics•Jan 26, 2021•0 citations

Quantum state transfer of electrons in chaotic quantum dots

Eduardo H. Santos, Francisco A. G. Almeida

Physica E Low-dimensional Systems and Nanostructures•Oct 21, 2020•1 citation

Highly uniform first-electron position in qubit arrays fabricated on dedicated QSOI(R) 300mm commercial platform

Johan Pelloux-Prayer, Elise Prin, Giselle A. Elbaz +11 more

We report progress toward the development of a quantum silicon-on-insulator (QSOI(R)) technology compatible with 300mm CMOS fabrication and adapted from the 28nm Fully-Depleted SOI (28nm FD-SOI) platform for scalable quantum computing. We compare quantum devices fabricated with standard 28nm FD-SOI and QSOI(R) technologies, and show striking improvements of room temperature electrostatic properties of the individual device. Moreover, the QSOI(R) technology has significantly reduced the device variability and the dispersion of device properties at the wafer level. Transistor metrics are reproduced by TCAD simulations showing that the electrostatics of the devices behave as expected for QSOI(R) technology. Wafer-scale measurements at sub-2K show reproducible quantum dots down to the few-electron regime with 69\% yield for successful charge detection of the first electron and a dispersion of the first electron position of $\mathrm{\pm 35 mV}$ over 377 quantum dots. These results establish QSOI(R) as a promising platform for CMOS-compatible quantum device co-integration.

cond-mat.mes-hallCross-listedarXiv:2609.20043•Sep 18, 2026

Electron counting in quantum dots

Simon Gustavsson, Renaud Leturcq, M. Studer +5 more

arXiv:0905.4675•Surface Science Reports•Apr 9, 2009•150 citations

Conditional Dispersive Readout of a CMOS Single-Electron Memory Cell

Simon Schaal, Sylvain Barraud, John J. L. Morton +1 more

For direct interfacing of digital and quantum electronics in quantum computation, mature CMOS technology, with its potential for large-scale integration and data management, offers solutions for control, readout, and fast data processing with large numbers of qubits. The authors combine three likely components of an all-CMOS quantum computer---a quantum-dot transistor, a digital transistor for control, and an rf readout circuit---to yield a single-electron memory cell. The digital transistor locks charge on the quantum-dot gate and allows conditional readout via gate-based rf reflectometry, demonstrating the building blocks for time-multiplexed readout of multiqubit devices.

arXiv:1708.04159•Physical Review Applied•May 10, 2018•29 citations

Interacting electrons in a quantum dot : quantum Monte Carlo studies

Ari Harju

•Jan 1, 1999•0 citations
We report progress toward the development of a quantum silicon-on-insulator (QSOI(R)) technology compatible with 300mm CMOS fabrication and adapted from the 28nm Fully-Depleted SOI (28nm FD-SOI) platform for scalable quantum computing. We compare quantum devices fabricated with standard 28nm FD-SOI and QSOI(R) technologies, and show striking improvements of room temperature electrostatic properties of the individual device. Moreover, the QSOI(R) technology has significantly reduced the device variability and the dispersion of device properties at the wafer level. Transistor metrics are reproduced by TCAD simulations showing that the electrostatics of the devices behave as expected for QSOI(R) technology. Wafer-scale measurements at sub-2K show reproducible quantum dots down to the few-electron regime with 69\% yield for successful charge detection of the first electron and a dispersion of the first electron position of ±35mV\mathrm{\pm 35 mV}±35mV over 377 quantum dots. These results establish QSOI(R) as a promising platform for CMOS-compatible quantum device co-integration.
For direct interfacing of digital and quantum electronics in quantum computation, mature CMOS technology, with its potential for large-scale integration and data management, offers solutions for control, readout, and fast data processing with large numbers of qubits. The authors combine three likely components of an all-CMOS quantum computer---a quantum-dot transistor, a digital transistor for control, and an rf readout circuit---to yield a single-electron memory cell. The digital transistor locks charge on the quantum-dot gate and allows conditional readout via gate-based rf reflectometry, demonstrating the building blocks for time-multiplexed readout of multiqubit devices.