For over three decades, the presence of magnetic flux noise with a power spectral density scaling roughly as
SPhi(f)propto1/falpha, where
alphalesssim1, has been known to limit the low-frequency performance of dc superconducting quantum interference devices (SQUIDs). In recent years, experiments indicate that this same noise persists to frequencies up to 1~GHz and is a dominant source of dephasing in flux-sensitive superconducting quantum bits (qubits). Thus, the reduction of flux noise presents a major hurdle towards the successful realization of scalable quantum computers that are based on flux-based qubits. In this thesis, we present experimental measurements, theoretical analyses, and numerical simulations that support a more detailed understanding of both the microscopic and macroscopic properties of flux noise.Our experimental work begins with flux noise measurements of a large number of SQUIDs in the temperature range from 0.1~K to 4~K. We report on measurements of ten SQUIDs with systematically varied geometries and show that
alpha increases as the temperature is lowered; in so doing, each spectrum pivots about a nearly constant frequency. The mean square flux noise, inferred by integrating the power spectra, grows rapidly with temperature and at a given temperature is approximately independent of the outer dimension of a given SQUID washer. We show that these results are incompatible with a model based on the random reversal of independent, spins that are located at the surface of the SQUID washer.In the course of our flux noise measurements, we became aware of a spurious contribution to low-frequency critical current noise in Josephson junctions---normally attributed to charge trapping in the barrier---arising from temperature instabilities inherent in cryogenic systems. These temperature fluctuations modify the critical current via its temperature dependence. By computing cross-correlations between measured temperature and critical current noise in Al-AlOx-Al junctions, we show that, despite excellent temperature stability, temperature fluctuations induce observable critical current fluctuations. Particularly, because
1/f critical current noise has decreased with improved fabrication techniques in recent years, it is important to understand and eliminate this additional noise source.Next, we introduce a numerical method of calculating the mean square flux noise
Phisq from independently fluctuating spins on the surface of thin-film loops of arbitrary geometry. By reciprocity,
Phisq is proportional to
langleBbf(rbf)2rangle, where
Bbf(rbf) is the magnetic field generated by a circulating current around the loop and
rbf varies over the loop surface. By discretizing the loop nonuniformly, we efficiently and accurately compute the current distribution and resulting magnetic field, which may vary rapidly across the loop. We use this method to compute
Phisq in a number of scenarios in which we systematically vary physical parameters of the loop. We compare our simulations to an earlier analytic result predicting that
PhisqproptoR/W in the limit where the loop radius
R is much greater than the linewidth
W. We further show that the previously neglected contribution of edge spins to
Phisq is significant---even dominant---in narrow-linewidth loops.To calculate theoretical dephasing rates in qubits, we consider flux noise with a spectral density
SPhi(f)=A2/(f/1 hboxHz)alpha, where
A is of the order of 1~
muPhi0,hboxHz−1/2 and
0.6leqalphaleq1.2;
Phi0 is the flux quantum. For a qubit with an energy level splitting linearly coupled to the applied flux, our calculations of the dependence of the pure dephasing time
tauphi of Ramsey and echo pulse sequences on
alpha for fixed
A show that
tauphi decreases rapidly as
alpha is reduced. We find that
tauphi is relatively insensitive to the noise bandwidth,
f1leqfleqf2, for all
alpha provided the ultraviolet cutoff frequency
f2>1/tauphi. We calculate the ratio
tauphi,E/tauphi,R of the echo (
E) and Ramsey (
R) sequences, and the dependence of the decay function on
alpha and
f2. We investigate the case in which
SPhi(f0) is fixed at the ``pivot frequency''
f0neq1~Hz while
alpha is varied, and find that the choice of
f0 can greatly influence the sensitivity of
tauphi,E and
tauphi,R to the value of
alpha.Finally, we conclude with a brief review of our principal results and conclusions. We also comment on promising avenues of future research.
Abstract : Qubit dephasing is governed by low-frequency noise in the bias parameters that control the energy separation between the qubit states. It has been shown that dephasing in phase and flux qubits is dominated by an excess low frequency magnetic flux noise with a 1/f power spectrum and magnitude at 1 Hz of order 1 microPhi0/sqrt(Hz). Recent experiments by McDermott et al. provide clear evidence for the existence of unpaired magnetic states on the surfaces of superconducting thin film devices; it is now believed that fluctuations of these surface spin states are the source of the ubiquitous 1/f flux noise. However, the microscopic mechanism that drives fluctuations of these spins is not understood; moreover, there is no clear path to reducing the flux noise magnitude. This program is devoted to a systematic investigation of magnetic surface defects in SQUIDs and phase qubits. Measurements of surface spin susceptibility and susceptibility noise will yield valuable clues about the microscopic nature of the magnetic fluctuators, and shed light on interactions between defects. The role of qubit loop geometry on flux noise magnitude and dephasing will be explored in detail. The experiments will guide theoretical efforts to develop improved models for flux noise.
Superconducting Quantum Interference Devices (SQUIDs) are currently being used as flux qubits and read-out detectors in a variety of solid-state quantum computer architectures. The main limitation of SQUID qubits is that they have a coherence time of the order of 10 us, due to the presence of intrinsic flux noise that is not yet fully understood. The origin of flux noise is currently believed to be related to spin impurities present in the materials and interfaces that form the device. Here we present a novel numerical method that enables calculations of the flux produced by spin impurities even when they are located quite close to the SQUID wire. We show that the SQUID will be particularly sensitive to spins located at its wire edges, generating flux shifts of up to 4 nano flux quanta, much higher than previous calculations based on the software package FastHenry. This shows that spin impurities in a particular region along the wire's surface play a much more important role in producing flux noise than other spin impurities located elsewhere in the device.
The performance of SQUIDs and superconducting qubits based on magnetic flux is degraded by the presence of magnetic flux noise with a spectral density scaling approximately inversely with frequency. It is generally accepted that the noise arises from the random reversal of spins on the surface of the superconductors. We introduce a numerical method of calculating the mean square flux noise from independently fluctuating spins on the surface of thin-film loops of arbitrary geometry. By reciprocity, is proportional to 〈 B ( r ) 2 〉, where B ( r ) is the magnetic field generated by a circulating current around the loop and r varies over the loop surface. By discretizing the loop nonuniformly, we efficiently and accurately compute the current distribution and resulting magnetic field, which may vary rapidly across the loop. We use this method to compute in a number of scenarios in which we systematically vary physical parameters of the loop. We compare our simulations to an earlier analytic result predicting that in the limit where the loop radius R is much greater than the linewidth W . We further show that the previously neglected contribution of edge spins to is significant—even dominant—in narrow-linewidth loops.
Recent experiments on superconducting flux qubits, consisting of a superconducting loop interrupted by Josephson junctions, have demonstrated quantum coherence between two different quantum states. The state of the qubit is measured with a superconducting quantum interference device (SQUID). Such measurements require the SQUID to have high resolution while exerting minimal backaction on the qubit. By designing shunts across the SQUID junctions appropriately, one can improve the measurement resolution without increasing the backaction significantly. Using a path-integral approach to analyze the Caldeira-Leggett model, we calculate the narrowing of the distribution of the switching events from the zero-voltage state of the SQUID for arbitrary shunt admittances, focusing on shunts consisting of a capacitance
Cs and resistance
Rs in series. To test this model, we fabricated a dc SQUID in which each junction is shunted with a thin-film interdigitated capacitor in series with a resistor, and measured the switching distribution as a function of temperature and applied magnetic flux. After accounting for the damping due to the SQUID leads, we found good agreement between the measured escape rates and the predictions of our model. We analyze the backaction of a shunted symmetric SQUID on a flux qubit. For the given parameters of our SQUID and realistic parameters for a flux qubit, at the degeneracy point we find a relaxation time of $113\phantom{\rule{0.3em}{0ex}}\ensuremath{\mu}\mathrm{s}$, which limits the decoherence time to $226\phantom{\rule{0.3em}{0ex}}\ensuremath{\mu}\mathrm{s}$. Based on our analysis of the escape process, we determine that a SQUID with purely capacitive shunts should have narrow switching distributions and no dissipation.
It is well known that that superconducting qubits based on Josephson junctions have the advantages of scalability and the qubit states are easy to prepare and control. In addition, demonstration of Rabi oscillations in various superconducting circuits shows that superconducting qubits are promising for scalable quantum information processing. However, despite flexibility of design and fabrication, easier to scale up, and fast gate speed, superconducting qubits usually have much shorter decoherence time than trapped ions, NMR etc. due to the relatively strong interactions between qubits and environment. Recent experiments show that low frequency flux noise is the dominant mechanism of decoherence in superconducting flux qubits. However, despite extensive effort the origin of flux noise is still not well understood. The goal of this work is to identify the source and characterize the property of flux noisein rf SQUID flux qubit through various spectroscopy and time-resolved measurements. Our result show that one can determine all circuit parameters needed for reconstructing qubit Hamiltonian with high accuracy via measurement of macroscopic resonant tunneling (MRT) and photon assisted tunneling (PAT) and that the amount of flux noise in rf SQUID qubits scales linearly with self inductance of the qubits. In addition, we have investigated the dynamics of a three-level flux qubit in incoherent regime. The result demonstrates that treating a multi-level physical qubit, such as the superconducting flux qubit, as an ideal two-level quantum system may be inadequate under certain circumstances.